• Journal of the Korean Vacuum Society
• /
• v.16 no.2
• /
• pp.128-133
• /
• 2007

In this study, we observed the shapes of CNTs formed with the thinckness of catalyst. Catalyst layer was grown by magnetron sputtering method and the thickness of Ni catalyst is the range from 20 to 80 nm. Also, the synthesis of CNT with Ni catalyst thickness was grown by hot-filament PECVD method. And, we investigated the composition of CNTs by using EDS measurement, also observed the shapes of CNTs by using HRTEM and FESEM measurements. In the result, through the TEM analysis, we observed the empty inside of CNTs and the multiwall CNTs, also confirmed the tip of CNT containing Ni. The composition of CNTs are consisted of an element of C, Ti, and Ni. As you shown the growth shapes of CNTs, the pretreatment of the catalyst before te growth of CNTs changed the particle size of the catalysts and grown the CNTs of the different shapes. Consequently, the best vertically alined and well-arranged CNTs exhibited from the substrate deposited at the catalyst thickness of 40 nm.

• Journal of Environmental Health Sciences
• /
• v.42 no.3
• /
• pp.196-204
• /
• 2016

Objectives: Aluminum is well known as a potent neurotoxicant. There are many reports that aluminum can be toxic to humans and to animals. However, there are only few studies on the assessment of aluminum exposure among humans in Korea. Therefore, the aim of this study was to evaluate current aluminum concentrations among the adult population in regions of Korea. Methods: We selected 439 adults aged 20-89 years from the Busan-Ulsan-Gyeongnam region and certain other sites. Blood aluminum concentrations were analyzed using inductively-coupled plasma mass spectrometry (ICP/MS). The geometric means (GM) and 95% confidence intervals (CI) of aluminum concentrations were calculated, and we also confirmed the proportion of excess of the aluminum reference value. Results: Total GM (95% CI) of aluminum levels was 14.26 (13.43-15.14) ppb. Levels among males (15.58 [14.09-17.22] ppb) were higher compared to among females (13.51 [12.54-14.55] ppb), and levels increased with subject age from 40 years and over. Three point one nine percent of the subjects exceed the reference value of 50 ppb. Lastly, aluminum concentration has a log-normal distribution with lnN (x; 2.89, 0.642), x>0. Conclusion: In the present study, we evaluated the distribution of blood aluminum concentrations among the normal population in Korea, and we found some adults exceeding the reference levels. However, in order to compare the results with other studies, an extended study including measurement of serum aluminum level is required. In addition, further research on various population groups, including occupational exposure of workers, is required.

• Analytical Science and Technology
• /
• v.16 no.2
• /
• pp.117-124
• /
• 2003

Oxygen to metal ratio has been measured by wet and dry chemical analysis to study the properties of sintered $UO_2$ pellets and $U_3O_8$ in the lithium reduction process of spent pressurized water reactor fuels. Uranium dioxide pellets simulated for the spent PWR fuels with burnup values of 20,000~60,000 MWd/MtU were prepared by mixing $UO_2$ powder and oxides of fission product elements, pelleting the powder mixture and sintering it at $1,700^{\circ}C$ under a hydrogen atmosphere. For wet chemical analysis, the simulated spent fuels were dissolved with mixed acid (10 M HCl : 8 M $HNO_3$, 2.5 : 1, v/v) using acid digestion bomb technique. The total amount of uranium and fission products added in the simulated spent fuels were measured using inductively coupled plasma atomic emission spectrometry. Weight change of the simulated fuel during its oxydation was measured by thermogravimetry and then the O/M ratio result was compared to that obtained by wet chemical analysis. Influence of $Mo_{0.4}-Ru_{0.4}-Rh_{0.1}-Pd_{0.1}$, quaternary alloy, on the determination of O/M ratio was investigated.

