• Earthquakes and Structures
• /
• v.19 no.6
• /
• pp.485-498
• /
• 2020

Non-ductile detailing of Reinforced Concrete (RC) frames may lead to structural failure when the structure is subjected to earthquake response. These designs are generally encountered in older RC frames constructed prior to the introduction of the ductility aspect. The failure observed in the beam-column joints (BCJs) and accompanied by excessive column damage. This work examines the seismic performance and failure mode of non-ductile designed RC columns and exterior BCJs. The design was based on the actual building in Tainan City, Taiwan, that collapsed due to the 2016 Meinong earthquake. Hence, an experimental investigation using cyclic testing was performed on two columns and two BCJ specimens scaled down to 50%. The experiment resulted in a poor response in both specimens. Excessive cracks and their propagation due to the incursion of the lateral loads could be observed close to the top and bottom of the specimens. Joint shear failure appeared in the joints. The ductility of the member was below the desired value of 4. This is the minimum number required to survive an earthquake with a similar magnitude to that of El Centro. The evidence provides an understanding of the seismic failure of poorly detailed RC frame structures.

• Journal of Powder Materials
• /
• v.27 no.6
• /
• pp.468-476
• /
• 2020

The bone cement used for vertebroplasty must be sufficiently injectable. The introduction of granules reduces the amount of liquid required for liquefaction, implying that higher fluidity is achieved with the same amount of liquid. By employing β-tricalcium phosphate granules with an average diameter of 50 ㎛, changes in injectability are observed based on the paste preparation route and granular fraction. To obtain acceptable injectability, phase separation must be suppressed during injection, and sufficient capillary pressure to combine powder and liquid must work evenly throughout the paste. To achieve this, the granules should be evenly distributed. Reduced injection rates are observed for dry mixing and excessive granular content, owing to phase separation. All these correspond to conditions under which the clustered granules weakened the capillary pressure. The injected ratio of the paste formed by wet mixing displayed an inverted U-type shift with the granular fraction. The mixture of granules and powder resulted in an increase in the solid volume fraction, and a decrease in the liquid limit. This resulted in the enhancement of the liquidity, owing to the added liquid. It is inferred that the addition of granules improves the injectability, provided that the capillary pressure in the paste is maintained.

• Structural Engineering and Mechanics
• /
• v.85 no.1
• /
• pp.89-104
• /
• 2023

This work presents a proposal for employing reduced numerical integration in the formulation of the 4-node quadrilateral solid finite element. The use of these low-order integration rules leads to numerical instabilities such as those producing the hourglass effect. The proposed procedure allows evaluating a given constitutive model only in one integration point, achieving an attractive computational cost reduction and, also, successfully controls the hourglass effect. A validation of the proposal is included and discussed throughout the paper. To show the efficiency of the proposal, several application examples of masonry structures are studied and discussed. To represent the non-linear mechanical behaviour of masonry a plastic-damage model is implemented within the application of this sub-integration scheme. Also, in order to have a full and computationally efficient strategy to determine the behaviour of masonry structures, involving its evolution to collapse, a homogenization technique with a macro-modeling approach is used. The methodology discussed throughout this paper demonstrates a substantial computational cost reduction and an improved approximation of the non-linear problem evidenced by a reduction of up to 85% of the computational time for some cases.

• Journal of the Korean Society for Precision Engineering
• /
• v.12 no.2
• /
• pp.48-58
• /
• 1995

A micro positioning system using piezoelectric actuators have very wide application region such as ultra-precision machine tool, optical device, measurement systen. In order ro keep a high precision displacement resolution, they use a position sensor and feedback the error. From the practical point of view, a high-resolution displacement sensor system are very expensive and difficult to guarantee such sensitive sensors work properly in the hard opera- tion environment of industry. In this study, a micro-positioning grinding table which does not require position sensor but uses piezoelectric voltage feedback, has been developed. It is driven by hystersis-considering reference input voltage which calculated from computer and then uses actuator/sensor characteristics of piezoelectric materials. From the result of experiments we proved a fast and stable response of micro-positioning system and suggested efficient technique to control the piezoelectric actuator. And through grinding experiments, it is revealed that a characteristics of ground surfaces transient to plastic deformation as extremely small depth of grinding.

