• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.8 no.5
• /
• pp.1120-1128
• /
• 2004

In this paper, we has designed and implemented Up-converter for K-band with high IMD3 performance using balanced power amplifier. It is consisted of PA module and, Local Oscillator module with reject Filter, mixer module and If block, and Up-converter has a local loop path to decide whether it operate or not and has the sensing port to inspect output power level. According to the power budget of designed Up-converter, K-band balanced power amplifier was fabricated by commercial MMIC. Measurement results of up-converter show about 40dB Gain, PldB of 29dBm and OIP3 was 38.25dBm, that is good performance compared to power budgets. We has adjusted gate voltage of MMIC to control more than 30 dB gain. This up-converter was used in transceiver for PTP and PTMP, and applied to digital communication system that use QAM and QPSK modulation.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.16 no.11 s.102
• /
• pp.1106-1113
• /
• 2005

This paper presents a dual-band mixer for multi-standards of IEEE 802.1la/b/g using a single local oscillator, so as to improve the defects of legacy systems. Those systems have duplicate local oscillators and mixers to handle dual band signals, increasing complexity of system and power loss. The proposed circuit shows 11.6 dB, 16.8 dB of conversion loss and 8.77 dBm, 12.5 dBm of IIP3(Input 3rd Intercept Point) for respective bands when the two RF inputs of 2.452 and 5.260 GHz are down-converted to the identical 356 MHz If frequency. The RF-LO isolations are measured 36 dB, 41 dB at each frequencies and over 50 dB of LO-IF isolations are achieved at all cases.

• Journal of the Society of Naval Architects of Korea
• /
• v.52 no.1
• /
• pp.25-33
• /
• 2015

Following the previous works on the natural frequency of heaving circular cylinder, i.e. Lee and Lee (2013) and Kim and Lee (2013), an investigation of the same spirit on the 2-dimensional cylinder of Lewis form has been conducted. As before, the natural frequency is defined as that corresponding to the local maximum of the MCFR (Modulus of Complex Frequency Response), which is given by the equation of motion in the frequency domain analysis. Hydrodynamic coefficients were found by using the Ursell-Tasai method, and numerical results for them were obtained up to much higher frequencies than before, for which the method was known as numerically unstable in the past. For a wide range of H, the beam-draft ratio, and ${\sigma}$, the sectional area coefficient, including their practical ranges for a ship, results for the natural frequency were computed and presented in this work. Two approximate values for the natural frequency, one proposed by Lee (2008) and another one by the damped harmonic oscillator, were also compared with the current results, and for most cases it was observed that the current result is between the two values. Our numerical results showed that the values of the local maximum of MCFR as well as the natural frequencye increase as ${\sigma}$ increases while H decreases. At present, extension of the present finding to the 3-dimensional ship via the approximate theory like the strip method looks promising.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.30 no.12C
• /
• pp.1248-1255
• /
• 2005

We investigate the OFDM-based wireless LAN systems operating in the 60 GHz frequency band as part of the fourth-generation (4G) systems. The 60 GHz band is of much interest since this is the band in which a massive amount of spectral space has been allocated worldwide for dense wireless local communications. This paper gives an overview of 60 GHz bandchannel characteristics and an effect on phase noise. The performance of OFDM system is severely degraded by the local oscillator phase noise, which causes both common phase error and inter-carrier interference. In this paper, we apply phase noise suppression (PNS) algorithm that is easy for implementation to OFDM based 60 GHz wireless LAM system and analyze the SER performance. In case of using the PNS algorithm, SER performance is improved about 6dB, 7.5dB, respectively in 16, 64-QAM.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.6 no.1
• /
• pp.38-44
• /
• 1981

This paper is for the design and construction of TV translator using in the areas where TV signal is not detectible. In this paper, theoretical design method and the scheme to decrease the intermodulation occurred by the harmonics of local oscillator are proposed. In the processes of design we have known that intermodulation of wideband IF amplifier is cannot avoidable when only single IF band is used for all the TV channels As the input vs output characteristics of TV trasnlator we have obtained the constant output signal level of +30 dBm for the input signal levels of -76dBm~-26dBm. And in the 6MHz passband, more than 95% of linearity is obtained.

