• 한국표면공학회지
• /
• 제46권6호
• /
• pp.242-247
• /
• 2013

Zr-Al-N coatings were synthesized by the hybrid coating system combining arc ion plating and DC magnetron sputtering from a Zr and an Al target in argon-nitrogen atmosphere, respectively. By changing the power applied on the Al cathodes, the Zr-Al-N coatings with various Al contents were deposited. The microstructure and chemical compositions of the Zr-Al-N coatings were studied by X-ray diffraction (XRD), high-resolution transmission electron microscopy (HRTEM). With increasing of Al content in the coatings, the solid solution (Zr, Al)N crystallites were observed in the Zr-Al-N coatings. The nanohardness of the Zr-Al-N coatings exhibited a maximum value of 42 GPa for the Zr-Al (7.9 at.%)-N, and decreased with further increase in Al content in the coatings. The oxidation and corrosion behavior of the Zr-Al-N coatings revealed better properties compared than those of ZrN coatings due to the formation of a solid solution.

• Corrosion Science and Technology
• /
• 제17권5호
• /
• pp.218-224
• /
• 2018

Alloy 617 is a candidate Ni-based superalloy for intermediate heat exchanger (IHX) of a high-temperature gas reactor (VHTR), because of its good creep strength and corrosion resistance at high temperature. Small amount of impurities such as $H_2O$, $H_2$, CO and $CH_4$ are introduced inevitably in helium, as a coolant during operation of a VHTR. Reactions of material and impurities are accelerated with increase of temperature to $950^{\circ}C$ of operating temperature of a VHTR, leading to material corrosion aggravation. In this circumstance, high-temperature corrosion tests were performed at $950^{\circ}C$ in air and impure helium environments, up to 250 hours in this study. Oxidation rate of $950^{\circ}C$ in an air environment was higher than that of impure helium, explained by difference in outer oxide morphology and microstructure as a function of oxygen partial pressure. An equiaxed Cr-rich surface oxide layer was formed in an air environment, and a columnar Cr-rich oxide was formed in an impure helium environment.

• Bulletin of the Korean Chemical Society
• /
• 제32권9호
• /
• pp.3443-3447
• /
• 2011

The spectroscopic behavior of catechin (5,7,3',4'-tetrahydroxyflavan-3-ol), has been studied in the presence and the absence of air using UV-vis absorption spectrophotometry and fluorescence spectroscopy. The UV-vis absorption spectrum of catechin shows a very sharp and strong absorption maximum peak at 275 nm in deaerated water. New absorption maximum peaks appeared in aerated water, as well as in basic aqueous solution, caused by the oxidation of catechin. The absorbances in the UV-vis absorption spectrum of catechin decreased when the solution was left in the dark for a long time. The fluorescence emission spectrum of catechin after a long time period differs markedly from that in freshly prepared solution; the fluorescence maxia shifted as time passes after adding catechin to the solutions. When the deaerated basic catechin solutions were left in the dark for a long time, their fluorescence quantum yields were found to be nearly zero. This suggests that the oxidized catechin molecules were seen to have slowly undergone successive chemical reactions in basic buffer solution.

• 대한전자공학회:학술대회논문집
• /
• 대한전자공학회 2001년도 하계종합학술대회 논문집(2)
• /
• pp.29-32
• /
• 2001

In this paper, the thermal oxidation behaviors and the electrical characteristics of the thermal oxide grown on SiC are discussed. For these studies the oxide layers with various thickness were on SiC in wet $O_2$ or dry $O_2$ at l15$0^{\circ}C$ and the MOS capacitors using the 350$\AA$ gate oxide grown in wet $O_2$ were fabricated and electrically characterized. It was found from the experimental results that the oxidation rate of SiC with the Si-face and with the carbon-face were about 10% and 50% of oxidation rate of Si. The C-V measurement results of the SiC oxide showed abnormal hysterisis properties which had ever been not observed for the Si oxide. And the hysterisis behavior was seen more significant when initial bias voltage was more negative or more positive. The hysterisis property of the SiC oxide was believed to be due the substantial amount of the deep level traps to exist at the interface between the oxide and the SiC substrate. The leakage of the SiC oxide was found to be one order larger than the Si oxide, but the breakdown strength was almost equal to that of the Si oxide.

• 한국산학기술학회논문지
• /
• 제6권3호
• /
• pp.270-272
• /
• 2005

코발트 실리사이드는 낮은 전기 저항성 때문에 고효율 소자를 제조하는데 적합한 물질이다. 이는 전자소재가 소형화되면서 접촉저항과 혼합을 줄이기 위해 더욱 필요하게 되었다. 본 연구에서는 티타늄의 표면산화에 미치는 영향과, RTO 조건에서 온도에 따른 코발트 실리사이드 박막의 산화정도를 측정했다. 기질로서 p-형 실리콘웨이퍼를 사용하였고, 고속 열 가공을 통하여 박막을 가공하였다. 티타늄 층을 입혔을 때 산화충의 두께는 $500{\AA}$정도 성장하였다. 고속 열산화의 온도변화에 따라 산화막은 $550^{\circ}C\~700^{\circ}C$까지는 성장을 보였으나 $700^{\circ}C$이상에는 산화막 성장이 포화상태를 보였다.

