• Proceedings of the KIEE Conference
• /
• 2003.07b
• /
• pp.970-972
• /
• 2003

This paper presents a new speed sensorless control method of a permanent magnet synchronous motor based on instantaneous reactive power. The proposed algorithm is constructed by instantaneous reactive power in a synchronously rotating reference frame and is not affected by mechanical motor parameters, because mechanical equation is not used. The effectiveness of the proposed system is confirmed by the experimental results.

• Proceedings of the KIEE Conference
• /
• 2007.07a
• /
• pp.173-174
• /
• 2007

In this paper, a new speed sensorless control based on an instantaneous reactive power and a fuzzy PI compensator are proposed for the interior permanent magnet synchronous motor (IPMSM) drives. The conventional fixed gain PI and PID controllers are very sensitive to step change of command speed, parameter variations and load disturbance. Also, to the estimated speeds are compensated by using an instantaneous reactive power in synchronously rotating reference frame. In a fuzzy compensator, the system control parameters are adjusted by a fuzzy rule based system, which is a logical model of the human behavior for process control. The effectiveness of algorithm is confirmed by the experiments.

• Journal of international Conference on Electrical Machines and Systems
• /
• v.3 no.2
• /
• pp.190-199
• /
• 2014

In the last years, fault problem in power electronics has been more and more investigated both from theoretical and practical point of view. The fault problem can cause equipment failure, data and economical losses. And the analyze system require to ensure fault problem and also rectify failures. The current errors on these faults are applied for identified type of faults. This paper presents technique to detection and identification faults in three-phase voltage source inverter (VSI) by using time-frequency distribution (TFD). TFD capable represent time frequency representation (TFR) in temporal and spectral information. Based on TFR, signal parameters are calculated such as instantaneous average current, instantaneous root mean square current, instantaneous fundamental root mean square current and, instantaneous total current waveform distortion. From on results, the detection of VSI faults could be determined based on characteristic of parameter estimation. And also concluded that the fault detection is capable of identifying the type of inverter fault and can reduce cost maintenance.

• Korean Journal of Fisheries and Aquatic Sciences
• /
• v.47 no.6
• /
• pp.901-907
• /
• 2014

We investigated the population ecology of blackthroat seaperch, Doederleinia berycoides, from samples collected in the southern seas of Korea from January to December, 2006. Population ecological parameters included survival rate, the instantaneous coefficient of natural and fishing mortality, and age at first capture. The survival rate (S) of blackthroat seaperch was estimated as 0.4966 using the catch curve method. The instantaneous coefficient of total mortality (Z) was 0.8598/year. The instantaneous coefficient of natural mortality (M) was estimated as 0.4694/year. From the estimates of Z and M, the instantaneous coefficient of fishing mortality (F) was calculated as 0.3904/year. The age at first capture ($t_c$), based on the Pauly method, was 2.87 years.

• Structural Engineering and Mechanics
• /
• v.67 no.2
• /
• pp.155-163
• /
• 2018

The Early-age construction loading and changing properties of concrete, especially in the multi-story structures can affect the slab deflection, significantly. Based on previously conducted experiment on eight simply-supported one-way slabs this paper investigates the effect of concrete type, fiber type and content, loading value, cracking moment, ultimate moment and applied moment on the instantaneous deflection of Self-Compacting Concrete (SCC) slabs. Two distinct loading levels equal to 30% and 40% of the ultimate capacity of the slab section were applied on the slabs at the age of 14 days. A wide range of the existing models of the effective moment of inertia which are mainly developed for conventional concrete elements, were investigated. Comparison of the experimental deflection values with predictions of the existing models shows considerable differences between the recorded and estimated instantaneous deflection of SCC slabs. Calculated elastic deflection of slabs at the ages of 14 and 28 days were also compared with the experimental deflection of slabs. Based on sensitivity analysis of the effective parameters, a new model is proposed and verified to predict the effective moment of inertia in SCC slabs with and without fiber reinforcing under two different loading levels at the age of 14 days.

• Proceedings of the Korea Water Resources Association Conference
• /
• 1987.07a
• /
• pp.151-158
• /
• 1987

The purpose of thes study is to estimate the parameters of linear reservoir models in order to derive the instantaneous unit hydrograph from a given small experimental watershed. The linear reservoir model is a conceptual model, consisting of cascade or parallel equal linear reservoirs, preceded by a linear channel which involved NASH, SLR(single linear reservoir)and 2-PLR(two-parallel linear reservoir)model. The NASH model have two parameters N and K, single linear reservoir has one parameter K1 and two-parallel linear reservoirs have two parameters K1, K2;where N denote the number of reservoirs and K is the storage coefficient of each reservoirs.