• ETRI Journal
• /
• v.40 no.2
• /
• pp.167-179
• /
• 2018

This paper proposes an IEEE 802.15.4m compliant TV white-space orthogonal frequency-division multiplexing (TVWS)-(OFDM) radio frequency (RF) transceiver that can be adopted in advanced metering infrastructures, universal remote controllers, smart factories, consumer electronics, and other areas. The proposed TVWS-OFDM RF transceiver consists of a receiver, a transmitter, a 25% duty-cycle local oscillator generator, and a delta-sigma fractional-N phase-locked loop. In the TV band from 470 MHz to 698 MHz, the highly linear RF transmitter protects the occupied TV signals, and the high-Q filtering RF receiver is tolerable to in-band interferers as strong as -20 dBm at a 3-MHz offset. The proposed TVWS-OFDM RF transceiver is fabricated using a $0.13-{\mu}m$ CMOS process, and consumes 47 mA in the Tx mode and 35 mA in the Rx mode. The fabricated chip shows a Tx average power of 0 dBm with an error-vector-magnitude of < 3%, and a sensitivity level of -103 dBm with a packet-error-rate of < 3%. Using the implemented TVWS-OFDM modules, a public demonstration of electricity metering was successfully carried out.

• Journal of electromagnetic engineering and science
• /
• v.4 no.4
• /
• pp.143-149
• /
• 2004

This paper describes characteristics of the single-balanced low IF resistive FET mixer for the digital beam forming(DBF) receiver. This DBF receiver based on the direct conversion method is designed with Low IF I and Q channel. A radio frequency(RF), a local oscillator(LO) and an intermediate frequency(IF) considered in this research are 1950 MHz, 1940 MHz and 10 MHz, respectively. Super low noise HJ FET of NE3210S01 is considered in design. The measured results of the proposed mixer are observed IF output power of -22.8 dBm without spurious signal at 10 MHz, conversion loss of -12.8 dB, isolation characteristics of -20 dB below, 1 dB gain compression point(PldB) of -3.9 dBm, input third order intercept point(IIP3) of 20 dBm, output third order intercept point(OIP3) of 4 dBm and dynamic range of 30 dBm. The proposed mixer has 1.0 dB higher IIP3 than previously published single-balanced resistive and GaAs FET mixers, and has 3.0 dB higher IIP3 and 4.3 dB higher PldB than CMOS mixers. This mixer was fabricated on 0.7874 mm thick microstrip $substrate(\varepsilon_r=2.5)$ and the total size is $123.1\;mm\times107.6\;mm$.

• Journal of Navigation and Port Research
• /
• v.28 no.6
• /
• pp.573-578
• /
• 2004

The most important effects on algae multiplication are coming from maintaining the growth environment such as necessary nutrients and proper temperature, but it is difficult to adjust for every species individually. In this study, therefore, the environment is obtained using the local water where target organisms live, and their growth is promoted by raising the water temperature. A sensor to count the organism population is developed here. Because the early stage of a sudden increase of the algae population is detected using the sensor, it is available to predict the sudden increase of algae, a source of red tide.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.1 no.1
• /
• pp.23-31
• /
• 1976

When Television signal of VHF and UHF channel is retransmitted at the relay system with 6MHz Bandwidth including video and aural signals, the image is often affected with the unnatural changes of output amplitude frequency response within ttle region of dual sideband near to the carrier frequency. These phenomena are caused by the unnecessary lower sideband due to the spurious emission at the local oscillator, the nonlinear distortion in the linear amplifier, the intermoudulation distortion with the components of neighboring signal, the AM-PM conversion, and the envelope delay distortion. From the output characteristics, considering above results, the chief cause is caused by nonlinear response and has an effect on the bias states. Finally, it is confirmed that the effects on neighboring signal appear high in case of Down conversion than Up conversion and obtained the method for reducing the effects on the system.

• Proceedings of the KIEE Conference
• /
• 2008.05a
• /
• pp.153-156
• /
• 2008

본 논문은 Local oscillator의 2차 harmonic 신호를 이용하고 Dual gate FET 형태를 이용한 이중대역 주파수 혼합기 설계에 대한 연구 이다. 기존의 회로 구조는 두 대역을 처리하기 위해 각각 두 개의 국부 발진기와 혼합기를 사용함으로 인하여 구조의 복잡함과 큰 전력 손실이라는 단점을 가지고 있었다. 본 연구는 하나의 주파수 혼합기로 두 개의 대역에서 동시에 적용할 수 있는 Concurrent 이중 대역 설계 연구를 하였다. ISM(Industrial Science Medical) 대역 인 912MHz, 2.45GHz의 RF 입력과 455.5MHz, 1224.5MHz의 LO 입력 신호에서 동일한 IF인 1MHz로 하향변환 했을 때 모의실험 결과 변환이득은 각각 7dB, 12dB로 이고 RF-LO 격리도는 -29dB, -24.7dB가 나왔다. 또한 두 입력 단에서의 반사손실의 -15dB 이상을 얻었다. 또한 각각의 대역에서 잡음지수는 8.5dB, 6.26dB이다.