• 한국정보디스플레이학회:학술대회논문집
• /
• 2006.08a
• /
• pp.126-129
• /
• 2006

AC-plasma display panels were examined before and after the aging process to analyze the effect of the aging process. The gas analysis was done to detect the impurity gases out of the MgO film and phosphor by a residual gas analyzer. There were no differences found in the components. The MgO film was analyzed to find out the effect of an ion bombardment due to discharge. The surface roughness of the MgO film was different from regional groups due to the different degree of ion bombardments. XPS analysis showed that the 8 hour aging process was not sufficient to remove $Mg(OH)_2$ and $MgCO_3$ existed on the MgO surface. Photoluminescence measurement showed the small deterioration of blue and green phosphor.

• Toxicological Research
• /
• v.18 no.3
• /
• pp.233-240
• /
• 2002

In view of the effect of $\beta_2$-Adrenergic receptors ($\beta_2$-AR) as a risk factor for essential hypertension, we investigated the Fnu4HI and MnlI RFLPs of $\beta_2$ -AR gene in the Korean patients with essential hypertension and normal controls. There were no significant differences in the allele and genotype of these polymorphisms between normotensive and essential hypertensive subjects. In ethnic comparison, the allele frequencies of these three sites contained Nde I RFLP reported the association with essential hypertension in Korean population previously, were very different from those of other ethnic populations studied. The significant linkage disequilibrium was detected only in hypertensive group between Nde I and Fnu4HI sites. The Fnu4HI RFLP was also significantly associated with plasma triglyceride (TG) level. Therefore, our results suggest that the significant association between Fnu4HI variation in the human $\beta_2$-AR gene and plasma TG level may reflect the potential role of human $\beta_2$-AR gene as one of the genetic components for cardiovascular risk.

• Korean Journal of Air-Conditioning and Refrigeration Engineering
• /
• v.27 no.3
• /
• pp.158-168
• /
• 2015

To create an ultra-high vacuum state at the KSTAR, the temperature of plasma facing component and vacuum vessel should be maintained at $300^{\circ}C$ and $110^{\circ}C$ respectively at a baking phase. The purpose of this research is obtaining the target baking temperatures. Experiments were performed to investigate the temperature characteristics of PFC and VV at the baking phase. Thermal network analysis was used to find heat transfer rates among PFC, VV and other components, and this analysis was verified by using the experimental data. The required heating energy of the PFC and the heating and cooling energy of the VV for the target baking temperatures were found to be 346 kW, 28 kW, and 136 kW, respectively.

• Toxicological Research
• /
• v.16 no.3
• /
• pp.221-227
• /
• 2000

A 6-sulfooxymethylbenzo[a]pyrene (SMBP), the ultimate metabolite of methyl-substituted benzo[a]pyrene (BP), has been found to be carcinogenic in mice. These properties may be attributable to its strong reactivity with cellular macromolecules such as DNA. However, serum and its major constituent albumin attenuated significantly the cytotoxicity and mutagenicity of 5MBP in bacterial and mammalian cell systems. This inhibitory activity of serum against 5MBP-induced cytotoxicity and mutagenicity in Chinese hamster V79 cells appears to be caused by the reduced macromolecular adducts such as DNA and proteins, but serum failed to reduce 5MBP binding to naked calf thymus DNA. A number of proteins in the serum could act as nucleophiles that are able to intercept reactive chemicals through covalent binding. Albumin present in the plasma seems to be one of major components responsible for direct binding with 5MBp, thereby reducing its reactivity to genetic materials. We here determined which fraction is preferential for 5MBP binding through fractionation of 5MBP-treated serum with ammonium sulfate. The albumin-containing fraction had slightly more affinity for 5MBP than the immunoglobulin-containing fraction. Our results indicate that the covalent modification of plasma proteins may reduce 5MBP-induced damage.

• Journal of Welding and Joining
• /
• v.22 no.2
• /
• pp.59-68
• /
• 2004

Plasma transferred arc welding (PTAW) has been taken into consideration for repairing Ni-based superalloy components used gas turbine blades. Various cracks has been generally reported to be found in the base metal heat affected zone(HAZ) along grain boundary. Thus, hot cracking susceptibility of Ni-based superalloys was evaluated according to heat treatments. Hot ductility test was conducted on specimens with solution treated at 112$0^{\circ}C$ for 2 hours and aging treated at 845$^{\circ}C$ for 24hours after solution treatment. The results of the hot ductility test appeared that solution treated specimens were the highest ductility recovery rate among three conditions. The loss of ductility at high temperature in Ni-based superalloy was mainly controlled by the degree of pain boundary wetting due to constitutional liquation of MC carbide precipitates. Meanwhile, the highest ductility recovery rate in solution-treated alloys seems to be lack of M23C6, which can be dissolved during heating and then result in the local enrichment of Cr in the vicinity of the grain boundary.

