• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2006년도 제37회 하계학술대회 논문집 C
• /
• pp.1337-1338
• /
• 2006

BiSrCaCuO was prepared by the thermal pyrolysis method. The solid precursor produced by the dehydration of the gel at $120^{\circ}C$ for 12h is not in the amorphous state as expected but in a crystalline state. X-ray diffraction peaks of nearly the same angular position as the peaks of high Tc phase were observed in the precursor. After pyrolysis at $90^{\circ}C$ and calcination at $840^{\circ}C-920^{\circ}C$ for 4h, the high Tc phase was cleary observed. In this paper, the establishment of fabrication condition and additive effects of second elements were examined so as to improve the related properties to the practical use of BiSrCaCuO superconductor, and we reported the production of the BiSrCaCuO high Tc superconductor by the pyrolysis method.

• Journal of Electrochemical Science and Technology
• /
• 제15권1호
• /
• pp.168-177
• /
• 2024

Ni-rich cathode is one of the promising candidates for high-energy lithium-ion battery applications. Due to its specific capacity, easy industrialization, and good circulation ability, Ni-rich cathode materials have been widely used for lithium-ion batteries. However, due to the limitation of the co-precipitation method, including sewage pollution, and the instability of the long production cycles, developing a new efficient and environmentally friendly synthetic approach is critical. In this study, the Ni_0.91Co_0.06Mn_0.03CO₃ precursor powder was successfully synthesized by an efficient spray-drying method using carbonate compounds as a raw material. This Ni_0.91Co_0.06Mn_0.03CO₃ precursor was calcined by mixing with LiOH·H₂O (5 wt% excess) at 480℃ for 5 hours and then sintered at two different temperatures (780℃/800℃) for 15 hours under an oxygen atmosphere to complete the cathode active material preparation, which is a key component of lithium-ion batteries. As a result, LiNi_0.91Co_0.06Mn_0.03O₂ cathode active material powders were obtained successfully via a simple sintering process on the Ni_0.91Co_0.06Mn_0.03CO₃ precursor powder. Furthermore, the obtained LiNi_0.91Co_0.06Mn_0.03O₂ cathode active material powders were characterized. Overall, the material sintered at 780℃ shows superior electrochemical performance by delivering a discharge capacity of 190.76 mAh/g at 1^st cycle (0.1 C) and excellent capacity retention of 66.80% even after 50 cycles.

• 한국결정성장학회지
• /
• 제25권3호
• /
• pp.93-97
• /
• 2015

본 연구에서는 고순도 균질 마이크로 Ag 입자를 얻기 위하여 용매추출법과 RF-LPP법을 이용하여 Air 분위기에서 $500^{\circ}C$에서 3시간 동안 열처리하여 Ag 입자를 합성하였다. 합성된 마이크로 Ag 입자를 XRD에 의해 비교 분석한 결과 주요 peak들이 JCPDS card(No. 87-0719)와 일치하는 것을 확인하였다. RF-LPP법을 이용함으로써, 핵 생성 싸이트 제어를 통해 균질 마이크로 Ag 입자를 합성하였으며, 환원처리 후 산소의 함유가 줄어드는 것을 확인하였다. 본 연구를 통하여 재활용 기술에 큰 기여를 할 것이라 기대한다.

• 공업화학
• /
• 제10권3호
• /
• pp.331-335
• /
• 1999

진이급속 산화물은 전기화학적 산소 발생/환원에 대한 bifunctional 촉매효과가 있어 금속-공기 이차전지와 같은 에너지 저장기술 개발에 연구대상이 되어왔다. Amorphous citrate precursor법을 이용하여 perovskite 구조를 갖는 La-Ca-Co 산화물과 pyrochlore 구조를 갖는 Pb-Ru 산화물을 제조하고, 이후 열처리법으로 표면적이 큰 전이금속 산화물 촉매분말을 제조하였다. PTFE 결합 기체확산형 전극의 충방전 실험을 통하여 전기화학적 산소발생/환원에 대한 좋은 촉매능을 가짐을 확인하였고, ${\pm}25mA/cm^2$의 전류밀도를 가하고 공기를 공급하면서 충방전 실험한 결과 100시간 이내에서 두촉매분말 모두 안정하였다. ACP법으로 제조한 perovskite 구조의 La0.6Ca0.4CoO3과 pyrochlore 구조의 Pb2Ru2O6가 이차전지용 공기전극 재료로 사용할 수 있음을 확인하였다.

• Current Photovoltaic Research
• /
• 제10권2호
• /
• pp.39-48
• /
• 2022

A Se-containing Cu/SnSe₂/ZnSe precursor was employed to introduce S to the precursor to form Cu₂ZnSn(S,Se)₄ (CZTSSe) film. The morphology of CZTSSe films strongly varied with two different pre-annealing environments: S and N₂. The CZTSSe film with S pre-annealing showed a dense morphology with a smooth surface, while that with N₂ pre-annealing showed a porous film with a plate-shaped grains on the surface. CuS and Cu₂Sn(S,Se)₃ phases formed during the S pre-annealing stage, while SnSe and Cu₂SnSe₃ phases formed during the N₂ pre-annealing stage. The SnSe phase formed during N₂ pre-annealing generated SnS₂ phase that had plate shape and severely aggravated the morphology of CZTSSe film. The power conversion efficiency of the CZTSSe solar cell with S pre-annealing was low (1.9%) due to existence of Zn(S.Se) layer between CZTSSe and Mo substrate. The results indicated that S pre-annealing of the precursor was a promising method to achieve a good morphology for large area application.

