• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.16 no.10
• /
• pp.6839-6845
• /
• 2015

The optimization design method for the broadband operation of the sleeve monopole was proposed to unify the multiple antennas essential to the multi-functional broadband wireless communication systems into one antenna. The structure of the sleeve part was optimized to enhance the impedance matching characteristics based on the theoretical analysis that sleeve part can works as the open stub. The thick monopole was used for the broadband operation. The radius of the sleeve and the permittivity of the dielectric inside the sleeve was optimized to enhance the impedance matching characteristics for the broadband operation. The optimized sleeve monopole having thick monopole shows broadband characteristics over 3:1 bandwidth, from 0.8 to 2.43 GHz, which is suitable for the commercial wireless communication system. The proposed broadband sleeve monopole can reduce multiple antennas essential to the multi-functional broadband systems to one antenna.

• Journal of Electrical Engineering and Technology
• /
• v.13 no.5
• /
• pp.2045-2049
• /
• 2018

An antenna arrays for a satellite navigation systems require more antenna elements to mitigate multiple jamming signals. In order to maintain the small array size while increasing the number of antenna elements, miniaturization technique is essential for antenna design. In this work, an electrically small circular microstrip patch antenna with a 3 dB hybrid coupler is designed as an element antenna, where the 3 dB hybrid coupler can yield the circularly polarized radiation characteristic. The miniaturized element antenna typically has too large capacitance in GPS L1 and GLONASS G1 bands, making it difficult to match with a single stand-alone non-Foster matching circuit (NFMC) in a stable state. Therefore, we propose a new matching technique, referred to as the hybrid matching method, which consists of a NFMC and a passive circuit. This passive tuning circuit manages reactance of antenna elements at an appropriate capacitance without a pole in the operating frequency range. The antenna array is fabricated, and the measured results show a reflection coefficient of less than -10 dB and an isolation of greater than 50 dB. In addition, peak gain of the proposed antenna is increased by 22.3 dB compared to the antenna without the hybrid matching network.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.9 no.6
• /
• pp.1167-1173
• /
• 2005

In this paper, the use of an antenna array is considered for code timing acquisition of DS-CDMA signals. The probabilities of acquisition are evaluated by applying multiple narrow fixed-beams to the conventional MUSIC acquisition approach in the multiuser environment on the time-varying Rayleigh fading channel. Each fixed-beam for spatial filtering is dedicated to an individual angular sector that is formed by dividing the entire angular domain by the number of antenna elements. The fixed-beams with a capability of interference suppression provide the additional degrees of freedom,. Hence, the multibeam-based MUSIC estimator can be used to synchronize to more users than the conventional MUSIC algorithm for one antenna. The multibeam-based subspace method is evaluated to significantly improve the performance of a single antenna based MUSIC technique in multiuser scenarios.

• 한국정보통신설비학회:학술대회논문집
• /
• 2007.08a
• /
• pp.427-431
• /
• 2007

Applications in present-day mobile communication systems particularly require miniaturized dimensions and low-profiles of antenna in order to meet the mobile units. Thus, size reductions and bandwidth enhancements are becoming crucial design considerations for practical applications of microstrip antennas. The motivation of further experiments have been stepped to follow those studies for achieving compact and broadband, even multiplied operation modes, which are greatly increased with much attentions recently. To obtain broadband, single-feed, circularly polarized characteristics of microstrip antennas, a design with feed-line ought to be a factor of two. Usually, diagonally balanced-line feeds with hybrid coupler are employed to attain circular polarizations. We firstly formulated DGS (Defected Ground Structures) based operation principles of the entire microstrip components and therefore were able to derive impedance variance of feed-lines. After verifying corresponding experimental results, we targeted the frequency bands of UHF RFID (Ultra High Frequency Radio Frequency IDentification) and approximately of 0.4-2.4GHz have exhibited remarkable two resonance amplitudes as a dual band antenna. Our secondary researches were aimed to design quad band microstrip antenna which represents four resonance characteristics within the identical frequency bands as well. Microstrip patch has been meandered to lengthen the electrical paths, and the other design criteria with respecting physical parameters including radiation patterns and impedance bandwidths measurements will be described for verification. Advisable applications of these antennas can be GSM850, GSM900, GPS (L1-1575 and L2-1227) and UMTS-2110 of cellular systems, which extremely desire multiband and minimum size.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.12 no.1
• /
• pp.58-65
• /
• 2013

It's introduced a BLA(Branch Loop Antenna) that is modified from conventional loop, and verified antenna performances for applying to mobile handset. Branch elements are added to a rectangular loop, and low resonance is obtained by the length of the branch line. When resonance frequency of a single loop is 2.5GHz, BLA had near 900 MHz under the same antenna size. Multiple resonances are established by the locations of branch connection and their lengths. By the implementation and measurement for the dual band BLA, it's showed 75MHz -10dB bandwidth and -3.03~-1.46dBi average gains with 49.73~71.39% efficiencies at GSM900 band, and 90MHz -6dB bandwidth and -8.14~-2.17dBi average gains with 15.34~60.62% efficiencies at DCS1900 band. And H-plane radiation patterns were omni-directional. These performances are good for the mobile handset antenna.

