• Proceedings of the Korean Institute of Surface Engineering Conference
• /
• 2014.11a
• /
• pp.273-273
• /
• 2014

Quantum-dot sensitized solar cells (QDSCs) are an emerging class of solar cells owing to their easy fabrication, low cost and material diversity. Despite of the fact that the maximum conversion efficiency of QDSCs is still far less than that of Dye-Sensitized Solar Cells (>12 %), their unique characteristics like Multiple Exciton Generation (MEG), energy band tune-ability and tendency to incorporate multiple co-sensitizers concurrently has made QDs a suitable alternative to expensive dyes for solar cell application. Lead Sulfide (PbS) Quantum dot sensitized solar cells are theoretically proficient enough to have a photo-current density ($J_{sc}$) of $36mA/cm^2$, but practically there are very few reports on photocurrent enhancement in PbS QDSCs. Recently, $Hg^{2+}$ incorporated PbS quantumdots and Cadmium Sulfide (CdS) co-sensitized PbS solarcells are reported to show an improvement in photo-current density ($J_{sc}$). In this study, we explored the efficacy of $In_2S_3$ as an interfacial layer deposited through SILAR process for PbS QDSCs. $In_2S_3$ was chosen as the interfacial layer in order to avoid the usage of hazardous CdS or Mercury (Hg). Herein, the deposition of $In_2S_3$ interfacial layer on $TiO_2$ prior to PbS QDs exhibited a direct enhancement in the photo-current (Isc). Improved photo-absorption as well as interfacial recombination barrier caused by $In_2S_3$ deposition increased the photo-current density ($J_{sc}$) from $13mA/cm^2$ to $15.5mA/cm^2$ for single cycle of $In_2S_3$ deposition. Increase in the number of cycles of $In_2S_3$ deposition was found to deteriorate the photocurrent, however it increased $V_{oc}$ of the device which reached to an optimum value of 2.25% Photo-conversion Efficiency (PCE) for 2 cycles of $In_2S_3$ deposition. Effect of Heat Treatment, Normalized Current Stability, Open Circuit Voltage Decay and Dark IV Characteristics were further measured to reveal the characteristics of device.

• Food Science of Animal Resources
• /
• v.37 no.1
• /
• pp.79-86
• /
• 2017

Aflatoxin $M_1$ ($AFM_1$) after its bioconversion from aflatoxin $B_1$ in animal liver becomes the part of milk while heavy metals get entry into milk and milk products during handling in the supply chain. Aflatoxin $M_1$ and heavy metals being toxic compounds are needed to be monitored continuously to avoid any ailments among consumers of foods contaminated with such toxicants. Thirteen commercially available infant formula milk (IFM) brands available in Pakistani markets were analyzed for the quantitative determination of $AFM_1$ and heavy metals through ELISA and atomic absorption spectrophotometer, respectively. $AFM_1$ was found positive in 53.84% samples while 30.76% samples were found exceeding the maximum EU limit i.e. $0.025 {\mu}g/kg$ for $AFM_1$ in IFM. Heavy metals lead (Pb) and cadmium (Cd) were found below the detection limits in any of the sample, whereas the concentrations of iron (Fe), zinc (Zn) and nickel (Ni) ranged between 45.40-97.10, 29.72-113.50 and <$0.001-50.90 {\mu}g/kg$, respectively. The concentration of Fe in all the tested brands was found in normal ranges while the concentrations of Zn and Ni were found exceeding the standard norms. Elevated levels of $AFM_1$, Zn and Ni in some of the tested IFM brands indicated that a diet completely based on these IFM brands might pose sever health implications in the most vulnerable community i.e., infants.

• Journal of the Korean Association of Oral and Maxillofacial Surgeons
• /
• v.34 no.1
• /
• pp.19-27
• /
• 2008

Thirty-six sinus grafts were performed in 34 patients with an alveolar crest bone height in the posterior maxilla of 3 to 5 mm before grafting. The sinuses were grafted using Bio-Oss alone or mixed with fibrin glue. Group 1 was the control group and included 25 patients who received a xenograft mixed in saline. Group 2 comprised 9 patients who received a xenograft and fibrin glue. The study was further subdivided at the time of 9 months. This histologic study evaluated by hematoxylin-eosin (H&E) and histomorphometric analysis whether fibrin glue in combination with Bio-Oss enhances bone regeneration in sinus floor elevation in humans. The new bone formation was better in Group 2 than in Group 1, but the difference was not significant. The absorption of the graft material was faster in Group 2 than in Group 1, in the short term, but better in Group 1 over the long term, although the difference was not significant. Lamellar bone was formed earlier in Group 1 compared to Group 2, but the difference was not significant. Overall, the surgery site stabilized earlier with new bone formation in Group 2 than in Group 1, but the difference was not significant. Combining a fibrin sealant and Bio-Oss could lead to improved scaffolds for bone tissue engineering based on the synergistic effects of the biomaterials. Therefore, Bio-Oss or Bio-Oss plus Tisseel may be used depending on the situation.

