• 대한전기학회논문지:전기물성ㆍ응용부문C
• /
• 제51권4호
• /
• pp.158-163
• /
• 2002

The pulsed Power system has been widely used to many applications, such as E/P(Electrostatic Precipitator), DeNOx/DeSOx power system, often generator, etc. In this paper, we study EMTP analysis and characteristics of critical voltage and load in impedance on various electrode length of pulse corona. To obtain a stable pulse voltage, we designed a compact pulse generator switched MOSFET and tested their characteristics by adjusting electrode length and pulse repetition. As a re sult, critical voltage of pulse corona and load impedance on increasing electrode length were decreased. These results indicate we can control critical voltage of pulse corona and suppress arc discharging between two electrodes.

• Journal of the Optical Society of Korea
• /
• 제19권2호
• /
• pp.130-135
• /
• 2015

Based on the extended nonlinear Schr$\ddot{o}$dinger equation, the influences of the filter effect on pulse splitting in a passively mode-locked erbium-doped fiber laser with positive dispersion cavity are investigated theoretically. Numerical results show that, as the bandwidth of the spectral filter decreases, the nonlinear chirp appended to the pulse increases under the combined action of the filter effect of the super-Gaussian spectral filter and the self-phase modulation effect. On further decreasing the bandwidth, the wave breaking of the pulse takes place. In addition, by varying the pump power of the laser or the profile of the spectral filter, the influences of the filter effect on pulse splitting also change accordingly.

• Applied Science and Convergence Technology
• /
• 제23권3호
• /
• pp.145-150
• /
• 2014

MgO thin films were deposited by internal ICP-assisted reactive-magnetron sputtering with bipolar pulse bias on a substrate to suppress random arcs. Mg is reactively sputtered by a bipolar pulsed DC power of 100 kHz into ICP generated by a dielectrically shielded internal antenna. At a mass flow ratio of $Ar/O_2$ = 10 : 2 and an ICP/sputter power ratio of 1 : 1, optimal film properties were obtained (a powder-like crystal orientation distribution and a RMS surface roughness of approximately 0.42 nm). A bipolar pulse substrate bias at a proper frequency (~a few kHz) prevented random arc events. The crystalline preferred orientations varied between the (111), (200) and (220) orientations. By optimizing the plasma conditions, films having similar bulk crystallinity characteristics (JCPDS data) were successfully obtained.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2003년도 하계학술대회 논문집 C
• /
• pp.1732-1734
• /
• 2003

An MgO thin film sputtering system for the PDP (Plasma Display Panel) applications has been developed. This system was manufactured with a vertical In-Line type of 42 inch, which has the length of 520 mm and the width of 900 mm. A reactive magnetron discharge for this sputtering was generated using an unipolar pulsed power supply which has functions of constant voltage (Max. 500 V) and current (Max. 15 A) control, frequency of $10{\sim}100$ kHz and duty ratio of $10{\sim}60$ %. The experiment was conducted under various conditions : $3{\sim}10$ mTorr of pressure, the ratio of $O_2$/Ar = $0.1{\sim}0.5$, 50 % of duty and power of $0.5{\sim}1.7$ kW. From the experiment, the deposition rate of a static state and a moving state were measured to be about 45 nm/min and 6 nm m/min at the distance of 50 mm between the target and the substrate, respectively.

• 센서학회지
• /
• 제20권4호
• /
• pp.230-233
• /
• 2011

In this paper, highly-efficient optical gating in a junction device based on vanadium dioxide($VO_2$) thin film grown by a sol-gel method was investigated as a gate terminal of a three-terminal device using infrared light with a wavelength of ~1554.6 nm. Due to the photoinduced phase transition, the threshold voltage of the $VO_2$ junction device, at which the device current abruptly jumps, could be tuned with a sensitivity of ~96.5 V/W by adjusting the optical power of the infrared light directly illuminating the device. Compared with the tuning efficiency of the previous device fabricated using $VO_2$ thin film deposited by a pulsed laser deposition method, the threshold voltage of this device could be tuned by ~76.8 % at an illumination power of ~39.8 mW resulting in a tuning efficiency of ~1.930 %/mW, which is ~4.9 times larger than the previous device.

