• Korean Journal of Remote Sensing
• /
• v.34 no.2_1
• /
• pp.237-248
• /
• 2018

The vertical distribution of hydrometeor before precipitation near the cloud base has been analyzed using a scanning lidar, rawinsonde data, and Cloud-Resolving Storm Simulator (CReSS). This study mostly focuses on 13 Desember 2016 only. The typical synoptic pattern of lake-effect snowstorm induced easterly in the Yeongdong region. Clouds generated due to high temperature difference between 850 hPa and sea surface (SST) penentrated in the Yeongdong region along with northerly and northeasterly, which eventually resulted precipitation. The cloud base height before the precipitation changed from 750 m to 1,280 m, which was in agreement with that from ceilometer at Sokcho. However, ceilometer tended to detect the cloud base 50 m ~ 100 m below strong signal of lidar backscattering coefficient. As a result, the depolarization ratio increased vertically while the backscattering coefficient decreased about 1,010 m~1,200 m above the ground. Lidar signal might be interpreted to be attenuated with the penetration depth of the cloud layer with of nonspherical hydrometeor (snow, ice cloud). An increase in backscattering signal and a decrease in depolarization ratio occured in the layer of 800 to 1,010 m, probably being associated with an increase in non-spherical particles. There seemed to be a shallow liquid layer with a low depolarization ratio (<0.1) in the layer of 850~900 m. As the altitude increases in the 680 m~850 m, the backscattering coefficient and depolarization ratio increase at the same time. In this range of height, the maximum value (0.6) is displayed. Such a result can be inferred that the nonspherical hydrometeor are distributed by a low density. At this time, the depolarization ratio and the backscattering coefficient did not increase under observed melting layer of 680 m. The lidar has a disadvantage that it is difficult for its beam to penetrate deep into clouds due to attenuation problem. However it is promising to distinguish hydrometeor morphology by utilizing the depolarization ratio and the backscattering coefficient, since its vertical high resolution (2.5 m) enable us to analyze detailed cloud microphysics. It would contribute to understanding cloud microphysics of cold clouds and snowfall when remote sensings including lidar, radar, and in-situ measurements could be timely utilized altogether.

• Journal of Aerospace System Engineering
• /
• v.13 no.6
• /
• pp.9-16
• /
• 2019

The experiment on the liquid jet in crossflow in supersonic BFS (backward-facing step) flow was conducted to investigate the mixing characteristics. The working fluids are nitrogen and water. The shadow graph technique was used to visualize the flow field. Images captured by the high-speed camera were applied to analyze the flow phenomena. The liquid jet was injected at the re-circulation zone created by the supersonic jet flow. Experimental conditions are defined based on the pressure of the nitrogen gas chamber and pressurized liquid tank. In respective cases, the penetration depth of liquid jet and location of the Mach disc were observed to be proportional to the momentum ratio of gas and liquid jets.

• Advances in concrete construction
• /
• v.6 no.2
• /
• pp.103-121
• /
• 2018

This paper reports the effects of coarse and fine recycled concrete aggregates (RCA) on fresh and hardened properties of self-compacting concrete (SCC) containing ground granulated blast-furnace slag (GGBFS) as cement replacement. For this purpose, three SCC mixes groups, were produced at a constant water to binder ratio of 0.38. Both fine and coarse recycled aggregates were used as natural aggregates (NA) replacement at different substitution levels of 0%, 25%, 50%, 75% and 100% by volume for each mix group. Each group, included 0, 15% or 30% GGBFS as Portland cement replacement by weight. The SCC properties investigated were self-compactability parameters (i.e., slump flow, T500 time, V-funnel flow time, L-box passing ability and sieve stability), compressive strength, capillary water absorption and water penetration depth. The results show that the combined use of RCA with GGBFS had a significant effect on fresh and hardened SCC mixes. The addition of both fine and coarse recycled aggregates as a substitution up to 50% of natural aggregates enhance the workability of SCC mixes, whereas the addition from 50 to 100% decreases the workability, whatever the slag content used as cement replacement. An enhancement of workability of SCC mixes with recycled aggregates was noticed as increasing GGBFS from 0 to 30%. RCA content of 25% to 50% as NA replacement and cement replacement of 15% GGBFS seems to be the optimum level to produce satisfactory SCC without any bleeding or segregation. Furthermore, the addition of slag to recycled concrete aggregates of SCC mixes reduces strength losses at the long term (56 and 90 days). However, a decrease in the capillary water absorption and water permeability depth was noticed, when using RCA mixes with slag.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2016.02a
• /
• pp.384.1-384.1
• /
• 2016

