• 한국안전학회지
• /
• 제30권4호
• /
• pp.14-19
• /
• 2015

The purpose of this paper is to study the correlation application that electrical fire causes occurs for overcurrent and leakage current signals in the indoor wiring. In the order to purpose, the causes data of overcurrent, or leakage current of electrical fire are drawn out referring to past studies, consulting with experts and experimental data. The correlation application was then applied with fuzzy logic of intelligent technique. To check the reliability and performance of the correlation application, modified center of area(CoA) was adopted to calculate the possibility that electrical fire occurs, whose value was then compared to the results. The chance of electrical fire calculated is higher when two causes of fire are put into the CoA of the correlation application of this paper than that of when each cause is separately put into the CoA. The correlation application developed in this study enables better analysis on possible electrical fire due to overcurrent, or leakage current and provides managers with the possibility of electrical fire so that they can better manage at a time of overcurrent, or leakage current.

• 한국화재소방학회논문지
• /
• 제22권1호
• /
• pp.68-75
• /
• 2008

본 논문은 화재를 조기에 검출하기 위하여 칼라 영상처리기법을 이용하여 주변 조명과 환경의 변화에 대하여 강건한 화염검출방법을 제안한다. 주변 조명과 화염의 RGB 색 분포 분석을 통하여 주변 조명과 화염을 구분할 수 있는 임계값을 설정하여 후보 영역을 검출한다. 화염이 발생 후 연속적으로 변화하기 때문에 화염 영역의 히스토그램 평균값의 차를 이용하여 화염 유사 영역을 제기한다. 검출된 영역이 화염임을 판단하기 위하여 영역 서술자인 밀집도를 계산하여 최종적으로 화염 여부를 판정한다. 컴퓨터 시뮬레이션을 통하여 제안한 방법이 화염을 보다 잘 검출하고 조명 등 주변 환경 변화에 강건함을 보인다.

• 한국건축시공학회:학술대회논문집
• /
• 한국건축시공학회 2009년도 추계 학술논문 발표대회
• /
• pp.81-85
• /
• 2009

In the recent years, the high strength concrete has increasingly been used according to extending market of tall buildings. However, Ministry of Land, transport and Maritime Affairs was established by law with an alternative plan after June 2008 because of the weakness of high strength concrete accompanied spalling phenomena in fire. The mix design of concrete has to properly meet standards which are the spalling resistance of concrete and limited temperature of steel reinforcement. The fire proof concrete mixed fiber has widely been used to meet spalling safety on the many construction sites, the most researches about the fire proof concrete mixed fiber had being carried out focused on fire resistance, compressive strength and cast in place of concrete. But the most important thing is column shortening used the fire proof concrete within the vertical members. In this paper, the fire proof concrete filled spalling safety standards was experimented by required material when the column shortening is revised between normal concrete and fire proof concrete mixed fiber and then the results have done a comparative analysis. Also, The paper aimed to indicate a basic data for revision of column shortening of fire proof concrete.

• 한국화재소방학회논문지
• /
• 제28권4호
• /
• pp.50-56
• /
• 2014

성능설계 시험 안을 작성하기 위해서는 건축물에 발생할 수 있는 화재의 크기를 정량화하는 단계가 선행되어야 한다. 이러한 설계화재의 크기가 적합하게 선정되었을 때 화재로부터 안전하면서도 경제적인 설계가 가능하다. 우리나라는 성능설계의 역사가 짧고 공학적 자료가 축적되어 있지 않아 화재의 크기를 선정하는 데에 많은 문제점을 드러내고 있다. 이에, 해외의 설계화재 가이드라인과 국내의 실 화재 실험 자료를 조사하였다. 그리고 국내의 설계화재 선정 사례를 조사하여 그 적정성을 분석하고 건축물의 용도별로 설계화재의 가이드라인을 제안하였다.

• 한국화재소방학회논문지
• /
• 제24권6호
• /
• pp.112-119
• /
• 2010

본 연구에서는 제조물 관련 화재조사의 실태분석 및 개선방안을 도출하였다. 연구결과, 화재조사현장에서 조종자 역할을 하는 주체가 불분명하고, 화재피해이재민의 권익보호를 위한 제도적 장치가 부족하며, 소방의 화재감정기관 부재로 화재원인 도출에 한계가 있고, 제조물회사의 초기대응이 소극적인 것으로 나타났다. 개선방안으로는 소방이 화재조사현장에서 조종자 역할을 할 수 있는 제도의 도입, '민간 화재조사전문가' 제도의 도입, 소방의 화재감정기관 및 연구소의 설립.운영, 소방과 제조물회사와의 네트워크 구성 등이 필요한 것으로 나타났다.

