• 한국항해항만학회지
• /
• 제44권5호
• /
• pp.363-374
• /
• 2020

In the past, various research on the effects of waves generated by ships has been investigated. The most noticeable effect of the waves generated by a passing ship is the increase of the hydrodynamic forces and the unwanted large motion of the moored ship and high mooring forces that occur. Thus, it is crucial to investigate the effect of the waves generated by the passing ship near port on the motion of the moored ship and the tension of the mooring lines. A model test was performed with virtual ship-generated waves in a square tank at CWNU (Changwon National University). The IMU (Inertial Measurement Unit) and Optical-based system were used to measure the 6DOF (Six Degrees of Freedom) motion of the moored floater. Additionally the tension of mooring lines were measured by the tension gauges. The effects of the wave direction and wave height generated by the virtual ship-generated waves on the motion of the moored floater were analyzed.

• 한국항만학회지
• /
• 제6권2호
• /
• pp.33-42
• /
• 1992

In this paper we investigate the motion response of a moored ship in the fluid region sheltered by inclined breakwaters. The matched asymptotic expansion technique is employed to analyze the wave fields scattered by the inclined breakwaters. Fluid domain is subdivided into the ocean, entrance and sheltered regions. Unknown coefficients contained in each region can be determined by matching at the intermediate zone between two neighboring regions. The wave field generated by the ship motion can be analyzed in terms of Green's function method. To obtain the velocity jump across the ship associated with the symmetric motion modes, the sheltered region is further divided into near field of the ship and the rest field. The image method is introduced to consider the effect of the pier near the ship. The integral equation for the velocity jump is derived by the flux matching between the inner region and the outer region of a moored ship. Throughout the numerical calculation it is found that the inclined angle width of entrance of breakwaters as well as the location of moored vessel play an important role in the motion response of a moored ship.

• 한국항해항만학회:학술대회논문집
• /
• 한국항해항만학회 2019년도 춘계학술대회
• /
• pp.98-100
• /
• 2019

In the past, there were several researchers investigating waves generated by a small boat. Wave generated by a ship can be divided into two distinct systems of waves, such as transverse and diverging waves. It is necessary to understand the behavior of a ship in waves generated by a small boat near port in the view point of ship safety. In this study, the motion of moored floater in waves generated by a small boat near port is investigated. The model test is performed in waves in a square tank in Changwon National University (CWNU). IMU and optical-based system which uses the technique of recording and capturing attitude with respect time are used for measuring 6DOF motion of the moored floater. In addition, tension gauges are used to measure the tension of mooring lines. The effect of waves generated by a small boat on motion of the moored floater near port is investigated through performing the model test in various wave directions of virtually but reasonably assumed wave scenarios.

• 대한토목학회논문집
• /
• 제33권2호
• /
• pp.595-608
• /
• 2013

본 연구는 항만 공진 현상을 고려한 계류선박의 동요량 산정방법을 제시하고 공진현상이 선박의 동요에 미치는 영향을 정량적으로 평가한 것이다. 공진 현상의 해석은 타원형완 경사방정식을 채용한 CGWAVE 모형을 사용하였고, 계류선박의 동요 해석은 3차원 Green 함수 모형을 사용하였다. 본 방법은 현지 계류선박의 동요량 계측 결과를 이용하여 타당성을 검증하였고, 포항신항의 최근 파랑 관측 자료와 비교하여 현지 항만의 적용성을 검토하였다. 파랑 관측 기록에서 얻어진 포항신항의 공진주기는 80분, 33분, 23분, 8분 등의 장주기 성분과 항내 슬립에서 발생한 주기 42초, 54초, 60초 등의 외중력파 성분이었으며 공진 해석 모형은 이들 공진주기를 잘 재현하였다. 본 연구에서는 포항신항의 제 8부두에 5,000톤, 10,000톤, 30,000톤의 선박이 계류되었을 때 공진 성분을 포함한 경우와 포함하지 않은 경우의 동요량을 각각 산정하여 공진 현상이 선박 동요에 미치는 영향을 검토하였다. 공진 성분을 포함한 경우는 그렇지 않은 경우에 비하여 12~400 %의 동요량 증가를 보였다. 공진 현상이 동요량에 미치는 영향은 Surge, Heave 동요는 선박이 클 수록, Roll과 Yaw 동요는 반대로 선박이 작을 수록 커짐을 알 수 있었다.

• 한국해양공학회지
• /
• 제17권4호
• /
• pp.8-15
• /
• 2003

When a typoon sets into harbour, a moored ship shows erratic motions and even mooring line failure may occur. such troubles may be caused by harbour resonance phenomena, resulting in large motion amplitudes at low frequency, which is close ti the natural frequency of th moored ship. The nonlinear motions of a ship moored to quay are simulated under external forces due to wave, current including mooring forces in time domain. The forces due to waves are obtained from source and dipole distribution method in the frequency domain. The current forces are calculated by using slow motion maneuvering equation in the horizontal plane. The wind forces are calculated from the empirical formula of ABS and the mooring forces of ropes and fenders are modeled as linear spring.