• Journal of Advanced Navigation Technology
• /
• v.25 no.5
• /
• pp.384-389
• /
• 2021

An optimal ground station (GS) antenna pattern design method for network-based UAV command and control communication systems considering complexity and performance is presented. The GS antenna consists of multiple side sectors and one upward sector. The antenna gain for each vertical/horizontal angle of the GS antenna according to the change of antenna design parameters such as the number of sectors, horizontal and vertical beam-width, and tilt-angle is modeled, and the effect of the parameter changes on the signal-to-noise ratio (SNR) distribution in the virtual three-dimensional space is analyzed. It is observed that the tilt-angle of the side sectors has the greatest effect on the performance, and the longer the distance between GSs, the higher the maximum altitude and the smaller the number of side sectors, the tilt-angle should be lower. In addition, it is observed that the wider vertical beam-width of the side sector is advantageous in maximizing the lowest SNR, but narrow vertical beam-width is advantageous in maximizing the average SNR.

• Journal of information and communication convergence engineering
• /
• v.12 no.2
• /
• pp.67-74
• /
• 2014

In multi-hop communication systems, two-way relaying is one of the solutions to mitigate the spectral efficiency loss caused by a half-duplex transmission. In this paper, a simple two-way relaying scheme is proposed for two-hop two-user multiple input multiple output (MIMO) systems. In the proposed system, a base station and a relay station (RS), both equipped with two antennas, form a point-to-point MIMO channel, while the RS and two single-antenna mobile users form a point-to-multipoint multiuser (MU)-MIMO channel. Numerical examples show that the proposed system achieves a significant sum rate gain as compared to a one-way relaying system as the distance between a relay and the two users decreases. We also show that although we can expand the proposed scheme to more than two users, its performance gain as compared to that of one-way relaying decreases with an increase in the number of users.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.9 no.12
• /
• pp.5015-5027
• /
• 2015

Transceiver optimization in multiple input multiple output (MIMO) cognitive systems is studied in this paper. The joint transceiver beamformer design is introduced to minimize the transmit power at secondary base station (SBS) while simultaneously controlling the interference to primary users (PUs) and satisfying the secondary users (SUs) signal-to-interference-plus-noise ratio (SINR) based on the convex optimization method. Due to the limited cooperation between SBS and PUs, the channel state information (CSI) usually cannot be obtained perfectly at the SBS in cognitive system. In this study, both perfect and imperfect CSI scenarios are considered in the beamformer design, and the proposed method is robust to CSI error. Numerical results validate the effectiveness of the proposed algorithm.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.39A no.8
• /
• pp.437-444
• /
• 2014

In this paper, we propose a path loss model with the multiple antennas and doppler shift for high speed railroad communication. Path loss model is very important in order to design consider diverse characteristic in high-speed train communication. Currently wireless communication systems use the multiple antennas in order to improve the channel capacity or diversity gain. However, until recently, many researches on path loss model only consider geographical environment between the transmitter and the receiver. There is no study about path loss model considering diversity effect and doppler shift. In order to make average residuals considering doppler shift we use tuned free space path loss model which is utilized for measurement results at high speed railroad. The environment of high speed rail is mostly at viaduct and flatland over than 50 percent. And in order to make average residuals considering multiple antenna we use theoretical estimation of diversity gain with MRC scheme. proposed model predict loss of received signal by estimating average residuals between diversity effect and doppler shift.

• Journal of electromagnetic engineering and science
• /
• v.10 no.4
• /
• pp.263-269
• /
• 2010

Multiple input multiple output (MIMO) has been considered one of the key enablers of broadband wireless communications. The indoor environment is known to be favorable to ensure both high rank property and high signal-to-interference/noise ratio (SINR) to fully exploit MIMO spatial multiplexing (SM) gain. In this paper, we describe several practical deployment cases where repeater links (or relay links), such as those present with an indoor distributed antenna system (DAS), can act as keyholes to degenerate the rank property of MIMO communications. In this case, we cannot exploit MIMO SM gain in indoor environment. We propose a novel MIMO communication scheme which uses simple converter in the devices in repeater links to resolve the rank degeneration issue and to ensure MIMO SM gain in highly MIMO-favorable indoor environment. MIMO SM is possible over the indoor DAS with single cable line through use of simple converters, which enables practical deployment in real fields.