• Journal of Environmental Science International
• /
• v.8 no.5
• /
• pp.607-610
• /
• 1999

The odor removal of landfill site leachate was carried out using pyroligenous liquid. The constituent elements of pyroligenous liquid and leachate were also analysed, employing Atomic Absorption Spectroscopy(AAS). Before order removal, the heavy metal ions such as Pb, Zn, Cu, Mn, Fe and Ni, in pyroligenous liquid were detected with ultra trace level. However, in this liquid, other metal ions such as As, Hg and Cd were not observed. The optimum condition for removing odor fromthe leachate was observed in 15 times dilution of pyroligenous liquid. Also, the degree of outlet odor was 1. Furthermore, the concentration of odor constituent compounds, e.g. $H_2S, NH_3, NH_2$ and $CO_2$ in the leachate was remarkably reduced. Finally, water quality of the leachate was improved.

• Journal of Korean Society of Water and Wastewater
• /
• v.8 no.2
• /
• pp.12-24
• /
• 1994

The occurrence of objectionable tastes and odors in drinking water is a common and widespread problem. The most troublesome odors are usually those described as muddy or earthy-musty. Two organic compounds which have been implicated as the cause of earthy-musty odor problems in water are geosmin and 2-Methylisoborneol. These earthy-musty organics have been shown to be metabolites of actinomycetes and blue green algae. The purpose of this paper is to describe adsorbability in removing these two oder causing compounds(geosmin and 2-MIB) upon various conditions like pH variation, adding humic acid and different activated carbon. The conclusion of this study are as followings. In batch test, carbon dosage is 10mg/100ml for geosmin and 15mg/100ml for 2-MIB. Both were in equilibrium state after 60 hours. In model simulation, F-P model described experiment data and modelling data appropriately in geosmin but F-S model not. In case of 2-MIB, models didn't describe relation between experiment and modelling data well. Two causative agents of earthy-musty odor compounds, geosmin and 2-MIB, are strongly adsorbed by activated carbon either coconut or brown. There appears to be no effect of pH (3,7,9) on adsorption of these two organics. Activated carbon proved to be more effective for removing geosmin than for removing 2-MIB. When activated carbon is. used in removing these two organics, the removal of these appeared to be adversely affected by back ground organic compounds, such as humic substances, due to competitive adsorption.

• Journal of Animal Environmental Science
• /
• v.14 no.1
• /
• pp.1-8
• /
• 2008

This study was conducted to solve the problem of public grievance owing to odor of a pig farm. Odor emissions from pig production systems mainly originate from liquid manure storage and solid manure fermentation. The low-cost odor abatement system (OAS) for application at liquid manure storage tank and solid manure fermentation facilities was developed in this study. The OAS adapted odor removing principles of a biofilter and biotrickling filter. The OAS is very simplified in structure. The appearance of the OAS had a form of cylindrical or cubical shape. The system performance was monitored for about one year after stabilization. A 7 seconds empty bed contact time for the OAS was adapted to achieve the odor reduction levels. The commercial type of OAS was constructed with media comprised of wood chips. Moisture content always remained above 50% wet basis. Average ammonia removal efficiency for the developed design was 89% at the liquid manure storage tank. Also, the removal efficiency at a solid manure fermentation facility was 86% on ammonia.

• Journal of the Korean Society of Safety
• /
• v.13 no.1
• /
• pp.92-97
• /
• 1998

Malodorous gases give discomfort and harm to laborers and residential neighborhoods and therefore, the removing odor materials emitted from plants and industrial facilities is important subject. The main ingredients of alkali odor are $NH_3$ and $CE_3SH$. The adsorption characteristics of odors were studied using four different activated carbon fibers(ACF) and active carbon(AC). Alkali odor was removed by using ACF impregnated with $H_3PO_4$ and $H_2SO_4$ and treated with $HNO_3$ and NaOH. The experimental result showed that ACF has a higher removal efficiency than AC. The adsorption capacity was increased with the impregnation and surface treatment, and $H_2SO_4$ was the best impregnant for the removal of alkali odor.

• Applied Chemistry for Engineering
• /
• v.20 no.2
• /
• pp.218-222
• /
• 2009

As we look into the related technologies at home and abroad, the odor and dust removal technologies did not make us satisfied because its removal method is not appropriate and its economical efficiency was low. If bad odor and dust were generated simultaneously, we should install two removal factories separately, and it made a big problem. Consequently, we investigated to obtain the related basic information for a new hybrid bag filter system which can remove both odor and dust at the same time, using bag filter with ACF (dual filter type).

