• Proceedings of the Optical Society of Korea Conference
• /
• 2000.02a
• /
• pp.8-9
• /
• 2000

최근 광통신 분야의 발전을 바탕으로 경제적이고 간편한 밀리미터파의 발생, 변조 및 검파를 위한 밀리미터파-Photonics 기술연구가 활발히 진행되고 있다. 이러한 밀리미터파-Photonics 시스템을 구현하기 위해서 필요한 중심 부품중에 하나가 고출력, 광대역 광 검출기이다. 이러한 요구조건을 만족시키는 광 검출기로서 VMDP(Velocity Matched Distributed Photodetector)는 기존의 광 검출기 구조에 비해 월등한 성능을 나타내고 있다. 기존에 AlGaAs/GaAs를 이용해서 0.86$mu extrm{m}$에서 작동하는 VMDP가 제시되었으나 이 형태는 현 광통신 시스템에 적용하기에는 부적당한 파장대역이다. 이에 본 연구에서는 InGaAsP/InP를 기반으로 1.55$\mu\textrm{m}$에서 작동하는 VMDP를 설계하고자 한다. (중략)

• Journal of the Korean Vacuum Society
• /
• v.17 no.4
• /
• pp.353-358
• /
• 2008

In order to increase extraction efficiency of AlGaInP-based vertical RED LEDs, chemical wet etching technique was produced by using a roughened surface with triangle-like morphology. A commonly used $H_3PO_4$-based solution was applied for chemical wet etching. The light extraction of AlGaInP LED was related to the n-side roughed surface morphology. The morphology of roughed surface is analyzed by the atomic force microscope (AFM). As a result, the roughed surface AlGaInP LED has a root-mean-square (RMS) roughness of 44 nm. The brightness shows 41% increase after roughening n-side surface, as compared to the ordinary flat surface LED.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.48 no.11
• /
• pp.1-8
• /
• 2011

One of the most important parameters that limit maximum output power of transistor is breakdown. InAlAs/InGaAs/GaAs Metamorphic HEMTs (MHEMTs) have some advantages, especially for cost, compared with InP-based ones. However, GaAs-based MHEMTs and InP-based HEMTs are limited by lower breakdown voltage for output power even though they have good microwave and millimeter-wave frequency performance with lower minimum noise figure. In this paper, InAlAs/$In_xGa_{1-x}As$/GaAs MHEMTs are simulated and analyzed for breakdown. The parameters affecting breakdown are investigated in the fabricated 0.1-${\mu}m$ ${\Gamma}$-gate MHEMT device having the modulation-doped $In_{0.52}Al_{0.48}As/In_{0.53}Ga_{0.47}As$ heterostructure on the GaAs wafer using the hydrodynamic transport model of a 2D commercial device simulator. The impact ionization and gate field effect in the fabricated device including deep-level traps are analyzed for breakdown. In addition, Indium mole-fraction-dependent impact ionization rates are proposed empirically for $In_{0.52}Al_{0.48}As/In_xGa_{1-x}As$/GaAs MHEMTs.

• Proceedings of the IEEK Conference
• /
• 2003.07b
• /
• pp.1073-1076
• /
• 2003

This paper shows the performance as a photodetector of InP/InGaAs HPT operated with a base bias and forntside optical injection through the emitter. InP/InGaAs HPT produced the high optical gain of about 16.2 where HPT is biased at Vc=1V, I$_{B}$=20$\mu$A with an input optical power of 2.4$\mu$W. And we examined that the optical gain of HPTs becomes larger when operating in 3-terminal configuration rather than 2-terminal with the floating base. The optical performance of InP/InGaAs HPT is an attractive to the PIN Photodetector for use in long wavelength optical receivers.s.

• Proceedings of the Optical Society of Korea Conference
• /
• 2000.02a
• /
• pp.10-11
• /
• 2000

광통신을 이용한 근거리 전송과 장거리 전송에서 1.3 및 1.55 $mu extrm{m}$ 파장 영역의 빛이 사용되고 있다. 향후, 각 가정마다 광선로를 연결하는 Fiber-to-the-home (FTTH)의 개념과 광CATV가 발전함에 따라 1.3 및 1.55 $\mu\textrm{m}$ 빛을 검출하는 소자와 송신하는 소자가 필요하게 된다. 본 논문에서는 이러한 다중파장을 검출할 수 있는 집적소자를 제작 및 측정하였다. 본 논문에서 사용된 epitaxial layer의 구조는 N-InP 기판 위에 1 $\mu\textrm{m}$의 n-InP buffer층, 5층의InGaAs/InGaAsP 다중양자우물과 0.2 $\mu\textrm{m}$ InGaAsP separate confinement heterostructure (SCH) 층, 0.5$\mu\textrm{m}$ InP clad층과 0.1 $\mu\textrm{m}$ InGaAs cap 층으로 구성되어있다. 모든 epi 층은 InP 기판에 격자 정합이 되어있다. 다중양자우물구조는 84 $\AA$의 InGaAs 우물층과 100 $\AA$의 InGaAsP 장벽층으로 구성되며, 상온에서 0.787 eV (1.575 $\mu\textrm{m}$)의 bandgap energy를 갖도록 설계하였다. (중략)

• Journal of the Korean Vacuum Society
• /
• v.20 no.5
• /
• pp.345-355
• /
• 2011

GaAs-based metamorphic high electron mobility transistors (MHEMTs) and InP-based high electron mobility transistors (HEMTs) have good microwave and millimeter-wave frequency performance with lower minimum noise figure. MHEMTs have some advantages, especially for cost, compared with InP-based ones. In this paper, InAlAs/InxGa1-xAs/GaAs MHEMTs are simulated for DC/RF small-signal analysis. The hydrodynamic simulation parameters are calibrated to a fabricated 0.1-${\mu}m$ ${\Gamma}$-gate MHEMT device having the modulation-doped $In_{0.52}Al_{0.48}As/In_{0.53}Ga_{0.47}As$ heterostructure on the GaAs substrate, and the simulations for RF small-signal characteristics are performed, compared with the measured data, and analyzed for the devices. In addition, the simulations for the DC/RF characteristics of the MHEMTs with different gate-recess structures are performed, compared and analyzed.

