• Journal of Korean Society of Water and Wastewater
• /
• v.28 no.1
• /
• pp.135-142
• /
• 2014

The performance of inorganic sludge separation system is evaluated. Anaerobic digester effluent sludge is used for feed sludge of this system and hydrocyclone is used for inorganic sludge separation. For phosphorus removal and recovery $MgCl_2$ is pumped into MAP growth tank, a component of inorganic sludge separation system. Using this system inorganic sludge which contained less than 40 % of organic matter can be discharged stably and the maximum amount of separated inorganic sludge is 13.4 % of influent sludge based on dry solid. The amount of phosphorus recovered as MAP(as P) is 16.7 % to influent T-P.

• Journal of the Korean Applied Science and Technology
• /
• v.27 no.3
• /
• pp.344-352
• /
• 2010

Magnetite and inorganic sludge were mainly composed of $Fe_2O_4$ and $Fe_2O_3$, respectively. Initial specific surface areas of magnetite and inorganic sludge were 130 $m^2$/g and 31.7 $m^2$/g. $CO_2$ decomposition rate for inorganic sludge was increased with temperature. Maximum $CO_2$ decomposition rates were shown 89% for magnetite at $350^{\circ}C$ and 84% for inorganic sludge at $500^{\circ}C$. Specific surface area for magnetite was not varied significantly after $CO_2$ decomposition. However, specific surface area for inorganic sludge was greatly decreased from initial 130 $m^2$/g to approximately 50~60 $m^2$/g after reaction. Therefore, it was estimated that magnetite could be used for $CO_2$decomposition for a long time and inorganic sludge should be wasted after $CO_2$ decomposition reaction.

• Journal of the Korean Society of Manufacturing Process Engineers
• /
• v.21 no.9
• /
• pp.35-41
• /
• 2022

The moisture content of many inorganic sludges is less than 70% during dewatering. Hence, a mono or piston pump cannot feed the sludge dryer. Thus, most inorganic sludge should be moved to a landfill or recycled directly without any reduction method. This development was invented to apply cyclone dryers using air and specially designed for the continuous injection of sludge sources by negative pressure and high air velocity for low moisture inorganic matter. Therefore, wastewater sludge and raw water treatment sludge discharged from various industrial fields might be settled by this development. The cyclone dryer was commercialized useful as moisture reduction equipment. This development was applied using a sludge injection system for sludge feeding and under the cooperation of ejector design computational fluid dynamics. Furthermore, this paper presented good ejector model results, blowing an airflow of 264 m³/min at an actual performance test.

• Journal of Korean Society of Water and Wastewater
• /
• v.28 no.4
• /
• pp.411-417
• /
• 2014

The performance of the new aerobic digestion system combined with inorganic sludge separation unit and sludge solubilization unit, CaviTec II, is evaluated. Anaerobic digester effluent sludge is used for feed sludge of CaviTec II system. By addition of CaviTec II, the amount of cake generated is reduced by 27%, and the soluble nitrogen is reduced by 92%.

• Journal of Korean Society on Water Environment
• /
• v.32 no.5
• /
• pp.458-464
• /
• 2016

This study evaluated the dewatering efficiency of inorganic dehydrating agents that contain oyster shells. A filter press dehydrator was used for this study. The experiments were performed by the single injection of calcium-based chemicals, the single injection of oyster shells, and the mixed injection of oyster shells and calcium-based chemicals. The moisture content of the dewatered cake generated after dehydration confirmed that the best dewatering efficiency was found at the mixing ratios of CaCO₃ to sludge, oyster shell to sludge, and inorganic dehydrating agent to sludge of 3:1, 10:1, and 1.5:2.5:1, respectively. The moisture contents exhibited less than 58% when the injection mixing ratio of inorganic dehydrating agent to sludge was 1.5:2.5:1. From EPS, SEM, and EDX analysis, it was found that the calcium adsorbed on the sludge surface could reduce extracellular polymeric substances (EPSs) and enhanced the dewaterbility. Based on the above results, it is considered possible to apply inorganic dehydrating agents containing recycled oyster shells in sludge dewatering in order to reduce sludge.

