• Journal of the Korean Society of Hazard Mitigation
• /
• v.8 no.4
• /
• pp.111-118
• /
• 2008

Riparian buffer zone prevents sediment entry into drainage channels or as a protection from runoff and wind erosion. However, Studies about its removing effect according to Riparian buffer zone are shorted now. In this study, using the SWAT model, Byongseong watershed is built on the Arcview GIS. Using the function of the filter strip in SWAT model, it is also examined about the variation of sediment yield. As a simulation result, the case of constructing riparian buffer zones at subbasins near the outlet shows generally high efficiency on removing sediment yield. In addition, according to the scenario analysis of changing riparian buffer zone width, it is thought that 5-10m riparian buffer zone width is the highest efficiency on removing sediment yields generated from Byeongseong watershed.

• Journal of Communications and Networks
• /
• v.18 no.3
• /
• pp.429-438
• /
• 2016

In this paper, we investigate an interference mitigation scheme by antenna selection in device-to-device (D2D) communication underlaying downlink cellular networks. We first present the closed-form expression of the system achievable rate and its asymptotic behaviors at high signal-to-noise ratio (SNR) and the large antenna number scenarios. It is shown that the high SNR approximation increases with more antennas and higher ratio between the transmit SNR at the base station (BS) and the D2D transmitter. In addition, a tight approximation is derived for the rate and we reveal two thresholds for both the distance of the D2D link and the transmit SNR at the BS above which the underlaid D2D communication will degrade the system rate. We then particularize on the small cell setting where all users are closely located. In the small cell scenario, we show that the relationship between the distance of the D2D transmitting link and that of the D2D interfering link to the cellular user determines whether the D2D communication can enhance the system achievable rate. Numerical results are provided to verify these results.

• Nuclear Engineering and Technology
• /
• v.53 no.6
• /
• pp.1858-1868
• /
• 2021

Resisting an accidental impact of large commercial aircrafts is an important aspect of advanced nuclear power plant (NPP) design. Especially after the 9·11 event, some regulations were enacted, which required the design of NPPs should consider the accidental impact of large commercial aircrafts. Normal working of equipment is important for stopping reactor under an impact when an NPP is in operation. However, there is a lack of reliable analysis and research on the impact test of nuclear prototype equipment. Therefore, in order to study the response of the equipment under high acceleration impact, a centrifugal pump is selected as the research object to perform the impact test. A horizontal half-sinusoidal pulse wave was applied to the working pump. The test results show that the horizontal response of the motor and flange is greater compared to other parts, as well as the vertical response of the coupling. The stress response of the pump body support and motor support is high, hence these parts should be considered in the design of the pump. Finally, combined with the damage and stress evaluation results of the pump under different amplitudes, the ultimate impact acceleration that the pump can withstand is given.

• Journal of Korean Society on Water Environment
• /
• v.32 no.3
• /
• pp.243-252
• /
• 2016

In cases of water pollution accidents, accurate prediction for arrival time and concentration of contaminants in a river is essential to take proper measures and minimize their impact on downstream water intake facilities. It is critical to fully understand the behavior characteristics of contaminants on river surface, especially in case of oil spill accidents. Therefore, in this study, the effects of main parameters of advection and diffusion of contaminants were analyzed and validated by comparing the results of Lagrangian particle tracking (LPT) simulation of Environmental Fluid Dynamic Code (EFDC) model with those of Global Position System (GPS)-equipped drifter experiment. Prevention scenario modeling was accomplished by taking cases of movable weir operation into account. The simulated water level and flow velocity fluctuations agreed well with observations. There was no significant difference in the speed of surface particle movement between 5 and 10 layer modeling. Therefore, 5 layer modeling could be chosen to reduce computational time. It was found that full three dimensional modeling simulated wind effects on surface particle movements more sensitively than depth-averaged two dimensional modeling. The diffusion range of particles was linearly proportional to horizontal diffusivity by sensitivity analysis. Horizontal diffusivity estimated from the results of GPS-equipped drifter experiment was 0.096 m²/sec, which was considered to be valid for applying the LPT module in this area. Finally, the scenario analysis results showed that particle movements could be stagnant when discharge from the upstream weir was reduced, implying the possibility of securing time for mitigation actions such as oil boom installation and wiping oil contaminants. The outcomes of this study can help improve the prediction accuracy of particle tracking simulation to establish the most suitable mitigation plan considering the combination of movable weir operation.

• Journal of Climate Change Research
• /
• v.3 no.1
• /
• pp.1-12
• /
• 2012

In order to use as basic data of adaptation, this study focused on a 'Water management vulnerability estimation' in Korea. Vulnerability is estimated dividing into flood mitigation and water resource management. Temporal resolution is 2000 year and the future 2020 year, 2050 year, 2100 year via A1B scenario. Time series data was normalized. Then weight that is gotten through delphi investigation was multiplied. Vulnerability is calculated through this process. In flood mitigation vulnerability, it was estimated to adaptation ability affect relatively biggest influence. In future, some area of Gangwon-do was analyzed that the flood mitigation vulnerability increases. In water resource management, it was estimated to climate exposure affect relatively biggest influence. At 2020 yr, there is a trend toward increased in the Chungcheongbuk-do and DaeJeon, Daegu, some area of Gyeongsangnamdo. Because this study evaluate relative vulnerability of whole country and analyzed spatial distribution, when local government establishes climate change adaptation details enforcement countermeasure, this study can give help to grasp whether should invest more in some field.