• Proceedings of the Korean Institute of Building Construction Conference
• /
• 2021.05a
• /
• pp.53-54
• /
• 2021

Grenfell Tower was renovated in 2014 and 2016 at a high cost to replace the exterior materials, windows and co-heating facilities of the building. The exterior materials used during the repair work were sandwich panels filled with polyethylene and plastic, which were expanded on the aluminum metal surface. It is a product called Celotex RS 5000, a low-resolution but inexpensive repair material, and is currently an external material that cannot be used in high-rise buildings. Similar domestic fire cases began to focus social attention on the safety of high-rise buildings through the Busan Residential Complex Fire (2010), Uijeongbu Urban Living Housing Fire (2015), and Ulsan Residential Complex Fire (2020), and residents' safety concerns are increasing. In Korea, the occurrence and risk of similar fires are high, so setting up fire prevention measures through fire case investigation is considered the most basic measure in securing human safety. Therefore, the purpose of this study is to examine the status of fire damage caused by domestic and foreign eruptions, domestic and international research status and related regulations on external materials and windows starting from the Grenfell Tower fire in England.

• Transactions of Materials Processing
• /
• v.32 no.4
• /
• pp.215-220
• /
• 2023

In this study, the correction process of stress-strain curves obtained from hot compression test is introduced since the barreling induced by friction and adiabatic heat generation induced by plastic work occur under high strain rate. A shear friction factor was quantitatively estimated by measuring the dimension of barreling and temperature rise due to adiabatic heat generation was directly measured during compression test. Thereafter, the stress-strain curves were re-evaluated by introducing several equations to correct the effects of the friction and temperature rise. It was found that adiabatic factor at strain rate of 10/s is in the range of about 0.5 to 0.75 for Nimonic 80A and decreases as the assigned temperature increases.

• Korean Journal of Environmental Agriculture
• /
• v.5 no.2
• /
• pp.141-148
• /
• 1986

The blue-light effect on the grown as well as on the physiological activity of some major horticultural plants in Korea has been investigated. The light quality used for the work was obtained from sunlight filtered by an orangecolored polyethylene film which removed about 70% of visible light in the spectral region of $350㎚{\sim}500㎚$. The film was developed in this laboratory especially for the work and named BCR film meaning blue color-removing film. The light environment in the plastic house which was built with BCR film provided plants with the blue color-deficient sunlight. Thus, the photobiological effect of blue light could be examined conversely by comparing with the effect of white sunlight in a conventional plastic house built with colorless polyethylene film. In a sense of applicability to horticulture, two remarkable effects of the blue color-deficient sunlight on plant physiology were observed: First, it enhanced to a great extent the growth activity of plants-pepper, cucumber, zucchini, tomato, and leaf lettuce at the vegetative stage as well as at the reproductive stage, as demonstrated by their yield which were in average $40{\sim}50%$ increased compared with the control (under white sunlight). Second, it improved significantly the cold tolerance of plants, as exhibited with their resistance to chilling during treatment in a cold chamber maintained at a temperature which caused chilling injury to the plants of control. The visualized effects were reflected on the physiological activity of cells on organelle level. Chloroplast isolated from the plant leaves grown under BCR film showed considerably stronger photosynthetic activity, as judged by the increased electron transport rate of illuminated chloroplast, than that from leaves grown under white PE film. Mitochondria from leaves grown under BCR film maintained normal respiration activity until temperature decreased to a few degree($^{\circ}C$) lower than the temperature which caused respiratory inhibition to mitochondria obtained from leaves of the control.

• Journal of the Korean Geosynthetics Society
• /
• v.21 no.2
• /
• pp.57-65
• /
• 2022

This study simulated the shock wave propagation through the tamping material between explosives and hole wall at blasting works and verified the effect of tamping materials. The Arbitrary Lagrangian-Eulerian(ALE) method was selected to model the mixture of solid (Lagrangian) and fluid (Eulerian). The time series analysis was carried out during blasting process time. Explosives and tamping materials (air or water) were modeled with finite element mesh and the hole wall was assumed as a rigid body that can determine the propagation velocity and shock force hitting the hole wall from starting point (explosives). The numerical simulation results show that the propagation velocity and shock force in case of water were larger than those in case of air. In addition, the real site at blasting work was modeled and simulated. The rock was treated as elasto-plastic material. The results demonstrate that the instantaneous shock force was larger and the demolished block size was smaller in water than in air. On the contrary, the impact in the back side of explosives hole was smaller in water, because considerable amount of shock energy was used to demolish the rock, but the propagation of compression through solid becomes smaller due to the damping effect by rock demolition. Therefore, It can be proven that the water as the tamping media was more profitable than air.

