• Journal of Applied Biological Chemistry
• /
• 제55권1호
• /
• pp.61-65
• /
• 2012

Three major curcuminoids in turmeric (Curcuma longa), curcumin, demethoxycurcumin, and bisdemethoxycurcumin, were efficiently extracted by optimizing extraction condition and simultaneously analyzed and identified using reverse phase high-performance liquid chromatography, thin-layer chromatography, and liquid chromatography-mass spectrometry method. The highest yield of extraction amount 0.279 g, 9.30% was obtained by dipping method with extraction time of 7 h.

• 한국세라믹학회지
• /
• 제32권12호
• /
• pp.1417-1423
• /
• 1995

α/β sialon based composites containing silicon nitride whisker and silicon carbide platelet were fabricated by hot pressing. Effect of the reinforcing agents on the α to β phase transformation of the sialon as well as on the mechanical properties was investigated. Silicon nitride whisker and silicon carbide platelet promoted the phse transformation. TEM/EDS analysis revealed that the grain containing the whisker had 'core-rim' structure; core being high purity Si3N4 whisker and rim being β-sialon. Flexural strength of the composite decreased with the reinforcement addition which, on the other hand, improved fracture toughness of it. High temperature strength was measured at 1300℃ to be about 130 MPa lower than that measured at RT for the whisker reinforced composites.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2007년도 추계학술대회 논문집
• /
• pp.246-247
• /
• 2007

(Ba,Sr,Ca)$TiO_3$ powders, which were prepared by sol-gel method using a solution of Ba-acetate, Sr-acetate and Ca-acetate and Ti iso-propoxide, were mixed with organic vehicle and the BSCT thick films were fabricated by the screen-printing techniques on high purity alumina substrates. The structural and dielectric properties were investigated for various $Dy_2O_3$ doping contents. As a result of thermal analysis, the exothermic peak was observed at around $670^{\circ}C$ due to the formation of the polycrystalline perovskite phase. All BSCT thick films, sintered at $1420^{\circ}C$ for 2h, showed the typical XRD patterns of perovskite polycrystalline structure and no pyrochlore phase was observed. The average grain size of the specimens decreased with.

• 대한약학회:학술대회논문집
• /
• 대한약학회 2002년도 Proceedings of the Convention of the Pharmaceutical Society of Korea Vol.2
• /
• pp.341.2-341.2
• /
• 2002

An efficient process for the solution-phase synthesis of biaryl amides has been developed. Girard's reagent T. an inexpensive scanvenger. was found to be very efficient in trapping excess aromatic acid chlorides. resulting in water soluble by-products. which were easily removed from the products by liquid-liquid extraction. The ease of use. and the excellent purity of the amide libraries obtained are important features of this protocol. (omitted)

• 공업화학
• /
• 제5권4호
• /
• pp.597-608
• /
• 1994

$(NH_4)_2SO_4$와 저품위 bauxite의 황산화 반응에 따라 얻어진 ammonium aluminium sulfate로부터 수열균일침전을 통해 무정형 alumina gel수화물 및 결정형 boehmite를 합성하고 이로 부터 고순도 $Al_2O_3$를 제조하는 새로운 공정 개발을 시도하였다. 이 공정은 ammonium aluminium sulfate용액 중의 Fe 성분을 제거하기 위한 용매추출공정과 정제된 ammonium aluminium sulfate용액으로부터 균일침전에 의한 Al 함유 침전물의 생성에 관한 것으로 이루어져 있다. 추출제 Alamine 336에 의한 적절한 용매추출조건은 shaking time 4분, 수상에 대한 유기상의 비 0.25였다. Urea를 이용한 수열균일 침전반응은 Al 함유용액 중의 Al에 대한 urea의 당량비 6.0의 조건에서 반응온도 $100^{\circ}C$ 이하에서는 무정형 alumina gel 수화물, $120^{\circ}C$ 이상 $150^{\circ}C$ 이하에서는 pseudo boehmite 그리고 $150^{\circ}C$ 이상에서는 결정형 boehmite가 합성되었다. 이 합성된 무정형 alumina gel 수화물은 소성시간 2시간, 소성온도 $1000^{\circ}C$ 이상에서 그리고 결정형 boehnite는 소성시간 2시간, 소성온도 $1250^{\circ}C$ 이상에서 ${\alpha}-Al_2O_3$로 전이되며 얻어진 ${\alpha}-Al_2O_3$의 순도는 99.97%의 고순도였다.

