• The Journal of the Korea institute of electronic communication sciences
• /
• v.14 no.6
• /
• pp.1129-1138
• /
• 2019

Since substations are structurally complex due to the concentration of protection coordination facilities with substation facilities for long distance power transmission, it is difficult to design a protection coordination system to minimize the spreading effect of the fault when a fault occurs on transmission line or distribution line. Therefore, in this paper, the bus configuration and the basic logic of protection coordination that have a major influence on the reliability of substation power supply were analyzed, and the substation protection coordination logic to detect internal and external faults was developed based on EMTP-RV. As the basic logic of substation protection coordination, the percent differential protection relay logic for substation internal fault detection and the overload protection relay logic for inference of external failure were modeled. Finally, the 154kV substation including the protection coordination logic was modeled using EMTP-RV, and the effectiveness of the protection coordination design methodology was confirmed through the several fault simulation cases based on EMTP-RV.

• Journal of Environmental Science International
• /
• v.1 no.2
• /
• pp.119-124
• /
• 1992

Cloud streets were successfully simulated by numerical model (RAMS) including an Isolated mountain near the coast, large sensible heat flux from the sea surface, uniform stratification and wind velocity with low Froude number (0.25) in the inflow boundary The well developed cloud streets between a pair of convective rolls are simulated at a level of 1 km over the sea. The following five results were obtained: 1) port the formation of the pair of convective rolls, both strong static instability and a topographically induced mechanical disturbance are strongly required at the same time. 2) Strong sensible heat flux from the sea surface is the main energy source of the pair of convective rolls, and the buoyancy caused by condensation in the cloud is negligibly small. 3) The pair o( convective rolls is a complex of two sub-rolls. One is the outer roll, which has a large radius, but weak circulation, and the other is the inner roll, which has a small radius, but strong circulation. The outer roll gathers a large amount of moisture by convergence in the lower marine boundary, and the inner roll transfers the convergent moisture to the upper boundary layer by strong upward motion between them. 4) The pair of inner rolls form the line-shaped cloud streets, and keep them narrow along the center-line of the domain. 5) Both by non-hydrostatic and by hydrostatic assumptions, cloud streets can be simulated. In our case, non-hydrostatic processes enhanced somewhat the formation of cloud streets. The horizontal size of the topography does not seem to be restricted to within the small scale where non-hydrostatic effects are important.

• The Transactions of the Korean Institute of Electrical Engineers P
• /
• v.60 no.3
• /
• pp.114-119
• /
• 2011

Large Power transformer is a complex and critical component of power plant and consists of cellulosic paper, insulation oil, core, coil etc. Insulation materials of transformer and related equipment break down to liberate dissolved gas due to corona, partial discharge, pyrolysis or thermal decomposition. The dissolved gas kinds can be related to the type of electrical faults, and the rate of gas generation can indicate the severity of the fault. The identities of gases being generated are using very useful to decide the condition of transformation status. Therefore dissolved gas analysis is one of the best condition monitoring methods for power transformer. Also, on-line multi-gas analyzer has been developed and installed to monitor the condition of critical transformers. Rogers method, IEC method, key gas method and Duval Triangle method are used to failure diagnosis typically, and those methods are using the ratio or kinds of dissolved gas to evaluate the condition of transformer. This paper analyzes the reliability of transformer diagnostic methods considering actual dissolved gas concentration. Fault diagnosis is performed based on the dissolved gas of five transformers which experienced various fault respectively in the field, and the diagnosis result is compared with the actual off-line fault analysis. In this comparison result, Diagnostic methods using dissolved gas ratio like Rogers method, IEC method are sometimes fall outside the ratio code and no diagnosis but Duval triangle method and Key gas method is correct comparatively.

• Transactions of the Korean Society of Mechanical Engineers A
• /
• v.34 no.10
• /
• pp.1513-1519
• /
• 2010

Recently, on-line process monitoring systems using sensors are being extensively used to produce highquality products. However, the difficulty in installing the sensors within the mold in the cases of micro-molds, optical molds, and molds with complex structures is a serious disadvantage of such process monitoring systems. In this study, the quantitative index of a process monitoring system was evaluated with the mold cavity pressure and the nozzle pressure for the injection molding machine. In order to evaluate the effect of the nozzle pressure, we performed correlation analysis for the weight of the molded product. We also examined the control characteristics of the injection molding machine by analyzing the effect of multistage injection speed, holding pressure, and injection pressure limit on the process monitoring data.

• Ocean and Polar Research
• /
• v.26 no.4
• /
• pp.669-678
• /
• 2004

Coastal states are adopting maritime boundary delimitation as their primary maritime policy because maritime jurisdiction directly relates to vast economic interest. This becomes specially important and sensitive when complex maritime boundary issues are involved between neighboring coastal states. China has not actively carried out nor declared maritime boundary delimitation until recently with any country except Agreement between China and Viet Nam on the demarcation of the territorial water, the exclusive economic zones and the continental shelf of China and Vet Nam in the Gulf of Tonkin on 25 December 2000 (hereinafter, the Gulf of Tonkin Agreement). The principles that governs maritime boundary delimitation are to consider primarily an agreement between States concerned, however, if no agreement can be reached, all relevant circumstances are considered to achieve an equity between concerned States. Relevant circumstances are length of coastline, form of coastline, existence and position of island or islands, speciality of geology/topography, and factor of economy and deffnce. Factors which sinologists are considering in regard to continental shelf delimitation of the Yellow Sea are as follows; i) geographical factor, ii) geological factor, iii) topographical factor, iv) environment and ecological (factor, v) historic interest, and vi) social and economic interest. The 'Gulf of Tonkin Agreement' is completed by basically applying the principle of delimitation according to median line which seems that China has adopted the maritime boundary delimitation principle of 'half and half' which was the intention of chinese government. At the same time, China recognized Viet Nam's dominion and sovereign right over the partial exclusive economic zone and the continental shelf of Dao Bach Long Vi in Gulf of Tonkin. This case can be considered as an example of mutual concession or compromise in delimiting maritime boundary for states of concerned.

