• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.17 no.9
• /
• pp.939-950
• /
• 1992

The performance of common spreading code scheme employing multiple-capture receiver is compared to that of transmitter-oriented (T/O) code division multiple access (CDMA) scheme in view of the possibility of collision-free transmissions and the effect of secondary multiple-access interference. For performance comparisons, secondary multiple-access interference is characterized for the common code scheme and the T/O CDMA scheme that assures perfectly collision-free transmissions. Throughput performance is then evaluated for these two schemes with direct-sequence spread-spectrum/differential-phase-shift-keying (DS-SS/DPSK) data modulation and forward-error-control coding (BCH codes) in the presence of an additive white Gaussian noise (AWGN). It is shown that when the number of radios is relatively large, the maximum normalized throughput is greater for the common code scheme than for the T/O CDMA scheme at a moderate signal-to-noise ration(SNR).

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.4 no.1
• /
• pp.179-189
• /
• 2000

Recently, due to the increasing interests in deep sea development, all possible efforts to the development of underwater unmanned working vehicles such as AUV(Autonomous Underwater Vehicle) or underwater robot are exerted. This paper proposes a new efficient acoustic-based underwater image data communication system, which ensures a certain level of maximum throughput regardless of the propagation delay of ultrasonic and allowsfast data transmission through the multiple ultrasonic communication channel. Proposed system consists of an acoustic transducer which operates at 136kHz center frequency and it's 10kHz bandwidth, pre-amplifier, $\pi/4 QPSK$(Quadrature Phase Shift Keying) modulation/demodu-lation method, image compressing method using JPEG technique and modified Stop & Wait protocol. The experimental result of the system make it possible to transfer the underwater image as a high throughput at the basin test. The results of test are also verified which allows to desirable transmission performance compared with the existing developed system and the possibility to put the practical use of survey and investigation in the water.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.53 no.3
• /
• pp.3-10
• /
• 2016

To establish a network environment where multiple wireless personal area networks(WPAN) are simultaneously operating in the same area, we need to consider the effects of inter-device interference. The extent of interference effect from neighboring frequency channel interferer may be different depending on the modulation types that are used for constructing the wireless network. If a modulation scheme with high spectral side lobes is used, the spatial separation between devices plays a major role in determining the amount of interference from neighboring frequency channel interferer. In this paper, we investigate the effect of inter-device interference in the overlapped raised cosine offset quadrature-quadrature phase shift keying (ORC-$OQ^2PSK$) modulation based WPAN. By comparing the results with those of GFSK modulation based WPAN, we verify the feasibility of ORC-$OQ^2PSK$ based WPAN.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.15 no.6
• /
• pp.995-1002
• /
• 2020

This paper investigates the achievable data rate for non-orthogonal multiple access(NOMA) with correlated information sources(CIS), under the binary phase shift keying(BPSK) modulation, in contrast to most of the existing NOMA designs using continuous Gaussian input modulations. First, the closed-form expression for the achievable data rate of NOMA with CIS and BPSK is derived, for both users. Then it is shown by numerical results that for the stronger channel user, the achievable data rate of CIS reduces, compared with that of independent information sources( IIS). We also demonstrate that for the weaker channel user, the achievable data rate of CIS increases, compared with that of IIS. In addition, the intensive analyses of the probability density function(PDF) of the observation and the inter-user interferennce(IUI) are provided to verify our theoretical results.

• Journal of Advanced Navigation Technology
• /
• v.26 no.5
• /
• pp.319-324
• /
• 2022

If radio interference occurs or there is no navigation device, radio navigation of high-speed moving object becomes impossible. Nevertheless, if there are multiple ground stations and precise range measurement between the high-speed moving object and the ground station can be secured, it is possible to estimate the position of moving object. This paper proposes a position estimation method using high-precision TDOA measurement generated using TLM signal. In the proposed method, a common error of moving object is removed using the TDOA measurements. The measurements is generated based on TLM signal including SOQPSK PN symbol capable of precise timing synchronization. Therefore, since precise timing synchronization of the system has been performed, the timing error between ground stations has a very small value. This improved the position estimation performance by increasing the accuracy of the measured values. The proposed method is verified through software-based simulation, and the performance of estimated position satisfies the target performance.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.9 no.1
• /
• pp.93-99
• /
• 2008

In this paper, we propose new modulation schemes using the conventional CACB modulation with constant amplitude property. Also the proposed modulation schemes supports high transmission data rate by increasing the spectral efficiency. In order to obtain the high spectral efficiency, the $Q^2$PSK and CA-$Q^2$PSK are used. We explain the simplest combining modulation scheme of CACB and $Q^2$PSK (i.e., CACB-$Q^2$PSK). However, this modulation scheme cannot support the constant amplitude property. Hence the first CACB-CA-$Q^2$PSK (or CACB-CA-$Q^2$PSK I) modulation scheme is proposed for the constant amplitude property. In the modulation scheme, the redundant constant amplitude encoding (spectral efficiency decrease) is required. Therefore, the second CACB-CA-$Q^2$PSK (or CACB-CA-$Q^2$PSK II) modulation scheme is proposed retaining the constant amplitude and the spectral efficiency. Computer simulations show that the proposed CACB-CA-$Q^2$PSK II is the efficient modulation scheme.

