• Transactions of the Korean Society for Noise and Vibration Engineering
• /
• v.20 no.1
• /
• pp.22-28
• /
• 2010

Approximate analysis for a building installed with a friction damper is performed to get insight of its dynamic behavior. Energy balance equation is used to have a closed analytical form solution of dynamic magnification factor(DMF). It is found out that DMF is dependent on friction force ratio and resonance frequency. Approximation of DMF and equivalent damping ratio of a friction damper is proposed with such assumption that the building with a friction damper shows harmonic steady-state response and narrow banded response behavior near resonance frequency. Linear transfer function from input external force to output building displacement is suggested from the simplified DMF equation. Root mean square of a building displacement is derived under earthquake-like random excitation. Finally, design procedure of a friction damper is proposed by finding friction force corresponding to target control ratio. Numerical analysis is carried out to verify the proposed design procedure.

• The Journal of the Korea Contents Association
• /
• v.7 no.3
• /
• pp.42-49
• /
• 2007

This paper implements RFID(radio-frequency identification)System to which the system was apply SS(Spread Spectrum) method. The system designed by using the algorithm for microprocessor with PLL of the receiver, PN spread, modulation and demodulation of the transceiver, and transistor amplifier for the output of stabilized BPSK (Binary Phase Shift Keying) signal. furthermore, it reduced the interference of the signal by designing the micro-strip narrow banded patch antenna, which is convenient for printing and producing, and decreased the volume of filter size in the system. It is also designed for the lower powered system with the possible application to UHF band of $860\sim930MHz$ for the international standard frequency band, which is the quota share of RFID distribution system.

• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.9 no.2
• /
• pp.57-62
• /
• 1997

Based on the facts that significant parts of the harbor response spectrum usually reside in the vicinity of the Helmholtz mode in the eastern part of Korea. economically feasible redemption measures of seiches for malfunctioned harbors already in service is proposed by extending the wisdom of perforated breakwaters and adjusting the width of entrance channel as a control tool. It turns out that as the entrance channel is getting narrower, the harbor system is getting slender due to the increase of added hydrodynamic length so that harbor response can be effectively diminished and separated from the incident wave spectrum where considerable amount of wave energy is located at the lower frequency range.

• Journal of the Society of Naval Architects of Korea
• /
• v.55 no.6
• /
• pp.466-473
• /
• 2018

Most frequency domain-based approaches assume that structural response should be a Gaussian random process. But a lot of non-Gaussian processes caused by multi-excitation and non-linearity in structural responses or load itself are observed in many real engineering problems. In this study, the effect of non-Normality on fatigue damages are discussed through case study. The accuracy of four frequency domain methods for non-Gaussian processes are compared in the case study. Power-law and Hermite models which are derived for non-Gaussian narrow-banded process tend to estimate fatigue damages less accurate than time domain results in small kurtosis and in case of large kurtosis they give conservative results. Weibull model seems to give conservative results in all environmental conditions considered. Among the four methods, Benascuitti-Tovo model for non-Gaussian process gives the best results in case study. This study could serve as background material for understanding the effect of non-normality on fatigue damages.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.32 no.5B
• /
• pp.321-329
• /
• 2012

Two regular progressive wave trains, the directions of which are slightly different from each other, develop a honeycomb pattern of wave crests due to their nonlinear interaction. In the honeycomb pattern of wave crest, the nodal line area, which has very low wave energy, is formed. When the honeycomb pattern is developed near the beach area, rip current evolves through the nodal line area formed in the cross shore direction. In this study, to confirm that the formation of honeycomb pattern of waves near the beach area is a dominant mechanism of rip current occurred at Haeundae beach, we performed a numerical simulation of nearshore circulation at Haeundae beach under an unidirectional and monochromatic wave condition by using a nonlinear Boussinesq equation model. As a result, wave refraction due to topographical characteristics (i.e., submerged shoal) of Haeundae gave rise to several wave trains propagating with slightly different directions toward the beach, and consequently rip currents well developed through the nodal line area of honeycomb patterns of wave crest. In addition, we found that a narrow-banded spectral wave condition (i.e., a swell spectrum) increases more likelihood of rip current than a broad-banded spectral wave condtion based on the simulations employing various wave spectra with an equivalent wave height and period.

• Journal of the Society of Naval Architects of Korea
• /
• v.48 no.4
• /
• pp.299-307
• /
• 2011

The offshore plants such as FPSO are subjected to combination loading of environmental conditions (swell, wave, wind and current). Therefore the fatigue damage is occurred in the operation time because the units encounter the environmental phenomena and the structural configurations are complicated. This paper is a research for frequency domain fatigue analysis of wide-band random loading focused on accuracy of fatigue damage estimation regarding the proposed methods. We selected ideal bi-modal spectrum. And comparison between time-domain fatigue analysis and frequency-domain fatigue analyses are conducted through the fatigue damage ratio. Fatigue damage ratios according to Vanmarcke's bandwidth parameter are founded for wide-band. Considering safety, we recommend that Jiao-Moan and Tovo-Benasciutti methods are optimal way at the fatigue design for wide-band response. But, it is important that these methods based on frequency-domain unstably change the accuracy according to the material parameter of S-N curve. This study will be background and guidance for the new frequency-domain fatigue analysis development in the future.