We reported that amorphous silicon (a-Si) thin film provide sample plate exhibiting a multimodality to measure biomolecules by secondary ion mass spectrometry (SIMS) and laser desorption/ionization mass spectrometry (LDI-MS). Kim et al.1 reported that a-Si thin film were suitable to detect small molecules such as drugs and peptides by SIMS and LDI-MS. Recently, bacterial identification has been required in many fields such as food analysis, veterinary science, ecology, agriculture, and so on.2 Mass spectrometry is emerging for identifying and profiling microbiology samples from its advantageous characters of label-free and shot-time analysis. Five species of bacteria - S. aureus, G. glutamicum, B. kurstaki, B. sphaericus, and B. licheniformis - were sampled for MS analysis without lipid extraction in sample preparation steps. The samples were loaded onto the a-Si thin film with a thickness of 100 nm which did not only considered laser-beam penetration but also surface homogeneity. Mass spectra were recorded in both positive and negative ionization modes for more analytical information. High reproducibility and sensitivity of mass spectra were demonstrated in a mass range up to mass-to-charge ratio(m/z) 1200 by applying the a-Si thin film in mentioned above MS. Principle component analysis (PCA) - a popular statistical analysis widely used in data processing was employed to differentiate between five bacterial species. The PCA results verified that each bacterial species were readily distinguished and differentiated effectively from our MS approach. It shows a new opportunity to rapid bacterial profiling and identification in clinical microbiology. More details will be discussed in the presentation.

• International Journal of Highway Engineering
• /
• v.17 no.4
• /
• pp.53-61
• /
• 2015

PURPOSES : The objective of this study is to evaluate the SDAR (solvent deasphaltene residue), which is obtained from the solvent deasphalting (SDA) process, as a pavement material. METHODS : The physical properties of the SDAR were evaluated based on its chemical composition, and asphalt mixtures with the SDAR were fabricated and used for the evaluation of mechanical properties. Firstly, the chemical composition of SARA (saturate, aromatic, resin and asphaltene) was analyzed using the TLC-FID (thin-layer chromatography-flame ionization detector). Moreover, the basic material properties of the asphalt binder with the SDAR were evaluated by the penetration test, softening point test, ductility test, and PG (performance grade) grade test. The rheological properties of the asphalt binder with the SDAR were evaluated by the dynamic shear modulus ($G^*$) obtained using the time-temperature superposition (TTS) principle. Secondly, the mechanical properties of the asphalt mixtures with the SDAR were evaluated. The compactibility was evaluated using the gyratory compacter. Moreover, the tensile strength ratio (TSR) was used for evaluating the moisture susceptibility of the asphalt mixtures (i.e., susceptibility to pothole damage). The dynamic modulus $E^*$, which is a fundamental property of the asphalt mixture, obtained at different temperatures and loading cycles, was used to evaluate the mechanical properties of the asphalt mixtures. RESULTS AND CONCLUSION : The SDAR shows stiffer and more brittle behavior than the conventional asphalt binder. As the application of the SDAR directly in the field may cause early failures, such as cracks on pavements, it should be applied with modifiers that can favorably modify the brittleness property of the SDAR. Therefore, if appropriate additives are applied on the SDAR, it can be used as a pavement material because of its low cost and strong resistance to rutting.

• Journal of the Korea Concrete Institute
• /
• v.27 no.4
• /
• pp.435-441
• /
• 2015

Concrete, as a porous media, has permeability and it is considered as a major parameter for durability evaluation. Cold joint caused by delayed placing of concrete accelerates water permeation and intrusion of harmful ions. In the paper, concrete specimens containing GGBFS (Ground Granulated Blast Furnace Slag) and OPC (Ordinary Portland Cement) are prepared with cold joint section, and water permeability and water flow at the age of 91 days are measured for 2 weeks. Sound concrete with GGBFS shows decreased permeability to 89% for sound concrete with OPC and 0.86 of decreasing ratio is evaluated in GGBFS concrete with cold joint. Through WPT (Water Penetration Test), the effects of mineral admixture and cold joint on water permeability are evaluated, and variation in water behavior via cold joint is analyzed through probabilistic method as well.

