• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2005년도 전력전자학술대회 논문집
• /
• pp.430-432
• /
• 2005

This paper presents a novel, single stage, isolated, three-phase switching rectifier capable of switching at high frequency. The circuit topology Provides zero-voltage switching for all switches, output voltage regulation, unity input power factor, all in a single power conversion stage. Operating principle and experimental results in the 48V/100A DC power supply of three-phase single stage method are presented.

• Journal of Power Electronics
• /
• 제4권4호
• /
• pp.197-204
• /
• 2004

Two-stage Power-Factor-Correction (PFC) converters are the most common circuits for drawing sinusoidal and in phase current waveforms from an ac source with a good regulated output voltage. The first stage is a boost PFC converter with average-current-mode control for achieving the near-unity power factor and the second stage is a forward converter with voltage-mode control to regulate the output voltage. Stability analysis and design methods of two-stage PFC converters have previously been discussed using linear models. Recently, new nonlinear phenomena have been detected in pre-regulator boost PFC circuits and a new nonlinear model has been proposed for pre-regulated PFC converters. Therefore, investigation of two-stage PFC converters from the nonlinear viewpoint becomes important because the second stage DC/DC converter adds more complexity to the circuit. So, this paper introduces a study of the stability of two-stage PFC converters. A novel nonlinear model of two-stage PFC converters is proposed. Then, a stability analysis is made based upon this nonlinear model. The high correspondence between the simulated and experimental results confirms our analysis.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2004년도 하계학술대회 논문집 B
• /
• pp.1214-1216
• /
• 2004

Conventional Switched Mode Power Supplies(SMPS) with diode-capacitor rectifier have distorted input current waveform with high harmonic contents. Typically, these SMPS have a power factor lower than 0,65. To improve with this problem the power factor correction(PFC) circuit of power supplies has to be introduced. PFC circuit have tendency to be applied in new power supply designs. The input active power factor correction circuits can be implemented using either the two-stage or the single-stage approach. In this paper, the comparative analysis of power factor correction circuit using feedforward control with average current mode single-stage flyback method converter and two-stage converter which is combination of boost and flyback converter. The two prototypes of 50W were designed and tested a laboratory experimental. Also, the comparative analysis is confirmed by simulation and experimental results.

• Journal of Power Electronics
• /
• 제7권2호
• /
• pp.174-180
• /
• 2007

In this paper, a simple control method for two-stage utility grid-connected photovoltaic power conditioning systems (PCS) is proposed. This approach enables maximum power point (MPP) tracking control with post-stage inverter current information instead of calculating solar array power, which significantly simplifies the controller and the sensor. Furthermore, there is no feedback loop in the pre-stage converter to control the solar array voltage or current because the MPP tracker drives the converter switch duty cycle. This simple PCS control strategy can reduce the cost and size, and can be utilized with a low cost digital processor. For verification of the proposed control strategy, a 2.5kW two-stage photovoltaic grid-connected PCS hardware which consists of a boost converter cascaded with a single-phase inverter was built and tested.

• 대한전기학회논문지:전력기술부문A
• /
• 제50권9호
• /
• pp.424-430
• /
• 2001

A multi-level optimal power flow(OPF) algorithm has been evolved from a simple two stage optimal Power flow algorithm for constrained power economic dispatch control. In the proposed algorithm, we consider various constraints such as ower balance, generation capacity, transmission line capacity, transmission losses, security equality, and security inequality constraints. The proposed algorithm consists of four stages. At the first stage, we solve the aggregated problem that is the crude classical economic dispatch problem without considering transmission losses. An initial solution is obtained by the aggregation concept in which the solution satisfies the power balance equations and generation capacity constraints. Then, after load flow analysis, the transmission losses of an initial generation setting are matched by the slack bus generator that produces power with the cheapest cost. At the second stage we consider transmission losses. Formulation of the second stage becomes classical economic dispatch problem involving the transmission losses, which are distributed to all generators. Once a feasible solution is obtained from the second stage, transmission capacity and other violations are checked and corrected locally and quickly at the third stage. The fourth stage fine tunes the solution of the third stage to reach a real minimum. The proposed approach speeds up the two stage optimization method to an average gain of 2.99 for IEEE 30, 57, and 118 bus systems and EPRI Scenario systems A through D testings.

