• Clean Technology
• /
• v.28 no.2
• /
• pp.97-102
• /
• 2022

Lithium sulfur (Li-S) batteries have attracted considerable attention as a promising candidate for next-generation power sources due to their high theoretical energy density, low cost, and eco-friendliness. However, the poor electrical conductivity of sulfur and its insoluble discharging products (Li₂S₂/Li₂S), large volume changes, severe self-discharge, and dissolution of lithium polysulfide intermediates result in rapid capacity fading, low Coulombic efficiency, and safety risks, hindering Li-S battery commercial development. In this study, a three-dimensionally (3D) connected hierarchical porous carbon framework (HPCF) derived from waste sunflower seed shells was synthesized as a sulfur host for Li-S batteries via a chemical activation method. The natural 3D connected structure of the HPCF, originating from the raw material, can effectively enhance the conductivity and accessibility of the electrolyte, accelerating the Li⁺/electron transfer. Additionally, the generated micropores of the HPCF, originated from the chemical activation process, can prevent polysulfide dissolution due to the limited space, thereby improving the electrochemical performance and cycling stability. The HPCF/S cell shows a superior capacity retention of 540 mA h g^-1 after 70 cycles at 0.1 C, and an excellent cycling stability at 2 C for 700 cycles. This study provides a potential biomass-derived material for low-cost long-life Li-S batteries.

• Computers and Concrete
• /
• v.31 no.5
• /
• pp.457-468
• /
• 2023

Buildings, bridges, and dams are examples of civil infrastructure that play an important role in public life. These structures are prone to structural variations over time as a result of external forces that might disrupt the operation of the structures, cause structural integrity issues, and raise safety concerns for the occupants. Therefore, monitoring the state of a structure, also known as structural health monitoring (SHM), is essential. Owing to the emergence of the fourth industrial revolution, next-generation sensors, such as wireless sensors, UAVs, and video cameras, have recently been utilized to improve the quality and efficiency of building forensics. This study presents a method that uses a target-based system to estimate the dynamic displacement and its corresponding dynamic properties of structures using UAV-based video. A laboratory experiment was performed to verify the tracking technique using a shaking table to excite an SDOF specimen and comparing the results between a laser distance sensor, accelerometer, and fixed camera. Then a field test was conducted to validate the proposed framework. One target marker is placed on the specimen, and another marker is attached to the ground, which serves as a stationary reference to account for the undesired UAV movement. The results from the UAV and stationary camera displayed a root mean square (RMS) error of 2.02% for the displacement, and after post-processing the displacement data using an OMA method, the identified natural frequency and damping ratio showed significant accuracy and similarities. The findings illustrate the capabilities and reliabilities of the methodology using UAV to evaluate the dynamic properties of structures.

• The Plant Pathology Journal
• /
• v.39 no.4
• /
• pp.409-416
• /
• 2023

Bacterial leaf blight of carrots caused by Xanthomonas hortorum pv. carotae (Xhc) is an important worldwide seed-borne disease. In 2012 and 2013, symptoms similar to bacterial leaf blight were found in carrot farms in Jeju Island, Korea. The phenotypic characteristics of the Korean isolation strains were similar to the type strain of Xhc. Pathogenicity showed symptoms on the 14th day after inoculation on carrot plants. Identification by genetic method was multi-position sequencing of the isolated strain JJ2001 was performed using four genes (danK, gyrB, fyuA, and rpoD). The isolated strain was confirmed to be most similar to Xhc M081. Furthermore, in order to analyze the genetic characteristics of the isolated strain, whole genome analysis was performed through the next-generation sequencing method. The draft genome size of JJ2001 is 5,443,372 bp, which contains 63.57% of G + C and has 4,547 open reading frames. Specifically, the classification of pathovar can be confirmed to be similar to that of the host lineage. Plant pathogenic factors and determinants of the majority of the secretion system are conserved in strain JJ2001. This genetic information enables detailed comparative analysis in the pathovar stage of pathogenic bacteria. Furthermore, these findings provide basic data for the distribution and diagnosis of Xanthomonas hortorum pv. carotae, a major plant pathogen that infects carrots in Korea.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.33 no.6
• /
• pp.203-209
• /
• 2023

