• 한국환경과학회지
• /
• 제7권2호
• /
• pp.203-208
• /
• 1998

A simple on-line measurement system consisting of a conventional peristaltic pump, a HPLC-type heater, and a flow-through spectrophotometer is introduced for the determination of chemical oxygen demand(CODI. The system was configured such that the reaction mixture in the highly concentrated surffuric acrid medium flowing through the PTFE reaction tubing was heated at 150℃ and the absorbance of dichromate was continuously moutored at 445 m. The same addation principle as in the standard procedure was employed akcept the use of CoSO4 as a new effective catalyst. To test the system, potassium hydrogen phthalate was selected as a COD standard material. With suitably optimized reaction condition, the applicable concentration range depends on the concentration of potassium dichromate in the oxidizing reagent. With 2.0×10-3 M and 5.0×10-4M dichromate, the linear dynamic range was observed up to 400 ppm and 100 ppm, respectively. The standards in the Unear ranges were shown to be completely oxidized, which was confirmed with sodium oxalate or Mohr's salt. In all cases, the typical reproduclbility for betweenruns was 2% or less. The proposed measurement system provides the valuable in- formation for the further development of automated analysis system based on the present standard procedure.

• 한국세라믹학회지
• /
• 제25권5호
• /
• pp.449-454
• /
• 1988

The effects of salts which was used as a catalysis in formation of $\alpha$-calciumusulfate hemihydrate from dicalcium sulfate hydrate were investigated on the hydration of $\alpha$-calciumsulfate hemihydrate. The hydration of $\alpha$-calciumsulfate hemihydrate was studied by the measurements of crystalline water, heat evolution. Also the hydrates were analyzed by XRD, DSC and SEM. The promotive effect each salts on the hydration was as follows: NaCl>NH4Cl>NaNO3>NH4NO3, and the hydration rate was accelerated with concentration of salts. The effect of Al2(SO4)3 and potassium sodium tartrate on the hydration was slmilar to water, whereas sodium succinate and gelatin retarded the hydration in comparision with water. These salts affected the hydration time but total heat evoution was similar.

• 한국미생물·생명공학회지
• /
• 제9권2호
• /
• pp.77-82
• /
• 1981

Candide tropicalis was selected for its ability to utilize spent waste generated by the alcohol distillery using tapioca starch as a raw material. Optimum pH and temperature on batch culture of the organism were 4.0 and 3$0^{\circ}C$. The growth of the organism was markedly increased when 0.2% of ammonium sulfate, 0.002% of potassium phosphate dibasic, add 0.04% of magnesium sulfate were supplemented to the filtrate. At these conditions, maximum specific growth rate and saturation constant were 1.0 hr$^{-1}$ and 4.4 g.1$^{-1}$ , respectively. At a dilution rate of 0.5hr$^{-1}$ , a productivity of 1.84 g.1$^{-1}$ . hr$^{-1}$ was obtained and about 70% of carbohydrate was assimilated. Protein content of dried cell was about 60%.

• 한국응용과학기술학회지
• /
• 제26권2호
• /
• pp.199-204
• /
• 2009

Silicone dioxide absorbed polyoxyethylene alkylether sulfate (EU-S133D) surfactant was prepared. Core-shell polymers of inorganic/organic pair, which have both core and shell component, were synthesized by sequential emulsion polymerization using Acrylate as a shell monomer and potassium persulfate (KPS) as an initiator. We found that when Acrylate core prepared by adding 2.0 wt% EU-S133D, silicone dioxide/Acrylate core-shell polymerization was carried out on the surface of silicone dioxide particle without forming the new silicone dioxide particle during acrylate shell polymerization in the inorganic/organic core-shell polymer preparation. The structure of core-shell polymer were investigated by measuring to the thermal decomposition of polymer composite using thermogravimetric analyzer and morphology of latex by scanning electron microscope(SEM).

