• Korean Journal of Materials Research
• /
• v.16 no.4
• /
• pp.241-247
• /
• 2006

Structural studies have been performed on precipitation hardening discovered in $L1_2-ordered\;Ni_3(Al,Cr)$ containing 0.2 to 3.0 mol% of carbon using transmission electron microscopy (TEM). Fine octahedral precipitates of $M_{23}C_6$ appeared in the matrix by aging at temperatures around 973 K after solution treatment at 1423 K. TEM examination revealed that the $M_{23}C_6$ phase and the matrix lattices have a cube-cube orientation relationship and keep partial atomic matching at the {111} interface. After prolonged aging or by aging at higher temperatures, the $M_{23}C_6$ precipitates then adopt a rod-like morphology elongated parallel to the <100> directions. Deformation at temperature below 973 K, typical Orowan loops were observed surrounding the $M_{23}C_6$ particles. At higher deformation temperatures, the Orowan loops disappeared and the morphology of dislocations at the particle-matrix interfaces suggested the existence of attractive interaction between dislocations and particles. The change of the interaction modes between dislocation and particles with increasing deformation temperature can be considered as a result of strain relaxation at the interface between matrix and particles.

• Korean Journal of Animal Reproduction
• /
• v.21 no.3
• /
• pp.311-319
• /
• 1997

This study was carried out to investigate the ultrastructural changes of spermatozoa obtained from 20 of 3-year-old male chum salmon(Oncorhynchus keta) collected and analysed in middle October in 1995. The ultrastructural changes of gonad of fingerlings were examined to describe the sex differentiation of this species. The results obtained in this study were as follows : In spermatozoa, the nucleus is dense and homogeneous. Two spheroidal mitochondria(about 350nm long) are situated in parallel between the nucleus and the axoneme. Spermatozoa mitochondria are assembled into an organized sheath surrounding the outer dense fibres and axoneme of the flagellar midpiece. The sheath flagellum is situated beneath the base of the sperm head. The primordial germ cells of 6.8~7.2${\mu}{\textrm}{m}$ in size, which were buried under fibrous mesenchymal tissue between gut duct and notochord of larva with a total length of 2.4cm at 50 days after hatching. In juvenile of 10.5cm in total length at 70 days after hatching, the gonad was occupied by bundles of oogonia. The dense drumstick bodies(large arrows) are observed in the nuclei of the primordial gonad and surrounding tissue cells of fingerling at 70 days after hatching. The oval Barr bodies(asterisk) are observed in the nuclei of the primordial germ cells under the mitosis(2n). Note the large mitochondria, ribosomes and rough endoplasmic reticulum in the cytoplasm. Accordingly, the fingerlings at 70 days after hatching are identified as the female(xx). In result, the gonadal sex differentiation begins from the 70 days after hatching in chum salmon.

• Applied Microscopy
• /
• v.32 no.3
• /
• pp.257-263
• /
• 2002

Microstructural investigations of $(Li_{1/2}Pr_{1/2})TiO_3$ (LPT) complex perovskite compounds were carried out using X-ray diffractometry and transmission electron microscopy. LPT has not only the ordering of A-site cation deficiencies but also has the antiphase and inphase tilting of oxygen octahedron and the antiparallel shift of cations. Both the antiphase boundaries and the ferroelastic domains are present in the microstructure. Spinodal decomposition is found in the microstructure. The measured dielectric properties were ${\varepsilon}_r=84.6,\;Q\;{\Large f}_o=776\;GHz,\;{\tau}_{f}=-233.66ppm/^{\circ}C$.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2000.11b
• /
• pp.3-38
• /
• 2000

Slope draperies in soil and rock are a well known method to avoid rockfalls into the roads or onto housings. Common wire mesh or a combination of wire mesh and wire rope nets are pinned to the slope by the means of fully grouted nails or anchors. Most of these installations have not been designed to stabilize the slope, but simply avoid the rocks from bouncing. The combination of soil- or rocknailing with a designable flexible facing system offers the advantage of a longterm stabilization of slopes and can replace other standard methods for slope stabilization. The capability to transfer axial and shear loads from the flexible facing system to the anchor points is most decisive for the design of the stabilization system. But the transfer of forces by mesh as pure surface protection devices is limited on account of their tensile strength and above all also by the possible force transmission to the anchoring points. Strong wire rope nets increase the performance for slope stabilizations with greater distances between nails and anchors and are widely used in Europe. However, they are comparatively expensive in relation to the protected surface. Today, special processes enable the production of diagonally structured mesh from high-tensile steel wire. These mesh provide tensile strengths comparable to wire rope nets. The interaction of mesh and fastening to nail / anchor has been investigated in comprehensive laboratory tests. This also in an effort to find a suitable fastening plates which allows an optimal utilization of the strength of the mesh in tangential (slope-parallel) as well as in vertical direction (perpendicular to the slope). The trials also confirmed that these new mesh, in combination with suitable plates, enable substantial pretensioning of the system. Such pretensioning increases the efficiency of the protection system. This restricts deformations in the surface section of critical slopes which might otherwise cause slides and movements as a result of dilatation. Suitable dimensioning models permit to correctly dimension such systems. The new mesh with the adapted fastening elements have already been installed in first pilot projects in Switzerland and Germany and provide useful information on handling and effects.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.14 no.8
• /
• pp.863-870
• /
• 2003

The digital transmission system entered in a RF region as digital system use IC chips of the speeder edge rate and clock speed nowadays. Optical path really was used in order to obtain the more capacity. In this paper, we described importance of electrical interconnect to get the signal integrity in optical module by simulation and experiment. 12 channel${\times}$2.5 G/ps optical parallel transmitter modules were manufactured by two different method ; access lines with microstrip and stripline type. We have clearly shown that the optical module adopting microstrip type with S$\sub$11/ $\geq$ -10 dB presents distortion but the optical module adopting stripline type with S$\sub$11/ $\leq$ : 15 dB obtains eye opening in 2.5 Gbis optical eye pattern response.

