• Journal of the Korean Society of Tobacco Science
• /
• v.8 no.1
• /
• pp.41-48
• /
• 1986

This experiment was carries out to study on the effect of temperature raising rate to chemical composition of tobacco leaves during the midrib drying stage of flue-curing. The results were as follows : In the case of the temperature raising rate became more rapidly during midrib drying stage. It had a tendency to increase in oxailic acid, succinlc acid, ammonia, polyphenol; there was a large loss of total sugar, reducing sugar, malic acid, palmitic acid and linolenic acid; leaf color became more reddish; the leaf quality index value decreased, thereby the quality of external appearance deteriorated. It is desirable that the temperature raising rate had to be more slowly.

• Journal of the Korean Wood Science and Technology
• /
• v.23 no.1
• /
• pp.35-41
• /
• 1995

Persimmon boards of 30mm thick were dried, their temperatures were monitored during drying with 490 and 200watt microwave, and the drying efficacy and problems were investigated. The effects of pretreatments such as presteaming and prefreezing were also examined. The persimmon green lumbers of 80% moisture content were dried to 10% for only 50~60 and 110 minutes with 49watt and 200watt microwave, respectively. Severe internal checks were, however, found in all boards. The presteamed boards collapsed on their surfaces earlier than the controls. It may attribute to the high temperature inside boards during microwave drying and the decrease of their internal tensile strength caused by the presteaming treatment. To increase the internal tensile strength of the pretreated boards and to reduce their internal checks, they were air-dried at room temperature. The air-dried boards could be dried to 10% moisture content clearly and free from defects with 200watt microwave. The heating efficiency were also calculated with the maximum weight loss per minute of 490watt and 200watt.

• Korean Journal of Food Science and Technology
• /
• v.31 no.6
• /
• pp.1589-1595
• /
• 1999

Reverse osmosis(RO) and rotary evaporation, freezer drying and spray drying as concentration and dehydration methods were, respectively, employed to investigate their effect on the flavor quality of ginger powder. Rotary evaporation and spray drying methods were more effective to restrict the browning of ginger powder than RO and freezer drying methods. Concentration methods had no effect on the free amino acids and free sugar contents of ginger powder, but freezer drying resulted in the less quality loss than spray drying. And the powder prepared from enzymatically hydrolyzed extract contained less crude protein, crude ash, browning and the changes in free amino acids, but had more the crude fat, solubility and free sugars than that from ginger extract obtained by filter press. Sensory results indicated that quality of ginger powder prepared by RO concentration and freeze drying of enzymatically hydrolyzed extract was as good as that without enzyme hydrolysis

• Journal of Biosystems Engineering
• /
• v.7 no.1
• /
• pp.42-52
• /
• 1982

This study was intended to develop a cost function for the natural air in-bin drying: system which could lead to an optimization of the drying system cost. Based on the cost function developed, a series of simulated drying tests were conducted with 10-year weather data (1970~1979) for 7 different regions by applying an appropriate levels of system factors. System performance factors treated in this study were initial moisture content, airflow rate, bin diameter and grain depth. An optimization procedure to find the least cost system was developed as follows: First, the worst year of the past decade was determined in consideration of the dryiang time and maximum dry matter loss. Second, the minimum airflow rate for a fixed bin diameter and grain depth was determined. Third, the optimum grain depth was found for the minimum airflow rate with different initial moisture contents and bin diameters. The results obtained in this study are summarized as follows: 1. The optimization procedure developed in this study was able to reduce the time and efforts significantly. 2. Optimum values of drying parameters including airflow rate, grain depth, and fan size were determined for different initial moisture contents and bin diameters in each region. The results are shown in Tables 3 to 9. 3. Optimum grain depths decreased as the initial moisture content and airflow rate increased. 4. Drying time for the least cost system should be reduced with higher initial moisture content and lower drying potential to prevent grain spoilage. 5. The fixed cost was 65 to 75 percent of the total system cost and the variable cost was 25 to 35 percent. To reduce the fixed cost it is desirable to use a drying bin 2 or 3 times a year.

• Korean Journal of Food Science and Technology
• /
• v.7 no.2
• /
• pp.69-73
• /
• 1975

Hot air drying of red pepper was studied on the quality of dried products at various drying conditions. In order to investigate the effects of drying methods on the red pepper quality, color appearance, capsanthin (red pigment) and capsaicine (hot taste principle) were analyzed. Color appearance and red pigments of dried red pepper powder were excellently superior to the conventional sun dried products, in spite of partial decolorization by cut drying, at moderate drying temperature ranges from $55^{\circ}C$ to $65^{\circ}C$. A better capsaicine content was recorded at hot air whole dried peppers than the conventional sun dried products. on the other hand about 20 percent loss was observed in cut dried ones. And hot air dried red pepper powder showed better preservative properties than sun dried pepper.