• 대한화장품학회지
• /
• 제10권1호
• /
• pp.42-48
• /
• 1984

The comparative detergency of Sodium dodecyl sulfate (SDS) solution near the first critical micelle concentration (CMC) was measured by means of a 131 I-labelled castor oil as a soil. More than 95% radiochemical purity of 131 I-labelled castor oil was obtained using potassium lidide as a carrier. Polyester test fabric was soiled with 131 I-labelled castor oil, and washed in a conventional washing apparatus mounted on appropriate devices. Fabric radioactivities were measured before and after washing by a scintilation counter. Near the first CMC, the detergency of SDS was increased with decreasing of surface tension of SDS. It was also shown that 131 I-labelled castor oil was useful for studying the detergency of SDS.

• 한국식품영양과학회지
• /
• 제11권2호
• /
• pp.31-35
• /
• 1982

폐액으로 방류되는 두부 폐수(whey)를 이용하여 alcohol 발효를 실시하였으며 다음과 같은 결과를 얻었다. whey중(中)에 함유(含有)된 환원당은 약 0.71%로서 이당(糖)을 이용(利用)하며 l당(當) 최대(最大) 1.86 g의 ethanol이 생산(生産)되었으나 수률(收率)이 낮아서 경제성은 희박하다. 그러나 발효에 의해서 단백질과 당이 각각 94%, 81%만큼이나 감소한 결과(結果)로 미루어 보아 두부 폐수중(廢水中)의 유기물(有機物)을 alcohol 발효(醱酵)에 이용(利用)할 수 있음을 확인(確認)하였다.

• 한국환경보건학회지
• /
• 제23권1호
• /
• pp.34-42
• /
• 1997

A laboratory experiments were performed to investigate the treatment of photographic processing wastewater by chemical oxidation and biological treatment system. The effect of reaction conditions such as hydrogen peroxide dosage, ferrous sulfate dosage and pH on the COD removal in Fenton oxidation were investigated. The optimal dosage of hydrogen peroxide was 2.58 M and 3.87 M for the developing and fixing process wastewater, respectively. The Fenton oxidation was most efficient in the pH range of 3-5 and the optimal condition for initial reaction pH was 5 for a developing process wastewater. With iron powder catalyst, the COD for a developing process wastewater was removed in lower pH than with ferrous sulfate catalyst. The removal efficiency of COD for refractory compounds such as Diethyleneglycol, Benzylalcohol, Hydroxylamine Sulfate, Ammonium Thiosulfate, Ammonium Ferric EDTA and Disodium EDTA in the photogaphic wastewater was found than 90% except Potassium Carbonate. When the photographic processing wastewater after pretreatment by Fenton oxidation was treated with batch activated sludge process, the addition of $KH_2PO_4$ as a phosphorous compound improved the removal efficiency of COD. During the continuous biological treatment of developing and fixing process wastewater after pretreatment by Fenton oxidation, the effluent COD concentration less than 100 mg/l was obtained at 0.425 and 0.25 kgCOD/m$^3$.d, respectively.

• 한국표면공학회지
• /
• 제5권3호
• /
• pp.77-85
• /
• 1972

A method of preparation of synthetic ignorgaic coating on copper (patina) has been presented . An Eh--pH diagram was constructed for the present Cu-H2O-SO$_4$ system using the most recently available thermodynamic data. In the path of the patination at room temperature the general behaviour of copper in acidic copper sulfate solutions with potassium chlorate as an oxidizing agent appeared to follow those predictable in this Eh-pH diagram. In the presence 0.05 molar cupric sulfate at a temperature of about 28$^{\circ}C$ a green brochantite (CuSO$_4$$.$3Cu(OH)$_2$) layer was formed on copper sheet in 20 days. In a solution having an initial pH of 3.5 the development of a brochantite coating has been observed to take place in two stages. In the first, a layer of cuprous oxide formed on the copper at a relatively rapid rate. In the ensuing step the outer layer of cuptrite was oxidized at much slower rate to form brochantite. The syntetic coatings appeared to consist of crystal-lites of brochanitite growing perpendicular to the cuprose oxide surface. The outer tips of the -crystallites were reasily broken off and gave to the layer a rather chalky character. Underneath, at the brochantite Cu$_2$O interface, however, the green layers were firmely attached. The effect of reagent concentration , solution agitation , and moderate temperature increase were investigated to improve the quality of coating. So also in a qualitative way were the effect of light.

