• KIEAE Journal
• /
• v.16 no.3
• /
• pp.121-128
• /
• 2016

Purpose: The vacuum glazing should constantly retain the gap in vacuum state to maintain high thermal performance. To do so, pillars are used to prevent the glazing from clinging to each other by the atmospheric pressure and therefore surface of the vacuum glazing is consistently affected by residual stress. The vacuum glazing could be applied to curtain wall systems at spandrel area to fulfill a rigorous domestic standard on U-value of the external wall. However, this can lead to high glazing temperature increase by heat concentration at a back panel and finally thermal stress breakage. This study experimentally determined weakness of the vacuum glazing systems on the thermal stress breakage and investigated effect of the residual stress. Method: The experiment first built two scale-down mock-up facilities that replicate the spandrel area in curtain wall, and then installed single low-e glass and vacuum glazing respectively. The two mock-up facilities were exposed to outside to induce the thermal stress breakage. Result: The experiment showed that the temperature occurred the thermal stress breakage was $114.4^{\circ}C$ for the single low-e glass and $118.9^{\circ}C$ for the vacuum glazing respectively. The result also showed the vacuum glazing reached the critical point earlier than the single low-e glass, which means that the vacuum glazing has high potential to occur the thermal shock breakage. In addition, the small temperature difference between two glazing indicates that the residual stress scarcely affects breakage of the vacuum glazing.

• Journal of Korean Society of Forest Science
• /
• v.99 no.1
• /
• pp.57-61
• /
• 2010

Data with collected from 278 trees sampled through out the climatic range of Quercus acuta in Jeju Experiment Forests. The models tested to select the best-fit equations form the Max & Burkhart's model, Kozak's model, and Lee's model. Performance of the equations in predicting of residuals on predicted values. In result, all three models gave slightly better values of fit statistics. In plotting residuals against predicted diameter, Max & Burkhart's model showed underestimation in predicting small diameter and Lee's Model did the same in predicting small diameter. Based on the above analysis of three models in predicting stem taper, Kozak's model was chosen for the best-fit stem taper equations, and its parameter estimates was given for Quercus acuta. Kozak's model was used to develop a stem volume table outside bark for Quercus acuta.

• Journal of Korean Society of Water and Wastewater
• /
• v.25 no.3
• /
• pp.383-390
• /
• 2011

In this study, a process combined biofiltration with sulfur-utilizing autotrophic denitrification and membrane separation was proposed to examine the efficiency of nitrogen removal. As an experimental device, hollow-fiber module was installed in the center of reactor to generate the flux forward sulfur layer in the cylinder packed with granular sulfur. In addition, a simple module was installed in activated sludge aeration tank which inside and outside of sulfur-using denitrification module was covered with microfilter and the module was considered as an alternative of clarifier. The experiment for developing new MBR process was carried out for three years totally. As the results of first two-year experiment, successful nitrogen removal performance was revealed with lab-scale test and pliot scale plant using artificial wastewater and actual plating wastewater. In this year, pilot scale test using actual domestic wastewater was performed to prove field applicability. As the results, high-rate nitrogen removal performance was confirmed with about 0.19 kg ${NO_3}^--N/m^3$ day of rate. Also significant fouling and pressure increase were not found during the experiment. And, the production ratio of sulfate and the consumption ratio of alkalinity showed a slightly higher value about 311 mg ${SO_4}^{2-}/L$ and 369 mg $CaCO_3$/L, respectively. In conclusion, the developed MBR process can be utilized as an alternative for retrofiting existing wastewater plants as well as new construction of advanced sewage wastewater treatment plants, with cost-effective merit.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.65 no.6
• /
• pp.1001-1006
• /
• 2016

As consumption of energy is increasing rapidly, energy saving is emphasized in nowadays. Thermal power plant occupies a large proportion in various type of power plant. Major causes of decreased power generation efficiency on thermal power stations is deposition of fly ash. Soot Blower is a facility to remove the ash which is deposited outside of tube by steam blowing on boiler. Residual stream which caused by lance tube in soot blower cannot be discharged steam effectively in lance tube causes reducing the thickness of lance tube. On the contrary, increasing discharge ratio of steam, lance tube cannot sustain proper pressure to remove ash on tube. This study suggests increasing discharge ratio of steam with proper pressure to remove ash on tube by optimization on shape of lance tube nozzle. To optimize shape of nozzle, discharge ratio and maximum blowing pressure on nozzle is selected as object functions. Diameter of nozzle, distance between nozzles, angle of nozzle and gap between nozzle is selected as design parameters. Then the design of experiment (DOE) with an orthogonal array is performed to analyze the effect of design parameters. And grey relational analysis and analysis of mean (ANOM) is performed to optimize shape of lance tube.