• Journal of the Korean Society of Food Science and Nutrition
• /
• v.41 no.9
• /
• pp.1315-1319
• /
• 2012

Red pepper (Capsicum annuum L.) powder is widely used as a spice and flavor ingredient in the food industry. It is well known that during the drying process red pepper undergoes physico-chemical and nutritional changes. The objective of this study was to investigate the quality of red pepper powder according to drying method. Red pepper was dried by far-infrared drying, hot air drying, and polyethylene (PE) house drying. Average moisture content of dried red pepper powder from the three different drying methods was $12.5{\pm}0.3%$. The pH level slightly increased from 4.93 before drying to 5.00~5.54 after drying. Contents of capsaicinoids were highest (224.40 mg/100 g) in the PE house drying method and lowest (191.87 mg/100 g) in the hot air drying ($70^{\circ}C$) method. However, capsaicinoid contents were not significantly different among the various drying methods. Vitamin C content decreased as temperature increased. Drying conditions, particularly temperature, lead to loss of vitamin C in red pepper, resulting in quality degradation. Taken together, these results demonstrate that the content of vitamin C, one of the major factors affecting pepper powder quality, was affected by drying temperature.

• Proceedings of the Korea Concrete Institute Conference
• /
• 2000.10b
• /
• pp.925-928
• /
• 2000

In this paper, physical properties of cement mortar for floor using expansion agent are discussed varied with mixing time and curing temperature, delivery time and content of added water for preventing fluidity loss. According to experimental results, slump loss shows high with elapse of time And as curing temperature goes up, it also show high when curing temperature goes up and time lag between mixing and casting increases. As curing temperature goes down, drying shrinkage shows to be decreased. But it shows decline tendency with increase of added water content.

• Journal of Biosystems Engineering
• /
• v.3 no.1
• /
• pp.33-46
• /
• 1978

To get the goal of self-supply of food grain, improvement of post-harvest grain operations in rural area is under consideration as an important task of agriculture in Korea. This is study is focused on elimination of losses and deteriorations of grain and reduction of labour requirements and funds for post-harvest grain operations. The purpose of this study are presentation of basic data referring to conventional post-harvest grain operations in rural area and suggestion of improving methods for the operations, and also finding out reasonable operating processes of the operations. The result of this study are follows; 1. Grain drying in-the-filed which is performed before threshing has major factors of grain loss during drying, and so should be restrained as possible. Combine harvesting system is recommended among other king of mechanized harvesting systems for restraining in-the-field drying and securing available labors for drying. 2. It is predicted that mechanical grain drying could be prevalent when combine harvesting is taken place. Recommended grain drier for pre-combine harvesting system and for combine harvesting system is batch-type drier and circulating -type drier, respectively. 3. As existing farm storages for grain have insufficient spaces and offer poor conditions for grain storing , it is greatly needed to build up new storage which store only grains. And it is concluded that storing grain in community common storages in desirable. 4. Power supplying system for milling machinery in local milling plants, that a large capacity prime mover supplies power to 4 to 6 kinds of milling machinery simultaeously, should be converted to a system of several small capacity prime movers supplying power to each machiner y for the purpose of reducing extra consumption of energy. 5. Governmental grain, of which Korean farms produced, should be milled and stored in the local milling plant successively for the purpose of reducing transportation fee and stroing facilities. 6. Furture post-havest grain operations-drying, storing and milling should be periormed successively in he community common plant. And average optimum processing capacity of the plant is estimated about 300 metric ton of grain every year.

• Korean Journal of Medicinal Crop Science
• /
• v.5 no.3
• /
• pp.211-216
• /
• 1997

Peony is commonly used as roots that peeled and dried. But intact root contains higher medicinal constituents than peeled root (machine peeling). The yield of roots was also higher in intact roots. Use of intact root saved the labor time for peeling and 15% of root from yield loss by peeling. Paeoniflorin content was different with each zones of root. The content of Paeoniflorin was 5.11% in epidermis and 3.28% in cortex. When peeled peony roots were dried at hot air after briquet fire drying, root color was good for commercialization. But color of intact root was good at hot air drying without briquet fire drying. The required time for drying was longer in drying of intact roots than peeled roots drying.

• Journal of Korean Society of Environmental Engineers
• /
• v.28 no.7
• /
• pp.746-751
• /
• 2006

In this study, drying and carbonization experiment was conducted in a fluidized bed reactor according to the variations in gas velocity, particle size, and reactor temperature. As a result, the weight loss rates of sludge by drying in the fixed bed and fluidized bed type dryer showed that drying in the fluidized bed was about 6 times faster than drying in the fixed bed, and the weight loss rates of sludge by carbonization in the fixed bed and fluidized bed type reactor showed that carbonization in the fluidized bed was about 4 times faster than drying in the fixed bed. This implies that carbonization in the fluidized bed was completed within 10 minutes. Although the amount of char decreased with the increase of carboniration temperature, the amount of char became similar at upper 873K. Also, the amount of char decreased with increasing gas velocity. Consequently, it could be efficient that slow fluidization should be maintained within the range of fluidization in case of fluidized carbonization of sewage sludge at 873K.