• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.23 no.5
• /
• pp.1319-1324
• /
• 1998

The phase and frequency commands of a ratating radar system that utilizes frequency scanning to steer the beam in the azimuth direction and phase shifters in the elevation direction are derived in terms of the angles of the groung based coordinate system. The antenna type considered is slotted arrays that are easy to construct at such high microwave frequency as the X band. The frequency that has non-linear characteristics as a functio ofthe elevation angle is plotted and the derived frequency equation is aproximated to be a simple form to reduce the calculation time for real time multi-function radar systems. It is shown that the approximated frequency command is in good agreement with the exact one if the range of azimuth scanning is limited by ${\pm}10^{\circ}$.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2004.07b
• /
• pp.794-797
• /
• 2004

The object of investigation is represented by PbxSrl-xTiO3(PST) thin films, which were fabricated by the alkoxide-based sol-gel method on Pt/Ti/SiO2/Si substrate. We have investigated both structural and dielectric properties of PST thin films aimed to tunable microwave device applications as a function of Pb/Sr ratio. PST thin films showedtypical polycrystalline structure with a dense microstructure without secondary phase formation. Dielectric properties of PST films were found as strongly dependent on Pb/Sr composition ratio. Increasing of Pb content leads to simultaneous increasing of both dielectric constant and dielectric loss characteristics of PST films. The figure of merit (FOM) Parameter (FOM : (%) tunability / tan (%)) reached a maximal value of 27.5 corresponding to Pb/Sr ratio of 40/60. The tunability increased with increasing Pb content. The dielectric constants, dielectric loss and tunability of the PST thin films at Pb/sr ratio of 40/60 measured at 100 kHz were 335, 0.0174 and 47.89 %, respectively.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.23 no.10
• /
• pp.1145-1150
• /
• 2012

In this paper, an improved Schiffman phase shifter is proposed using slot-coupled lines. It consists of the typical coupled lines and a simple rectangular slot which is placed in the ground plane underneath the coupled lines. Phase responses of the slot-coupled Schiffman phase shifter are analyzed in consideration of the phase velocity of two independent transmission modes and the characteristic impedance of slot-coupled line. The $905^{\circ}$ Schiffman phase shifters with high impedance ratio is realized at 2.4 GHz, which cannot be implemented with the conventional coupled lines. The measured results show that the bandwidth is around 74.2 % within the phase errors ${\pm}5^{\circ}$. The measured return loss is found to be better than 15.0 dB and insertion loss is less than 1.5 dB over the operating frequency band.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.25 no.7
• /
• pp.721-727
• /
• 2014

In this paper, an broadband Schiffman phase shifter is proposed using vertically installed coupled lines. It consists of the typical coupled lines and a extra coupled lines which is installed vertically on the original coupled lines plane. Phase responses of Schiffman phase shifter with vetically installed coupled lines are analyzed in consideration of the phase velocity of two independent transmission modes and the characteristic impedances. The $90^{\circ}$ Schiffman phase shifters with high impedance ratio is realized at 2.4 GHz, which cannot be implemented with the conventional coupled lines. The measured results show that the bandwidth is 1.5~3.2 GHz(70.8 %) within the phase errors ${\pm}5^{\circ}$. The measured return loss is found to be better than 12.4 dB and insertion loss is less than 1.2 dB over the operating frequency band.

• Journal of the Institute of Electronics Engineers of Korea SP
• /
• v.47 no.3
• /
• pp.81-86
• /
• 2010

Since CORDIC (COordinate Rotation DIgital Computer) is able to carry out the phase operation, such as vector to phase conversion or rotation of vectors, with adders and shifters, it is well suited for the design of the frequency synchronization unit in OFDM receivers. It is not easy, however, to fully utilize the CORDIC in the OFDM demodulator because of the non-linear characteristics of the direction sequence (DS), which is the representation of the phase in CORDIC. In this paper a new representation method is proposed to linearize the direction sequence approximately. The maximum phase error of the linearized binary direction sequence (LBDS) is also discussed. For the purpose of designing the hardware, the architectures for the binary DS (BDS) to LBDS converter and the LBDS to BDS inverse converter are illustrated. Adopting LBDS, the overall frequency synchronization hardware for OFDM receivers can be implemented fully utilizing CORDIC and general arithmetic operators, such as adders and multipliers, for the phase estimation, loop filtering of the frequency offset, derotation for the frequency offset correction. An example of the design of 22 bit LBDS for the T-DMB demodulator is also presented.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.22 no.4
• /
• pp.470-480
• /
• 2011

