• Journal of KSNVE
• /
• v.6 no.5
• /
• pp.671-677
• /
• 1996

This paper presents the analytical method for predicting turbulence- induced noise in the multilayered cylinder composed of an outer hose, an inner fluid and an internal core. It is assumed that an infinite axisymmetric cylinder is located horizontally in water with free stream velocity and the turbulent boundary layer (TBL) surrounding the outer hose is fully developed and homogeneous. The transfer function at the core surface due to the propagation of the pressure fluctuation within the TBL is formulated using the linearized Navier-Stockes equation for solid and fluid. In the estimation of the energy spectrum of wall pressure fluctuation, the empirical formula proposed by Strawderman based on the Corcos model is used. A general algorithm for the calculation of the pressure level at the surface of a core, that is, turbulence- induced noise, is presented. Through the detailed numerical simulation, it is found that the major noise mechanism is the propagation of the bulge wave along hose.

• The Proceedings of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.4 no.2
• /
• pp.41-45
• /
• 1990

The previous plasma diagnostics on HPS (high pressure sodium) lamp have analyzed only the average temperature and pressure. But the time change of the plasma state of HPS lamp is great by the small heat inertia. By these properties, the necessity of the diagnostics of time change of plasma state is important. This thesis proposes a new time-varying spectroscopy technics that can get the time-varying plasma state by measuring and analyze Na D line spectrum.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 1996.05a
• /
• pp.38-42
• /
• 1996

The pressure-area isotherm of monolayer at the air-water interface were obtained and the LB films were fabricated onto a quartz slides and quartz crystal by conventional Langmuir-Blodggett(LB) method. The UV absorption spectra of Langmuir-Blodggett(LB) film on quartz slides and spectrum of monolayer formed on quartz crystal have been measured. The photoisomerization of the long-chain fatty avid containing azobenzene were obtained by the application of UV and visible light. The reversibility of photoisomerization were more clear difference when the number of C$\_$n/ increased. At the pressure-area isotherms, the value of surface pressure increment were decreased when the number of C$\_$n/ increased, A surface pressure of 20mN/m was obtained as a proper one for a film deposition. The photoisomerization at LB films were also obtained by application of UV and visible light. So the LB film of long-chain fatty acid containing azobenzene has possibility to being applies to functional molecular devices such as photomemory and light switching.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.24 no.7
• /
• pp.945-956
• /
• 2000

The axisymmetric bodies considered in this study have hemispherical and ellipsoidal noses. The near-field pressure fluctuations over each nose model at $Re_D=2.43{\times}10^5$ were investigated in the laminar separation region and developing turbulent boundary layers using a 1/8' pin-holed microphone sensor. The wall pressure fluctuations were also measured in an axisymmetric boundary layer on a cylinder parallel to mean flow at a momentum thickness Reynolds number of 850 and a boundary layer thickness to cylinder radius ratio of 1.88.

• Wind and Structures
• /
• v.26 no.4
• /
• pp.191-204
• /
• 2018

This article presents a study of the largest-ever (height = 220 m) cooling tower using the large eddy simulation (LES) method. Information about fluid fields around the tower and 3D aerodynamic time history in full construction process were obtained, and the wind pressure distribution along the entire tower predicted by the developed model was compared with standard curves and measured curves to validate the effectiveness of the simulating method. Based on that, average wind pressure distribution and characteristics of fluid fields in the construction process of ultra-large cooling tower were investigated. The characteristics of fluid fields in full construction process and their working principles were investigated based on wind speeds and vorticities under different construction conditions. Then, time domain characteristics of ultra-large cooling towers in full construction process, including fluctuating wind loads, extreme wind loads, lift and drag coefficients, and relationship of measuring points, were studied and fitting formula of extreme wind load as a function of height was developed based on the nonlinear least square method. Additionally, the frequency domain characteristics of wind loads on the constructing tower, including wind pressure power spectrum at typical measuring points, lift and drag power spectrum, circumferential correlations between typical measuring points, and vertical correlations of lift coefficient and drag coefficient, were analyzed. The results revealed that the random characteristics of fluctuating wind loads, as well as corresponding extreme wind pressure and power spectra curves, varied significantly and in real time with the height of the constructing tower. This study provides references for design of wind loads during construction period of ultra-large cooling towers.

