• Proceedings of the Korean Institute of Communication Sciences Conference
• /
• 1984.04a
• /
• pp.25-28
• /
• 1984

This paper describes the design of band-pass filter using the dielectric resonator and microstrip line depends mainly upon the magnetic field and is principal parameter as band-pass filter. Because dielectric resonator band~pass filter has a very high-Q, the bandwidth of this filter is very narrow. as a result of experiment, the dielectric resonator bandwidth of this filter is very narrow. As a result of experiment, the dielectric resonator band-pase filter has various modes central frequencies due to the mode change and good characteristric as a band-pass filter.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.25 no.5A
• /
• pp.593-601
• /
• 2000

In a multi-bandwidth CDMA system, the performance of multiple order selection combining rake receivers are analyzed according to the spreading bandwidth of the system and the delay spread of the Rayleigh fading channel. The results for various channel environments indicate a tradeoff between total received signal energy and multipath fading immunity. Increasing the occupied bandwidth of the system(wide-bandwidth spreading) gives better performance for small delay spread environments, while gathering more energy(narrow-bandwidth spreading)gives better performance for large delay spread environments. It is shown that the performance difference between low and high order selection combining grows larger as the spreading bandwidth increases. It is also noted that performance degrades by increasing the bandwidth above a certain point and the optimum spreading bandwidth for each channel environment decreases as the delay spread of the channel increases.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.45 no.5
• /
• pp.65-70
• /
• 2008

A novel fast locking dual-loop integer-N phase locked loop(PLL) with adaptive bandwidth scheme is presented. When the PLL is out-of-lock, bandwidth becomes much wider than 1/10 of channel spacing with the wide bandwidth loop. When the PLL is near in-lock, bandwidth becomes narrower than 1/10 of channel spacing with the narrow bandwidth loop. The proposed PLL is designed based on a $0.35{\mu}m$ CMOS process with a 3.3V supply voltage. Simulation results show the fast look time of $50{\mu}s$ for an 80MHz frequency jump in a 200KHz channel spacing PLL with almost 14 times wider bandwidth than the channel spacing.

• Journal of the Korean Institute of Telematics and Electronics D
• /
• v.35D no.8
• /
• pp.82-88
• /
• 1998

We propose and design a new type of anrrow band-pass optical filter based on two fiber gratings with different reflection wavelength. The ripples occur in the spectra of the filter with two uniform fiber gratings. Our simulation results also show that the ripples disappear with the fiber gratings apodized to both gaussian and hyperbolic tangent function. The hyperbolic tangent function seems to be a better apodization function for improving the filter's performance in terms of narrow pass bandwidth and high transmission.

• Proceedings of the KIEE Conference
• /
• 1998.07e
• /
• pp.1850-1851
• /
• 1998

Using the "MAGIC" code, computer simulation is performed to design a cathode structure which provides a radial distribution of electron beam density matching the field distribution of the $TM_{05}$ mode. Thus, very narrow band $TM_{05}$ mode microwave radiation can be generated in an open end waveguide. The simulation results show that the vircator can indeed be operated at the selected frequency 10.2GHz with a very narrow bandwidth(${\Delta}{\omega}/{\omega}$ < 1%).

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.7 no.4
• /
• pp.784-799
• /
• 2013

This paper presents an adaptive rate control scheme for streaming-based content sharing service. This scheme delivers multimedia contents from a user device to another device or seamlessly redirects streaming service across heterogeneous user devices. In the proposed scheme, a streaming server adjusts video quality level according to the network and client status. Our scheme is different from other rate control schemes, because the video quality at the server is decided not only based on the available bandwidth, but also based on the device characteristics and bandwidth requirement at the access network. We also propose a bandwidth estimation method to achieve more equitable bandwidth allocations among streaming flows competing for the same narrow link with different Round Trip Times (RTTs). Through the simulation, we prove that our scheme improves the network stability and the quality of streaming service by appropriately adjusting the quality of the video stream. The simulation results also demonstrate the ability of the proposed scheme in ensuring RTT-fairness while remaining throughput efficient.

• The Transactions of the Korean Institute of Electrical Engineers C
• /
• v.51 no.12
• /
• pp.573-577
• /
• 2002

We designed wideband HTS antennas which consists of two triangle -radiation patches using a $YBa_2Cu_3O_{7-X}$ (YBCO) superconducting thin film. The major limitation of high-Tc superconducting (HTS) microstrip antennas is the narrow bandwidth due to the high Q and thin substrate. Defining bandwidth as the frequency range over which standing wave ratio (SWR) 2:1 or less, HTS antenna bandwidths are typically 0.85 % to 1.1 %. Thus considerable effort has been focused on developing antennas for broadband operation. To calculate input impedance and design of the broadband HTS antennas a moment method technique was used. The HTS antenna fabricated in this work was designed for K-band, which is useful band for satellite to satellite communications. The bandwidth obtained was a significant 6.7 % and the other measured performance of our HTS antenna, including the bandwidth, radiation Pattern, efficiency, standing wave ratio (SWR) and return losses was reported.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2002.07a
• /
• pp.523-526
• /
• 2002

We designed wideband HTS antennas which consists of two triangle-radiation patches using a YBa$_2$Cu$_3$O$\sub$7-x/ (YBCO) superconducting thin film. The major limitation of high-Tc superconducting (HTS) microstrip antennas is the narrow bandwidth due to the high Q and thin substrate. Defining bandwidth as the frequency range over which standing wave ratio (SWR) 2:1 or less, HTS antenna bandwidths are typically 0.85% to 1.1%. Thus considerable effort has been focused on developing antennas for broadband operation. To calculate input impedance and design of the broadband HTS antennas a moment method technique was used. The HTS antenna fabricated in this work was designed for K-band, which is useful band for satellite-to-satellite communications. The bandwidth obtained was a significant 6.7% and the other measured performance of our HTS antenna, including the bandwidth, radiation Pattern, efficiency, standing wave ratio (SWR) and return losses was reported.

• The Transactions of the Korean Institute of Electrical Engineers D
• /
• v.54 no.3
• /
• pp.180-185
• /
• 2005

Microstrip antennas generally have a lot of advantages that are thin profile, lightweight, low cost, and conformability to a shaped surface application with integrated circuitry. In addition to military applications, they have become attractive candidates in a variety of commercial applications such as mobile satellite communications, the direct broadcast system (DBS), global positioning system (GPS), and remote sensing. Recently, many of the researches have been achieved for improving the impedance bandwidth of microstrip antennas. The basic form of the microstrip antenna, consisting of a conducting patch printed on a grounded substrate, has an impedance bandwidth of $1\~2\%$. For improvement of narrow bandwidth of microstrip patch, we were designed U-slot microstrip patch antenna in this paper. This antenna had wide bandwidth for all personal communication services (PCS) and IMT-2000. For the design of U-slot microstrip patch antenna using a finite difference time domain(FDTD) method. This numerical method could get the frequency property of U-slot patch antenna and the electromagnetic fields of slots.

• ETRI Journal
• /
• v.33 no.2
• /
• pp.291-294
• /
• 2011

This letter proposes an open-ended waveguide antenna with a single split-ring resonator. In contrast to the waveguide antennas incorporating multiple rings reported in a previous study, which exhibited narrow bandwidth, the proposed antenna uses only one ring to achieve broader bandwidth while keeping the aperture small. A single ring has a relatively low quality factor compared to multiple rings. The simulated and measured fractional bandwidth was 4.13% and 4.03%, respectively, which is much broader than the fractional bandwidth of about 1% demonstrated in a previous study. This simple technique can be used in many applications that require small apertures including near-field probes and array elements.