• Journal of Korean Society of Environmental Engineers
• /
• v.28 no.6
• /
• pp.620-625
• /
• 2006

In this investigation, an ICP-DRC/MS method to measure arsenic with ultra-trace concentration without any interference by the compounds such as $^{40}Ar^{35}Cl^+\;and\;^{40}Ca^{35}Cl^+$, which disturb the precise measurement of arsonic was described. Thus, the oxgen was introduced into the dynamic reaction cell as reaction gas and reacted with arsenic ion created in plasma gas, $AsO^+$ was formed and detected with m/z of 91 by ICP-MS. It resulted in better detection limit than the old method with m/z of 75($As^+$). The optimum condition for oxygen supply as the reaction gas was 0.5 mL/min. The analytical features of the method are as follows: detection limit of $0.02{\mu}g/L$, precision(RSD) of 3.4%, and recovery of 96%. Arsenic in the water samples from the tributary streams to the Han River and the main stream of Paldang were analyzed with this method to identify the characteristics in its distribution. The concentration of As ranged from 0.53 to $1.26{\mu}g/L$. We could measure As with very low concentration, less than $1.0{\mu}g/L$, with excellent reproducibility. The method developed is expected to be applied to analyze As of the samples from sea water, food, and domestic and industrial waste water which have high concentration of Cl and/or Ca.

• Asian-Australasian Journal of Animal Sciences
• /
• v.31 no.2
• /
• pp.208-217
• /
• 2018

Objective: Examine the effects of supplementing bahiagrass hay (BG) with potentially anthelmintic quantities of hays of perennial peanut (PEA) or sericea lespedeza (LES) or seeds of velvet bean (Mucuna pruriens L.; MUC) or papaya (PAP) on the intake and nutritive value (Experiment 1), and the performance and parasite burden (Experiment 2) of goats. Methods: In Experiment 1, 38 male goats ($27.4{\pm}5.7kg$ body weight) were randomly assigned to each of 5 treatments: i) BG alone and BG plus; ii) PEA; iii) LES; iv) MUC; and v) PAP. Goats were fed for ad libitum consumption and adapted to the diets for 14 d followed by 7 d of measurement. The PEA, LES, MUC (50%, 50%, and 10% of the diet dry matter [DM], respectively), and PAP (forced-fed at 10 g/d) were fed at rates that would elicit anthelmintic effects. In Experiment 2, goats remained in the same treatments but were allocated to 15 pens (3 pens per treatment) from d 22 to 63. All goats were infected with parasites by grazing an infected bahiagrass pasture from 0800 to 1500 h daily and then returned to the pens. Results: Dry matter intake tended to be greater in goats fed PEA and LES than those fed BG (757 and 745 vs 612 g/d, respectively). Digestibility of DM (59.5% vs 54.9%) and organic matter (60.8% vs 56.0%) were greater in goats fed MUC vs BG, respectively. In Experiment 2, feeding PAP, LES, and PEA to goats reduced nematode fecal egg counts by 72%, 52%, and 32%, reduced abomasal adult worm counts by 78%, 52%, and 42%, and decreased plasma haptoglobin concentrations by 42%, 40%, and 45% relative to feeding BG alone, respectively. Conclusion: Supplementation with PEA, LES, and PAP decreased the parasite burden of goats but did not increase their performance. PAP was the most effective anthelmintic supplement.

• The Korean Journal of Physiology
• /
• v.23 no.1
• /
• pp.43-49
• /
• 1989

Effects of atrial natriuretic peptide (ANP) on the development of hypertension in 2-kidney, 1-clip (2-K, 1-C) rats were examined. In one group of rats, ANP infusion (500 ng/hr, iv) started immediately after clipping the renal artery. Another group of rats with one kidney-clipped was without ANP infusion and served as a control. Blood pressure was measured on days 4, 7, and 10 following clipping the renal artery. Upon the last blood pressure measurement finished, blood sample was collected by decapitation to measure plasma renin activity (PRA), and both kidneys were taken to weigh and to measure renin content. The ANP-infused group showed an attenuation of increases in blood pressure compared to the non-infused control group. PRA was lower in the ANP-infused group than in the non-infused group. Cortical renal renin content (RRC) of the clipped kidneys was not different between ANP-infused and non-infused groups. The clipped kidneys showed a higher RRC and weighed less than the non-clipped contralateral kidneys within each group. In contrast, sham-clipped rats did not show significant changes in any of the parameters examined regardless of whether ANP was infused or not. These results demonstrate that chronic ANP infusion does not prevent but does attenuate the development of hypertension in 2-K, 1-C rats. It is suggested that ANP plays a role in the long-term regulation of blood pressure, at least in part, by antagonizing the renin-angiotensin-system.

