• 한국정보디스플레이학회:학술대회논문집
• /
• 2008.10a
• /
• pp.1193-1195
• /
• 2008

We propose a novel light guide plate for an edge-lit LED backlight. Properly designed micro-prisms enable light to go out of the LGP in near vertical direction and luminance fluctuations in front of the LEDs to be invisible.

• Proceedings of the Korea Concrete Institute Conference
• /
• 2005.05a
• /
• pp.323-326
• /
• 2005

Uniaxial tension test of Glass Fiber Reinforced Polymer (GFRP) bar reinforced concrete prisms was performed. The objective was to investigate the adequate cover thickness of the GFRP rebars. The tension stiffening effect of GFRP bar reinforced concrete was also studied. The test variables included rebar types (conventional steel rebar and two different GFRP rebars) and cover thicknesses (five different cover thicknesses ranging between 1-3db). Normal strength concrete was used. Cracking patterns on concrete surface and cracking loads were careful1y observed during the direct tensile test. The test results indicated that the adequate cover thickness of the GFRP rebars may even be larger than that of the steel rebars and that the cover thickness of 2db commonly specified for the GFRP rebars may not be large enough. The tension stiffening effect of the GFRP rebars was also quantified and documented from the test results.

• Structural Engineering and Mechanics
• /
• v.55 no.1
• /
• pp.137-160
• /
• 2015

The one-way (two-way) flexural strength of RCC prisms (circular slabs) reinforced with glass fiber textiles is addressed. To this end, alkaline-resistant glass fiber textiles with three surface weights were used in the composite, the matrix concrete was designed with zero/nonzero slump, and the textiles were used with/without an intermediate layer provided by epoxy resin and sand mortar. Prisms were tested under a four-point loading apparatus and circular slabs were placed on simple supports under a central load. Effects of the amount and geometry of reinforcement, matrix workability, and the intermediate layer on the ultimate load and deflection were investigated. Results revealed that, with a specific reinforcement amount, there is an optimum textile tex for each case, depending on the matrix mix design and the presence of intermediate layer. Similar results were obtained in one-way and two-way bending tests.

• Advances in concrete construction
• /
• v.3 no.3
• /
• pp.161-185
• /
• 2015

FRP confining is a widely used method for seismic retrofitting of concrete columns. Several studies investigated the stress-strain behavior of FRP confined concrete prisms with square and rectangular sections both experimentally and analytically. In some studies, the monotonic stress-strain behavior of confined concrete was investigated and compressive strength models were developed. To study the reliability of these models, thorough statistical tests are required. This paper aims to investigate the reliability of the presented models using statistical tests including t-test, wilcoxon rank sum test, wilcoxon signed rank test and sign test with a level of significance of 5%. Wilk Shapiro test was also employed to evaluate the normality of the data distribution. The results were compared for different cross section and confinement types. To see the accuracy of the models when there were no significant differences between the results, the coefficient of confidence was used.

• Bulletin of the Korean Chemical Society
• /
• v.30 no.9
• /
• pp.2132-2134
• /
• 2009

• 한국해양학회지
• /
• v.7 no.2
• /
• pp.86-97
• /
• 1972

The tides, tidal currents and tidal prisms at Inchon Harbor are studied with recent data. The tides at Inchon Harbor is of semi-diurnal type having a spring range of 798cm and a phase age of 2 days. The monthly mean sea level at Inchon has a maximum at August and a minimum at January with a annual range of about 40cm. the tidal currents at Inchon Outer Harbor are of semi-diurnal type same as tides and nearly reversing type. The flood and ebb currents set north and south with a velocity of about 90-175 cm/sec and 120-225 cm/sec at spring tide and begin 0.2 hours after L.W. and 0.7 hours after H. W., respectively. Non-tidal currents flow southward with 10-20 cm/sec at west side of the stream and northward with 15-20 cm/sec at east side of the stream at Inchon Outer Harbor. The flood volume through the Inchon Outer Harbor fluctuates fortnightly from 590 10$\^$6/㎥ spring tide to 260 $10^6/m^3$ at neap tide and ebb volume changes from 470 $10^6/m^3$ at spring tide to 200 $10^6/m^3$ at neap tide, respectively. The flow area along the channel to the Estuary of Yeomha is controlled by the tidal prism as expressed by $A=1.14{\times}10^{-4}P^{0.966}$

