• Journal of the Korean Institute of Telematics and Electronics S
• /
• v.34S no.5
• /
• pp.25-34
• /
• 1997

Relatively slow tuning speed of optical device causes the unwanted delay in high speed single-hop multiwavelength networks. To lessen the overhead, we present a channel access protocol with dynamjic message scheduling. Th eframe structure of proposed protocol adopts hybrid multiaccess scheme in which WDMA is used as a basic multiaccess technique and TDMA is used to provide subchannels within a wavelength band. This architecture has two merits : the network extention is not limited by available number of wavelengths, and the transmission delay caused by optical device tuning time can to minimize the number of tunings. It schedules messages that require same wavelength channels sequencely, so the total transmission delay is reduced by decreasement of wavelength changes. The performance of proposed protocol is evaluated through numerical analysis based on probability and queueing theory. The peformance of proposed protocol is evaluated through numerical analysis based on probability and queueing theory. The numeric results show that the peformance of proposed protocol is better than that of previous one.

• Journal of the Korean Institute of Telematics and Electronics A
• /
• v.33A no.2
• /
• pp.50-58
• /
• 1996

This paper proposes the channel-access protocol suitable to a very high speed photonic WDM network with star configuration, which can provide a high channel utilization and insensitivity to the propagation delay. The proposed protocol employs a control channel and a simple status table to deal with the propagation delay which has been a major limiting factor in the performance of the very high speed optical communication networks. The control channel transmits control information in order to reserve access on data channels, and each node constitutes a status table after the reception of control pckets which holds information about the availbility of destination node and data channel. The proposed protocol is insensitive to the propagation delay time by removing necessity of the retransmission and by allowing parallel transmission of control packet and data packets. It is proved in analysis and discrete event simulation that the proposed protocol is superior in throughput and mean delay, especially at the high load conditions compared to the existing high speed channel-access protocols.

• IEMEK Journal of Embedded Systems and Applications
• /
• v.6 no.3
• /
• pp.149-156
• /
• 2011

Transmission delay and packet loss induced by a communication network can degrade the control performance and, even make the system unstable. This paper presents a method for compensating transmission delay and packet loss in a networked control system for unmanned underwater vehicle. The proposed method is based on Lagrange interpolation in order to satisfy the requirements of simplicity and model-independency. In this work, the lost/delayed data are estimated in real time by only using the past data without requiring any mathematical model of the controlled system. Consequently, the proposed method can be implemented independent of the controlled system, and also it can achieve fast and accurate compensation performance. The performance of the proposed technique is evaluated by numerical simulations with an unmanned underwater vehicle.

• International Journal of Precision Engineering and Manufacturing
• /
• v.6 no.3
• /
• pp.29-36
• /
• 2005

With the rapid growth of the Internet, the Internet-based robot has been realized by connecting off-line robot to the Internet. However, because the Internet is often irregular and unreliable, the varying time delay in data transmission is a significant problem for the construction of the Internet-based robot system. Thus, this paper is concerned with the development of an Internet-based robot system, which is insensitive to the Internet time delay. For this purpose, the PPS (Position Prediction Simulator) is suggested and implemented on the system. The PPS consists of two parts : the robot position prediction part and the projective virtual scene part. In the robot position prediction part, the robot position is predicted for more accurate operation of the mobile robot, based on the time at which the user's command reaches the robot system. The projective virtual scene part shows the 3D visual information of a remote site, which is obtained through image processing and position prediction. For the verification of this proposed PPS, the robot was moved to follow the planned path under the various network traffic conditions. The simulation and experimental results showed that the path error of the robot motion could be reduced using the developed PPS.

• Journal of information and communication convergence engineering
• /
• v.11 no.3
• /
• pp.153-166
• /
• 2013

A hierarchical time division multiple access (HTDMA) medium access control (MAC) protocol is proposed for clustered mobile underwater acoustic networks. HTDMA consists of two TDMA scheduling protocols (i.e., TDMA1 and TDMA2) in order to accommodate mobile underwater nodes (UNs). TDMA1 is executed among surface stations (e.g., buoys) using terrestrial wireless communication in order to share mobility information obtained from UNs which move cluster to cluster. TDMA2 is executed among UNs, which send data to their surface station as a cluster head in one cluster. By sharing mobility information, a surface station can instantaneously determine the number of time slots in a TDMA2 frame up to as many as the number of UNs which is currently residing in its cluster. This can enhance delay and channel utilization performance by avoiding the occurrence of idle time slots. We analytically investigate the delay of HTDMA, and compare it with that of wellknown contention-free and contention-based MAC protocols, which are TDMA and Slotted-ALOHA, respectively. It is shown that HTDMA remarkably decreases delay, compared with TDMA and Slotted-ALOHA.