• 한국대기환경학회지
• /
• 제31권3호
• /
• pp.287-301
• /
• 2015

This study was conducted to investigate size distribution characteristics of water-soluble ionic components in the airborne particulate matter (PM) collected from an urban area in Busan using a MOUDI cascade impactor from March to October 2010. The inorganic constituents in the fine particles (${\leq}1.8{\mu}m$) predominantly consisted of sulfate, nitrate, ammonium, and potassium. Sulfate and ammonium concentrations showed a high correlation and similar equivalent concentrations in the fine modes including $0.18{\sim}0.32{\mu}m$, $0.32{\sim}0.56{\mu}m$, and $0.56{\sim}1.0{\mu}m$. This indicates that the main chemical component in the fine particles would be forms of ammonium sulfate such as $(NH_4)_3H(SO_4)_2$, $(NH_4)_2SO_4$, and $(NH_4)HSO_4$. Back trajectory analysis showed that relatively higher concentrations of ammonium, nitrate, and sulfate in the fine mode, compared to the coarse mode, are caused both by domestic sources and long-range transports originated from China continent. High concentration episodes of PM both in the fine mode and the coarse mode were attributed both by anthropogenic sources, such as ship emissions and traffic emissions, and by natural sources such as seawater (sea salt), respectively.

• KSBB Journal
• /
• 제18권3호
• /
• pp.180-185
• /
• 2003

GAGs의 추출 방법 중 효소의 사용으로 추출 효율의 상승과 원료수급의 문제점을 해결할 수 있었다. 그러나 효소 사용에 따른 생산단가의 상승과 단백질 함량의 증가에 따른 화장품 규격을 만족시킬 수 없음으로, 1/60 M sodium phosphate buffer로 105$^{\circ}C$로 열수 추출하는 것이 화장품 규격을 만족시키는 방법으로 나타났다. 이렇게 추출한 GAGs의 SO$_4$ 함량은 31.2%이고 회분의 함량이 22.2%로 GAGs 추출 향상을 위해 사용되어지는 sodium phosphate의 사용으로 회분 함량이 높아졌음을 알 수 있고 무기질 분석에서 Na의 함량이 3.0 mg%로 총 무기질의 47.6%를 차지하고 있었다. 시료를 HPLC로 분석하였을 때 chondroitin sulfate A, C와 동일한 분석시간을 나타내어 chondroitin sulfate의 함유 가능성을 나타내고, glucosamine과 galactose가 78.0% 존재하는 것을 당조성 분석을 통해 확인하였다. 일반 성분, HPLC분석, 당 조성분석과 아미노산 분석결과로 glucosamine과 galacturonic acid가 주가 되어 threonine으로 연결된 구조를 하는 GAGs라는 것을 알 수 있다. 화장품 원료 기준에 맞추기 위해서는 sulfate 함량이 35.0~45.0%, 단백질 함량은 14.0~22.0%로 유지해야하므로 제단백결과 5.0%, 10.0%, 20.0% TCA (w/v) 처리, 10.0%, 20.0%, 40.0% HCI (v/v) 처리, UF(ultra filtration)를 포함한 10.0% TCA (w/v), 20.0% SSA (w/v), 25.0% HCI (v/v) 처리 결과 5.0% TCA (w/v) 및 10.0% HCI (v/v)이 화장품 기준에 적합하며 경제적이며 효율적이라는 것을 알 수 있었다.