• KIPS Transactions on Computer and Communication Systems
• /
• v.9 no.11
• /
• pp.265-272
• /
• 2020

In the research of brain computer interface (BCI) technology, one of the big problems encountered is how to deal with some people as called the BCI-illiteracy group who could not control the BCI system. To approach this problem efficiently, we investigated a kind of spectral EEG characteristics in the prior resting state in association with BCI performance in the following BCI tasks. First, spectral powers of EEG signals in the resting state with both eyes-open and eyes-closed conditions were respectively extracted. Second, a convolution neural network (CNN) based binary classifier discriminated the binary motor imagery intention in the BCI task. Both the linear correlation and binary prediction methods confirmed that the spectral EEG characteristics in the prior resting state were highly related to the BCI performance in the following BCI task. Linear regression analysis demonstrated that the relative ratio of the 13 Hz below and above the spectral power in the resting state with only eyes-open, not eyes-closed condition, were significantly correlated with the quantified metrics of the BCI performance (r=0.544). A binary classifier based on the linear regression with L1 regularization method was able to discriminate the high-performance group and low-performance group in the following BCI task by using the spectral-based EEG features in the precedent resting state (AUC=0.817). These results strongly support that the spectral EEG characteristics in the frontal regions during the resting state with eyes-open condition should be used as a good predictor of the following BCI task performance.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.53 no.8
• /
• pp.66-75
• /
• 2016

Due to aggressive scaling of device sizes and reduced noise margins, physical defects caused by aging and process variation are continuously increasing. Additionally, with scaling limitation of metal wire and the increasing of communication volume, fault tolerant method in manycore network-on-chip (NoC) has been actively researched. However, there are few researches investigating reliability in NoC with voltage-frequency-island (VFI) regime. In this paper, we propose a table-based routing technique that can communicate, even if link failures occur in the VFI NoC. The output port is alternatively selected between best and the detour routing path in order to improve reliability with minimized hardware cost. Experimental results show that the proposed method achieves full coverage within 1% faulty links. Compared to $d^2$-LBDR that also considers a routing method for searching a detour path in real time, the proposed method, on average, produces 0.8% savings in execution time and 15.9% savings in energy consumption.

• Journal of Internet Computing and Services
• /
• v.16 no.3
• /
• pp.1-11
• /
• 2015

WBAN(Wireless Body Area Network) operating around the human body aims at medical and non-medical service at the same time. and it is the short-range communication technology requiring low-power, various data rate and high reliability. Various studies is performing for IEEE 802.15.4, because IEEE 802.15.4 can provide high compatibility for operate WBAN among communication standard satisfiable these requirements. Meanwhile, in the case of coexisting many IEEE 802.15.4-based WBAN, signal interference and collision are the main cause that is decreasing data reliability. but IEEE 802.15.4 Standard does not consider about coexistence of many networks. so it needs improvement. In this paper, To solve about this problem, identify coexistence problem of IEEE 802.15.4-based WBAN by preliminary experiments. and propose a scheme to mitigate the reliability decrease at multiple coexistence WBAN. The proposed scheme can be classified in two steps. The first step is avoidance to collision on the CFP through improving data transmission. The second step is mitigation collision through converting channel access method. Proposed scheme is verified the performance by performing comparison experiment with Standard-based WBAN.

• Journal of Korea Multimedia Society
• /
• v.10 no.10
• /
• pp.1347-1355
• /
• 2007

A sensor network is composed of a large number of tiny devices, scattered and deployed in a specified regions. Each sensing device has processing and wireless communication capabilities, which enable it to gather information from the sensing area and to transfer report messages to a base station. The energy-efficient routing paths are established when the base station requests a query, since each node has several characteristics such as low-power, constrained energy, and limited capacity. The established paths are recovered while minimizing the total transmit energy and maximizing the network lifetime when the paths are broken. In this paper, we propose a routing algorithm that each sensor node reports its adjacent link information to the sink node when a sink node broadcasts a query. The sink node manages the total topology and establishes routing paths. This algorithm has a benefit to find an alternative path by reducing the negotiating messages for establishing paths when the established paths are broken. To reduce the overhead of collection information, each node has a link information before reporting to the sink. Because the node recognizes which nodes are adjacent. The proposed algorithm reduces the number of required messages, because sensor nodes receive and report routing messages for establishment at the beginning of configuring routing paths, since each node keeps topology information to establish a routing path, which is useful to report sensing tasks in monitoring environments.