• The Journal of Industrial Distribution & Business
• /
• v.9 no.12
• /
• pp.23-29
• /
• 2018

Purpose - The purpose of this study is to apply a cost effective ultrasonic odor reduction method that generated micro-bubbles using ejector to the Southeast Asian wastewater market. Research design, data, and methodology - A leather maker located in Ansan-city, Gyunggi-do, South Korea was sampled from the collection tank to select experimental materials. Experimental setup consisted of circulating water tank-air ejector-ultrasonic device, and circulating wastewater. Sample analysis was performed by CODcr, T-N, T-P, and turbidity by the National Environmental Science Institute. Results - Experimental results show that it is most effective in removing odors when the frequency range of ultrasonic wave is 60~80 Khz and the output is 200 W. It showed that the concentration of complex odor dropped from a maximum of 14,422 times to a minimum of 120 times. Also, analysis of ammonia and hydrogen sulfide in specific odor substances has shown that they were reduced from 1.5 ppm to 0.4 ppm and from 0.6 ppm to 0.1 ppm, respectively. Conclusions - It is possible to shorten more than 12 hours in the treatment of micro-organisms. It can be seen that the processing time of odor after ultrasonic treatment in the pre-treatment facility is reduced by 25% when compared to the resultant micro-organisms after the chemical treatment, that is, the time of the bio-treatment of micro-organisms. Based on the results, it was confirmed that the pre-treatment method using the ultrasonic and the air ejector device of the experiment shows the effect of reducing the water pollutants and odor more effectively in a relatively short time than the conventional advanced oxidation method.

• Journal of Korea Water Resources Association
• /
• v.30 no.3
• /
• pp.235-245
• /
• 1997

A pilot scale study for removing odor and trihalomethane formation potential (THMFP) was investigated in the standard water treatment plant equipped with ozone oxidation and granular activated carbon (GAC) adsorption processes. The removal efficiency of dissolved organic carbon (DOC) in the pilot scale standard water treatment process (PSWTP) was about 25%, however, no more removal in the ozone oxidation process. On a GAC after 30 days operation, DOC removal efficiency was about 75%. Odor removal efficiency was about 30% in PSWTP, 60% in ozone oxidation, and almost complete in well as DOC. Mid-1 and 2 that showed breakthrough in odor inducing material as well as DOC. Mid-1 and 2 chlorination was able to reduce trihalomethanes (THM) by 25% compared to prechloringation, while postchlorination alone could reduce them by 30%.

• Applied Chemistry for Engineering
• /
• v.20 no.5
• /
• pp.547-552
• /
• 2009

When fiber reinforced plastics (FRP) products are manufactured, dust and odor materials are inevitably generated in a workplace. To improve the bad condition of the workshop, we developed the Hybrid Bag Filter attached activated carbon fiber (ACF) and installed the system at two companies producing FRP goods. In order to raise the efficiency of dust collection, we set the ducts both on the ceiling and at the bottom of the wall and according to the circumstances of the workshop's space, moving dust collector also adopted as a different type of flexible duct. Pulse Jet Type Bag Filter is also equipped to operate the system more effectively, for the improved fine environment because of high dust removal efficiency. Finally, we investigated the removal tendency of the dust and odor when operating the System of Hybrid Bag Filter.

• Resources Recycling
• /
• v.12 no.1
• /
• pp.48-54
• /
• 2003

Odor-removing polyethylene film utilizing waste shell powder (annual production: 250,000 ton) was prepared. Odor removal was designed to work by cation or cationic surfactant adsorbed onto the shell surface by ion-exchange: cationic surfactants (DTAB (n-dodecyltrimethylammonium bromide), CTAB (n-cetyltrimethylammonium bromide) and DHAB (n-dihexade-cyldimethylammonium bromide), and cations $Ce^{3+}$ , $Mg^{2+}$ and $Al^{3+}$) were used. Surface-modified waste shell powder was com-pounded with LDPE to produce 20 wt% shell masterbatch (MB), and the MB was again blended with LDPE to get shell-containing LDPE films with 3,5, 10 wt% of shell (width: 40 cm, thickness: 40 $\mu\textrm{m}$). Mechanical properties of the various shell-LDPE films maintained more than 80 % of that of pure LDPE film. Both shell film modified with cationic surfactant and one without shell surface-modification showed excellent odor-removing ability.

• Applied Chemistry for Engineering
• /
• v.32 no.5
• /
• pp.497-503
• /
• 2021

In this study, different methods to coat honeycomb and metal foam substrate with platinum/titania for removing odor gases and volatile organic compounds were investigated. Among them, the powder coating and the nano coating were compared. Scanning electron microscopy/energy dispersive X-ray spectroscopy (SEM/EDX) analysis was used to investigate the surface conditions and exposed platinum composition ratios on honeycomb and metal foam. Also, the catalytic oxidation performance of toluene, trimethylamine and isopropyl alcohol was compared according to the coating method.