• Journal of Veterinary Clinics
• /
• v.25 no.4
• /
• pp.257-262
• /
• 2008

Renal ischemia-reperfusion injury is great clinical important because viability of the transplanted organ depends on the tolerance of the graft to ischemia-reperfusion injury, an inevitable processing during surgery. The purpose of this study was to investigate the effects of irrigation-aspiration in ischemia-reperfusion injury model induced by cross-clamping of renal vessels. Blood samples were collected from these dogs for measurement of kidney function and antioxidant enzyme activity, and RI at the intrarenal artery was measured at different time intervals. And the kidneys were taken for histopathologic evaluation at day 14. Kidney function (Cr and BUN) showed a significant increasing in untreated group compared to treated group. Resistive index of intrarenal artery was no significant difference among the groups. Activity of antioxidant enzymes in plasma was significant decrease in untreated group compare to control group while in treated group was no significant difference compared to control group. In histopathologic finding, treated group was showed less damage than that of untreated group. This result suggests that the processing of irrigation-aspiration is useful to reducing ischemia-reperfusion injury.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.23 no.1
• /
• pp.51-57
• /
• 2013

We have applied mechanical alloying (MA) to produce Heusler $Fe_2VAl$ thermoelectric alloy using a mixture of elemental $Fe_{50}V_{25}Al_{25}$ powders. An optimal milling and heat treatment conditions to obtain the single phase of Fe2VAl compound with fine microstructure were investigated by X-ray diffraction and differential scanning calorimetry (DSC) measurement. The $Fe_{50}V_{25}Al_{25}$ MA sample ball-milled for 60 hours exhibits a bcc ${\alpha}$-(Fe,V,Al) solid solution. Single phase of Heusler $Fe_2VAl$ compound can be obtained by MA of $Fe_{50}V_{25}Al_{25}$ mixture for 60 hours and subsequently heated up to $700^{\circ}C$. Sintering of the MA powders was performed in a spark plasma sintering (SPS) machine using graphite dies at $900{\sim}1000^{\circ}C$ under 60 MPa. The Vickers hardness of bulk sample sintered at $1000^{\circ}C$ was high value of Hv 870. All compact bodies have a high relative density above 90 % with metallic glare on the surface.

• Journal of the Microelectronics and Packaging Society
• /
• v.27 no.3
• /
• pp.77-81
• /
• 2020

Commercialization of flexible OLED displays, such as rollable and foldable displays, has attracted tremendous interest in next-generation display markets. However, during bending deformation, cracking and delamination of thin films in the flexible display panels are the critical bottleneck for the commercialization. Therefore, measuring mechanical properties of the fragile thin films in the flexible display panels is essential to prevent mechanical failures of the devices. In this study, tensile properties of the metal and ceramic nano-thin films were quantitatively measured by using a direct tensile testing method on the water surface. Elastic modulus, tensile strength, and elongation of the sputtered Mo, MoTi thin films, and PECVD deposited SiN_x thin films were successfully measured. As a result, the tensile properties were varied depending on the deposition conditions and the film thickness. The measured tensile property values can be applied to stress analysis modeling for mechanically robust flexible displays.

• Journal of the Korean Ceramic Society
• /
• v.52 no.6
• /
• pp.410-416
• /
• 2015

Recently, a new $Y_2O_3$ coating deposited using the EB-PVD method has been developed for erosion resistant applications in fluorocarbon plasma environments. In this study, surface crack formation in the $Y_2O_3$ coating has been analyzed in terms of residual stress and elastic modulus. The coating, deposited on silicon substrate at temperatures higher than $600^{\circ}C$, showed itself to be sound, without surface cracks. When the residual stress of the coating was measured using the Stoney formula, it was found to be considerably lower than the value calculated using the elastic modulus and thermal expansion coefficient of bulk $Y_2O_3$. In addition, amorphous $SiO_2$ and crystalline $Al_2O_3$ coatings were similarly prepared and their residual stresses were compared to the calculated values. From nano-indentation measurement, the elastic modulus of the $Y_2O_3$ coating in the direction parallel to the coating surface was found to be lower than that in the normal direction. The lower modulus in the parallel direction was confirmed independently using the load-deflection curves of a micro-cantilever made of $Y_2O_3$ coating and from the average residual stress-temperature curve of the coated sample. The elastic modulus in these experiments was around 33 ~ 35 GPa, which is much lower than that of a sintered bulk sample. Thus, this low elastic modulus, which may come from the columnar feather-like structure of the coating, contributed to decreasing the average residual tensile stress. Finally, in terms of toughness and thermal cycling stability, the implications of the lowered elastic modulus are discussed.