• Wind and Structures
• /
• v.31 no.3
• /
• pp.255-267
• /
• 2020

A systematic set of low-speed wind tunnel experiments was performed at Re = 6.5×10⁴ and 1.1×10⁵ to study the mean wind loading experienced by surface-mounted finite-height square prisms for different aspect ratios, incidence angles, and boundary layer thicknesses. The aspect ratio of the prism was varied from AR = 1 to 11 in small increments and the incidence angle was changed from α = 0° to 45° in increments of 1°. Two different boundary layer thicknesses were used: a thin boundary layer with δ/D = 0.8 and a thick boundary layer with δ/D = 2.0-2.2. The mean drag and lift coefficients were strong functions of AR, α, and δ/D, while the Strouhal number was mostly influenced by α. The critical incidence angle, at which the prism experiences minimum drag, maximum lift, and highest vortex shedding frequency, increased with AR, converged to a value of α_c = 18° ± 2° once AR was sufficiently high, and was relatively insensitive to changes in δ/D. A local maximum value of mean drag coefficient was identified for higher-AR prisms at low α. The overall behaviour of the force coefficients and Strouhal number with AR suggests the possibility of three flow regimes.

• Wind and Structures
• /
• v.20 no.5
• /
• pp.661-682
• /
• 2015

This study investigates the use of time-frequency coherence analysis for detecting and evaluating coherent "structures" of surface pressures and wind turbulence components, simultaneously on the time-frequency plane. The continuous wavelet transform-based coherence is employed in this time-frequency examination since it enables multi-resolution analysis of non-stationary signals. The wavelet coherence quantity is used to identify highly coherent "events" and the "coherent structure" of both wind turbulence components and surface pressures on rectangular prisms, which are measured experimentally. The study also examines, by proposing a "modified" complex Morlet wavelet function, the influence of the time-frequency resolution and wavelet parameters (i.e., central frequency and bandwidth) on the wavelet coherence of the surface pressures. It is found that the time-frequency resolution may significantly affect the accuracy of the time-frequency coherence; the selection of the central frequency in the modified complex Morlet wavelet is the key parameter for the time-frequency resolution analysis. Furthermore, the concepts of time-averaged wavelet coherence and wavelet coherence ridge are used to better investigate the time-frequency coherence, the coherently dominant events and the time-varying coherence distribution. Experimental data derived from physical measurements of turbulent flow and surface pressures on rectangular prisms with slenderness ratios B/D=1:1 and B/D=5:1, are analyzed.

• Education of Primary School Mathematics
• /
• v.27 no.2
• /
• pp.139-153
• /
• 2024

This analysis was intended to present pedagogical implications related to the guidance of solid figures in elementary mathematics textbooks. The definitions of mathematical concepts and visually represented examples presented in the prism and pyramid units were analyzed. As a result of the analysis, differences were observed in both the method and content of defining mathematical concepts, even though the same curriculum was reflected. Additionally, various forms of visual examples were provided during the learning process of prisms and pyramids. Based on the results of this analysis, it is necessary to understand the definition of mathematical concepts and to teach students in an appropriate manner, considering the goals of each session and the objectives of the activities involved in presenting visual examples.

• Honam Mathematical Journal
• /
• v.43 no.1
• /
• pp.17-25
• /
• 2021

A set D ⊆ V (G) is an independent transversal dominating set of G if D is a dominating set and also intersects every maximum independent set in G. The minimum cardinality of such a set is equal to the transversal domination number, denoted by ��it(G). This paper is devoted to the computation of the independent transversal domination number of some complementary prism.