• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2001.07a
• /
• pp.435-438
• /
• 2001

Thin films of vanadium oxide(VO$\sub$x/) have been deposited by r.f. magnetron sputtering from V$_2$O$\sub$5/ target in gas mixture of argon and oxygen. The oxygen/(oxygen+argon) partial pressure ratio is changed from 0% to 8%. Crystal structure, chemical composition and bonding properties of films sputter-deposited under different oxygen gas pressures are characterized through XRO, XPS, RBS and FTIR measurements. All the films prepared below 8% O$_2$ are amorphous, and those prepared without oxygen are gray indicating the presence of V$_2$O$\sub$$_4$/ phase in the films. V$_2$O$\sub$5/ and lower oxides co-exist in sputter-deposited films and as the oxygen partial pressure is increased the films become more stoichiometric V$_2$O$\sub$5/. The increase of O/V ratio with increasing oxygen gas pressure is attributed to the partial filling of oxygen vacancies through diffusion. It is observed that the oxygen atoms. located on the V-O plane of V$_2$O$\sub$5/ layer participate more readily in the oxidation process.

• Journal of Korea Foundry Society
• /
• v.15 no.4
• /
• pp.377-387
• /
• 1995

Partial squeeze die casting is a special die casting process which combines squeeze technique to conventional die casting. The influence of squeeze pressure $(1500-3000kg/cm^2)$ and time-lags(0.5-2.0sec) on defect control, density and microstructure of ADC12 alloy die casts has been studied by appling partial squeeze die casting to air compressure front housing production. Defect free, maximum density of $2.736kg/cm^3$ with sound microstructure of ADC12 alloy die cast has been obtained by partial squeeze die casting technique at the pressure of $2000-2500kg/cm^2$ and time-lags of 1.0-2.0sec.

• Journal of Korean Society for Atmospheric Environment
• /
• v.6 no.1
• /
• pp.57-72
• /
• 1990

The oxidation of carbon monoxide on a catalyst, $LaSrNiCoO_3$ was investigatigated with a plug flow system. Kinetic quantities such as reaction-rate, reaction order and Arhenius-parameters at various reactor temperature from 200$^\circ$C to 300$^\circ$C were determined. Also, the optimum condition for the oxidation of carbon monoxide with this catalyst was determined and are as follows. Partial pressure of oxigen ; 428mmHg Partial pressure of carbon monoxide ; 332mmHg Mixed moral ratio of oxigen and Carbon monoxide ; 1.3 : 1 Total gas flow ; 224ml/min Reaction temperature ; 340$^\circ$C The reaction kinetic equation at the optimum condition, temperature range from 200$^\circ$C to 340$^\circ$C, are as follow. $$ $v = Ae^{6.5Kcal/RT} [CO]^{0.93 \sim 0.98} [O_2]^{0.42 \sim 0.50}$ $$ In addition to this, numerical calculation were performed to evaluate the mass and heat transfer effect on this system.

• Bulletin of the Korean Chemical Society
• /
• v.7 no.5
• /
• pp.341-346
• /
• 1986

The electrical conductivity of the system ${\alpha}-Fe_2O_3-CoO$ was measured in the temperature range 200-1000$^{\circ}C$ and PO$_{2}$ range 10$^{-7}-2{\times}10^{-1}$ atm. Possible defect models were suggested on the basis of conductivity data, which were measured as a function of temperature and of oxygen partial pressure. The observed activation energies were 0.50 eV and 1.01 eV in the low- and high-temperature regions, respectively. The observed conductivity dependences on PO$_{2}$ were ${\sigma}\;{\alpha}\;PO_2^{-1/6}$ in the PO$_{2}$ range $10^{-7}-10^{-4}$ atm and ${\sigma}\;{\alpha}\;PO_2^{-1/4}$ at PO$_{2}$ 's of $10^{-4}-2{\times}10^{-1}$ atm at temperatures from 300-1000$^{\circ}C$. An extrinsic electron conduction due to an Vo defect and an intrinsic electron conduction due to an Fei' defect were suggested at different temperature and oxygen partial pressure regions, respectively.