• Korean Journal of Materials Research
• /
• v.4 no.6
• /
• pp.687-694
• /
• 1994

Heteroepitaxial InP/GaAs layers were grown using the selective liquid phase epitaxy (SLPE) technique. It was observed that the optimum LPE conditions were $660^{\circ}C$ growth temperature, $5^{\circ}C$ supercooling, and $0.4^{\circ}C$/min cooling rate. Maximum expitaxial layer overgrowth (ELO) of 110-160$\mu \textrm{m}$ was obtained when the seed was aligned along (112) orientation. Initial melt-back of the substrate was observed but limited to the seed region so that flat In-Ga-As-P layers were grpwn throughout the GaAs substrates. The InP/GaAs heteroepitaxial structure could be obtained by growing an additional InP layer on top of the In-Ga-As-P layer.

• Journal of the Korean Institute of Telematics and Electronics D
• /
• v.36D no.3
• /
• pp.66-74
• /
• 1999

InAlGaAs/InGaAs HBTs with the various emitter junction gradings(xf=0.0-1.0) and the modified collector structures (collector- I;n-p-n, collector-II;i-p-n) are simulated and analyzed by HMC (Hybrid Monte Carlo) method in order to find an optimum structure for the shortest transit time. A minimum base transit time($ au$b) of 0.21ps was obtainsed for HBT with the grading layer, which is parabolically graded from $x_f$=1.0 and xf=0.5 at the emitter-base interface. The minimum collector transit time($\tau$c) of 0.31ps was found when the collector was modified by inserting p-p-n layers, because p layer makes it possible to relax the electric field in the i-type collector layer, confining the electrons in the $\Gamma$-valley during transporting across the collector. Thus InAlGaAs/InGaAs HBT in combination with the emitter grading($x_f$=0.5) and the modified collector-III showed the transit times of 0.87 psec and the cut-off frequency (f$\tau$) of 183 GHz.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2012.02a
• /
• pp.441-441
• /
• 2012

Franz Keldysh Oscillation (FKO)은 p-n 접합 구조의 Photoreflectance (PR) spectra에서 표면 및 계면의 전기장(electric field) 특성을 반영한다. InAs/GaAs 양자점 태양전지(Quantum Dot Solar Cell, QDSC) 구조에서 InAs 양자점 층 전후에 AlGaAs 층을 삽입하여 퍼텐셜 장벽(potential barrier) 두께에 따른 PR spectra 및 GaAs-matrix에서 FKO 주파수 특성을 비교 분석하였다. InAs/GaAs 양자점 태양전지는 p-i-n 구조의 i-GaAs에 2.0 monolayer (ML), 8주기의 InAs 양자점 층을 삽입하여 Molecular Beam Epitaxy (MBE) 방법으로 성장하였다. 각 양자점 층 전후에 두께가 각각 0.0, 1.6, 2.8, 6.0 nm인 AlGaAs 층을 삽입하여 퍼텐셜 장벽 두께에 따른 FKO 주파수 변화를 관측하였다. 또한 태양전지 구조의 전기장 분포를 좀 더 용이하게 관측하기 위해 여기 광의 세기(power intensity)를 충분히 낮추어 Photovoltaic effect에 의한 내부 전기장의 변화를 최소화하여 비교 분석하였다. InAs/GaAs 양자점 태양전지 구조에서 AlGaAs 장벽층이 없는 경우, PR spectra의 Fast Fourier Transform 결과에 반영되는 FKO 주파수 특성은 p-i-n 구조 계면에서 공핍층(depletion region)의 space charge field보다 양자점 층의 내부 전기장에 의한 FKO 주파수가 더 큰 진폭(amplitude)을 보였다. 반면에, AlGaAs 장벽층이 삽입되면 두께가 커짐에 따라 p-i-n 구조 계면의 space charge field에 의해 더 큰 진폭의 FKO 주파수가 관측되었다. 이는 AlGaAs 장벽층이 삽입됨으로써 양자점 층 내 양자 상태 수 및 여기광에 의한 캐리어의 수와 관련이 있음을 확인하였으며, 결과적으로 GaAs-matrix에서 p-i-n 구조 계면의 space charge field에 영향을 미치게 됨을 알 수 있다. 이러한 PR 특성 결과들을 InAs/GaAs 양자점 태양전지의 설계 및 제조에 반영함으로써 양자효율 증대에 기여할 것으로 기대된다.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.15 no.1
• /
• pp.68-72
• /
• 2004

The integrated voltage-controlled-oscillator(VOC) operating at 1.75 ㎓ is designed using the InGaP/GaAs HBT process. The proposed noise removal circuit and FR-4 substrate structure in this letter show the better characteristic of the phase noise and reduce the size of the VCO. The frequency tuning range of the VCO is about 200 ㎒ and the phase noise at 120 ㎑ offset is -119.3 ㏈c/㎐. The power consumption of the VCO core is 11.2 ㎽ at 2.8 V supply voltage and the output power is -2 ㏈m. The calculated figure of merit(FOM) is 191.7, which shows the best performance compared with the previous FET or HBT VCO.