• Safety and Health at Work
• /
• v.5 no.2
• /
• pp.106-111
• /
• 2014

Background: The manufacture of paint involves a variety of processes that present with medical hazards. Safety initiatives are hence introduced to limit hazard exposures and promote workplace safety. This aim of this study is to assess the use of available control measures/initiatives in selected paint factories in Lagos West Senatorial District, Nigeria. Methods: A total of 400 randomly selected paint factory workers were involved in the study. A well-structured World Health Organization standard questionnaire was designed and distributed to the workers to elicit information on awareness to occupational hazards, use of personal protective devices, and commonly experienced adverse symptoms. Urine samples were obtained from 50 workers randomly selected from these 400 participants, and the concentrations of the heavy metals (lead, cadmium, arsenic, and chromium) were determined using atomic absorption spectroscopy. Results: The results show that 72.5% of the respondents are aware of the hazards associated with their jobs; 30% have had formal training on hazards and safety measures; 40% do not use personal protective devices, and 90% of the respondents reported symptoms relating to hazard exposure. There was a statistically significant (p < 0.05) increase in the mean heavy metal concentrations in the urine samples obtained from paint factory workers as compared with nonfactory workers. Conclusion: The need to develop effective frameworks that will initiate the integration and ensure implementation of safety regulations in paint factories is evident. Where these exist, there is a need to promote adherence to these practice guidelines.

• Journal of Applied Biological Chemistry
• /
• v.42 no.3
• /
• pp.140-145
• /
• 1999

Livestock manure is generally beneficial to soil and crop production when appropriate amount is applied, but excessive application may be detrimental to soil and water environments. A proper protocol of livestock waste treatment is required to manage the quality of soil and water. A trickling filter system using rice straw media was employed to treat piggery wastewater from small-scaled livestock farms as an alternative to the currently available methods. Batches of piggery wastewater were treated with this system, and the byproducts of rice straw media and trickling filtrate were applied to the soil with cultivating rye (Secale cereale L.). Objective of this research was to characterize these byproducts for the sustainable soil amendments and rye production. Both the treated straw medium and filtrate were proven to be effective organic fertilizers for rye plant development, with the enhanced but balanced absorption of nutrients. The synergistic effects of filtrate in addition to straw application did not show, but the filtrate appeared to lead to a higher water content of the plant. No specific nutrient deficiency or toxicity symptom was shown due to the salts derived from the byproducts applied. Chemical parameters of the soil quality were significantly improved with the application of straw medium either with or without the filtrate. Judging from parameters relating to the salt accumulations, such as sodium adsorption ratio (SAR), electrical conductivity (EC), exchangeable sodium percentage (ESP), potassium adsorption ratio (KAR), and residual P concentrations, the byproducts from piggery wastewater exhibited no detrimental effects on soil quality within the ranges of treatments used. In addition to the effectiveness of the rice straw trickling filter system for the small-scaled swine farms, both rice straw medium and filtrate could be recycled for the sustainable soil amendment and plant nutrition.

• Journal of the Korean Society of Food Science and Nutrition
• /
• v.18 no.3
• /
• pp.316-320
• /
• 1989

This study was performed to assess the contamination levels of the heavy metals (Pb, Cd, Cr, Cu, Fe, Zn and Mn) for common restaurant meals in Seoul area. The samples were seolong-tang, galbi-tang, yeukge-jang, kalguksoo, doenjang-chige, bibim-bab, bibim-nangmyon, bulgogi, chazang-myon, yanggobchang and zumuluk, which were seperated draind residues from fluids. The heavy metal contents were determined by atomic absorption spectrophotometer. The results obtained were as follows : ${\circ}$ The total amount of heavy metals per meals were $131.8{\mu}g\;lead,\;18.4{\mu}g\;cadmium,\;135.5{\mu}g\;chromium,\;804.9{\mu}g\;copper,\;7430.6{\mu}g\;iron,\;2807.4{\mu}g\;zinc,\;and\;841.6{\mu}g$ manganese. ${\circ}$ Intake levels per daily through common restaurant meals were lower than the daily intake limit established by FAO/WHO.