Cobalt sulfide nanocomposites were synthesized through a simple hydrothermal method as anode materials for sodium ion batteries (SIBs). In this work, a cobalt sulfide nanoparticle (CoS-NF) and a cobalt sulfide nanocomposite integrated with reduced graphene oxide (CoS@G-NC) were fabricated for electrochemical energy storage performance of battery. The as-prepared CoS@G-NC electrode exhibited reversible and stable cycle performance (62 % after 30 cycles at current density of 200 mA g^-1). The improved electrochemical property was attributed to the small grain growth and uniform distribution of cobalt sulfide during synthesis, which maximized the diffusion pathway for sodium ions and effectively suppressed the delamination and volume expansion of cobalt sulfide during the conversion reaction. The results provide promising anode materials for next-generation SIBs.

• The Journal of Korea Institute of Information, Electronics, and Communication Technology
• /
• v.17 no.3
• /
• pp.146-154
• /
• 2024

In this paper, we present a convenient liquid crystal (LC) molecular alignment method using brush hairs as an alternative to the rubbing process in the LC display industry. Titanium strontium yttrium zirconium oxide (TiSrYZrO) solution was prepared using a sol-gel process, and the TiSrYZrO alignment film production and LC molecular alignment were integrated through a one-step brush coating process. As the curing temperature increased, the LC molecule alignment of the LC cell improved, and the formation of a physical surface anisotropic structure due to the shear stress caused by the movement of the brush hairs on the coating surface led to uniform alignment of the LC molecules. Uniform and homogeneous LC molecular alignment was confirmed through polarizing optical microscopy and pretilt angle measurement. Through thermal oxidation using X-ray photoelectron spectroscopy, the TiSrYZrO thin film well formed of metal oxide was confirmed and verified to have excellent optical transparency. From these results, it is expected that a convenient LC molecular alignment method using brush hairs as an alternative to the rubbing process will be a viable next-generation technology.

• The Transactions of the Korea Information Processing Society
• /
• v.5 no.4
• /
• pp.1033-1043
• /
• 1998

In this paper, we present an improved multicasting path assignment algorithm based on the minimum cost spanning tree. In the method presented in this paper, a multicasting path is assigned preferentially when a node to be received is found among the next degree nodes of the searching node in the multicasting path assignment of the constrained steiner tree (CST). If nodes of the legacy group exist between nodes of the new group, a new path among the nodes of new group is assigned as long as the nodes may be excluded from the new multicasting path assignment taking into consideration characteristics of nodes in the legacy group. In assigning the multicasting path additionally, where the source and destination nodes which can be set for the new multicasting path exist in the domain of identical network (local area network) and conditions for degree constraint are satisfied, a method of producing and assigning a new multicasting path is used. The results of comparison of CST with MCSTOP, MCSTOp algorithm enhanced performance capabilities about the communication cost, the propagation delay, and the computation time for the multicasting assignment paths more than CST algorithm. Further to this, research activities need study for the application of the international standard protocol(multicasting path assignment technology in the multipoint communication service (MCS) of the ITU-T T.120).

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.20 no.1
• /
• pp.21-28
• /
• 2009