• Geophysics and Geophysical Exploration
• /
• v.12 no.1
• /
• pp.69-76
• /
• 2009

We report an implementation of the Ground Penetrating Radar (GPR) survey at a site that corresponds to a ruined castle. The objective of the survey was to characterise buried archaeological structures such as walls and tiles in Van Khan Tooril's Ruin, Mongolia, by 2D and 3D GPR techniques. GPR datasets were acquired in an area 10mby 9 m, with 10 cm line spacing. Two datasets were collected, using GPR with 500MHz and 800MHz frequency antennas. In this paper, we report the use of instantaneous parameters to detect archaeological targets such as tile, brick, and masonry by polarimetric GPR. Radar polarimetry is an advanced technology for extraction of target scattering characteristics. It gives us much more information about the size, shape, orientation, and surface condition of radar targets. We focused our interpretation on the strongest reflections. The image is enhanced by the use of instantaneous parameters. Judging by the shape and the width of the reflections, it is clear that moderate to high intensity response in instantaneous amplitude corresponds to brick and tiles. The instantaneous phase map gave information about the location of the targets, which appeared as discontinuities in the signal. In order to increase our ability to interpret these archaeological targets, we compared the GPR datasets acquired in two orthogonal survey directions. A good correlation is observed for the alignments of reflections when we compare the two datasets. However, more reflections appear in the north-south survey direction than in the west-east direction. This is due to the electric field orientation, which is in the horizontal plane for north-south survey directions and the horizontally polarised component of the backscattered high energy is recorded.

• Journal of KIISE:Software and Applications
• /
• v.26 no.8
• /
• pp.1000-1009
• /
• 1999

본 논문에서는 비디오 데이타를 분석하여 다양한 카메라의 동작을 정량적으로 추출하는 방법을 제안한다. 본 논문에서 제안하는 카메라의 동작 추출 방법은 어파인 모델을 이용한 방법으로 인접 영상으로부터 추출한 동작 벡터를 어파인 모델에 적용하고 회귀분석법을 통해 어파인 모델을 구성하는 파라미터를 구한다. 그런 다음, 파라미터들의 크기를 분석하고 상호 관계를 해석하여 카메라의 동작을 추출한다. 본 논문에서는 잡음이 포함된 동작 벡터를 필터링하여 사용하므로 잡음에 강건한 결과를 얻을 수 있다. 그리고 어파인 모델을 구성하는 파라미터만을 분석함으로써 카메라의 다양한 동작을 간단하면서도 비교적 정확하게 추출한다. 실험 결과는 카메라의 동작을 정확하게 추출하고 있음을 보여준다.Abstract This paper presents an elegant method, an affine-model based approach, that can qualitatively estimate the information of camera motion. We define various types of camera motion by means of parameters of an affine-model. To get those parameters from images, we fit an affine-model to the field of instantaneous velocities, rather than raw images. We correlate consecutive images to get instantaneous velocities. The size filtering of the velocities are applied to remove noisy components, and the regression approach is employed for the fitting procedure. The fitted values of the parameters are examined to get the estimates of camera motion. The experimental results show that the suggested approach can yield the qualitative information of camera motion successfully.

• Korean Journal of Fisheries and Aquatic Sciences
• /
• v.39 no.4
• /
• pp.344-348
• /
• 2006

The ecological characteristics and stock biomass of the Shiba shrimp, Metapenaeus joyneri, in Korean waters were determined, using fishery data from the Ministry of Maritime Affairs and Fisheries (MOMAF) and available length frequency data. The instantaneous coefficient of total mortality (Z) of M. joyneri was estimated to be 4.191year, and the annual survival rate (S) was 0.015. The estimated instantaneous coefficient of fishing mortality (F) for recent years was calculated to be 1.94/year. The age at first capture of M. joyneri was 0.71 years. Based on these parameters, the annual biomass of the M. joyneri stock was estimated using a biomass-based cohort analysis and data on the annual catch in weight at age for 1993-2004 in Korean waters. During the study period, the biomass of the shrimp peaked in 1994 at about 9,082 metric tons. Subsequently, it decreased to 500 metric tons in 1998.

• Journal of the Korean Institute of Telematics and Electronics S
• /
• v.36S no.8
• /
• pp.65-80
• /
• 1999

This paper presents an elegant method, an affine-model based approach, that can qualitatively estimate the information of camera motion. We define various types of camera motion by means of parameters of an affine-model. To get those parameters form images, we fit an affine-model to the field of instantaneous velocities, rather than raw images. We correlate consecutive images to get instantaneous velocities. The size filtering of the velocities are applied to remove noisy components, and the regression approach is employed for the fitting procedure. The fitted values of the parameters are examined to get the estimates of camera motion. The experimental results show that the suggested approach can yield the qualitative information of camera motion successfully.