• Journal of Environmental Impact Assessment
• /
• v.8 no.1
• /
• pp.29-40
• /
• 1999

This study focuses on one of typical energy-intensive industries, the cement industry. The purpose of the study is to propose $SO_2$ emission reduction measures in the cement industry. This study partially employed and modified AIM(Asia-Pacific Integrated Model) developed by Japan National Environmental Research Institute to develop AIM/KOREA SULFUR model for simulation. In the study, a base scenario, and mitigation scenarios(a use of low-sulfur contain fuel, fuel conversion to cleaner energy, an induction of desulfurization systems, and energy saving) were employed. The results of the simulation are summarized below: The sulphur dioxide emission from the cement industry in 1992 was estimated to be 106,000 metric tons; however, according to base scenario, sulphur dioxide emission is expected to be increased to 219,000 metric tons, which is 2.1 times greater than that in 1992 by year 2020. To alleviate such increasement, simulation results under various scenarios proved that some degrees of reduction may be possible by an induction of desulfulization systems although there may be numerous ways to interpretate the simulation results.

• 한국방재학회:학술대회논문집
• /
• 2008.02a
• /
• pp.695-698
• /
• 2008

The SWAT model was used to assess the impacts of potential future climate change on the hydrology of the Upper Geum River Basin(UGRB). Calibration and validation of SWAT were performed on a monthly basis for 1982-1995 and 1996-2005, respectively. The impact of ten 15-year(1988-2002) scenarios were then analyzed relative to a scenario baseline. Among them, scenario 1-6 were set to show the sensitivity response. A doubling of atmospheric CO2 concentration was predicted to result in an maximum monthly flow increase of 11 percent. Non-linear impacts were predicted among precipitation change scenarios of -42, -17, 17, and 42 percent, which resulted in average annual flow changes in UGRB of -55, -24, 26, and 65 percent.

• Earthquakes and Structures
• /
• v.20 no.3
• /
• pp.337-351
• /
• 2021

On September 12, 2016, the Gyeongju earthquake occurred in the south-eastern region of the Korean peninsula. The event was ranked as the largest magnitude earthquake (=5.8) since instrumental recording was started by the Korean Metrological Administration (KMA) in 1978. The objective of this study is to provide information obtained from the 2016 Gyeongju earthquake and to propose a procedure estimating seismic risk of a typical old RC building for past and potential earthquakes. Ground motions are simulated using the point source model at 4941 grid locations in the Korean peninsula that resulted from the Gyeongju earthquake and from potential future earthquakes with the same hypocenter considering different soil conditions. Nonlinear response history analyses are conducted for each grid location using a three-story gravity-designed reinforced concrete (RC) frame that most closely represents conventional old school and public buildings. Then, contour maps are constructed to present the seismic risk associated with this building for the Gyeongju earthquake and potential future scenario earthquakes. These contour maps can be useful in the development of a mitigation plan for potential earthquake damage to school and public buildings at all grid locations on the Korean peninsula.

• Proceedings of the Korea Water Resources Association Conference
• /
• 2022.05a
• /
• pp.160-160
• /
• 2022

Floods are the most common natural disasters and are annually causing severe destructions worldwide. Human activities, along with expected increased extreme precipitation patterns as a result of climate change enhance the future potential of floods. There are proven evidence that infrastructure based responses to flood disaster is no longer achieving optimum mitigation and have created a false sense of security. Nature-based solutions(NBS) is a widely accepted sustainable and efficient approach for disaster risk reduction and involves the protection, restoration, or management of natural and semi-natural ecosystems to tackle the climate and natural crisis. Adoption of NBS in decision-making, especially in developing nations is limited due to a lack of sufficient scenario-based studies, research, and technical knowledge. This study explores the knowledge gap and challenges on NBS adoption with case study of developing nation, specially for flood management, by the study of multiple scenario analysis in the context of climate, land-use change, and policies. Identification and quantification of the strength of natural ecosystems for flood resilience and water management can help to prioritize NBS in policymaking leading to sustainable measures for integrated flood management.

• Journal of the Korean Society of Safety
• /
• v.32 no.5
• /
• pp.168-178
• /
• 2017

In order to prevent major and chemical accidents, some of the plants which would like to install and operate hazard chemicals handling facilities must submit Off-site Consequence Analysis due to recent arisen leak accidents since 2015. A lot of chemical industrials choose gas detectors as mitigation equipment to early detect gas vapor. The way of placement of gas detectors has two methods; Code-based Design(CBD) and Performance-based Design. The CBD has principles for gas detectors to be installed with consideration for the place that is expected to accumulate gas, and the leak locations according to legal standards and technical guidelines, and has a possibility to be unable to detect by these rules to locate gas detectors by vapor density information. The PBD has two methods; a Geographic Method and Scenario based Method. The Scenario-based Method has been suggested to make up for the Geographic Coverage Method. This Scenario-based Method draw the best optimum placement of gas detectors by considering leak locations, leak speed information, leak directions and etc. However, the domestic placement guidelines just refers to the CBD. Therefore, this study is to compare existing placement location of gas detectors by the domestic CBD with placement locations, coverages and the number of gas detectors in accordance with the Scenario-based Method. Also this study has measures for early detecting interest of Vapor Cloud and suitable placement of gas detectors to prevent chemical accidents. The Phast software was selected to simulate vapor cloud dispersion to predict the consequence. There are two cases; an accident hole size of leak(8 mm) from API which is the highst accident hole size less than 24.5 mm, and a normal leak hole size from KOSHA Guide (1.8 mm). Detect3D was also selected to locate gas detectors efficiently and compare CBD results and PBD results. Currently, domestic methods of gas detectors do not consider any risk, but just depend on domestic code methods which lead to placement of gas detectors not to make personnels recognize tolerable or intolerable risks. The results of the Scenario-based Method, however, analyze the leak estimated range by simulating leak dispersion, and then it is able to tell tolerable risks. Thus it is considered that individuals will be able to place gas detectors reasonably by making objectives and roles flexibly according to situations in a specific plant.