DFT-spread OFDM(Discrete Fourier Transform-Spread Orthogonal Frequency Division Multiplexing) is very effective for solving the PAPR(Peak-to-Average Power Ratio) problem. Therefore, the SC-FDMA(Single Carrier-Frequency Division Multiple Access) which is basically same to the DFT spread OFDM was adopted as the uplink standard of the 3GPP LTE ($3^{rd}$ Generation Partnership Project Long Term Evolution). Unlike the ordinary OFDM system, the SC-FDMA using DFT spreading method is vulnerable to the ICI(Inter-Carrier Interference) problem caused by the phase noise and IQ(In-phase/Quadrature) imbalance and effected FDE(Frequency Domain Equalizer). In this paper, the ICI effects from the phase noise and IQ imbalance which can be problems in uplink transmission are analyzed according the back-off level of HPA. Next, we propose the equalizer algorithm to remove the ICI effects. This proposed equalizer based on the FDE can be considered as up-graded and improved version of PNS(Phase Noise Suppression) algorithm. This proposed equalizer effectively compensates the ICI resulting from the phase noise and IQ imbalance. Finally, through the computer simulation, it can be shown that about SNR=14 dB is required for the $BER=10^{-4}$ after ICI compensation when the back-off is 4.5 dB, $\varepsilon=0.005$, $\phi=5^{\circ}$, and $pn=0.06\;rad^2$.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.30 no.7C
• /
• pp.726-734
• /
• 2005

Traditional watermarking technologies are symmetric method which embedding and detection keys are the same. Although the symmetric watermarking method is easy to detect the watermark, this method has weakness against to malicious attacks remove or modify the watermark information when the symmetric key is disclosure. Recently, the asymmetric watermarking method that has different keys to embed and detect is watched by several researchers as a next generation watermarking technology. In this paper, hybrid asymmetric watermarking algorithm is proposed. This algorithm is composed of correlation detection method and critical criteria method. Each method can be individually used to detect watermark from a watermarked content. Hybrid asymmetric detection is complement between two methods, and more feasible than when each method is used respectively, Private key and public key are generated by secure linear transformation and specific matrix. As a result, we have proved the proposed algorithm is secured than symmetric watermarking algorithms. This algorithm can expand to multi bits embedding watermark system and is robust to JPEG and JPEG2000 compression.

• Journal of the HCI Society of Korea
• /
• v.5 no.2
• /
• pp.15-24
• /
• 2010

A Digilog Book is an augmented reality (AR) based next generation publication supporting both sentimental analog emotions and digitized multi-sensory feedbacks by combining a conventional printed book and digital contents. As a Digilog Book authoring software, ARtalet provides an intuitive authoring environment through 3D user interface in AR environment. In this paper, we suggest ARtalet authoring environment based trajectory editing method to generate and manipulate a movement path of an augmented 3D object on the Digilog Book. Specifically, the translation points of the 3D manipulation prop is examined to determine that the point is a proper control point of a trajectory. Then the interpolation using splines is conducted to reconstruct the trajectory with smoothed form. The dynamic score based selection method is also exploited to effectively select small and dense control points of the trajectory. In an experimental evaluation our method took the same time and generated a similar amount of errors as the usual approach, but reduced the number of control points needed by over 90%. The reduced number of control points can properly reconstruct a movement path and drastically decrease the number of control point selections required for movement path modification. For control manipulation, the task completion time was reduced and there was less hand movement needed than with conventional method. Our method can be applicable to drawing or curve editing method in immersive In-Situ AR based education, game, design, animation, simulation application domains.

• Journal of KIISE:Computing Practices and Letters
• /
• v.10 no.6
• /
• pp.514-528
• /
• 2004

An emotion-based video scene retrieval algorithm is proposed in this paper. First, abrupt/gradual shot boundaries are detected in the video clip representing a specific story Then, five video features such as 'average color histogram' 'average brightness', 'average edge histogram', 'average shot duration', and 'gradual change rate' are extracted from each of the videos and mapping between these features and the emotional space that user has in mind is achieved by an interactive genetic algorithm. Once the proposed algorithm has selected videos that contain the corresponding emotion from initial population of videos, feature vectors from the selected videos are regarded as chromosomes and a genetic crossover is applied over them. Next, new chromosomes after crossover and feature vectors in the database videos are compared based on the similarity function to obtain the most similar videos as solutions of the next generation. By iterating above procedures, new population of videos that user has in mind are retrieved. In order to show the validity of the proposed method, six example categories such as 'action', 'excitement', 'suspense', 'quietness', 'relaxation', 'happiness' are used as emotions for experiments. Over 300 commercial videos, retrieval results show 70% effectiveness in average.