• 한국전자통신학회논문지
• /
• 제8권11호
• /
• pp.1617-1624
• /
• 2013

논문에서는 방화셔터와 피난계단이 존재하는 실내 환경의 화재 시뮬레이션을 실시하여 방화셔터와 화재 확산 사이의 관계를 분석하였다. 화재 시뮬레이션용 상용 소프트웨어인 FDS(Fire Dynamics Simulator)를 사용하여 가상으로 설정한 실내 로비에서 화재 규모와 방화셔터의 개폐 여부를 변화시켜 가면서 모의실험을 실시하였다. 실험을 통해 화재실 벽면과 계단 입구의 온도 변화, 이산화탄소 농도 변화, 연기의 확산 등의 변수들을 구하고 결과를 검토하였다. 피난계단에서 온도와 이산화탄소의 분포는 화재규모와 개구부의 개폐 여부와 별 상관이 없으나, 방화셔터의 부분 하강이 연기의 확산을 막고 있음을 알 수 있었다.

• Steel and Composite Structures
• /
• 제43권3호
• /
• pp.353-362
• /
• 2022

Bridge fire hazard has become a growing concern over the last decade due to the rapid increase of ground transportation of hazardous materials and resulting fire incidents. The lack of fire safety provisions in steel bridges can be a significant issue owing steel thermal properties that lead to fast degradation of steel properties at elevated temperatures. Alternatively, the development of composite action between steel girders and concrete decks can increase the fire resistance of steel bridges and meet fire safety requirements in some applications. This paper reviews the fire problem in steel bridges and the fire behavior of composite steel-concrete bridge girders. A numerical model is developed to trace the fire response of a typical bridge girder and is validated using measurements from fire tests. The selected bridge girder is composed by a hot rolled steel section strengthened with bearing stiffeners at midspan and supports. A concrete slab sitting on the top of the girder is connected to the slab through shear studs to provide full composite action. The validated numerical model was used to investigate the fire resistance of real scale bridge girders and the effect of the composite action under different scenarios (standard and hydrocarbon fires). Results showed that composite action can significantly increase the fire resistance of steel bridge girders. Besides, fire severity played an important role in the fire behavior of composite girders and both factors should be taken into consideration in the design of steel bridges for fire safety.

• 한국화재소방학회:학술대회논문집
• /
• 한국화재소방학회 1997년도 International Symposium on Fire Science and Technology
• /
• pp.423-438
• /
• 1997

Today's building and fire prevention codes are mostly prescriptive. Prescriptive codes are based on major fires in earlier years that created a need for specific building provision. These codes provide a minimum level of safety. As the general and engineering uses of computers have increased over the years, so has use of computers in the fire protection engineering. This has allowed fire protection engineers to develop alternative approaches to solve today's fire protection problems or to evaluate the performance of a specific fire safety goal. A performance based approach to building and fire codes involves the following: 1) identifying specific goals, such as, safely getting out of the building in 10 minutes, 2) obtain conceptual approval from authorities, 3) define performance level, 4) develop design solutions and identify tools such as, fire tests, models, or methods, to demonstrate that a design will meet the fire protection objective 5) test solutions, 6) present test method and results to the authorities. Some people in the fire protection community consider this to be nothing more than an intellectual exercise, while the others view it as a way to reduce expenses on large project$^4$ Others in fire protection community view this as a way to refine the design process to design fire protection systems to better protect the fire hazards. This paper will focus on application of these tools, specifically computer fire models, to actual cases such as: design of a smoke control system heat transfer analysis and egress of building occupants during potential fires.

• 한국안전학회지
• /
• 제24권3호
• /
• pp.13-18
• /
• 2009

This paper is purposed to develop DAQ H/W, S/W and DB which can be used in developing electrical fire alarm system or in analyzing electrical fire cause, by detecting and monitoring precursor signals which have high possibility leading to electrical fire on electrical distribution wires. In this paper, developed was DAQ H/W adopting the C8051FXXX CPU which can analyze the measurement signals of current and voltage in electrical distribution wires, other CPU was investigated in view of the best digital sampling rate on the basis of previous researches for electrical fire alarm system. Also, the S/W which can interface with DAQ H/W's communication protocol and can be applied for electrical fire causes analysis, are embodied by LabVIEW. The combined DAQ H/W and S/W could analyze efficiently normal as well as abnormal electrical signals such as RMS value, instantaneous value of current and voltage, frequency signals etc, on the electrical wires. Also, DB system was constructed for recording various analysis results for precursor signals including voltage and current signals. The results by simulator and experiment showed that the suggested scheme with DAQ H/W, S/W and DB in this paper has high usability.

• 한국멀티미디어학회논문지
• /
• 제19권2호
• /
• pp.180-188
• /
• 2016

In this paper, we propose a fire detection algorithm based on motion information and color information analysis. Conventional fire detection algorithms have as main problem the difficulty to detect fire due to external light, intensity, background image complexity, and little fire diffusion. So we propose a fire detection algorithm that accurate and fast. First, it analyzes the motion information in video data and then set the first candidate. Second, it determines this domain after analyzing the color and the domain. This algorithm assures a fast fire detection and a high accuracy compared with conventional fire detection algorithms. Our algorithm will be useful to real-time fire detection in real world.