• 한국터널공학회:학술대회논문집
• /
• 2005.04a
• /
• pp.225-232
• /
• 2005

The construction of parallel tunnel by using the shield TBM method was increased recently. Accordingly the application and the propriety of the parallel shield TBM tunnels were studied through domestic and foreign construction cases herein. Also the behavior of tunnel structure and ground was evaluated by a numerical analysis with various ground conditions and the distance between the parallel tunnels. As a result, it was concluded that a deep investigation as well as a ground reinforcement was required with a ratio(L/D) of the distance between the parallel tunnels(L) to tunnel outer diameter(D) less than 0.5 because the Interference phenomenon was expected to occur. And the appropriateness of the application method of parallel shield TBM tunnel was validated through the 2-dimensional numerical analysis simulated the process of excavation after the ground reinforcement in the starting area of the OOO construction site with the ratio(L/D) of 0.35.

• Journal of the Korea Institute of Information Security & Cryptology
• /
• v.14 no.2
• /
• pp.57-68
• /
• 2004

We present a new parallel algorithm for extending the domain of a UOWHF. Our algorithm is based on non-complete l-ary tree and has the same optimal key length expansion as Shoup's which has the most efficient key length expansion known so far. Using the recent result [8], we can also prove that the key length expansion of this algorithm and Shoup's sequential algorithm are the minimum possible for any algorithms in a large class of "natural" domain extending algorithms. But its prallelizability performance is less efficient than complete tree based constructions. However if l is getting larger then the parallelizability of the construction is also getting near to that of complete tree based constructions.tructions.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.21 no.4
• /
• pp.53-60
• /
• 2007

In this study, an experiment on the efficient construction method of plate electrodes, the influence of electric potential interference in plate electrodes, and building foundations were explored. The experimental result of the electric potential measurement was taken on the basis of the direction of movement and the condition in which the plate electrodes are laid underground in building foundations. It shows that the construction method of laying the plate electrodes vertically exhibits a more efficient reduction of electric potential in a diagonal direction and on an X axis than laying plates horizontally. For plate electrode construction in an area that has uniform conditions, the parallel joint construction method is more effective than a single construction to reduce earth electrical potential and ground resistance. In addition, a straight arrangement performs well in ground efficiency, compared to the parallel arrangement.

• Proceedings of the KSME Conference
• /
• 2003.11a
• /
• pp.1781-1786
• /
• 2003

This research develops a robot as the device which constructs underwater harbour. This construction is to build a breakwater, which is dangerous and difficult. The hydraulic parallel mechanism-typed robot is developed to mechanize the construction by operating of a stoneworker (or diver) through a joystick. The six-dof robot is able to carry 2-3 tons' heavy stone and put it on the surface of breakwater. This paper presents the mechanical design of a miniature robot, its control and application for the breakwater construction.

• Journal of computational fluids engineering
• /
• v.10 no.1
• /
• pp.67-72
• /
• 2005

This research is based on the iterative space-marching method for incompressible and compressible Navier-Stokes equations[1-4]. A principle of parallel computational schemes construction for steady and unsteady problems is suggested. It is analytically proven that convergence of these schemes is unconditional for incompressible case. When the parallel scheme is used the total volume of computations is the sum of a large number of independent and equal parts. Estimation of the speed-up K shows that K > 1000 in ideal case. First results of using the parallel schemes are presented.

• Journal of Korean Tunnelling and Underground Space Association
• /
• v.9 no.4
• /
• pp.387-401
• /
• 2007

Recently, because of the restriction of land for construction and interference of adjacent structure, parallel tunnels with small clearance have been planned and constructed in many sites. In this case, the stability of pillar at center part is very important factor to satisfy the stability of tunnel structure under the construction. In this paper, numerical analyses for the asymmetry parallel tunnels with a narrow width of pillar have been carried out to search for the optimum reinforcement measure for rock pillar and verify the stability of tunnel. Rock pillar between each single tunnel is supposed to be under heavy load by rock mass. The analysis of stress state at rock pillar at various cases for construction conditions is required to investigate the structural behaviour of tunnels and stability of the pillar. Strength-stress ratio is calculated based on the failure theory of rock and the safety factor of tunnel is computed with strength reduction technique. Through these numerical results, reasonable reinforcement measures for rock pillar at parallel tunnel were established and recommended.

• The Transactions of the Korea Information Processing Society
• /
• v.5 no.1
• /
• pp.40-48
• /
• 1998

Linear size expanders have been studied in many fields for the practical use, which make it possible to connect large numbers of device chips in both parallel communication systems and parallel computers. One major limitation on the efficiency of parallel computer designs has been the highly cost of parallel communication between processors and memories. Linear order concentrators can be used to construct theoretically optimal interconnection network schemes. Existing explicitly defined constructions are based on expanders, which have large constant factors, thereby rendering them impractical for reasonable sized networks. For these objectives, we use the more detailed matching points in permutation functions, to find out the bigger expansion constant from an equation, $\mid\Gamma_x\mid\geq[1+d(1-\midX\mid/n)]\midX\mid$. This paper presents an improvement of expansion constant on constructing concentrators using expanders, which realizes the reduction of the size in a superconcentrator by a constant factor. As a result, this paper shows an explicit construction of (n, 5, $1-\sqrt{3/2}$) expander. Thus, superconcentrators with 209n edges can be obtained by applying to the expanders of Gabber and Galil's construction.

• Journal of international Conference on Electrical Machines and Systems
• /
• v.3 no.4
• /
• pp.451-457
• /
• 2014

Parallel operation systems have an advantage in that they can be constructed quickly and inexpensively by combining existing electric power converters. However, in this case, there is a peculiar problem in that a cross current flows between the electric power converters. To design a control system more simply and commonalize the core of combination reactors, we reviewed a system construction method for parallel operation systems constructed with three electric power converters.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.30 no.1C
• /
• pp.1-8
• /
• 2005

In this paper, we present a novel LDPC code construction called as semi-algebra low density parity check(LDPC) codes which is one kind of deterministic LDPC code based on dual-diagonal sub-matrix. The constructing method results in a class of high rate LDPC codes. Codes in this class have a large girth and good minimum distances. Furthermore, they can be implemented by simple parallel array architecture using cyclic shift register and perform well with the iterative decoding.

• Journal of the Korean Solar Energy Society
• /
• v.27 no.4
• /
• pp.19-26
• /
• 2007

This paper concerns the study of absorption refrigeration and heat pump cycle to use sewage. Simulation analysis on the double-effect absorption refrigeration cycle with parallel and two-stage heat pump cycle has been performed. The working fluid is Lithium Bromide and water solution. The absorption refrigeration cycle use sewage as a cooling water for the absorber and condenser, and absorption refrigeration cycle does that as a chilled water for the evaporator of the first stage cycle. And the two-stage cycle consists of coupling double-effect with parallel and single effect cycle so that the first stage absorber and condenser produces heating water to evaporate refrigerant in the evaporator of the second stage. The effects of operating variables such as a absorber temperature on the coefficient of performance have been studied for absorption refrigeration and heat pump cycle.