• 전기화학회지
• /
• 제2권1호
• /
• pp.5-12
• /
• 1999

PVA-전구체법을 사용하여, 리튬전지의 양극물질인 $Li_xNi_{1-y}Co_yO_2$의 다결정성 분말을 합성하였다. 합성된 분말을 양극물질로 사용하여 리튬이온전지를 제조하여 전지의 전기화학적 성질을 측정하였다. PVA와 금속이온간의 상대적 양, PVA의 농도 및 중합도, 열처리조건, 금속의 조성비 등 여러 다른 합성조건을 변화시키면서, 그러한 합성상의 조건 변화가 리튬이온전지의 전지특성과 어떠한 상호관계를 갖는지 조사하였다. 전지의 초기성능에 관한 한, PVA-전구체법으로 합성한 $Li_xNi_{1-y}Co_yO_2$의 경우, 최적의 조성은 x=1.0, y=0.26인 것으로 관찰되었다. PVA-전구체법으로 합성할 경우, 전구체에 남는 잔여탄소로 인해 형성되는 $Li_2CO_3$가 전지의 성능을 저하시키는 것으로 관찰되었다. 이를 제거하기 위해 건조 공기의 흐름 속에서 열처리를 하거나, 합성 후 2차 열처리 과정에서 $500^{\circ}C$의 온도에서 건조공기의 흐름을 유지하며 annealing 처리를 하는 것이 전지의 특성을 크게 개선하는 것으로 관찰되었다.

• Transactions on Electrical and Electronic Materials
• /
• 제18권3호
• /
• pp.155-158
• /
• 2017

In this paper, ZnO Thin Film Transistors (TFTs) were fabricated by a sol-gel method using a low-temperature process, and their physical and electrical characteristics were analyzed. To lower the process temperature to $200^{\circ}C$, we used a zinc nitrate hydrate ($Zn(NO_3)_2{\cdot}xH_2O$) precursor. Thermo Gravimetric Analyzer (TGA) analysis showed that the zinc nitrate hydrate precursor solution had 1.5% residual organics, much less than the 6.5% of zinc acetate dihydrate at $200^{\circ}C$. In the sol-gel method, organic materials in the precursor disrupt formation of a high-quality film, and high-temperature annealing is needed to remove the organic residuals, which implies that, by using zinc nitrate hydrate, ZnO devices can be fabricated at a much lower temperature. Using an X-Ray Diffractometer (XRD) and an X-ray Photoelectron Spectrometer (XPS), $200^{\circ}C$ annealed ZnO film with zinc nitrate hydrate (ZnO (N)) was found to have an amorphous phase and much more oxygen vacancy ($V_o$) than Zn-O bonds. Despite no crystallinity, the ZnO (N) had conductance comparable to that of ZnO with zinc acetate dihydrate (ZnO (A)) annealed at $500^{\circ}C$ as in TFTs. These results show that sol-gel could be made a potent process for low-cost and flexible device applications by optimizing the precursors.

• 대한화학회지
• /
• 제58권4호
• /
• pp.388-392
• /
• 2014

Benzothieno[2,3-d]pyrimidines (2,3,4) and benzothieno[3,2-e][1,3,4]triazolo[4,3-c] pyrimidines (5a-c) were synthesized from the precursor 2-amino-7-oxo-4,5,6,7-tetrahydro-1-benzothiophene-3-carbonitrile 1 by employing the conventional method as well as the microwave irradiation technique. The precursor 2-amino-3-cyanothiophene analogue 1 was synthesized by employing the well-known Gewald reaction. In the present work it has been found that the microwave supported syntheses are more efficient than the conventional classical heating methods. The structures of all the compounds were ascertained by spectral and analytical data.

• 한국전기전자재료학회논문지
• /
• 제11권11호
• /
• pp.1001-1006
• /
• 1998

$WO_3$ based semiconduction sensor have been reported to have excellent sension properties to $NO_x$ gases by many researchers. In this study appropriate $WO_3$ precursor have been chosen and thin film sensors were fabricated by metallo organic deposition process. Their sensing characteristics were investigated as a function of NO concentration, heat treatment, and measuring temperature. Tungsten dichloro triethoxide was found to be a good precursor for $WO_3$ thin film in this method. Samples heat treated at $600^{\circ}C$ showed sensitivity (S) 200 to 50 ppm NO gas when measuring temperature was $150^{\circ}C$.

• Nuclear Engineering and Technology
• /
• 제22권2호
• /
• pp.139-150
• /
• 1990

본 논문에서는 제한된 중성자속 측정치로부터 중성자속과 프리커서의 공간분포를 추정하는 방법을 기술하였다. Luenberger 옵저버 이론에 근거하여, 이를 시간과 공간에 의존하는 원자로 동특성 방정식과 같은 북산변수계통에 확장하였다. 간단한 원자로 모형에 대해서 이 방법을 응용한 결과, 소수의 계측기만으로 얻은 정보를 이용하여 중성자속과 프리커서의 공간분포를 효과적으로 추정할 수 있음을 알았다.