• Progress in Medical Physics
• /
• v.19 no.1
• /
• pp.42-48
• /
• 2008

Bio-implantable devices such as heart pacers, gastric pacers and drug-delivery systems require power for carrying out their intended functions. These devices are usually powered through a battery implanted with the system or are wired to an external power source. This paper describes an inductive power transmission link, which was developed for an implantable stimulator for direct stimulation of denervated muscles. The carrier frequency is around 1MHz, the transmitter coil has a diameter of 46mm, and the implant coil is 46mm. Data transmission to the implant with amplitude shift keying (ASK) and back to the transmitter with passive telemetry can be added without major design changes. We chose the range of coil spacing (2 to 30mm) to care for lateral misalignment, as it occurs in practical use. If the transmitter coil has a well defined and reliable position in respect to the implant, a smaller working range might be sufficient. Under these conditions the link can be operated in fixed frequency mode, and reaches even higher efficiencies of up to 37%. The link transmits a current of 50 mA over a distance range of 2-15 mm with an efficiency of more than 20% in tracking frequency. The efficiency of the link was optimized with different approaches. A class E transmitter was used to minimize losses of the power stage. The geometry and material of the transmitter coil was optimized for maximum coupling. Phase lock techniques were used to achieve frequency tracking, keeping the transmitter optimally tuned at different coupling conditions caused by coil distance variations.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2007.10a
• /
• pp.693-697
• /
• 2007

The SSB modem performs the modulation process which converts the digital voltage level to the audible frequency band signal and the demodulation process which converts reversely the audible frequency signal to the digital voltage level. The modulator and the demodulator are implemented with a single DSP chip. Because of the SSB specific character, the distortion occurs when the frequency is changed. This distortion has no effect on voice communication, but it has an significant effect on data communication. In other words, it is impossible to send data stream with adjacent 2 periods. Therefore, in case of using 2-tone FSK, it is needed to send at least 3 periods to transmit 1 bit. Therefore we implemented the modem using modified phase-delay shift keying to transmit 1 tone signal for high speed transmission. In the 1200[bps] mode, it generates 0, $187{\mu}s$ delay time at 1.3kHz symbol frequency, and in the 2400[bps] mode, 0, $70{\mu}s$, $130{\mu}s$, $200{\mu}s$ delay time at 1.5kHz symbol frequency. Finally, in the maximum 3600[bps] mode, it generates 0, $100{\mu}s$, $160{\mu}s$, $250{\mu}s$ delay time at 2.0kHz symbol frequency. The measured results of the implemented SSB modem shows a good transfer functional characteristic by spectrum analyzer, almost same bandwidth in pass band and 20dB higher SNR comparing the German PACTOR and American CLOVER and in the experimental transmitting test, we verified the transmitted data is received correctly in platform.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.49 no.7
• /
• pp.39-47
• /
• 2012

The combination of the broadband property and the wide area coverage of satellite communications enables high speed transmission. Every user in the region under the satellite beam coverage can tranceiver and one can simultaneously communicate with multiple users. For these reasons, it is one of commendable telecommunication networks for information transfer. Since the satellite communications use open channels, it is likely to cause jamming with unwanted interference signals. In the thesis, APSK (Amplitude Phase Shift Keying) is employed, which is recommended for DVB-S2 due to high-speed transmission and excellent bandwidth efficiency. For obtaining reliable communication under the jamming environments, the communication satellite transponder rests on the polyphase filter bank structure, which enables switching among the subchannels and gain control on each subchannel, resulting in effectively eliminating jamming. Furthermore, the nulling scheme, one of the various anti-jamming approaches, is investigated, in which unwanted jamming signals are eliminated in the frequency domain after passing through the analysis part of the polyphase filter bank. The performance of the nulling scheme is evaluated for tone jamming and partial band jamming in terms of BER and EVM. The simulation results indicate that the nulling scheme improve the BER and EVM performance over the case without any anti-jamming approach.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.11 no.10
• /
• pp.1852-1857
• /
• 2007

The SSB modem performs the modulation process which converts the digital voltage level to the audible frequency band signal and the demodulation process which converts reversely the audible frequency signal to the digital voltage level. The modulator and the demodulator are implemented with a single DSP chip. Because of the SSB specific character, the distortion occurs when the frequency is changed. This distortion has no effect on voice communication but it has an significant effect on data communication. In other words, it is impossible to send data stream with adjacent 2 periods. Therefore, in case of using 2-tone FSK, it is needed to send at least 3 periods to transmit 1 bit. Therefore we implemented the modem using modified phase-delay shift keying to transmit 1 tone signal for high speed transmission. In the 1200[bps] mode, it generates 0, $187{\mu}s$, delay time at 1.3kHz symbol frequency, and in the 2400[bps] mode, 0, $70{\mu}s\;130{\mu}s\;200{\mu}s$, delay time at 1.5kHz symbol frequency. Finally, in the maximum 3600[bps] mode, it generates 0, $100{\mu}s\;160{\mu}s\;250{\mu}s$ 2.0kHz symbol frequency. The measured results of the implemented SSB modem shows a good transfer functional characteristic by spectrum analyzer, almost same bandwidth in pass band and 20dB higher SNR comparing the emu FACTOR and American CLOVER and in the experimental transmitting test, we verified the transmitted data is received correctly in platform.