• Journal of Power Electronics
• /
• 제15권2호
• /
• pp.431-442
• /
• 2015

Dead-time element must be set into space vector pulsed width modulation signals to avoid short circuits of the inverter. However, the dead-time element distorts the output voltage vector, which deteriorates the performance of electrical machine drive system. In this paper, dead-time effect and its compensation control strategy are analyzed. Based on the analysis, the voltage distortion caused by dead-time is regarded as two disturbances imposed on dq axes in the rotor reference frame, which degenerates the current tracking performance. To inhibit the adverse effect caused by the dead-time, a control scheme using two linear extended state observers is proposed. This method provides a strong ability to suppress dead-time effects. Simulations and experiments are conducted on a permanent magnet synchronous motor drive system to demonstrate the effectiveness of the proposed method.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2015년도 전력전자학술대회 논문집
• /
• pp.387-388
• /
• 2015

본 논문은 장펄스 폭을 가지는 펄스 전원 장치에 대해서 기술한다. 펄스 전원 장치는 크게 충전부와 펄스부로 나누어 진다. 충전부의 경우 고효율, 고신뢰성을 위한 공진형 컨버터와 높은 전압이득을 위한 배전압 정류 회로로 구성 되어 있으며, 펄스부의 경우 펄스의 제어가 용이하고 고밀도 구현이 가능한 수정형 막스 방식의 제네레이터를 채택하고 있다. 또한 개발된 펄스 전원 장치는 직렬 스태킹 되어 있는 반도체 스위치의 효과적인 동기화 및 안정적인 구동과 장펄스를 만들어 내기 적합한 게이트 구동회로를 사용하고 있다. 다양한 실험 결과를 통하여 장펄스 전원장치 설계의 타당성과 우수성을 검증한다.

• 한국전기전자재료학회논문지
• /
• 제22권10호
• /
• pp.897-903
• /
• 2009

We have designed the backward wave oscillator. A power-pulsed generator oscillated at 24 GHz has higher frequency than current one. It is very inportant to prevent microwave from going into the beam diode, since intence microwave will harmfully affect beam generation. Due to the axial mode operation, there exist a critial value of beam energy for the oscillation. By changing the condition at the SWS end, an enhanced performance of the K-band oversized BWO is observed in a low magnetic field region about 0.8T.

• 한국레이저가공학회지
• /
• 제3권1호
• /
• pp.12-20
• /
• 2000

The nuclear steam generators are subjected to corrosion environmental condition during operation that can result in stress corrosion in the tube wall. If any tube wall degradation is recognized, the tube must be repaired by plugging or sleeving. For the sleeving repair, Nd : YAG laser welded sleeving technology is one of the most promising when considering radioactive working conditions in the nuclear power plant. In this paper, the laser welding characteristics of steam generator tube and sleeve materials are investigated. The effects of average laser power, laser energy, welding speed, pulse duration and frequency are evaluated. Based on these results, Nd : YAG laser welded sleeving repair was applied to the degraded steam generator tubes in real environment.

• 한국광학회지
• /
• 제14권3호
• /
• pp.338-342
• /
• 2003

최근 활발하게 연구되고 있는 광섬유 센서에 사용되는 광펄스신호가 광섬유에 입력될 때 발생할 수 있는 stimulated Brillouin scattering현상에 대하여 연구하였다. 펄스광원의 평균 광세기가 연속광원의 광세기와 같으면 SBS현상도 같아진다는 것을 알 수 있었다. 연구결과를 통해 연속광원을 이용한 SBS측정 결과를 이용하여 광펄스신호가 입력되었을 때 SBS 현상을 예측할 수 있다.