• The Journal of the Acoustical Society of Korea
• /
• v.33 no.4
• /
• pp.268-272
• /
• 2014

This paper presents a method for speech recognition using multi-section vector-quantization (MSVQ) and time-delay recurrent neural network (TDTNN). The MSVQ generates the codebook with normalized uniform sections of voice signal, and the TDRNN performs the speech recognition using the MSVQ codebook. The TDRNN is a time-delay recurrent neural network classifier with two different representations of dynamic context: the time-delayed input nodes represent local dynamic context, while the recursive nodes are able to represent long-term dynamic context of voice signal. The cepstral PLP coefficients were used as speech features. In the speech recognition experiments, the MSVQ/TDRNN speech recognizer shows 97.9 % word recognition rate for speaker independent recognition.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.11 no.4
• /
• pp.86-94
• /
• 2012

VANETs can provide traffic warring service to help drivers drive safely based on the information of the traffic condition. The driver can drive safely through the warning service information provided by the VANET and know the traffic condition exactly more than through only the sight of driver. In this paper we suggest a new mechanism of updating the table to broadcast the message more rapidly based on the table driven method as the way of sending the emergency message in the VANETs. When updating the table, nodes sends only based on the message transmission success rate. In the result of simulation we could find that the suggested mechanism would reduce the delay time of the emergency message broadcast compared to the existing mechanism.

• Journal of Institute of Control, Robotics and Systems
• /
• v.9 no.1
• /
• pp.90-98
• /
• 2003

The real-time industrial network, often referred to as fieldbus, is an important element for building automated manufacturing systems. Thus, in order to satisfy the real-time requirements of field devices, numerous fieldbus protocols have been announced. But the application of fieldbus has been limited due to the high cost of hardware and the difficulty in interfacing with multi-vendor products. Therefore, as an alternative to fieldbus, the computer network technology, especially Ethernet (IEEE 802.3), is being adapted to the industrial environment. However, the crucial technical obstacle for Ethernet is its non-deterministic behavior that makes it inadequate for industrial applications where real-time data have to be delivered within a certain time limit. Recently, the development of switched Ethernet shows a very promising prospect for industrial application due to the elimination of uncertainties in the network operation resulting in much improved performance. This paper focuses on the application of the switched Ethernet for industrial communications. More specifically, this paper presents an analytical and experimental performance evaluation of the switched Ethernet and a case study about networked control system.

• International Journal of Fuzzy Logic and Intelligent Systems
• /
• v.5 no.4
• /
• pp.360-366
• /
• 2005

In the past, when there were few vehicles on the road, the T.O.D.(Time of Day) traffic signal worked very well. The T.O.D. signal operates on a preset signal cycling which cycles on the basis of the average number of average passenger cars in the memory device of an electric signal unit. Now days, with increasing many vehicles on restricted roads, the conventional traffic light creates startup-delay time and end-lag-time. The conventional traffic light loses the function of optimal cycle. And so, $30-45\%$ of conventional traffic cycle is not matched to the present traffic cycle. In this paper we proposes electro sensitive traffic light using fuzzy look up table method which will reduce the average vehicle waiting time and improve average vehicle speed. Computer simulation results prove that reducing the average vehicle waiting time which proposed considering passing vehicle length for optimal traffic cycle is better than fixed signal method which doesn't consider vehicle length.

• Journal of KIISE:Information Networking
• /
• v.37 no.6
• /
• pp.483-488
• /
• 2010

Due to the prevalence of various mobile devices and wireless broadband networks, there has been a significant increase in interest and demand for multimedia streaming services. Moreover, the user can service the participatory video broadcasting service in the mobile device and it can be used to deliver the real-time news and more variety information in the user side. Live multimedia service of user participation should consider not only the video quality but also the delay bounds and continuity of video playback for improving the user perceived QoS (Quality of Service) of streaming service. In this paper, we propose an adaptive rate control scheme, called DeBuG (Delay Bounds Guaranteed), to guarantee the delay bounds and continuity of video playback for the real-time streaming in mobile devices. In order to provide those, the proposed scheme has a quality adaptation function based on the transmission buffer status and network status awareness. It also has a selective frame dropper, which is based on the media priority, before the transmission video frames. The simulation results demonstrate the effectiveness of our proposed scheme.