• Journal of the Korean Vacuum Society
• /
• v.7 no.4
• /
• pp.285-292
• /
• 1998

The vacuum vessel of the KSTAR tokamak has a so large poloidal cross- section that workers can enter into the inside the vessel. To produce a clean plasma with low impurity concentrations it is planned that the whole vessel including plasma facing components will be baked out at $350^{\circ}C$ and the base pressure of the vessel will be kept in the range of ultra high vacuum. Large thermal stresses are expected during bake-outs to a three-dimensionally complex structure of the vessel, consequent ununiformity of the temperature distribution and support systems to resist forces acting on the vessel. In this report variations of the thermal stress according to temperature gradients on the vessel and constraint conditions of supporting structures are studied and some possible counterplans are discussed.

• Transactions on Electrical and Electronic Materials
• /
• v.15 no.3
• /
• pp.164-169
• /
• 2014

We investigated the etching characteristics of $HfAlO_3$ thin films in $O_2/Cl_2/Ar$ and $O_2/BCl_3/Ar$ gas, using a high-density plasma (HDP) system. The etch rates of the $HfAlO_3$ thin film obtained were 30.1 nm/min and 36 nm/min in the $O_2/Cl_2/Ar$ (3:4:16 sccm) and $O_2/BCl_3/Ar$ (3:4:16 sccm) gas mixtures, respectively. At the same time, the etch rate was measured as a function of the etching parameter, namely as the process pressure. The chemical states on the surface of the etched $HfAlO_3$ thin films were investigated by X-ray photoelectron spectroscopy. Auger electron spectroscopy was used for elemental analysis on the surface of the etched $HfAlO_3$ thin films. These surface analyses confirm that the surface of the etched $HfAlO_3$ thin film is formed with nonvolatile by-product. Also, Cl-O can protect the sidewall due to additional $O_2$.

• The Korean Journal of Mycology
• /
• v.13 no.1
• /
• pp.53-55
• /
• 1985

To determine contents of inorganic elements of Ganoderma lucidum (Fr.) Karsten, the horn-shaped carpophores and the pileus of Ganoderma lucidum were incinerated and analyzed by inductively coupled plasma atomic emission spectrophotometry. The ash contents of the pileus and the horn-shaped carpophore were 1.48 and 1.40 % respectively. The pileus contained calcium, magnesium, sodium, manganese, iron, zinc and germanium in that order. The horn-shaped carpophore contained magnesium, calcium, zinc, manganese, iron, copper and germanium in that order.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.14 no.3
• /
• pp.185-189
• /
• 2001

In this paper, since the research on the etching of SrBi$_2$Ta$_2$$O_{9}$(SBT) thin film was few (specially Cl$_2$-base) we had studied the surface reaction of SBT thin films. We have used the OES(optical emission spectroscopy) in high density plasma etching as a function of RF power, dc bias voltage, and Cl$_2$/(Cl$_2$+Ar) gas mixing ratio. It had been found that the etch rate of SBT thin films appeared to be more affected by the physical sputtering between Ar ions and surface of the SBT compared to the chemical reaction. The change of Cl radical density that was measured by the OES as a function of gas combination showed the change of the etch rate of SBT thin films. Therefore, the chemical reactions between Cl radical in plasma and components of the SBT enhanced to increase the etch rates SBT thin films. These results were confirmed by XPS(x-ray photoelectron spectroscopy) analysis.s.

• Analytical Science and Technology
• /
• v.33 no.2
• /
• pp.86-97
• /
• 2020

Reconstruction and separation of explosive-contaminated overlapping fingerprints constitutes an analytical challenge of high significance in forensic sciences. Laser-induced breakdown spectroscopy (LIBS) allows real-time chemical mapping by detecting the light emissions from laser-induced plasma and can offer powerful means of fingerprint classification based on the chemical components of the sample. During recent years LIBS has been studied one of the spectroscopic techniques with larger capability for forensic sciences. However, despite of the great sensitivity, LIBS suffers from a limited detection due to difficulties in reconstruction of overlapping fingerprints. Here, the authors propose a simple, yet effective, method of using chemical mapping to separate and reconstruct the explosive-contaminated, overlapping fingerprints. A Q-switched Nd:YAG laser system (1064 nm), which allows the laser beam diameter and the area of the ablated crater to be controlled, was used to analyze the chemical compositions of eight samples of explosive-contaminated fingerprints (featuring two sample explosive and four individuals) via the LIBS. Then, the chemical validations were further performed by applying the Raman spectroscopy. The results were subjected to principal component and partial least-squares multivariate analyses, and showed the classification of contaminated fingerprints at higher than 91% accuracy. Robustness and sensitivity tests indicate that the novel method used here is effective for separating and reconstructing the overlapping fingerprints with explosive trace.