• Bulletin of the Society of Naval Architects of Korea
• /
• v.27 no.4
• /
• pp.3-14
• /
• 1990

For a moored body on the sea surface, incident waves with narrow-banded spectra excite the body oscillations of short and long periods. Since the period of slow oscillations can be as long as the natural period of the moored body in horizontal modes, resonance can occur and resulting large motions may cause significant strains in mooring cables. By using the perturbation method of multiple scales, the large slow motion can be analyzed without solving any second-order potentials explicitly. To the leading order, the flows associated with the fast and slow motions interact only parametrically and thus they can be studied separately. It is found that the slow motion strongly depends on the mooring stiffness. In particular, if the moring stiffness is considerably weak compared to the body inertia, the slow motion is highly amplified near resonance. It is also shown that the slow motion is associated with the generation of long waves.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.32 no.4B
• /
• pp.243-251
• /
• 2012

To investigate the characteristics of rip current occurring at Haeundae beach, observations obtained from a buoy and a CCTV were analyzed and numerical experiments were conducted. During observed rip-current events, the CCTV images showed that a couple of wave-trains, which are close to regular waves with slightly different directions, propagated to the beach, and wavelet analyses of data from the buoy showed very narrow-banded spectra with a peak frequency. From the evidences, it was inferred that a known mechanism of generating rip current due to the nodal line area of honeycomb-patterned wave crest was one of the significant factors of rip current occurrences of Haeundae beach. The mechanism has been explained by the following: When two wave-trains with slightly different directions propagate to a beach, wave crests of the incident wave-trains form honeycomb pattern due to nonlinear interaction. The nodal lines of honeycomb pattern are developed in the cross-shore direction. And longshore currents flow toward the nodal line area which has very low wave energy. Consequently their mass flux is expelled through the area toward the sea direction. To confirm the generation, numerical experiments were performed using a nonlinear Boussinesq equation model. In the cases with two incident wave-trains with slightly different directions and with a monochromatic wave propagating over a submerged shoal, it was seen that the honeycomb pattern of wave crests was well developed, and thus rip currents were evolved along the nodal lines.

• Journal of the Society of Naval Architects of Korea
• /
• v.60 no.5
• /
• pp.375-387
• /
• 2023

The subsea power cables are increasingly important for harvesting renewable energies as we develop offshore wind farms located at a long distance from shore. Particularly, the continuous flexural motion of inter-array dynamic power cable of floating offshore wind turbine causes tremendous fatigue damages on the cable. As the subsea power cable consists of the helical structures with various components unlike a mooring line and a steel pipe riser, the fatigue analysis of the cables should be performed using special procedures that consider stick/slip phenomenon. This phenomenon occurs between inner helically wound components when they are tensioned or compressed by environmental loads and the floater motions. In particular, Vortex-induced vibration (VIV) can be generated by currents and have significant impacts on the fatigue life of the cable. In this study, the procedure for VIV fatigue analysis of the dynamic power cable has been established. Additionally, the respective roles of programs employed and required inputs and outputs are explained in detail. Demonstrations of case studies are provided under severely sheared currents to investigate the influences on amplitude variations of dynamic power cables caused by the excitation of high mode numbers. Finally, sensitivity studies have been performed to compare dynamic cable design parameters, specifically, structural damping ratio, higher order harmonics, and lift coefficients tables. In the future, one of the fundamental assumptions to assess the VIV response will be examined in detail, namely a narrow-banded Gaussian process derived from the VIV amplitudes. Although this approach is consistent with current industry standards, the level of consistency and the potential errors between the Gaussian process and the fatigue damage generated from deterministic time-domain results are to be confirmed to verify VIV fatigue analysis procedure for slender marine structures.

• Journal of the Mineralogical Society of Korea
• /
• v.22 no.1
• /
• pp.1-11
• /
• 2009

Fine-grained peridotite xenoliths are rarely trapped in the basaltic rocks from the southeastern part of Jeju Island. Based on textural characteristics of the constituent phases showing uniform-sized, fine-grained tabular to mosaic grains with rare porphyroclastic relics, the studied samples can be defined as fine-grained, foliated porphyroclastic peridotites (FPP). Almost no significant difference among the FPPs in textures and major element compositions implies that the FPPs were derived from a structural domain, experiencing similar deformation events and deformation patterns. Moreover, the bimodal distribution with kink-banded porphyroclasts ($2{\sim}3mm$) and stain-free neoblasts ($200{\sim}300{\mu}m$), straight to gently curved grain boundaries with triple junctions, interstitial melt pockets, and microstructures for migrating grain boundary suggest that the studied samples went through dynamic recrystallization (${\pm}$ static recrystallization) in the presence of melt/fluid movement along foliation planes. No notable difference between the FPP and common protogranular xenoliths in major element compositions and geochemical evolution also implies that the FPP and protogranular xenoliths were from a similar horizon. Thus, the textural and geochemical characteristics of the FPPs reflects deformation events occurred at a localized and narrow zone within the lithospheric mantle beneath the Jeju Island. Although further detailed studies are necessary to define deformation events, the most possible process which could trigger deformation in the FPP in the rigid upper mantle was the ascending basaltic magma forming high-stress deformation zones. The suggested high-stress deformation zones in the lithosphere beneath the Jeju Island may be produced by paleo-faulting events related to the ascent of basalt magma before Jeju Island was formed.