• Korean Chemical Engineering Research
• /
• v.47 no.5
• /
• pp.651-654
• /
• 2009

In this study, non-catalytic transesterification using supercritical methanol was performed for preparation of biodiesel from palm oil. In order to investigate the effects of reaction parameters such as molar ratio of methanol to oil(30:1~60:1), pressure(8~25 MPa), temperature($320{\sim}350^{\circ}C$), agitation speed(0~1,000 rpm) and time(0~20 min) on the content of fatty acid methyl esters(FAMEs), we carried out the study using a batch reactor. With increasing molar ratio of methanol to oil, the content of FAMEs increased. However, the content of FAMEs was little affected by molar ratio above 45 and pressure above 20 MPa. The content of FAMEs increased when the temperature increased. However, the content of FAMEs decreased with temperature above at $350^{\circ}C$ and with time above 5 min. It was found that the agitation speed above 500 rpm scarcely affected the content of FAMEs. The highest content of FAMEs in biodiesel(95%) was obtained under the reaction conditions: temperature of $335^{\circ}C$, pressure of 20 MPa, molar ratio of 45:1(methanol to palm oil), agitation speed of 500 rpm and time of 10 min.

• Fashion & Textile Research Journal
• /
• v.8 no.5
• /
• pp.577-584
• /
• 2006

The binding of heavy metal ions onto cross-linked chitosan in dilute aqueous solution has been investigated as a function of pH (4.0 and 7.0), agitation period (10-180min) and concentration of various metal cations (5, 10, 50 and 100ppm). In order to obtain adsorbents that are insoluble and stable, and prevent the dissolution loss of chitosan into an acidic aqueous solution, chitosan flakes were cross-linked with epichlorohydrine (ECH) and its adsorption behavior was compared with that of the non cross-linked chitosan. An advantage of ECH is that it does not eliminate the cationic amine functional group of chitosan. In terms of adsorption ratio, the chitosan cross-linked at an ECH was inferior to original chitosan and was found that chitosan has a selectivity much remarkable than the cross-linked chitosan in low concentrated metal solutions. However, no significant decreases in the adsorption ratios were observed between the cross-linked ECH-chitosan and the non cross-linked chitosan concerning the adsorption of $Ni^{2+}$, $Co^{2+}$, $Pb^{2+}$ and $Zn^{2+}$ acidic solution.

• Clean Technology
• /
• v.14 no.4
• /
• pp.281-286
• /
• 2008

Absorption rate of carbon dioxide was measured in the aqueous polyacrylamide (PAA) solution containing triethanolamine (TEA) of $0{\sim}2.0\;kg\;mol/m^3$ in a flat-stirred vessel with an impeller of 0.05 m and agitation speed of 50 rpm at $25^{\circ}C$ and 101.3 kPa. The chemical absorption rate of $CO_2$ was estimated by mass transfer mechanism based on the film theory using the physicochemical properties containing the liquid-side mass transfer coefficient of $CO_2$ and the kinetics of reaction between $CO_2$ and TEA to compare with the measured rate. The aqueous PAA solution acted as a reducing agent by viscoelastic property of non-Newtonian liquid based on the same viscosity of the solution.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 1998.11a
• /
• pp.17-20
• /
• 1998

Thermal behavior of Flow Pattern Defect (FPD) and Large Pit (LP) in Czochralski Silicon crystals was investigated by applying high temperature ($\geq$1100$^{\circ}C$) annealing and non-agitation Secco etching. For evaluation of the effect of LP upon device performance / yield, DRAM and ASIC devices were fabricated. The results indicate that high temperature annealing generates LPs whereas it decreases FPD density drastically, and LP does not have detrimental effects on the performance /

• Journal of Microbiology and Biotechnology
• /
• v.17 no.4
• /
• pp.650-654
• /
• 2007

In our previous work, a method of pretreating lipase was developed to prevent loss of its activity during covalent immobilization. In this study, Rhizopus oryzae lipase was pretreated before immobilization and then immobilized on a silica gel surface. The effects of the various materials and conditions used in the pretreatment stage on the activity of immobilized lipase were investigated. Immobilized lipase pretreated with 0.1% of soybean oil had better activity than those pretreated with other materials. The optimal temperature, agitation speed, and pretreating time for lipase pretreatment were determined to be $40^{\circ}C$, 200rpm, and 45min, respectively. The activity of immobilized soybean oil pretreated lipase was 630U/g matrix, which is 20 times higher than that of immobilized non-pretreated lipase. In addition, immobilized lipase activity was maintained at levels exceeding 90% of its original activity after 10 reuses.

• Journal of Mechanical Science and Technology
• /
• v.17 no.8
• /
• pp.1203-1210
• /
• 2003

Emission of ultrasonic vibration to turbulent flow promotes the turbulence generation due to the resonantly oscillating pressure field and thereby induced cavitation. In addition, ultrasonic vibration is well transmitted through water and not dissipated easily so that the micro-bubbles involved in the fluid induce the gaseous cavitation if the bubbles are resonated with the ultrasonic field. In the present study, we found through LDV measurement that the gaseous cavitation induced by ultrasonic vibration to CO$_2$saturated water flow in the rectangular cross-sectioned straight duct enhances turbulence much more than the case of non-ultrasonic or normal ultrasonic conditions without gaseous cavitation. We also found that the fluctuating velocity component induced by emitting the ultrasonic vibration in normal direction of a rectangular channel flow can be redistributed to stream-wise component by the agitation of gaseous cavitation.