• Journal of KIISE
• /
• v.42 no.10
• /
• pp.1268-1279
• /
• 2015

In order to manage a large number of devices connected to the Internet of Things (IoT), the Internet Engineering Task Force (IETF) proposed the IPv6 Routing Protocol for Low Power and Lossy Networks (RPL). The route of the RPL network is generated through the use of an Objective Function (OF) that is suitable for the service that is required for the IoT network. Since the route of the RPL network is conventionally simply chosen only by considering the link quality between the nodes, it is sensible to seek an OF that can also provide better Quality of Service (QoS). In previous studies, the end-to-end delay might possibly be sub-optimal because they only deal with problems related to the reduction of energy consumption and not to the link quality on the path to the sink node. In this study, we propose a scheme that reduces the end-to-end delay but also gives full consideration to both the quality on the entire route to the destination and to the expected lifetime of nodes with bottlenecks from heaped traffic. Weighting factors for the proposed scheme are chosen by experiments and the proposed scheme can reduce the end-to-end delay and the energy consumption of previous studies by 20.8% and 10.5%, respectively.

• Journal of the Institute of Electronics Engineers of Korea CI
• /
• v.49 no.1
• /
• pp.39-45
• /
• 2012

In this paper, a distributed 2-hop routing algorithm is proposed. The main purpose of the proposed algorithm is to reduce the overall power consumption of each sensor node so that the lifetime of WSN(wireless sensor network) is prolonged. At the beginning of each round, the base station transmits a synchronization signal that contains information on the priority table that is used to decide whether each sensor node is elected as a cluster head or not. The priority table is constructed so that sensor nodes closer to half energy distance from the base station get the higher priority. 2-hop routing is done as follows. Cluster heads inside half energy distance from the base station communicate with the base station directly. Those outside half energy distance have to decide whether they choose 2-hop routing or 1-hop routing. To do this, each cluster head outside half energy distance calculates the energy consumption needed to communicate with the base station via 1-level cluster head or directly. If less energy is needed when passing through the 1-level cluster head, 2-hop routing is chosen and if not, 1-hop routing is chosen. After routing is done each sensor nodes start sensing data.

• KIPS Transactions on Computer and Communication Systems
• /
• v.6 no.3
• /
• pp.105-112
• /
• 2017

PCI Express is a bus technology that connects the processor and the peripheral I/O devices that widely used as an industry standard because it has the characteristics of high-speed, low power. In addition, PCI Express is system interconnect technology such as Ethernet and Infiniband used in high-performance computing and computer cluster. PGAS(partitioned global address space) programming model is often used to implement the one-sided RDMA(remote direct memory access) from multi-host systems, such as computer clusters. In this paper, we design and implement a OpenSHMEM API based on PCI Express maintaining the existing features of OpenSHMEM to implement RDMA based on PCI Express. We perform experiment with implemented OpenSHMEM API through a matrix multiplication example from system which PCs connected with NTB(non-transparent bridge) technology of PCI Express. The PCI Express interconnection network is currently very expensive and is not yet widely available to the general public. Nevertheless, we actually implemented and evaluated a PCI Express based interconnection network on the RDK evaluation board. In addition, we have implemented the OpenSHMEM software stack, which is of great interest recently.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.17 no.12
• /
• pp.2806-2811
• /
• 2013

New technologies such as multi-antenna and small cell were proposed as key technology for the next generation mobile system to cope with the explosively increasing mobile data traffic. In particular, heterogeneous mobile communication network which can improve spatial reuse factor by exploiting macro and small cells simultaneously is attracting attention. However, the heterogeneous network has a problem that the utilization of small cells becomes low because the transmit power of macro base stations is much higher than that of small base stations and then the probability that mobile stations are attached to the macro base stations becomes high. This problem is dominant in uplink. The concept of cell range expansion bias to mitigate the problem was proposed by 3GPP and the corresponding standardization is in progress. In this paper, we analyze the downlink performance of the heterogeneous mobile communication network based on a system level simulator with the cell range expansion bias in terms of average cell spectral efficiency.

• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.32 no.6
• /
• pp.561-568
• /
• 2020

Wave measurements using X-band radar have many advantages compared to other wave gauges including wave-rider buoy, P-u-v gauge and Acoustic Doppler Current Profiler (ADCP), etc.. For example, radar system has no risk of loss/damage in bad weather conditions, low maintenance cost, and provides spatial distribution of waves from deep to shallow water. This paper presents new methods for estimating significant wave heights of X-band marine radar images using Artificial Neural Network (ANN). We compared the time series of estimated significant wave heights (Hs) using various estimation methods, such as signal-to-noise ratio (${\sqrt{SNR}}$), both and ${\sqrt{SNR}}$ the peak period (TP), and ANN with 3 parameters (${\sqrt{SNR}}$, TP, and Rval > k). The estimated significant wave heights of the X-band images were compared with wave measurement using ADCP(AWC: Acoustic Wave and Current Profiler) at Hujeong Beach, Uljin, Korea. Estimation of Hs using ANN with 3 parameters (${\sqrt{SNR}}$, TP, and Rval > k) yields best result.

• Journal of Intelligence and Information Systems
• /
• v.28 no.1
• /
• pp.175-196
• /
• 2022

Information and communication and home appliance industries, which were one of South Korea's main industries, are gradually losing their export share as their export competitiveness is weakening. This study objectively analyzed export competitiveness and suggested export-promising countries in order to help South Korea's information communication and home appliance industries improve exports. In this study, network properties, centrality, and structural hole analysis were performed during network analysis to evaluate export competitiveness. In order to select promising export countries, we proposed a new variable that can take into account the characteristics of an already established International Trade Network (ITN), that is, the Global Value Chain (GVC), in addition to the existing economic factors. The conditional log-odds for individual links derived from the Exponential Random Graph Model (ERGM) in the analysis of the cross-border trade network were assumed as a proxy variable that can indicate the export potential. In consideration of the possibility of ERGM linkage, a parametric approach and a non-parametric approach were used to recommend export-promising countries, respectively. In the parametric method, a regression analysis model was developed to predict the export value of the information and communication and home appliance industries in South Korea by additionally considering the link-specific characteristics of the network derived from the ERGM to the existing economic factors. Also, in the non-parametric approach, an abnormality detection algorithm based on the clustering method was used, and a promising export country was proposed as a method of finding outliers that deviate from two peers. According to the research results, the structural characteristic of the export network of the industry was a network with high transferability. Also, according to the centrality analysis result, South Korea's influence on exports was weak compared to its size, and the structural hole analysis result showed that export efficiency was weak. According to the model for recommending promising exporting countries proposed by this study, in parametric analysis, Iran, Ireland, North Macedonia, Angola, and Pakistan were promising exporting countries, and in nonparametric analysis, Qatar, Luxembourg, Ireland, North Macedonia and Pakistan were analyzed as promising exporting countries. There were differences in some countries in the two models. The results of this study revealed that the export competitiveness of South Korea's information and communication and home appliance industries in GVC was not high compared to the size of exports, and thus showed that exports could be further reduced. In addition, this study is meaningful in that it proposed a method to find promising export countries by considering GVC networks with other countries as a way to increase export competitiveness. This study showed that, from a policy point of view, the international trade network of the information communication and home appliance industries has an important mutual relationship, and although transferability is high, it may not be easily expanded to a three-party relationship. In addition, it was confirmed that South Korea's export competitiveness or status was lower than the export size ranking. This paper suggested that in order to improve the low out-degree centrality, it is necessary to increase exports to Italy or Poland, which had significantly higher in-degrees. In addition, we argued that in order to improve the centrality of out-closeness, it is necessary to increase exports to countries with particularly high in-closeness. In particular, it was analyzed that Morocco, UAE, Argentina, Russia, and Canada should pay attention as export countries. This study also provided practical implications for companies expecting to expand exports. The results of this study argue that companies expecting export expansion need to pay attention to countries with a relatively high potential for export expansion compared to the existing export volume by country. In particular, for companies that export daily necessities, countries that should pay attention to the population are presented, and for companies that export high-end or durable products, countries with high GDP, or purchasing power, relatively low exports are presented. Since the process and results of this study can be easily extended and applied to other industries, it is also expected to develop services that utilize the results of this study in the public sector.