• Proceedings of the Korean Institute of Building Construction Conference
• /
• 2014.11a
• /
• pp.146-147
• /
• 2014

The environmental pollution problem the globally related to global warming arises, the demand for the solar power generation increases. But is generated sludge about 2tons in order to produce 1ton in the solar power generation used main material polysilicon. In this way, the arising sludge there is not method recycling and it is all discarded. Therefore, in this research, cement is not used dynamic properties tries to be analyze inorganic binder based on blast furnace slag and polysilicon sludge ratio. The appropriate replacement ratio of the experimental result polysilicon sludge was to be 8%.

• Journal of Environmental Health Sciences
• /
• v.37 no.6
• /
• pp.467-473
• /
• 2011

Objectives: Wastewater treatment plants typically produce a large volume of waste sludge. In this study, the conditioning and dewatering properties of a digested and thickened sludge from an industrial wastewater treatment plant were investigated in order to improve the dewaterbility of the sludge. Methods: Jar-tests and Buchner funnel tests were carried out to assess the conditioning and dewatering properties of a waste sludge. TTF (Time to Filter Test) and SRF (Specific Resistance to Filtration) were adopted as the indices of sludge dewaterbility. Results: The valuation indices influencing the dewaterbility of the waste sludge, including TTF, SRF, water contents, VS/TS ratio and turbidity, were measured. The TTF and SRF of the digested and thickened sludge were decreased to 40 sec, $3.43{\times}10^{12}$ m/kg, and 39 sec, $1.09{\times}10^{12}$ m/kg, respectively. Conclusions: The conditioner composed of natural inorganic materials turned out to be effective in the reduction of sludge water contents.

• Journal of Korean Society of Environmental Engineers
• /
• v.34 no.10
• /
• pp.651-655
• /
• 2012

This study aimed to investigate the effect of an inorganic conditioner composed of natural inorganic materials on the dewaterbility of sewage sludge and compare the performance with those of conventional organic polymeric conditioners. A dosage of 2.0 mg inorganic conditioner/g sludge TS decreased time to filter test (TTF), specific resistance to filtration (SRF), water content of dewatered sludge cake, turbidity from 146 to 41 sec, from $8.3{\times}10^{14}$ to $2.4{\times}10^{14}$ m/kg, from 82.1 to 77.1%, from 112 to 61.1 NTU, respectively, which was compatible to the conventional cation organic polymer. An inorganic conditioner would be used in sewage sludge treatment as a suitable alternative conditioner. Regression analysis showed a strong relationship among TTF, SRF, and water content.

• Journal of Korean Society of Environmental Engineers
• /
• v.36 no.12
• /
• pp.843-850
• /
• 2014

This study investigated to recycle ash produced in the sewage sludge incinerator using reduction/stabilization. Nonsintering process was performed by binding cement, geobond and sand mixed with sewage sludge ash (SSA). Results showed that unconfined compressive strength could be obtained components of sewage sludge ash. it exceeded more than double score of the 22.54 Mpa ($229.7kg/cm^2$) Korean standard. chemical ingradients of the sewage sludge ash was mainly composed of $SiO_2$, $Al_2O_3$, $Fe_2O_3$, CaO and others, which were similar to those of the each binders consisting cement and geobond. microstructure of solidified speceimen for the different admixture was related to the compressive strength according to SEM analysis. optimum mixing range of the sewage sludge ash to inorganic binder was found to be 10~40% which can widly safely regulate the confined compressive strength. This study revealed the sewage sludge ash can be partial replacement of the inorganic binder for recycling.

• Journal of the Korean Applied Science and Technology
• /
• v.26 no.4
• /
• pp.483-490
• /
• 2009

This research was conducted to estimate the characteristics of carbon dioxide decomposition using an inorganic sludge. The inorganic sludge was composed of high amount (66.8%) of $Fe_2O_3$. Hydrogen could be reduced with 0.247, 0.433, 0.644, and 0.749 at 350, 400, 450, and $500^{\circ}C$, respectively. The carbon dioxide decomposition rates at 250, 300, 350, 400, 450, and $500^{\circ}C$ were 32, 52, 35, 62, 75, and 84%, respectively. High temperature led to high reduction of hydrogen and better decomposition of carbon dioxide. The specific surface area of the sludge after hydrogen reduction was higher than that after carbon dioxide decomposition. The specific surface area of the sludge was more decreased with increasing of temperature.