• Korean Chemical Engineering Research
• /
• v.46 no.3
• /
• pp.555-560
• /
• 2008

Extraction was performed to prepare ash-free coal from low rank coal under the temperature of $200-430^{\circ}C$ and initial pressure of 0.1MPa. Three kinds of coal samples with different rank were used and N-methyl-2-pyrrolidinone(NMP, polar), 1-methyl naphthalene(I-MN, non-polar), Light Cycle Oil(LCO, non-polar) were used as solvents. Results showed that higher extraction yield could be obtained with NMP than with 1-MN and LCO, but the ash concentration shows minimun in the case of 1-MN. Three operation modes were compared, that is, idle, agitation and ultrasonic extraction mode. From the results, it was found that the extraction yield and ash concentration were 70.09% and 1.03% under the agitation mode, 80.7% and 0.76% under the ultrasonic operation mode respectively in the case of NMP used at the temperature of $350^{\circ}C$. Similar results were obtained with 1-MN. Effect of ultrasonic on the extraction was estimated as 15-20% increase in the yields and 26% reduction in the ash concentration.

• Resources Recycling
• /
• v.14 no.5 s.67
• /
• pp.45-53
• /
• 2005

Electro-generated chlorine leaching of waste printed circuit boards was investigated in hydrochloric acid solutions. Non-magnetic component of $0.6{\sim}1.2mm$ was prepared by grinding, magnetic separation, and sieving. The non-magnetic component of pulverized printed circuit board contained about 45% of metal component, in which copper was about 83.6%. The leaching rate of copper was greatly affected by current density and agitation speed. The leaching of copper up to 98% was achieved at $20mA/cm^2$, $50^{\circ}C$, 180 minutes, and 600 rpm in 1M HCl solutions. Increasing agitation and lowering current density enhanced utilization efficiency of electro-generated chlorine. Leaching of copper was suppressed at the initial stage, while the minor metal elements, such as aluminum, lead, and tin, were dominantly leached out.

• Korean Journal of Organic Agriculture
• /
• v.25 no.4
• /
• pp.843-859
• /
• 2017

The JK-1 isolate which was the best producer of indole-3-acetic acid and carotenoid among the 388 strains isolated from 28 wetlands in Jeju, was identified to be Rhodopseudomonas palustirs belongs to a typical group of non sulfur purple bacteria based on 16S sRNA sequencing. This study investigated the effect of different cultural conditions of pH, temperature, agitation, light and aeration on growth, IAA and carotenoid production of photosynthetic bacterium JK-1 for optimization of IAA and carotenoid production. It was found that growth, IAA, carotenoid, and bacteriochlorophyll production with light (3,000~3,500 Lux) and agitation (100 rpm) showed better results than those with dark/static or dark/agitation (100 rpm) in anaerobic conditions. The optimal pH, temperature and agitation speed for cell growth were 7, $30^{\circ}C$, 150 rpm, for IAA production were 9, $30^{\circ}C$, 150rpm and for carotenoid production were 6, $25^{\circ}C$, 50 rpm, cultured for 72 h under anaerobic light, respectively. The growth and IAA production were high in aerobic culture compared with anaerocic culture, whereas carotenoid and bacteriochlorophyll content were decreased extremely in aerobic condition (0.5~1 vvm). Subsequently, the optimal culture conditions for JK-1 were selected with pH 7, $30^{\circ}C$ and 100 rpm under anaerobic light and the effect on plant growth was tested by pot assay. Inoculation of JK-1 with 3% (v/v) level caused increase in shoot and root dry weigh that varied from 20%~58% to 40%~28% in young radish in camparison to uninoculated treatment at 50 days of growth. The study suggests that the JK-1 isolate may serve as efficient biofertilizer inoculants to promote plant growth.

• Korean Journal of Psychosomatic Medicine
• /
• v.27 no.2
• /
• pp.101-110
• /
• 2019

Objectives : It is not clear which clinical variables are most closely associated with delirium in the Intensive Care Unit (ICU). By comparing clinical data of ICU delirium and non-delirium patients, we sought to identify variables that most effectively differentiate delirium from non-delirium. Methods : Medical records of 6,386 ICU patients were reviewed. Random Subset Feature Selection and Principal Component Analysis were utilized to select a set of clinical variables with the highest discriminatory capacity. Statistical analyses were employed to determine the separation capacity of two models-one using just the selected few clinical variables and the other using all clinical variables associated with delirium. Results : There was a significant difference between delirium and non-delirium individuals across 32 clinical variables. Richmond Agitation Sedation Scale (RASS), urinary catheterization, vascular catheterization, Hamilton Anxiety Rating Scale (HAM-A), Blood urea nitrogen, and Acute Physiology and Chronic Health Examination II most effectively differentiated delirium from non-delirium. Multivariable logistic regression analysis showed that, with the exception of vascular catheterization, these clinical variables were independent risk factors associated with delirium. Separation capacity of the logistic regression model using just 6 clinical variables was measured with Receiver Operating Characteristic curve, with Area Under the Curve (AUC) of 0.818. Same analyses were performed using all 32 clinical variables;the AUC was 0.881, denoting a very high separation capacity. Conclusions : The six aforementioned variables most effectively separate delirium from non-delirium. This highlights the importance of close monitoring of patients who received invasive medical procedures and were rated with very low RASS and HAM-A scores.