• The Bulletin of The Korean Astronomical Society
• /
• v.39 no.1
• /
• pp.47.2-47.2
• /
• 2014

Several studies have reported the presence of sodium excess objects having neutral atomic absorption lines at $5895{\AA}$ (NaD) and $8190{\AA}$ that are deeper than expected based on stellar population models that match the stellar continuum. The origin of these lines is therefore hotly debated. van Dokkum & Conroy proposed that low-mass stars (0.3M) are more prevalent in massive early-type galaxies, which may lead to a strong NaI 8190 line strength. It is necessary to test this prediction, however, against other prominent optical line indices such as NaD, Mgb, and Fe5270, which can be measured with a significantly higher signal-to-noise ratio than NaI 8190. We identified a new sample of roughly one thousand NaD excess objects (NEOs; ~8% of galaxies in the sample) based on NaD line strength in the redshift range 0.00$H{\beta}$ line strengths and significant emission lines, which are indicative of the presence of young stellar populations. This result implies that the presence of the interstellar medium and/or dust contributes to the increase in NaD line strengths observed for these galaxies.

• Journal of the Korean Society of Propulsion Engineers
• /
• v.21 no.3
• /
• pp.56-60
• /
• 2017

In hypersonic aircraft, increase of aerodynamic heat and engine heat leads heat loads in airframe. It could lead structural change of aircraft's component and malfunctioning. Endothermic fuels are liquid hydrocarbon fuels which are able to absorb the heat load by undergoing endothermic reactions. In this study, exo-tetrahydrodicyclopentadiene was selected as a model endothermic fuel and experiments were investigated in endothermic fuel cooling system with zeolite catalyst. Three shapes of catalysts have been manufactured and endothermic characteristics were recovered. Bineded catalyst showed higher heat absorption and conversion than other two zeolite catalysts. In product distribution, binded catalyst showed higher aromatics composition.

• Electrical & Electronic Materials
• /
• v.8 no.5
• /
• pp.619-625
• /
• 1995

Polycrystalline CdTe thin film has been studied for photovoltaic application due to the 1.45 eV band gap energy ideal for solar energy conversion and high absorption coefficient. The formation of low resistance contact to p-CdTe is difficult because of large work function(>5.5eV). Common methods for ohmic contact to p-CdTe are to form a p+ region under the contact by in-diffusion of contact material to reduce the barrier height and modify a p-CdTe surface layer using chemical treatment. In this study, the surface chemical treatment of p CdTe was carried out by H$\_$3/PO$\_$4/+HNO$\_$3/ or K$\_$2/Cr$\_$2/O$\_$7/+H$\_$2/SO$\_$4/ solution to provide a Te-rich surface. And various thin film contact materials such as Cu, Au, and Cu/Au were deposited by E-beam evaporation to form ohmic contact to p-CdTe. After the metallization, post annealing was performed by oven heat treatment at 150.deg. C or by RTA(Rapid Thermal Annealing) at 250-350.deg. C. Surface chemical treatments of p-CdTe thin film improved metal/p-CdTe interface properties and post heat treatment resulted in low contact resistivity to p-CdTe.Of the various contact metal, Cu/Au and Cu show low contact resistance after oven and RTA post-heat treatments, respectively.

• Journal of Environmental Health Sciences
• /
• v.15 no.1
• /
• pp.33-49
• /
• 1989

Pollution in the rivers has received considerable attention in recent years, particullary with reference to the effect due to increasing concentration of heavy metals. The metals are toxic to the ecosystem as a whole and to man in particular, since he is at the end of a variety of food chains by virture of his varigated diet. In addition, numerous laboratory tests have established that certain metals, such as Cd, pose a threat to a wide variety of aquatic organisms at concentrations as low as a few $\mu$g/1. Before the biological effects of heavy metals in impacted ecosystems can be completely assessed, however it is necessary to provide data on the concentration of heavy metals in such systems. This study was performed to investigate the concentration level of heavy metals in water, fish and sediments from upstream ($S_1-S_4$) to downstream ($S_5-S_9$) of the Mankyung river. Samples of water, fish, and sediments were collected along the tributaries of the Mankyung from September to October in 1987 and analyzed for lead, cadmium, copper, and zinc by atomic absorption spectrophotometer. From the data presented in this study, we can infer that the concentrations of the heavy metals investigated both in water and sediments are similar to those found in literature for unpolluted regions. The results obtained from the analysis of the edible tissue of the C. auratus show low concentration levels of the four heavy metals investigated. We conclude that the area is still relatively unpolluted and recommended continuing the monitoring of heavy metal concentrations to improve our understanding of their cycle in the river environment.