Analog ferrite phase shifters based on rectangular waveguides which are used as component of passive phased array system have high power handling capability, but it is heavy and has high cost to fabricate. In this paper, we propose an analog ferrite phase shifter using substrate integrated waveguide(SIW), which has low cost and is easy to fabricate because it uses printed circuit board(PCB) process. The proposed structure is fabricated by using centeral dielectric material removal for inserting a ferrite bar. The measured results show that the proposed structure has not only $5.1^{\circ}$/mm phase variation but also return loss variation under 12.9 dB. Therefore, it is expected that the proposed phase shifter can plays an role to reduce weight and to has low cost on the phased array system.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.6 no.3
• /
• pp.169-174
• /
• 2006

In this work, we demonstrate a novel compact mechanical beam steering transmitter based on a direct vertical integration of a 2-D MEMS-based mechanical beam steering antenna with a VCO on a single silicon platform. By eliminating the long feed lines and waveguide metal blocks, the radiation pattern has been improved vastly, resulting in an almost ideal pattern at every scan angle. The losses incurred by the feed lines and phase shifters are also eliminated, which allows the transmitter to be implemented using only a single VCO. The system complexity has been greatly reduced with a total module size of only 1.5 cm ${\times}$ 1.5 cm ${\times}$ 0.4 cm. This work demonstrates that RF MEMS can be a key enabling technology for high-level integration.

• Journal of the Korea Institute of Military Science and Technology
• /
• v.11 no.4
• /
• pp.92-98
• /
• 2008

A beam steering system of X-band 2-D phased array antenna for radar application is developed. The beam steering system consists of real-time command generator, beam steering unit, control PCB of array module and power supply. It plays a role of beam steering and on-line check of phased array antenna. The performance of beam steering system is verified with pulse timing of current control in phase shifters and measurement of far-field of phased array antenna. The developed beam steering system offers basic technology to develop full-scale beam steering system of multi-function radar.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2003.07b
• /
• pp.719-722
• /
• 2003

Ferroelectric $Pb(Zr_{1-x}Ti_x)O_3$ (PZT) films were deposited on (001) MgO single crystals using sol-gel method. Structural properties and surface morphologies of PZT films were investigated using an X-ray diffractometer and a scanning electron microscopy, respectively. The dielectric properties of PZT films were investigated with the dc bias field using interdigitated capacitors (IDC) which were fabricated on PZT films using a thick metal layer by photolithography and dry etching process. The small signal dielectric properties of PZT films were calculated by a modified conformal mapping method with low and high frequency data, such as capacitance measured by an impedance gain/phase analyzer at 100 kHz and reflection coefficient (S-parameter) measured by a HP 8510C vector network analyzer at 1 -20 GHz. The IDC on PZT films exhibited about 67% of capacitance change with an electric field of 135 kV/cm at 10 GHz. These PZT thin films can be applied to tunable microwave devices such as phase shifters, tunable resonators and tunable filters.

• Korean Journal of Optics and Photonics
• /
• v.16 no.4
• /
• pp.376-383
• /
• 2005

We designed and fabricated integrated-optic tunable polarization controllers based on $LiNbO_3$ with the Ti-indiffused waveguide along the y-axis utilizing the electro-optic effect. The device consists of $TE↔TM$ mode converters and TE/TM phase shifters. We analyzed the operation principles of each device utilizing transfer matrices based on a Jones matrix and simulated shifting of the center wavelength by inducing voltage. We confirmed experimentally that the fabricated devices control the tunability of the center wavelength and the input SOP.