• 한국가구학회지
• /
• 제23권4호
• /
• pp.460-466
• /
• 2012

This study was conducted to investigate the surface hardness of thermally-compressed larch wood by compression set and temperature. The surface hardness of thermally-compressed larch wood increased with increasing compression set and temperature. For compression set 60%, the specific gravity was increased as 0.93. However, the surface hardness was lower value as 31.1 N/$mm^2$ compared with a similar specific gravity of the tropical timber. For density profile, less than compression set 40%, compression was observed mainly surface area. On the other hand, more than 50%, density profile variation was reduced by compression of central part. Results of this study indicate that thermally-compressed larch wood can be replace some imported hardwoods such as oak or cherry. However, thermally-compressed larch wood was difficult to replace the tropical timber being imported in terms of surface hardness.

• Journal of the Korean Wood Science and Technology
• /
• 제43권2호
• /
• pp.186-195
• /
• 2015

This study aims at modeling the rotary drying of wood chips in co-current mode and estimating the drying time of larch (Larix kaemferi) wood chip. Drying data were obtained in a lab. scale fixed bed dryer operating with an air velocity of 1 m/sec. and at hot air inlet temperatures of $100^{\circ}C$, $200^{\circ}C$, and $300^{\circ}C$. The lab. scale fixed-bed drying rates for small, medium and large size larch wood chips that had been dried from 40% wet-based moisture content (MC) to 10% MC at $200^{\circ}C$ drying temperature were 17.3 %/min., 10.2 %/min. and 5.5 %/min., respectively. It was predicted that larch large size wood chips could be dried from 40% MC to 10% MC in about 23.0, 34.6, and 44.7 minutes at $300^{\circ}C$, $200^{\circ}C$ and $150^{\circ}C$, respectively. Expected drying times for medium size chips were about 8.6, 11.2 and 13.2 minutes and those for small size chips were 4.3, 5.5 and 6.4 minutes, respectively.

• Journal of Forest and Environmental Science
• /
• 제27권1호
• /
• pp.55-60
• /
• 2011

This study has been carried out to investigate the preservation characteristics and weathering of larch wood treated with wood tar and wood vinegar, neglected under the circumstance of outdoor exposure, buried under ground, and deposited under water. Earlywood cell wall observed by optical microscope has been collapsed due to the fungi deterioration. This phenomenon occurred more frequently in the case of woods treated with wood tar and buried under ground. Relative crystallinity of woods treated with wood tar, exposed outdoors, and untreated wood buried under ground was highest at 63% while wood tar treated wood buried under ground was lowest at 46%.

• Journal of the Korean Wood Science and Technology
• /
• 제44권6호
• /
• pp.880-889
• /
• 2016

To evaluate the resistance of wood to decay caused by fungi, sapwood and heartwood of red pine (Pinus densiflora) and sapwood and heartwood of larch (Larix kaempferi) were conducted. Wood samples were immersed for 96 h in pyroligneous liquor. Then, the brown-rot fungus, Fomitopsis palustris, was used to examine the decay resistance of red pine and larch. Weight and density of wood from the all conditions increased after immersion treatment. Weight loss after decay resistance test was also dropped with a immersion treatment. The lowest weight loss indicated at immersion-treated heartwood of larch. Immersion treatment using pyroligneous liquor effectively increased the resistance of wood to decay caused by fungi.

• Journal of the Korean Wood Science and Technology
• /
• 제24권4호
• /
• pp.1-6
• /
• 1996

Extracts from bark have been studied with a view to producing water-proof wood adhesives. Lately many softwoods, such as radiata pine from New Zealand and larch from Siberia, Russia, have been imported and utilized, and their residual barks would be expecting as potential raw materials for something useful chemicals. The great effort toward utilization of bark extractives as a chemical feedstock has been made on a worldwide level. However few report has been done for the utilization of tree bark extractives in Korea. Hot-water extracts were prepared from barks of Japanese larch(Larix leptolepis). Siberian larch(Larix gmelinii) and Radiata pine(Pinus radiata). The effect of various factors, such as particle size, liquor ratio, extraction temperature, and reaction time, on the extractive yields was discussed. Particle sizes affected the hot-water extractives: the finer the particle size, the higher extractives and extract efficiency. Higher temperature and higher liquor ratio were more effective. Extractives from Japanese larch were relatively less than those from Siberian larch and Radiata pine barks. Formaldehyde precipitates was the highest in extractives of Radiata pine barks. It could be concluded that Siberian larch bark was the best raw material for tannin adhesives, because its extractive yield was higher than those of the other barks.

• Journal of the Korean Wood Science and Technology
• /
• 제10권2호
• /
• pp.12-21
• /
• 1982

