• Journal of the Korean institute of surface engineering
• /
• v.15 no.3
• /
• pp.127-137
• /
• 1982

In chemical plating of nickel and chromium on steel, studies on various factors affect-ing the plating operations were carried out. The optimum bath compositions and operat-ing conditions were obtained. The structure and properties of the as deposits or deposits after heat treatment were investigated. (1) The most optimum conditions for the chemical nickel and chromium plating were; 〔Ni2+〕/〔H2PO2-〕; 0.5∼0.8, 〔Cr3+〕/〔H2PO2-〕; 0.6∼0.9 PH;5.0∼5.5, temperature; 90∼95$^{\circ}C$ (2) In the case of nickel deposition, the hardness of deposits increased with increasing phosphorous contents. Heat-treating at the temperature range 200$^{\circ}C$ to 600$^{\circ}C$, the maximum hardness of deposits was obtained at 400$^{\circ}C$ and decreased at temperature above 400$^{\circ}C$ due to growth of Ni3P. (3) Corrosion resistance of chemical nickel deposits was improved with increasing of p-hosphorous contents and heat treating temperature.

• Proceedings of the Korea Contents Association Conference
• /
• 2006.05a
• /
• pp.444-447
• /
• 2006

We propose software reliability growth model, considering testing effort resource during testing stage of S/W, and compare the time dependent testing effort resource behavior in this paper. We develop the data technology method for the S/W reliability measure. We study in detail between the time elapse and reliability. Also, we determine the optimum release time which meets the target reliability. We decide optimum release time for each condition how the reliability is good before testing after development.

• Journal of the Korea Concrete Institute
• /
• v.12 no.5
• /
• pp.93-99
• /
• 2000

The physical properties of freshly mixed steel fiber reinforced recycled concrete(SFRRC) were_investigated. Physical state and quality of fresh concrete were monitored batch by batch. the properties of freshly mixed SFRRC were determined in terms of slump, air content, superplasticizer, and bleeding ratio. Concrete mixtures were produced for three kinds of aggregate proportions. So, the experimental variables are various aggregate proportions, steel fiber contents(0, 0.5, 1.0, 1.5%) and steel length(30, 50, 60mm). From experimental results, optimum s/a by various experimental variables, variations of the slump by the air contents, and optimum superplasticizer to decrease unit water were presented.

• Journal of the Korean Society of Tobacco Science
• /
• v.17 no.2
• /
• pp.149-159
• /
• 1995

The freeze drying rate was investigated under various conditions such as pressure and moisture contents in order to establish the optimum condition for expansion of the culled flue cured tobacco lamina. The optimal pressure in the chamber to maintain the heat and mass transfer was about 0.8torr, When the moisture contents of sample was 50-60%, expanding rate was the optimum condition and the rate was 67-76%. As the thickness of the sample layers was increased, drying-rate was decreased conversely and this result seemed to be due to decline of heat and mass transfer coefficients. Differences with the position of its stalk were also observed in drying rate, and low stalk position leaves of 5 and 3 was the fastest. Key words : freeze drying, Popping, expansion tobacco.

• Journal of Ginseng Research
• /
• v.6 no.2
• /
• pp.149-153
• /
• 1982

To investigate the effect of light intensity on the growth of shoots and roots, water and chlorophyll contents in the ginseng leaf were determined at 5%, l0%, 20%, 30% light transmittance rate (LTR) with 1,2 and 4 year-old ginseng plants in the field. Stem length, size of the leaf, water and chlorophyll contents were decreased as the increase of the light intensity in all ages of ginseng plants. The degree of decrease was severe in the one year-old ginseng compared to that of 2, or 4 year-old ginseng, while there was no difference between the 2 and 4 year-old plants. Root weight per plant was highest at 5% LTR in the one year-old plants, while it was at 20% LTR in the 2 and 4 year-old plants. Generally, demand of light for the growth of one year-old ginseng was lower than those of 2 or 4 year-old plants there was no difference of it among the ginseng plants older than 2 years.