• Asian-Australasian Journal of Animal Sciences
• /
• v.18 no.4
• /
• pp.463-469
• /
• 2005

An attempt was made to analyze the factors affecting mating performance of rams in pen mating systems. Due to many types of social interactions, mating performance of rams may decrease or increase. Six intact Muzaffarnagari rams were used and divided into three dominant subordinate pairs by food and ewe competition test. For dominant rams subordinate ram became competitor and vice versa. In the first experiment, ram was exposed to ewe but the competitor ram was kept outside the pen with the facility of visibility only. In the second experiment each ram was exposed to ewe along with the competitor ram and in third experiment ram was exposed to ewes (two) along with competitor ram in observation pen. Recordings of different mating and agonistic behaviour were done in all the experiments. It was found that subordinate ram's mating behaviour was inhibited by mere presence of a dominant ram out side without physical contact. However, when ram exposed to oestrus ewe(s) along with competitor ram, both dominant and subordinate rams spent much of their time in guarding activities instead of mating. In addition dominant ram tried to curtail the subordinate ram mating by agonistic interaction like fight and butting. Different guarding activities were observed either as active or passive type depending on level of dominanace. It was concluded that in a limited space the interaction of two or more rams might affect the number of services adversely.

• Journal of the Korean Solar Energy Society
• /
• v.22 no.3
• /
• pp.39-46
• /
• 2002

The results of experiment on the performance of natural ventilation by insulation thickness and height system of solar chimney are described. The 3-inside wall was made of concrete and 1-wall was made of glass. The two kinds of model experiment were performed. One was the varition of the 60cm, 90cm and 120cm of solar chimney, the other was the variation of the insulation thickness 10mm and 50mm and without insulation of outside wall of solar cimney. As the temperature difference between bottom and top expressed $1.7\sim2.9^{\circ}C$, air velocity measured $0.5\sim0.8m/s$ and ventilation rate was $194.4m^3/h$ in the case of the 120cm height of solar chimney, the respect of natural ventilation performance was superior to others cases in the first model experiment. Though the case of 120cm height of solar chimney was attached 50mm insulation the ventilation rate was not so much as the case of solar chimney was attached 10mm insulation. the temperature difference between bottom and top was the largest in the other cases. From this research, the natural ventilation performance of solar chimney was affected by not only height and insulation thickness of solar chimney but also wind velocity and directon.

• Journal of Educational Research in Mathematics
• /
• v.24 no.3
• /
• pp.333-357
• /
• 2014

This study resulted from a study regarding creative STEAM System based upon an experiment with the center of gravity. The results of the study are constructed by a fusion of mathematics and physics, showing that they are the same as mathematical calculations. Also, students can find that center of gravity of an object is in equilibrium on a metal rod when the center of gravity exactly is placed on the rod. The fact that an experimental results are correspond to calculations can maximize the effectiveness of teaching. And also this study has the following effectiveness. First, the exact construction and calculations arouses good competition among students. Second, this experiment can give students a motivation for study and increase their thinking in classes because the theoretical background of center of gravity experiment is basically attributed to math and science classes in school. This study includes three different types of center-of-gravity experiments. One is a simple type of experiment in which center of gravity exists inside of an object. Another is a complicated one in which the center of gravity is also inside of an object. However, the third type is an experiment in where the center of gravity is outside of an object. Therefore, it gives students an opportunity to discuss how to confirm equilibrium on a metal rod when the object has its center of gravity outside. Having discussions in class will allow students to have a critical way of thinking. In addition, searching for a way to solve a problem will increase creativity of students as well. And the last type is finding the center of gravity of a big acrylic panel where multiple objects are on the panel. According to the survey and interview conducted by students who participated in this program, teaching based on creative STEAM system helps students to get a better understanding and more fast acquisition of knowledge. We can expect that a well-planned creative STEAM system through a continuous study will be both effective and efficient in educating critical and creative students.

