• JSTS:Journal of Semiconductor Technology and Science
• /
• v.16 no.4
• /
• pp.443-450
• /
• 2016

The linearization technique for low noise amplifier (LNA) has been implemented in standard $0.18-{\mu}m$ BiCMOS process. The MOS-BJT derivative superposition (MBDS) technique exploits a parallel LC tank in the emitter of bipolar transistor to reduce the second-order non-linear coefficient ($g_{m2}$) which limits the enhancement of linearity performance. Two feedback capacitances are used in parallel with the base-collector and gate-drain capacitances to adjust the phase of third-order non-linear coefficients of bipolar and MOS transistors to improve the linearity characteristics. The MBDS technique is also employed cascode configuration to further reduce the second-order nonlinear coefficient. The proposed LNA exhibits gain of 9.3 dB and noise figure (NF) of 2.3 dB at 2 GHz. The excellent IIP3 of 20 dBm and low-power power consumption of 5.14 mW at the power supply of 1 V are achieved. The input return loss ($S_{11}$) and output return loss ($S_{22}$) are kept below - 10 dB and -15 dB, respectively. The reverse isolation ($S_{12}$) is better than -50 dB.

• KSBB Journal
• /
• v.30 no.4
• /
• pp.161-165
• /
• 2015

Lactic acid and its derivatives are widely used in the food, pharmaceutical, and cosmetic industries. It is also a major raw material for the production of poly-lactic acid (PLA), a biodegradable and environmentally friendly polymer and a possible alternative to synthetic plastics derived from petroleum. For PLA production by new strains of lactic acid bacteria (LAB), we screened LAB isolates from shellfish. A total of 51 LAB were isolated from 7 types of shellfishes. Lactic acid production of individual isolates was examined using high-performance liquid chromatography using a Chiralpak MA column and an ultraviolet detector. Lactobacillus plantarum T-3 was selected as the most stress-resistant strain, with minimal inhibition concentrations of 1.2 M NaCl, 15% ethanol, and 0.0020% hydrogen peroxide. In a 1 L fermentation experiment, $\small{D}$-lactic acid production of 19.91 g/L fermentation broth was achieved after 9 h cultivation, whereas the maximum production of total lactic acid was 41.37 g/L at 24 h.

• ETRI Journal
• /
• v.39 no.5
• /
• pp.756-763
• /
• 2017

A switchable single-wideband (SWB)-to-dual-wideband (DWB) bandpass filter (BPF), which is realized by using lumped switches, is presented in this paper. By alternating the operation modes-ON and OFF-in which the ON mode is achieved by placing the capacitors at the switching spots and the OFF mode is achieved by replacing the capacitors with inductors, DWB-to-SWB BPF can be achieved on the same device. In addition, by changing the capacitor values, the center frequency (CF) of the lower passband of DWB BPF can be easily tuned from 1.69 GHz to 2.22 GHz, while the higher passband stays almost unchanged. As an example, an SWB-to-DWB BPF is designed, fabricated, and measured. This BPF exhibits good performance including wideband, high isolation, compact size, and ability to switch.

• Food Science and Preservation
• /
• v.19 no.3
• /
• pp.438-442
• /
• 2012

To prepare calcium-binding peptides as calcium supplement, barley proteins were hydrolyzed using Flavourzyme for 18 h and the hydrolysates were ultra-filtered under 3 kDa as a molecular weight. The resultant filtered peptides were fractionated using ion exchange and normal-phase high performance liquid chromatography. Then each fraction that was obtained was determined for its calcium-binding activity to isolate the calcium-binding peptides. As a result, the highest calcium-binding peptide fraction was obtained, and the results suggest that barley protein hydrolysates can be used as a calcium supplement.

• Proceedings of the Korean Society of Propulsion Engineers Conference
• /
• 2017.05a
• /
• pp.572-582
• /
• 2017

It is definitely important to measure thrust during ground test when developing air-breathing engine, and in case of air-breathing engine, gross thrust should be calculated considering not only the measured thrust but also the force induced by the air flow of engine intake. Also, side thrust like yaw and pitch should be measured and analyzed using multi-component thrust measurement system. Engine performance was accurately evaluated by calculating the gross thrust of air breathing engine precisely which is analyzed from below serial procedure: labyrinth seal isolation, 1-axis gross thrust calculation, develop multi-component thrust measurement system, and side thrust analysis.