• Journal of Industrial Technology
• /
• v.29 no.A
• /
• pp.145-153
• /
• 2009

In this study, to determine characteristics of compaction and the soil water characteristic curve(SWCC) in decomposed granitic soils, compaction tests and SWCC tests were carried out for samples having various contents of coefficient of uniform($c_u$), By compacting their samples with standard Proctor density test, the effects of binder contents on maximum dry density and optimum moisture content were investigated and compared. Samples compacted with the maximum dry density and the optimum moisture content were tested by means of the SWCC, to determine their SWCC parameters, such as Brooks & Corey(${\lambda}$, ${\Psi}_b$), Van Genuchten (${\alpha}$, n, m), Fredlund & Xing(a, n, m).

• Journal of Environmental Health Sciences
• /
• v.3 no.1
• /
• pp.9-12
• /
• 1976

A study was performed to find out the fluoride contents in surface and ground waters from June, 1973 to July, 1974. Water samples were collected from 53 surface and ground water sources. The results are as follows: 1. Out of 53 samples, the ground water of Hwaengsung had the highest fluoride contents (1.6 mg/l) and 13 samples did not. have fluoride at all. 2. The waters from Yoju (ground), Chongnung (ground) Hwaengsung (ground) and Namyang (ground) had optimum fluoride level (0.6~1.7mg/l) for the prevention of dental caries. 3. The ground waters had more fluoride contents than surface waters and the waters of coastal areas had less fluoride contents than those of inland. 4. The waters of Kangwon province had the most fluoride contents (mean 0.57mg/l) and the waters of Cheju do had the least fluoride contents (mean 0.06 mg/l)

• Proceedings of the Materials Research Society of Korea Conference
• /
• 1997.10a
• /
• pp.166-166
• /
• 1997

• Journal of The Korean Society of Grassland and Forage Science
• /
• v.15 no.4
• /
• pp.274-278
• /
• 1995

This experiment was conducted to know what does the cutting date have an effect on the chemical composition and nutritive yield of Miscanthus sinensis, in order to determine the optimum cutting date of the plant when it is utilized as roughage. Miscanthus sinensis growing natively in the summit of Sam Ak mountain(550m above sea level) was cut at 10 days intervals from 25 July to 15 October, 1988. Plant length and dry matter contents were generally increased with delayed cutting date. Crude protein contents of the plant cut on 5, 15, and 25 of September were 5.5, 5.2 and 5.1%, respectively. Cmde fiber contents was similar with cutting treatment and averaged 35.6%. Cmde protein yield was higher in September than in other cutting date. Yield of crude fiber were 8.3, 9.3 and 9.3t/ha on 5, 15 and 25 September, respectively. Ratio of Cmde protein yield to Crude fiber yield on 5 September tended to be higher than on 15 September and 25 September. These results suggest that the optimum cutting date of the Miscanthus sinensis for good quality forage seems early September.

• Journal of Plant Biology
• /
• v.34 no.4
• /
• pp.289-296
• /
• 1991

Cultures of hairy root induced from ginseng(Panax C.A. Meyer) transformed with Agrobacterium rhizogenes (strain A4, ATCC 15834) were established and morphologically two different hairy root strains (HB1, HB2) were obtained. To determine the optimum growth rate, the hairy root (HB2) was cultured in various liquid medium supplemented with or without plant growth hormone. The growth rate of hairy root cultured on MS medium was 1.3-3.1 times higher than those cultured on other media, and the optimum sucrose concentration and pH were 3-6%, 5.5-6.5, respectively. Also, the growth rate of hairy root was increased when 0.02 M ammonium nitrate, 1.2 mM potassium phosphate (monobasic) and 0.5 mg/l IBA were supplied to liquid medium. The saponin patterns and contents of hairy root (HB2) were determined by TLC and HPLC. The crude saponin contents were 4.67% and the total saponin contents were 1.0%, on dry weight basis.