• Journal of Veterinary Clinics
• /
• v.32 no.4
• /
• pp.380-384
• /
• 2015

The relationships between end-tidal partial pressure of carbon dioxide ($P_{ET}CO_2$) and arterial partial pressure of carbon dioxide ($P_aCO_2$), and between $P_{ET}CO_2$ and blood pH in isoflurane-anesthetized cinereous vultures were evaluated. Nine cinereous vultures (weighing 7.3-9.5 kg) were anesthetized via mask with isoflurane, intubated, and connected to a mechanical ventilator. By mechanical ventilator, respiratory rate was altered to achieve a $P_{ET}CO_2$ randomly selected among 30 to 35 mmHg. $P_aCO_2$ and blood pH were determined in serial arterial samples and compared with concurrent $P_{ET}CO_2$ measured with a sidestream capnography. Thirty six samples, nine cinereous vultures were tested 4 times each, were used to determine correlations coefficients between $P_aCO_2$ and $P_{ET}CO_2$, and between $P_{ET}CO_2$ and blood pH. Strong correlations were observed between $P_aCO_2$ and $P_{ET}CO_2$ (r = 0.951, P = 0.000, y = 1.679x - 30.236, $R^2=0.905$) as well as between $P_{ET}CO_2$ and blood pH (r = -0.728, P = 0.000, y = -0.024x + 8.389, $R^2=0.530$) with Pearson's correlation coefficient and simple linear regression. These results suggest that the capnography used provided a sufficiently accurate estimation of $P_aCO_2$ and blood pH. Thus, the monitoring of $P_{ET}CO_2$ can be useful method to prevent hypoventilation for cinereous vultures receiving mechanical ventilation.

• Journal of the Korean Chemical Society
• /
• v.57 no.6
• /
• pp.769-777
• /
• 2013

The effect of operating conditions (temperature and the partial pressures of H2 and CO) on the reaction rate of Fischer-Tropsch synthesis (FTS) were investigated by carrying out experiments according to a Box-Behnken design (BBD), and were mathematically modeled by using response surface methodology (RSM). The catalyst used was a nano-structured cobalt/manganese oxide catalyst, which was prepared by thermal decomposition. The rate of synthesis was measured in a fixed-bed micro reactor with $H_2/CO$ molar feed ratio of 0.32-3.11 and reactor pressure in the range of 3-9.33 bar at space velocity of $3600h^{-1}$ and a temperature range of 463.15-503.15 K, under differential conditions (CO conversion below 2%). The results indicated that in the present experimental setup, the temperature and the partial pressure of CO were the most significant variables affecting reaction rate. Based on statistical analysis the quadratic model of reaction rate of FTS was highly significant as p-value 0.0002.

• Journal of the Korean Society of Food Science and Nutrition
• /
• v.26 no.3
• /
• pp.436-442
• /
• 1997

Corn starch was extruded under relatively low shear, high moisture, and low temperature. Puffing of corn starch dough was induced by injecting $CO_2$gas in the range from 0MPa to 0.09MPa. Piece density and compressive modulus for puffed corn starch were decreased by increasing the injection pressure to 0.07MPa, and increased above 0.07MPa. the microstructure of corn starch puffed with $CO_2$gas showed thick cell size, compared with those puffed with steam. RVA paste viscosity curves of corn starch puffed with $CO_2$had different patterns from those puffed with steam, probably resulted from partial gelatinization of starch. Water absorption and solubility were not significantly changed by $CO_2$injection pressure, but the average degree of polymerization was reduced by higher $CO_2$injection. The water absorption, water solubility, and the average degree of polymerization for corn starch puffed with $CO_2$were significantly lower than those puffed with steam.