Red pine and Japanese larch (Larix leptolepis Gordon) grown in Korea have been the main species of coniferous resources in Korea. Especially, planting area of Japanese larch has been increased continueously in the recent years due to its superior plant type and rapid growth rate and its stocks reached approximately 4.32 million cubic meters at the present time. Although many research works have been done for the utilization of the larch wood in various ways, still many problems are existed in its chemical applications due to a large proportion of soluble extractives. In this study, chemical composition of larch extractives and chemical structure of its major component were analyzed. In order to identify the basic structure of major component, gas-liquid chromatography for separation of some completely methylated alditols as their acetates on a 3% - ECNSS-M on Gas Chrom Q. column was used. Proportion of extractives of Japanese larch wood was higher than that of other conifers and major component of the soluble extractives was arabinogalactan, a schematic structural formula which was presented in Figure 2. The molar ratio of arabinose and galactose was 1:4.5. The main chain of arabinogalactan was composed of 1,3 linked ${\beta}$-D-galactopyranose residues, each of which carried a side chain, attached to the C-6 positions. The exact nature of all of the side chains is not known, but the majority of these side chain was composed of 1, 6 linked ${\beta}$-D-galactopyranose residues, with 2~3 such units present per average chain. Some of the galactose units in the main chain had a residue of 3 - 0 - ${\beta}$-L-arabinopyranosyl-L-arabinofuranose. In addition, a few terminal residues of D-glucuronic acid also was confirmed, attached to C-6 position of the D-galactopyranose residue. It could concluded that the main structure of highly branched arabinogalactan from Japanese larch extractive was essentially the same as those of the other larch species.

• Journal of the Korean Wood Science and Technology
• /
• 제43권3호
• /
• pp.381-389
• /
• 2015

본 연구에서는 반탄화된 낙엽송 칩을 분쇄한 후 그 입자를 이용한 펠릿성형에서 함수율과 입자크기의 영향을 반탄화 조건($220^{\circ}C$-50분, $250^{\circ}C$-50분, $250^{\circ}C$-120분)에 따라 조사하였다. 반탄화 후 함수율은 0.69~1.75%로 반탄화 처리전의 5.26%보다 낮았으나, 회분이나 발열량은 증가하였다. 또한 반탄화에 의한 중량감소율은 크게 증가하였는데 이는 헤미셀룰로오스의 분해가 활발하게 일어났기 때문으로 생각된다. 반탄화 낙엽송 칩에 포함된 탄소함량은 반탄화 처리 전 낙엽송 칩과 비교하여 증가하였으며 수소와 산소함량은 감소하였다. 반탄화 낙엽송 칩에 포함된 리그닌과 글루칸 함량은 반탄화 정도가 증가할수록 증가하였으며 헤미셀룰로오스는 감소하였다. 반탄화 칩을 분쇄하여 입자크기분포를 비교한 결과 높은 반탄화 조건은 낮은 반탄화 조건에서보다 1 mm 이하의 미세분 함량이 높았고 $500{\AA}$ 이상의 macropore가 생성되었다. 반탄화 분쇄 입자를 이용한 펠릿성형 과정에서 입자크기와 관계없이 반탄화 분쇄 입자의 함수율이 증가할수록 투입된 반탄화 분쇄 입자가 받는 압력은 감소하였으며 펠릿길이는 증가하였다.

• Journal of the Korean Wood Science and Technology
• /
• 제45권2호
• /
• pp.195-201
• /
• 2017

This study was conducted to evaluate the resistance of heat-treated wood using the catalyst to decay caused by fungi for sapwood and heartwood of two tree species, Korean red pine (Pinus densiflora) and Japanese larch (Larix kaempferi), respectively. Wood samples were immersed for 10 min in sulfuric acid (7.5%) and then heat-treated at $130^{\circ}C$ for 90 min. Fomitopsis palustris, a brown-rot fungus, was used to examine the decay resistance of Korean red pine and Japanese larch wood. Weight and density of wood from the all conditions increased after heat treatment using the catalyst. Weight loss after decay resistance test was also dropped with a heat treatment. The lowest weight loss indicated at heat-treated heartwood of Japanese larch. Heat treatment using the catalyst effectively increased the resistance of wood to decay caused by fungi.

• 펄프종이기술
• /
• 제48권3호
• /
• pp.99-106
• /
• 2016

Our aim was to identify the potential of reed stalk as a raw materials for biomass pellet production. Compared to woody biomass, reed stalk contained significant levels of ash. The holocellulose content of reed stalk was similar to that of larch, but the lignin content of reed stalk was lower than that of larch. In the elemental analysis, chlorine content of reed stalk was much higher than that of larch, and satisfied only the mixed biomass pellet B of European non-woody pellet standards(EN 14961-6). In quantitative analysis of the ash, heavy metals contents of reed stalk satisfied European non-woody pellet standards. Higher heating value of oven-dried reed stalk pellet was slightly lower than that of larch wood pellet. The durability of reed stalk pellet was lower than that of larch wood pellet. The results of this study indicate that reed stalk might be used as a raw material of mixed biomass pellet B.

• Journal of the Korean Wood Science and Technology
• /
• 제24권2호
• /
• pp.20-25
• /
• 1996

Wood chips of oak(Quercus mongolica) and larch(Larix leptolepis) were exploded with the optimum condition. Main components of exploded wood were separated with hot hot water and methanol. The hemicelluloses were purified from hot water extracts and alditol complexs were prepared from purified hemicellulose. And also, cellulose nitrate was prepared from extractive residue and characterized. The results can be summarized as follows. 1. Amounts of carbohydrate(72~79%) in the crude hemicellulose of larch wood was more than those of oak wood(55~66%). 2. The crude hemicelluloses were mainly composed of oligosaccharides in oak wood but those in larch wood contained about 50% monosaccharides. 3. Decolorization of hemicellulose was successful with activated charcoal and ion-exchange resin treatment. The alditol yields were 56.3~82.9%. 4. The degree of substitution(D.S.) of cellulose nitrate was 1.95~2.87 and it showed a good acetone solubility.