• Journal of the Korean Society for Railway
• /
• v.20 no.2
• /
• pp.190-195
• /
• 2017

This paper proposes a method to detect rail broken through impedance measurement. In general, broken rails are detected in real time using the track circuit, but the proposed method not only detects the broken rails but also estimates positions of broken areas by measuring the rail impedance. To electrically insulate one side of the rail, parallel resonance is made by adding a capacitor; then, the impedance of the other rail is measured. If the measured impedance has an inductive value, there is no broken area of rail. However if the measured impedance has a capacitive value, the rail is broken. The proposed method is modeled using a transmission line; it is shown that the modeling can estimate the position of the broken rail according to the impedance value. The rail impedance is measured by the proposed method for a 60m simple rail model, and it is verified that the presence of a broken rail changes the rail impedance.

• Korean Journal of Veterinary Research
• /
• v.31 no.1
• /
• pp.1-10
• /
• 1991

The present investigation was focussed on histochemical and electron microscopical observations of utero-vaginal(U-V) glands in U-V junctions of domestic hens. In histochemical observations, fine granules by PAS technique for mucopolysaccharides and nile blue stain for acidic lipids were slightly stained on the cytoplasm of U-V glandular epithelium. Larger granules by Sudan black B stain for neutral fat and phospholipids and Sudan III stain for neutral fat were heavily stained on the perinuclear region of the U-V gland epithelial cells. These positive materials were heavily stained on the U-V glandular epithelium of lowfecundity hens and non-laying hens. In scanning electron microscopic findings of the U-V junction surface, the orifices of U-V glands are seen as the crater-like invagination. The neck of the U-V gland and the epithelium of U-V iunction were covered by ciliated epithelial cells. Aggregates of spermatozoa are observed often to be on the necks of the U-V gland. These spermatozoa heads are embedded in the glandular tubules and many spermatozoa tails are free on the epithelium of uterine surface. In transmission electron microscopic findings, the epithelial cells of the U-V glandular orifices were ciliated, columnar cells. The apical regions of these cells contained numerous electrondense, round secretory granules of uniformly size. The epithelial cells of the U-V glandular tubule were columnar or pyramid shape with round or oval nuclei. These epithelial cells have numerous microvilli and also contained electron-dense, round secretary granules of uniformly size and electron-lucent vesicles of various size. Spermatozoa are seen as the cross-sections of various regions of heads and tails in glandular tubules. Also spermatozoa arranged longitudinally parallel within the glandular tubules.

• Proceedings of the KOSOMBE Conference
• /
• v.1995 no.05
• /
• pp.235-238
• /
• 1995

In this paper, we propose an effective coding method of the angiography by using the scalable structure in the frequency domain for MPACS(Medical Picture Archiving and Communication System). We employed the subband decomposition method and MPEG-2 system which is the international standard coding method of the general moving picture. After the subband decomposition is applied to split an input image into 4 bands in the spatial frequency domain, the motion compensated DPCM coding method of MPEG-2 is carried out for each subband. As a result, an easily controllable coding Structure is accomplished by composing the compound hit stream for each subband group. Follows are the simulation results of the proposed sheme for the angiography. A scalable structure which can be easily controlled for a loss of transmission or the band limit can be accomplisbed in the MPEG-2 stucture by the subband decomposition minimizing the side information. And by reducing the search area of the motion vector between -4 and 3, the processing speed of a codec is enhanced by more than two times without a loss of the picture quality compare with the conventional DCT coefficients decompositon method. And the processing speed is considerably improved in the case of the parallel construction of each subband in the hardware.

• Journal of the Institute of Electronics Engineers of Korea SC
• /
• v.42 no.1
• /
• pp.13-21
• /
• 2005

This paper presents a fuzzy model-based approach for synchronization of time-delay chaotic system with input saturation. Time-delay chaotic drive and response system is respectively represented by Takagi-Sugeno (T-S) fuzzy model. Specially, the response system contains input saturation. Using the unidirectional linear error feedback and the parallel distributed compensation (PDC) scheme, we design fuzzy chaotic synchronization system and analyze local stability for synchronization error dynamics. Since time-delay in the transmission channel always exists, we also take it into consideration. The sufficient condition for the local stability of the fuzzy synchronization system with input saturation and time-delay is derived by applying Lyapunov-Krasovskii theory and solving linear matrix inequalities (LMI's) problem. A numerical example is given to demonstrate the validity of the proposed approach.

• Proceedings of the Korea Concrete Institute Conference
• /
• 2008.04a
• /
• pp.921-924
• /
• 2008

Several techniques, including transmission X-ray photography and AC-impedance spectroscopy, are available for evaluating the fiber dispersion in a fiber reinforced concrete Evaluating the fiber dispersion in fiber reinfored concrete needs since the fibers bridge crackseffectively. However, these equipment is very expensive. Therefore this paper presents the quantitative evaluation method based on the image analysis of sectional image taken using an ordinary digital camera. After detecting the fiber accurately, the fiber dispersion characteristics are represented by the coefficient such as the fiber dispersion coefficient, the number of fibers in unit area, and the distribution of the fiber orientation. Test were performed to evaluate the effectiveness of proposed method and the dispersion characteristics of fibers according placing method and flow direction. Additionally, the effect of fiber dispersion characteristics on mechanical properties was investigated. Test results shows that fiber aligned along the flow direction and more fibers placed and dispersion was better on the section parallel to the flow direction. And about 50% difference in the flexural tensile strength according to the placing method occured.