• Journal of the Korean Vacuum Society
• /
• v.13 no.4
• /
• pp.139-144
• /
• 2004

Recently, the importance of clean vacuum and partial pressure measurement of gas species has been increased in the vaccum process. In this study, the partial pressures of $H_2$, He, C, N, $O_2$, $H_2O $, Ar/2, $N_2$(CO), Ar, $CO_2$ were measured by residual gas analyzer according to temperature of cryogenic pump which is used to clean vacuum generation and compared. The experimental results showed that the cryopanel temperature was reached to 12K after 72 minutes of pumping and after 25hours, the partial pressures in percent were 24.9 %, 6.6%, 5.5 %, 2.2 %, 3.8%, 30.7%, 6.5%, 6.1 %, 5.5%, 8.2% for $H_2$, He, C, N, $O_2$, $H_2O $, Ar/2, $N_2$, Ar, $CO_2$ respectively. The dominant gases were $H_2$ and $H_2O $, and the partial pressures were relatively high compare to other gases.

• Journal of Korean Society for Atmospheric Environment
• /
• v.21 no.6
• /
• pp.605-612
• /
• 2005

In this study, the possible use of HMDA (Hexamethylenediamine) as additive to enhance reaction between $CO_{2}$ and AMP (2-amino-2-methyl-1-propanol) which has higher absorption capacity than that of MEA (Monoethanolamine) was investigated. Also, the absorption capacity for $CO_{2}$ was compared with addition of HMDA, piperazine or MDEA (N-methyldiethanolamine) into $30\;wt\%$ AMP at $40^{circ}C$ and $CO_{2}$ partial pressure ranging from 0.5 to 120 kPa. Apparent rate constant ($K_{app}$) and absorption capacity with the addition of $5\∼20\;wt\%$ HMDA into AMP increased $214.2\∼276.3\%$ and $29.9\∼91.7\%$ than those of AMP alone. As a result, when $5\;wt\%$ HMDA added into AMP, the increasing rate of the absorption rate and the absorption capacity was found to be the highest. In addition, the absorption capacity increased $6.8\%,\;9.8\%,\;11.6\%$ with addition of MDEA, piperazine or HMDA respectively as compared to AMP alone at $CO_{2}$ partial pressure of 20 kPa. Consequently, HMDA as additive to improve absorption capacity of AMP was superior to other additives.

• Korean Journal of Materials Research
• /
• v.13 no.8
• /
• pp.519-523
• /
• 2003

We report the synthesis of cubic spinel $ZnCo_2$$O_4$thin films and the tunability of the conduction type by control of the oxygen partial pressure ratio. Zinc cobalt oxide films were grown on$ SiO_2$(200 nm)/Si substrates by reactive magnetron sputtering method using Zn and Co metal targets in a mixed Ar/$O_2$atmosphere. We found from X-ray diffraction measurements that the crystal structure of the zinc cobalt oxide films grown under an oxygen-rich condition (the $O_2$/Ar partial pressure ratio of 9/1) changes from wurtzite-type $Zn_{1-x}$ $Co_{X}$O to spinel-type $ZnCo_2$$O_4$with the increase of the Co/Zn sputtering ratio,$ D_{co}$ $D_{zn}$ . We noted that the above structural change accompanied by the variation of the majority electrical conduction type from n-type (electrons) to p-type (holes). For a fixed $D_{co}$ $D_{zn}$ / of 2.0 yielding homogeneous spinel-type $_2$O$ZnCo_4$films, the type of the majority carriers also varied, depending on the$ O_2$/Ar partial pressure ratio: p-type for an $O_2$-rich and n-type for an Ar-rich atmosphere. The maximum electron and hole concentrations for the Zn $Co_2$ $O_4$films were found to be 1.37${\times}$10$^{20}$ c $m^{-3}$ and 2.41${\times}$10$^{20}$ c $m^{-3}$ , respectively, with a mobility of about 0.2 $\textrm{cm}^2$/Vs and a high conductivity of about 1.8 Ω/$cm^{-1}$ /.