• 대한토목학회논문집
• /
• 제26권6B호
• /
• pp.651-660
• /
• 2006

외해에 접해 있는 항만은 항내정온도가 항만설계기준에 만족 되도록 설계되었을 지라도 계류선박의 동요 때문에 하역에 지장을 초래하고 가동률이 저하되는 현상이 빈번하게 발생하고 있다. 이것은 항만설계기준이 항내 파고만으로 설정되었기 때문이며, 이와 같은 현상을 방지하기 위해서는 계류선박의 동요를 고려한 새로운 가동률 평가방법이 필요하다. 본 연구는 선박동요해석모형을 이용하여 항내에 계류된 선박의 동요량을 산정하고 하역허용동요량과의 관계로부터 하역허용파고를 산정한 후 항만의 가동률을 평가하는 방법을 제시한 것이다. 여기서는 새로운 가동률 평가 방법을 현지 항만인 온산항에 적용하고 현행 평가 방법과 비교하여 두 방법의 차이를 제시하였다. 새로운 방법에 의한 항만가동률은 ENE와 NE방향에서 현행 항만설계기준에 의한 가동률 결과 보다 1~11% 정도 낮아 지는 것을 확인할 수 있었다. 따라서 외해에 접해 있는 항만은 설계 단계에서 파고 기준에 의한 항만가동률 평가뿐만 아니라 계류선박의 동요를 고려한 가동률 평가를 병행하여 평면배치 계획을 수립하여야 할 것이다.

• 한국항해항만학회지
• /
• 제27권2호
• /
• pp.193-198
• /
• 2003

일점계류된 선박의 외력에 의한 불안정 거동을 경감시키는 방법에 대하여 검토하였다. 계류된 선박의 수치계산 시뮬레이션을 위해 조종운동방정식을 사용하였고, 선박에 가해지는 외력으로는 풍력과 파강제력이 고려되었다. 파강제력은 3차원특이점분포법에서 얻어진 주파수전달함수로부터 시간영역해석법을 적용하였고, 풍력은 OCIMF(1994)에서 제시한 값을 사용하였다. 계류된 선박의 안전대책으로 바우스러스터를 이용한 제어방법, 두 번째 묘를 이용한 굴레(Birdle)를 씌우는 묘박법이 검토되었다.

• 한국항해항만학회:학술대회논문집
• /
• 한국항해항만학회 2006년도 International Symposium on GPS/GNSS Vol.1
• /
• pp.47-52
• /
• 2006

Recent warnings indicate that there is a potential risk of massive earthquake in Japan within 30 years. These earthquakes could produce large-scale tsunamis. Tsunamis are very powerful and can be traveled thousands of miles and caused damage in many countries. Consideration of the effect of tsunami to the moored ship is very important because it brings the loss of life and vast property damage. In this paper, the numerical simulation procedure to analyze the motions of a moored ship due to the observed waves of tsunami, Tokachi-off earthquake tsunami profile in northern Pacific coasts of Japan on September 26 in 2003. And the effects on the motions and mooring loads are investigated by numerical simulation. Numerical simulations consist of hydrodynamic analyses in a frequency domain and ship motion analyses in a time domain as the motions of moored ships are examined. As the process begins, the hydrodynamic and waveexciting forces for moored ships must be calculated. Ship motions and mooring forces can then be calculated by solving the equations of motion. In order to investigate the safety evaluation on the motions of moored ship by tsunami attack, we applied a numerical simulation procedure to a 135,000m3 LNG carrier moored at an offshore sea berth.

• 한국해양공학회:학술대회논문집
• /
• 한국해양공학회 2003년도 추계학술대회 논문집
• /
• pp.237-242
• /
• 2003

The influence of wave forces on the moored ship beside quay was investigated based on in-house ship mooring analysis and ship motion program in this paper. The wind and current are the general environmental factors for the mooring analysis beside quay in the mild weather. However, the weather is becoming rough, the wave phenomenon should be included in the mooring analysis. In this paper, as preliminary stages, each moored rope tension was evaluated based on wind and current environmental condition. The results were compared with those from MOSES, commercial program. In addition to this, wave forces of the ship were calculated in order to solve moored ship motion of equation. We will leave to solve this motion equation as future work.

• 한국해양공학회:학술대회논문집
• /
• 한국해양공학회 2002년도 춘계학술대회 논문집
• /
• pp.204-208
• /
• 2002

Mooring is the operation of securing a ship to a wharf or quay by means of rapes or chains. A. moored ship need not necessarily be truly stationary. It may be free to rise and fall with the tick or the loading and unloading of cargo or to oscillate in response to the action of the environmental forces. In this respect a moored ship is restricted to a limited amount of movement within well-defined bounds. This study is intended to analyze the tension of mooring lines by a FEM program, as the current velocities and working directions are varied. The motion of a berthed ship is studied concerning with the wave periods and the direction. Also the behavior of the modeled vessel are investigated for a berthed condition.