• 한국세라믹학회지
• /
• 제43권2호
• /
• pp.98-105
• /
• 2006

YBCO film was synthesized by using a new approach to the TFA-MOD method. In the fabrication process, $Y_2Ba_1Cu_1O_x\;and\;Ba_3Cu_5O_8$ powders were used as precursors (the so called '211 process'), instead of Y-, Ba-, and Cu-based acetates, and dissolved in trifluoroacetic acid followed by calcining and firing heat treatment. Consequently, we successfully fabricated YBCO film and evaluated the phase formation, texture evolution, and critical properties as a function of the calcining and firing temperature and humidity, in order to explore its possible application in coated conductor fabrication. The films were calcined at $430-460^{\circ}C$ and then fired at $750-800^{\circ}C\;in\;a\;0-20\%$ humidified $Ar-O_2$ atmosphere. We observed that $BaF_2$ phase was effectively reduced and that a sharp and strong biaxial texture formed under humidified atmosphere leading to increased critical properties. In addition, we found that the microstructure varied significantly with the firing temperature: the grain grew further, the film became denser, and the degree of texture and phase purity varied as the firing temperature increased. For the film fired at $775^{\circ}C$ after calcining at $460^{\circ}C$, the critical current was obtained to be 39 A/cm-width (corresponding critical current density is $2.0\;MA/cm^2$ which was probably attributed to such factors as the enhanced phase purity and out-of-plane texture, the moderate film density and grain size, and crack-free surface.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 1998년도 추계학술대회 논문집
• /
• pp.175-178
• /
• 1998

LiMn$_2$O$_4$-based spinels has been studied extensively as positive electrode materials for rechargeable lithium and lithium ion batteries. We describe here that LiMn$_2$O$_4$ cathode active materials is preparated by sol-gel process using water as solvent, which often yields inorganic oxides of excellent phase purity and well-controlled stoichiometry. Using this process, it has been possible to synthesize phase-pure crystalline spinel LiMn$_2$O$_4$ by calcining the appropriate precursors in air at 80$0^{\circ}C$ for several hours. The influence of different time have also been explored. LiMn$_2$O$_4$ preparated in the present study exhibit the single phase of cubic and active reaction at 400 ~ $600^{\circ}C$. Electrochemical studies show that the this method- synthesized materials appear to present reversible oxidation and reduction reactions at 3.0V ~ 4.5V and cycle stability during 50 cycle.

• 한국진공학회:학술대회논문집
• /
• 한국진공학회 2012년도 제42회 동계 정기 학술대회 초록집
• /
• pp.415-415
• /
• 2012

ZnO nanostructures were synthesized by a vapor phase transport process in a single-zone furnace within a horizontal quartz tube with an inner diameter of 38 mm and a length of 485 mm. The ZnO nanostructures were grown on Au-catalyzed Si(100) substrates by using a mixture of zinc oxide and graphite powders. The growth of ZnO nanostructures was conducted at $800^{\circ}C$ for 30 min. High-purity Ar and $O_2$ gases were pushed through the quartz tube during the process at a flow rate of 100 and 10 sccm, respectively. The sequence of ON/OFF cycles of the Ar gas flow was repeated, while the $O_2$ flow is kept constant during the growth time. The Ar gas flow was ON for 1 min/cycle and that was OFF for 2 min/cycle. The structure and optical properties of the ZnO nanostructures were investigated by field-emission scanning electron microscope, X-ray diffraction, temperature-dependent photoluminescence. The preferred orientation of the ZnO nanostructures was along c-axis with hexagonal wurtzite structure.

• 한국세라믹학회지
• /
• 제31권9호
• /
• pp.1005-1011
• /
• 1994

The three different composition of BaTi4O9, Ba2Ti9O20 and BaTi5O11 were prepared by coprecipitation process, and then the dielectric properties of these compounds were measured at low microwave frequencies. The powder showing high level of purity was synthesised by the coprecipition reaction of BaCl2 and TiCl4 where (NH4)2CO3 and NH4OH were used as a deflocculent. Followings are the result of this study: 1. The sintering temperature increased with increasing TiO2 content. 2. BaTi4O9 powder were synthesized as a single phase by this processing technique, but the resultant Ba2Ti9O20 and BaTi5O11 phase existed with Ba2Ti9O20 and BaTi5O11 phases. 3. Single phase BaTi4O9 showed high dielectric constant value of 35, high Q value of 8100.

• KSBB Journal
• /
• 제16권4호
• /
• pp.327-331
• /
• 2001

전라남도 보성산 녹차로부터 유용성분인 카테킨 화합물을 초임계 이산화 탄소와 첨가제를 사용하여 추출하고 역상 고성능 액체 크로마토그래피(RP-HPLC)를 사용하여 분석하였다. LiChrospher 100RP-18(15 $\mu$m)로 충진된 column을 이용하여 0.05% phosphoric acid가 포함된 물과 acetonitrile을 이동상으로 사용하였으며 구배용매 조성법을 적용하였다. 이동상의 조성에 따른 체류인자의 조절을 통해 EGCG를 분리하였다. 각각의 초임계 추출법에 따른 EGCG의 추출량을 비교한 결과, 초임계 유체에 극성물질을 포함하는 경우가 녹차의 유용 성분인 EGCG의 추출량이 가장 많았다. 그러나 ethanol에 의한 용매 추출법은 초임계 유체에 의한 추출법보다 EGCG에 대해 많은 추출양과 선택적인 고순도 분리가 가능하였다.