• Cartoon and Animation Studies
• /
• s.35
• /
• pp.329-346
• /
• 2014

Art is the product from the combination of politics, economy, and social and cultural aspects. Recent development of digital media has affected on the expansion of visual expression in art. Digital media allow artists to use sound and physical interaction as well as image as an plastic element for making a work of art. Also, digital media help artists create an interactive, synaesthetic and visual perceptive environment by combining viewers' physical interaction with the reconstruction of image, sound, light, and among other plastic elements. This research was focused on the analysis of the relationship between images in art work and the viewer and data visualization using sound from the perspective of visual perception. This research also aimed to develop an interactive art by visualizing physical data with sound generating from outer stimulus or the viewer. Physical data generating from outer sound can be analyzed in various aspects. For example, Sound data can be analyzed and sampled within pitch, volume, frequency, and etc. This researcher implemented a new form of media art through the visual experiment of LED light triggered by sound frequency generating from viewers' voice or outer physical stimulus. Also, this researcher explored the possibility of various visual image expression generating from the viewer's reaction to illusionary characteristics of light(LED), which can be transformed within external physical data in real time. As the result, this researcher used a motif from Piet Mondrian's Broadway Boogie Woogie in order to implement a visual perceptive interactive work reacting with sound. Mondrian tried to approach at the essence of visual object by eliminating unnecessary representation elements and simplifying them in painting and making them into abstraction consisting of color, vertical and horizontal lines. This researcher utilized Modrian's simplified visual composition as a representation metaphor in oder to transform external sound stimulus into the element of light(LED), and implemented an environment inducing viewers' participation, which is a dynamic composition maximizing a synaesthetic expression, differing from Modrian's static composition.

• Journal of Science of Art and Design
• /
• v.3
• /
• pp.145-177
• /
• 2001

The artist's interest has been captivated by ecological phenomena in Nature. Her keen captivation has then been focused into plastic art depicting the image of primitive life. The wide sweep of her work encompasses the totality of nature which consists of the human's subconscious power and imagination which she then portrays by organic images. These organic images are in contrast to scientific, mathematical and logical inference and consciousness. This research examines the character of the organic images in modern art by her analysis of some representative works by others. The image is an essential concept in the art which appeared in very different ways and in different perspectives. The image in the artwork appears to be the realistic expression until the early part of the 20th Century. Well into the 20th Century, it began being expressed in various ways such as combined images by imagination which is combined or rejected in the story of artwork. It also began being expressed by transferred images by changed original conditions. It is the main purpose of this research is to study of various expressions of organic images in the artwork of the Post-Modernism era. The character and meaning of organic image painting helps people to approach the human instinct more easily to find out the natural essence. It is also an objective of the organic image to tenderise our human sensibilities, thus helping us to regain vitality and recover our poor humanity in the barren wilderness of modern society. 'Life communion with nature' is a meeting point and common ground for Oriental Philosophy and organic image painting. Through this research, organic image painting is characterised in the four following ways : 1st) Organic image painting seeks regularity and perfection of outer shapes, in contrast to disordered and deformed nature, resulting in organic and biotic formalistic mode of plastic art. 2nd) Organic image painting seeks the formative. 3rd) Organic image painting pursues the priceless dignity of life by researching the formatted arrangement and figure, which contains primitive power of life. 4th) Organic image painting makes crystal clear the power of human and nature, which is a historic and biological phenomenon. This, in turn, exposes the humanistic view of the world from modern society best characterised in lost self-understanding, isolation and materialism. The representative organic image painting artists are Elizabeth Murray, Kusama Yayoi, and Niki do Saint Phalle. Elizabeth Murray used shaped canvas and a round construction of relief works. Kusama Yayoi used Automatistic expressionism originating from the realms of unconsciousness and which is represented by the mass and shape of a water drop. Niki do Saint Phalle shows the transcendence of universal life and anti-life to respect the dignity of life and the eco-friendliness relationship of human and nature in the post-modernism in art history. This is accomplished by surrealistic, symbolic, fantastic and humoristic expression. These three artists' works express the spirit of the organic image in contemporary art. It contains the stream of nature and life to seek not only the state of materialism in the reality, but also the harmonized world of nature and human which has almost lost the important meaning in modern times. Finally, this organic image is the plastic language of the majestic life. It is the romantic idea that the intimacy of nature and the universe and Surrealism, which emphasizes the unconsciousness , is the source of truth and spirit. Also it is influenced by primitive art and abstract art. According to this research, the subject 'Research About Organic Images' is not only an important element in the plastic arts from primitive society to the present, but is also fundamental to an true understanding of Post-Modernism.