• Journal of Biomedical Engineering Research
• /
• v.32 no.1
• /
• pp.15-24
• /
• 2011

While Compton imaging is recognized as a valuable 3-D technique in nuclear medicine, reconstructing an image from Compton scattered data has been of a difficult problem due to its computational complexity. The most complex and time-consuming computation in Compton camera reconstruction is to perform the conical projection and backprojection operations. To alleviate the computational burden imposed by these operations, we investigate a rebinning method which can convert conical projections into parallel projections. The use of parallel projections allows to directly apply the existing deterministic reconstruction methods, which have been useful for conventional emission tomography, to Compton camera reconstruction. To convert conical projections into parallel projections, a cone surface is sampled with a number of lines. Each line is projected onto an imaginary plane that is mostly perpendicular to the line. The projection data rebinned in each imaginary plane can then be treated as the standard parallel projection data. To validate the rebinning method, we tested with the representative deterministic algorithms, such as the filtered backprojection method and the algebraic reconstruction technique. Our experimental results indicate that the rebinning method can be useful when the direct application of existing deterministic methods is needed for Compton camera reconstruction.

• Asian Pacific Journal of Cancer Prevention
• /
• v.14 no.12
• /
• pp.7095-7100
• /
• 2013

Histone deacetylase (HDAC) inhibitors of cyclic peptide have been proved to be the most complex but the most stable and relative efficient inhibitors because of their large cap region. In this paper, a series of studies were carried out to evaluate the efficacy of synthetic bicyclic tetrapeptide inhibitors 1-5 containing hydroxamic acid referring molecular docking, anti-proliferation, morphology and apoptosis. Docking analysis, together with enzyme inhibitory results, verified the selective capability of inhibitor 4 to HDAC4, which might closely related to haematological tumorigenesis, with Phe227, Asp115, Pro32, His198 and Ser114 participating into hydrophobic interactions and Van der Waals force which was familiar with former study. Moreover, inhibitor 4 inhibited K562 cell line at the $IC_{50}$ value of 1.22 ${\mu}M$ which was 51-67 times more efficient than that for U937 and HL60 cell lines. Inhibitor 4 exhibited the cell cycle-arrested capability to leukemia at S phase or G2/M phase as well as apoptosis-induced ability in different degrees. Finally, we considered that bicyclic tetrapeptide inhibitors were promising inhibitors used in cancer treatment and inhibitor 4 could prevent K562 cell line well from proliferation, arrest cell cycle and induce K562 towards apoptosis to achieve the goals of reversing cancer cells which could become a potential leukemia therapeutic agent in the future.

• The Journal of the Korea Contents Association
• /
• v.9 no.2
• /
• pp.181-192
• /
• 2009

Prints in the contemporary art has the radical aspects at not only to maintain the characteristic of printmaking in a field of visual image but also to fulfill and communicate a desire of the public. We can see this from the change of the printmaking forms among the alternation of diverse expression methods and media such as from the line-cut at the Renaissance to colored print process, photography, the beginning of 20th century cartoons, advertisement, art, and graphic poster. From that, we can understand the printmaking as a fluid media, not fixed, has finely accomplished its functions as an act of visual language to smoothly communicate with the individual desire and character than word or language at the complex and various cultural surface. This study is focused on that prints as an avant-garde language in popular culture. Therefore, I have examined the following two aspects. First, with focussing at the specific characters of the graphic posters, I try to define the differences between language and visual language and the effect from it to our emotional perception and behavior with the politic and economic point of view. Second, how has the printmaking art as an fine arts finely accomplished an linguistic action. These are the purpose of this study.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.17 no.7
• /
• pp.374-379
• /
• 2016

On-line process monitoring schemes are designed to give early warnings of process faults. In the artificial intelligence and machine learning fields, reliable approaches have been utilized, such as kernel-based nonlinear techniques. This work presents a kernel-based empirical monitoring scheme with a small sample problem. The measurement data of normal operations are easy to collect, whereas special events or faults data are difficult to collect. In such situations, noise filtering techniques can be helpful in enhancing the process monitoring performance. This can be achieved by the preprocessing of raw process data and eliminating unwanted variations of data. In this work, the performance of several monitoring schemes was demonstrated using three-dimensional batch process data. The results showed that the monitoring performance was improved significantly in terms of the detection success rate.

• Proceedings of the KOSOMBE Conference
• /
• v.1997 no.05
• /
• pp.141-144
• /
• 1997

Femoral neck anteversion is the angle between the neck and the knee axis projected on a plane perpendicular to the longitudinal axis. Conventional methods that use cross-sectional Computed Tomography(CT) images to estimate femoral anteversion have several problems because of the complex 3D structure of the femur. These are the ambiguity of defining the longitudinal axis, the femoral neck axis and condylar line, and the dependence on patient positioning. Especially the femoral neck axis that is known as a major source of error is hard to determine from a single or multiple 2D transverse images. So we developed a new method for measuring femoral anteversion by 3D modeling method. In this method, femoral head is modeled as a sphere. The center of femoral neck is the mid-point of the 2D reconstructed oblique image in the femoral neck part. Then neck axis is a line connecting foregoing two centers. We model the longitude of femur as a cylinder, and the long axis is defined from the fitted cylinder. The knee axis which is tangent to the back of the femoral condyles is easily determined by table-top method. By the definition of femoral anteversion, the femoral anteversion is easily calculated from this model.