• 한국표면공학회지
• /
• 제47권4호
• /
• pp.147-154
• /
• 2014

Formation behavior of PEO (Plasma Electrolytic Oxidation) films on AZ31 Mg alloy was studied in aqueous solutions containing various concentrations of hydroxide ion ($OH^-$) and silicate ion ($SiO_3{^{2-}}$) by voltage-time curves, and corrosion resistance of the PEO film-covered specimen was investigated by immersion test in 0.5 M NaCl solution. From the analyses of the voltage-time curves, it is suggested that two different types of anions are essentially needed for the formation of PEO films on AZ31 Mg alloy: film formation agent and local film breakdown agent. $SiO_3{^{2-}}$ ion acts only as a film formation agent but $OH^-$ ion acts not only as a film formation agent but also film breakdown agent. The PEO films prepared on AZ31 Mg alloy in alkaline silicate solution showed very good corrosion resistance without any pitting or filiform corrosions up to 480 h of immersion in 0.5 M NaCl.

• 한국표면공학회:학술대회논문집
• /
• 한국표면공학회 2017년도 춘계학술대회 논문집
• /
• pp.151.2-151.2
• /
• 2017

본 연구에서는 정전류 조건에서 알루미늄 합금의 PEO(Plasma Electrolytic Oxidation) 피막 형성 거동에 미치는 전해질 내 cation($K^+$, $Na^+$)의 영향을 아크 발생 양상, 전압-시간 곡선 및 형성된 표면피막 구조를 관찰하여 연구하였다. 전해질은 0.5 M NaOH + 1 M $Na_2SiO_3$ 수용액과 0.5 M KOH + 1 M $Na_2SiO_3$ 수용액이 사용되었다. 아크 발생은 cation의 종류에 상관없이 동일하게 가장자리부터 시작되어 내부로 이동함으로써 전 표면에 걸쳐서 일어났다. 전 표면에서 PEO 피막이 형성된 이후에는 한 지점에서 지속적으로 아크가 발생하는 로컬버닝 현상이 두 용액에서 모두 관찰되었으나 $K^+$이온이 포함된 용액에서 로컬버닝이 빠르게 일어났다. 시편표면에서 아크가 발생하는 동안 중 각 전해액에서의 전압-시간 곡선에서 전압의 상승과 하강이 반복되는 거동이 동일하게 관찰되었다. 이러한 전압 등락의 크기는 $K^+$ 이온이 포함된 수용액에서 더 크게 나타났으며, 그 결과 표면 거칠기가 상대적으로 더 높은 PEO 피막이 형성되었다.

• Environmental Engineering Research
• /
• 제20권2호
• /
• pp.181-189
• /
• 2015

A composite material was tested to eliminate phenol in aqueous solution combining adsorption on activated carbon and photocatalysis with $TiO_2$ in two different ways. A first implementation involved a sequential process with a loop reactor. The aim was to reuse this material as adsorbent several times with in situ photocatalytic regeneration. This process alternated a step of adsorption in the dark and a step of photocatalytic oxidation under UV irradiation with or without $H_2O_2$. Without $H_2O_2$, the composite material was poorly regenerated due to the accumulation of phenol and intermediates in the solution and on $TiO_2$ particles. In presence of $H_2O_2$, the regeneration of the composite material was clearly enhanced. After five consecutive adsorption runs, the amount of eliminated phenol was twice the maximum adsorption capacity. The phenol degradation could be described by a pseudo first-order kinetic model where constants were much higher with $H_2O_2$ (about tenfold) due to additional ${\bullet}OH$ radicals. The second implementation was in a continuous process as with a fixed bed reactor where adsorption and photocatalysis occurred simultaneously. The results were promising as a steady state was reached indicating stabilized behavior for both adsorption and photocatalysis.

• 한국진공학회:학술대회논문집
• /
• 한국진공학회 2011년도 제41회 하계 정기 학술대회 초록집
• /
• pp.213-213
• /
• 2011

Gold catalysts supported on TiO2 have shown a unique catalytic behavior on CO oxidation, depending on surface effects. Particle size has an influence on the surface activity. To make monodisperse Au nanoparticles, organic capping ligands, such as alkylthiols, were used by a "greener" synthesis method [1,2] and Au nanoparticles were deposited on TiO2. However, organic capping ligands must be removed for high catalytic activities by the Au nanoparticles without changing the Au size [3]. We used UV ozone treatment to decompose thiol ligands. The samples have been characterized by X-ray photoelectron spectroscopy to examine the surface modification by UV ozone treatment. We show the size distribution of the gold nanoparticles by light scattering analysis and transmission electron microscopy. Au/TiO2 have been prepared using the wetness impregnation method. The catalytic performance of CO oxidation over Au supported on TiO2 under oxidizing reaction conditions (40 Torr CO and 100 Torr O2) were tested. The results show that the catalytic activity depends on particle size and the time of UV ozone exposure, which suggests the role of sulfur bonding in determining the catalytic activity of Au/TiO2 catalysts.

• 한국분말재료학회지
• /
• 제14권5호
• /
• pp.287-291
• /
• 2007

Oxidation behavior and microstructural characteristics of nano-sized Sn powder were studied. DTA-TG analysis showed that the Sn powder exhibited an endothermic peak at $227^{\circ}C$ and exothermic peak at $560^{\circ}C$ with an increase in weight. Based on the phase diagram consideration of Sn-O system and XRD analysis, it was interpreted that the first peak was for the melting of Sn powder and the second peak resulted from the formation of $SnO_2$ phase. Microstructural observation revealed that the $SnO_2$ powder, heated to $1000^{\circ}C$ under air atmosphere, consisted of agglomerates with large particle size due to the melting of Sn powder during heat treatment. Finally, fine $SnO_2$ powders with an average size of 50nm can be fabricated by controlled heat treatment and ultrasonic milling process.