• Journal of the Korean Institute of Intelligent Systems
• /
• v.14 no.1
• /
• pp.1-8
• /
• 2004

In this paper, we propose neural network-based fault diagnosis method to diagnose of sensor in the gas monitoring system. In the proposed method, using thermal modulation of operating temperature of sensor, the signal patterns are extracted from the voltage of load resistance. Also, ART2 neural network is used for fault isolation. The performance and effectiveness of the proposed ART2 neural network based fault diagnosis method are shown by simulation results using real data obtained from the gas monitoring system.

• The Transactions of the Korean Institute of Electrical Engineers D
• /
• v.54 no.6
• /
• pp.409-416
• /
• 2005

For broadband high-data-rate power line communication with the allocated frequency bandwidth from 2 to 30 MHz on medium voltage (MV) distribution power lines, a signal coupling unit is developed. The coupling unit is composed of a coupling capacitor for coupling communication signal, a drain coil, and an impedance matching part. The coupling capacitor made of ceramic capacitor is designed for transmission property of better than 1 dB in the frequency range. The drain coil is used for preventing low frequency high voltage from junction of medium voltage power line in case that a coupling capacitor is not working properly any more. Also, using ferrite core, a novel broadband impedance matching transformer is developed. A complete coupling unit with a coupling capacitor, a drain coil, and a matching transformer is housed by polymer for good isolation and distinguishing from high voltage electric facilities. Each is fabricated and its frequency behavior is tested. Finally, complete signal couplers are equipped in a MV PLC test bed and their performance are measured. The measurement shows that the coupling capacitor works excellently.

• Journal of electromagnetic engineering and science
• /
• v.17 no.2
• /
• pp.65-70
• /
• 2017

The design and implementation aspects of a new single-balanced mixer for ultra-wideband (UWB) applications are presented in this study. The proposed mixer utilizes a miniaturized UWB ring coupler as a balun, consisting of a pair of in-phase and inverted-phase transitional structures. The well-balanced UWB performance of the ring coupler, aside from the optimized diode matching, results in improved conversion loss and inter-port isolations for a wide bandwidth. The size of the implemented single-balanced diode mixer is reduced to about 60% of the area of the conventional single-balanced ring diode mixer. The measured results of the proposed mixer exhibit an average conversion loss of 7.5 dB (minimum 6.7 dB) and a port-to-port isolation of greater than 18 dB over a UWB frequency range of 3.1-10.6 GHz. The measured results agree well with the simulated results.

• Journal of the Korean GEO-environmental Society
• /
• v.8 no.4
• /
• pp.41-45
• /
• 2007

It is very important that selection of packing media with large surface area, high limited back pressure in biofilter. The object of this study is the isolation of sulfur-oxidizing bacteria and the removal of hydrogen sulfide in biofilter by media. This investigation led to the following results: 1) we isolated Thiobacillus sp. IW. at an abandoned coal mine in Hwasun, Jeonnam Province. 2) The inorganic media showed better results than the organic media from experiments looking at removal characteristics and changes in pressure drop using various media. 3) Among the inorganic media, fibril and PU media showed best performance.

• The Transactions of the Korean Institute of Electrical Engineers C
• /
• v.50 no.5
• /
• pp.238-242
• /
• 2001

In this paper, we extracted design parameters for re-entrant mode microstrip directional coupler using FE(finite element) calculations. The microstrip directional coupler suffers from a poor directivity due to effect of the inhomogeneous dielectric including both dielectric substrate and air in microstrip transmission lines. Thus, the phase velocity of even mode is not equal to that of odd mode. In order to improve the directivity of microstrip directional coupler, a novel re-entrant mode microstrip directional coupler was employed. In microstrip configuration, the high directivity can be reached by matching the even- and odd-mode effective phase velocities. Through the values of capacitance obtained from 2-dimensional FE calculations, the phase velocities for each mode and the design parameter were extracted for the proposed parallel coupled-line configuration. Based on the extracted design parameter with phase matching condition, we designed and fabricated a 30dB directional coupler at 0.85GHz. Experimental results show good performance with excellent, isolation and directivity.