• Journal of electromagnetic engineering and science
• /
• 제11권3호
• /
• pp.161-165
• /
• 2011

In this paper, a high-efficiency DC-AC converter is used for wireless energy transmission. The DC-AC convertter is implemented by combining the oscillator and power amplifier. Given that the conversion efficiency of a DC-AC converter is strongly affected by the efficiency of the power amplifier, a high-efficiency power amplifier is implemented using a class-E amplifier structure. Also, because of the low output power of the oscillator connected to the input stage of the power amplifier, a high-gain two-stage power amplifier using a drive amplifier is used to realize a high-output power DC-AC converter. The high-efficiency DC-AC converter is realized by connecting the oscillator to the input stage of the high-gain high-efficiency two-stage class-E power amplifier. The output power and the conversion efficiency of the DC-AC converter are 40.83 dBm and 87.32 %, respectively, at an operation frequency of 13.56 MHz.

• 지식경영연구
• /
• 제7권1호
• /
• pp.49-63
• /
• 2006

The objective of the study is to verify the discriminatory power of technology innovation in predicting Early Stage Ventures' success or failure. To accomplish this objective, we test early stage ventures'(Firm's period is below 3 years)technology innovation and performance. The result of the study is expected to be useful in loan evaluation, investment decision, internal management decision making and business improvement. The results of study is as follows. First, Early Stage Ventures' technology innovation power is composed of 4 major indexes(technology, marketability, manufacturing infra and economic feasibility). Second, we find that thirty-seven minor indexes are significant ex-ante variable which are discriminating between firms' success and failure in Early Stage Ventures. Also thirty-seven minor indexes explain 57.2% of the total variance. This explainable power of these indexes is similar to that of the existing 58 index elements. Finally, we find that the most important technology innovation power of Early Stage Ventures' is economic feasibility.

• KIEE International Transaction on Electrical Machinery and Energy Conversion Systems
• /
• 제4B권2호
• /
• pp.65-72
• /
• 2004

Switching power supply systems are widely used in many industrial fields. Power factor correction (PFC) circuits have a tendency to be applied in new power supply designs. The input active power factor correction (APFC) circuits can be implemented in either the two-stage approach or the single-stage approach. The two-stage approach can be classified into boost type PFC circuit and dc/dc converter. The power factor correction circuit with a boost converter used as an input power source is studied in this paper. In a boost power factor correction circuit there are two feedback control loops, which are a current feedback loop and a voltage feedback loop. In this paper, the regulation performance of output voltage and compensator to improve the transient response presented at the continuous conduction mode (CCM) of the boost PFC circuit is analyzed. The validity of designed boost PFC circuit is confirmed by MATLAB simulation and experimental results.

• 전력전자학회논문지
• /
• 제9권4호
• /
• pp.372-380
• /
• 2004

본 논문은 기존의 2개의 전력 처리단을 갖는 컨버터를 단일 전력단으로 구성하고, ZVS기법을 이용한 고역률 단일전력단 고주파 공진 AC-DC 컨버터를 제안하고 있다. 입력단에 승압형 역률개선 인덕터를 연결하여 일정 듀티비와 가변 스위칭 주파수로 입력전류를 불연속 모드로 제어함으로써 입력 역률을 개선하는 것이 가능하였다. 종래의 2개 전력 처리단을 가지는 컨버터의 경우 역률 제어용 스위치가 별도로 필요하지만 전력 처리단을 하나로 단일화 시키므로써 컨버터의 구성이 간략화 되어져, 비용의 저감과 신뢰성을 증가시킬 수 있는 등의 장점이 있다. 본 연구는 고역률 단일전력단 AC-DC 컨버터의 동작원리와 무차원화 파라미터를 이용한 특성평가를 범용성 있게 행하여, 특성평가에서 산출한 특성값을 기초로 하여 실험장치를 제작하였으며, 실험치와 이론치를 비교ㆍ검토하여 제안 회로의 특성해석의 정당성을 입증하고 있다.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2000년도 전력전자학술대회 논문집
• /
• pp.443-447
• /
• 2000

본 논문에서는 과학위성 1호의 전력계 설계에 대해서 서술한다 과학위성 1호의 전력계는 크게 Power stage와 Control stage로 나누어지는데 Power stage 는 200[Watt] Buck으로 구성되어 있으며 Control stage는 Hardware 제어기인 최대전력 추적기와 배터리 전압제어기 Software control을 위한 베터리 전류제어기와 직접 듀티제어기로 이루어져 각 동작모드에 따라서 적절한 제어기를 선택할 수 있게 되어있다. 따라서 신뢰성 있는 제어와 정밀제어를 선택적으로 정할 수 있기 때문에 위성의 운용면에서 용이성을 제공해 준다.