• Journal of the Korean Recycled Construction Resources Institute
• /
• v.6 no.3
• /
• pp.88-93
• /
• 2011

To resolve the problem which is demand and supply imbalance of fine aggregate by the shortage of natural fine aggregate and the environment regulations, the studies for the application of recycled fine aggregate made from waste concrete have been recently carried out. The objective of this study is to shed light on the mechanical properties and durability performance of concrete using recycle fine aggregate with various water to cement ratios and unit water contents. And it is intend to propose the fundamental data for structural application of recycled concrete. In particular, the effects according to the variations of water to cement ratios and unit water contents in recycled concrete with recycled fine aggregate replacement of 100 percent are discussed by the test results, such as air content, slump, time of set, compressive strength, tensile strength, carbonation, chloride penetration.

• Asia-Pacific Journal of Business Venturing and Entrepreneurship
• /
• v.7 no.1
• /
• pp.67-72
• /
• 2012

This study describes the environment change of an internal and external medical device market to be entered to European market of an urinary incontinence treatment device, is aimed at suggesting a participation plan analyzing urinary incontinence and treatments, and characteristic of new products & European urinary incontinence market. In conclusion, to sell the urinary incontinence treatment device developed as the world's first in European market, the following strategies are needed. First, the strategies domestic firms make family doctors and urologists heighten awareness of the urinary incontinence treatment device developed in Korea through participation of associations and exhibition being held in Europe to increase a market penetration level are needed. Second, it may be necessary to emphasize the fact that this devices are a characterful products and treatments, and cost-effectiveness treatments reducing infection ratio. Third, the domestic production firms of the urinary incontinence treatment device should suggest quality, delivery, and price consistency through looking for ways to lower the price while maintaining the quality in an increasingly competitive market conditions.

• Korean Journal of Environmental Agriculture
• /
• v.15 no.4
• /
• pp.434-441
• /
• 1996

This study was conducted to clarify the degradation pattern, safety evaluation and penetration ratio of benomyl and bitertanol to apple used as postharvest fungicides during CA(controlled atmosphere) and cold storage. In CA storage, the degradation of benomyl and bitertanol in stored apple was slow at the early stage, while that in cold storage was, on the contrary, faster at the early stage. The initial concentrations of benomyl and bitertanol in apples applied at the standard application concentrations were 2.24 and 1.54mg/kg, respectively, and their residual amounts were below the maximum residue limits, 1mg/kg at 135 and 96 days in CA storage, 115 and 70 days in cold storage, respectively. The half-lives of benomyl and bitertanol in stored apples were 124 and 130 days in CA storage, 101 and 111 days in the cold storage, respectively, indicating that the degradation was faster in cold storage than in CA storage. The residual amount of benomyl and bitertanol in stored apples was retained more in peels than in pulps of apples.

• Korean Journal of Soil Science and Fertilizer
• /
• v.47 no.6
• /
• pp.496-499
• /
• 2014

The present study investigated variations in soil microbial communities and the chemical properties of forest soils by differing amounts of penetrating sunlight. The soil temperature was significantly higher in higher light-penetrated soils. Higher light-penetrated soils (LP70) showed significantly more fungal communities than the lower light-penetrated soils (LP40 and LP50) (p < 0.05). The $NH_4$-N concentration in LP70 was significantly lower than those of LP40 and LP50, whereas the other chemical properties showed no significant difference among the soils. The cy19:0 to $18:1{\omega}7c$ ratio was significantly lower in LP70 than in LP 40 and LP50 showing the negative correlation of light level with microbial stresses (p < 0.05). The soil microbial communities and the chemical properties that showed positive eigenvector coefficients for PC1 were the fungi to bacteria, fungi, arbuscular mycorrhizal fungi, and Gram-positive bacteria, whereas negative eigenvector coefficients were found for $NH_4$-N, actinomycetes, Gram-negative bacteria, and bacteria. Consequently, the amount of penetrating light was responsible for microbial compositions in the forest soils in correlation with the concentration of $NH_4$-N and soil temperature.