• The KSFM Journal of Fluid Machinery
• /
• v.6 no.3 s.20
• /
• pp.51-57
• /
• 2003

Characteristics of the high frequency pulsatile flow have been investigated experimentally to understand the flow phenomena in the hydraulic system. One axis fatigue test bed, which is widely used for automobile field test, is used. Four pressure transducers, an amplifier and a A/D convertor are used to obtain the high frequency pulsatile pressure waveform in hydraulic system. The characteristics of frequency are analyzed by power spectrum method. According to the variations of pump input pressure and actuator acceleration frequency, the pressure is measured with or without an accumulator. The amplitude of pressure with accumulator is very lower than those without accumulator due to absorbing function of accumulator. As the frequency of actuator acceleration is increased, the effect of accumulator become very important to decrease the amplitude of pulsatile pressure waveform with high frequencies.

• Proceedings of the KIEE Conference
• /
• 1991.11a
• /
• pp.333-335
• /
• 1991

${\prod}-A$ characteristics and UV-visible spectrum of N-docosylquinolium-TCNQ monolayers were investigated. ${\prod}-A$ characteristics of N-docosylquinolium-TCNQ monolayer were measured following variation. i > ${\prod}-A$ characteristics with a variation of spreading amount. ii > ${\prod}-A$ characteristics with a variation of subphase temperature. An optium surface pressure for a LB Film deposition was found to be a 30, 45 mN/m in pure water subphase(pH 5.4, $25^{\circ}C$). UV-visible spectrum Analysis of these LB film were investigated. As a result, we think two kinds of surface pressure had no effect the monolayer aggregation but monolayer density.

• Transactions of the Korean Society of Pressure Vessels and Piping
• /
• v.16 no.1
• /
• pp.30-36
• /
• 2020

In SMART, the flow mixing header assembly (FMHA) is used to mix the coolant flowing into the reactor core to maintain a uniform temperature. The FMHA is designed to have enough stiffness so the resonance with reactor internal structures does not occurs during the pipe break and the seismic accidents. Since the gap between the FMHA and the core support barrel assembly is very narrow compared with the diameter of FMHA, the hydrodynamic mass effect acting on the FMHA is not negligible. Therefore the hydrodynamic mass characteristics on the FMHA are investigated to consider the fluid and structure interaction effects. The result of modal analysis for the dry and underwater conditions, the natural frequency of primary vibration mode for the horizontal direction is reduced from 136.67 Hz to 43.76 Hz. Also the result of frequency response spectrum seismic analysis for the dry and underwater conditions, the maximum equivalent stress are increased from 13.89 MPa to 40.23 MPa. Therefore, reactor internal structures located in underwater condition shall consider carefully the hydrodynamic mass effects even though they have sufficient stiffness required for performing its functions under the dry condition.

• Journal of Electrical Engineering and Technology
• /
• v.10 no.3
• /
• pp.1174-1180
• /
• 2015

We investigate in this paper the radiated electromagnetic waves together with the discharge characteristics of Trichel pulse of negative DC corona discharge in air in pin-to-plate and wire-to-plate configurations. The feature of the current pulse and the frequency spectrum of the electromagnetic radiations were measured under various pressures and gas gaps. The results show that the repetition frequency and the amplitude of Trichel pulse current depend on the discharge conditions, but the rising time of the pulse relates only to the radius of needle or wire and keeps constant even if the other conditions (including the discharge current, the gas gap and the gas pressure) change. There exists the characterized spectrum of electromagnetic waves from negative corona discharge in Trichel pulse regime. These characterized radiations do not change their frequency at a given cathode geometry even if the averaged current, the gas gap or the air pressure changes, but the amplitude of radiations changes accordingly. The characterized electromagnetic radiations from Trichel pulse corona relate to the formation or the rising edge of current pulse. It confirms that the characterized radiations from Trichel pulse supply information of discharge system and provide a potential method for detecting charged targets.

• Biotechnology and Bioprocess Engineering:BBE
• /
• v.6 no.3
• /
• pp.183-188
• /
• 2001

The deposition behavior and photoelectric response characteristics of chlorophyll a(Chl a) monolayers and multilayers were investigated under various film fabrication conditions. Chl a LB films were deposited onto quartz and pretreated ITO glass substrates under several fabrication conditions, including surface pressure and number of layers. The absorption spectra of Chl a in a solution state and solid-like state (LB films) were fairly consistent with each other, and two absorption peaks were found at 678 and 438nm, respectively. The prepared Chl a LB films were set into an electrochemistry cell equipped with a Pt plate as the counter electrode, and the photoelectric response characteristics were obtained and analyzed relative to the light illumination. By considering the resulting photocurrents, the optimal fabrication conditions for Chl a LB films were determined as 20mN/m of surface pressure and 20 layers. The action spectrum of the Chl a LB films was obtained in the visible region, and was found to be in good agreement with the absorption spectrum. The possible application of the proposed system as a constituent of an artificial color recognition device was suggested based on combining with the photoelectric conversion property of another light-sensitive biological pigment.