• Journal of Bio-Environment Control
• /
• v.20 no.2
• /
• pp.72-77
• /
• 2011

The objective of the present study is to provide the basic data necessary for estimating the overall heat transfer coefficient of commercial plastic greenhouse. The heat flow through covering of greenhouses was measured and the variation of overall heat transfer coefficient was analyzed. Because the inside-outside temperature difference of greenhouse to indicate the stabilized overall heat transfer coefficient was different depending on the number of covering layers, the actual overall heat transfer coefficient should be decided in range of inside-outside temperature difference to make the coefficient constant for each covering method. The variation trend of the overall heat transfer coefficient according to the inside-outside temperature difference corresponded with the existing research results, but the specific values of temperature difference to present the stabilized overall heat transfer coefficient were different each other. The increase rates of overall heat transfer coefficient with wind speed were quite dissimilar among several research results and the quantity of heat loss through covering according to the wind speed in the double layers covered or curtained greenhouse was less than that in the single layer covered greenhouse. Because there was large variations among the values of overall heat transfer coefficient for the polyethylene film greenhouses, it was required to establish the standardized environmental condition for experiment measuring heat flow through covering in commercial greenhouse.

• Korean Institute of Interior Design Journal
• /
• v.25 no.2
• /
• pp.21-29
• /
• 2016

This study has estimated the traits of conscious eye moving with the objects of the halls of subway stations. For that estimation, the observation data from eye-tracking were matched with the experiment images, while an independent program was produced and utilized for the analysis of the eye moving in the selected sections, which could provide the ground for clarifying the traits of space-users' eye moving. The outcomes can be defines as the followings. First, The application of the independently produced program provides the method for coding the great amount of observation data, which cut down a lot of analysis time for finding out the traits of conscious eye moving. Accordingly, the inclusion of eye's intentionality in the method for extracting the characteristics of eye moving enabled the features of entrance and exit of particular objects with the course of observing time to be organized. Second, The examination of eye moving at each area surrounding the object factors showed that [out]${\rightarrow}$[in], which the line of sight is from the surround area to the objects, characteristically moved from the left-top (Area I) of the selected object to the object while [in]${\rightarrow}$[out], which is from the inside of the object to the outside, also moved to the left-top (Area I). Overall, there were much eye moving from the tops of right and left (Area I, II) to the object, but the eye moving to the outside was found to move to the left-top (Area I), the right-middle (Area IV) and the right-top (Area II). Third, In order to find if there was any intense eye-moving toward a particular factor, the dominant standards were presented for analysis, which showed that there was much eye-moving from the tops (Area I, II) to the sections of 1 and 2. While the eye-moving of [in] was [I $I{\rightarrow}A$](23.0%), [$I{\rightarrow}B$](16.1%) and [$II{\rightarrow}B$](13.8%), that of [out] was [$A{\rightarrow}I$](14.8%), [$B{\rightarrow}I$](13.6%), [$A{\rightarrow}II$](11.4%), [$B{\rightarrow}IV$](11.4%) and [$B{\rightarrow}II$](10.2%). Though the eye-moving toward objects took place in specific directions (areas), that (out) from the objects to the outside was found to be dispersed widely to different areas.

• The Journal of the Convergence on Culture Technology
• /
• v.10 no.2
• /
• pp.201-208
• /
• 2024

In this study, we investigated whether the evacuation time according to the exit installation standards specified in the building code during a food factory fire is compatible with the evacuation time based on the performance-based design specified by the fire department, in order to determine if evacuation safety is ensured. We used the Pathfinder program to confirm the evacuation time, and experimented with three scenarios for exit installation standards towards the outside of the building: 60m, 80m, and 100m. The target building in the experiment corresponded to the building code's exit installation standard of 100m from each dwelling. The experimental results showed tt in the cases of 80m and 100m, ASET exceeded RSET, indicating tt evacuation safety was not ensured, while in the case of 60m, evacuation safety was maintained. Through this study, it was confirmed tt even when the exit installation standards towards the outside of the building are met, evacuation safety may not be guaranteed.