• Journal of Industrial Technology
• /
• v.16
• /
• pp.175-179
• /
• 1996

This research is the experimental and numerical study of investigating the characteristics of consolidation due to selfweight of soft marine clay. Column tests and centrifuge tests were carried out to selfweight of soft marine clay. Column tests and centrifuge tests were carried out to simulate the selfweight consolidations in field. Tests were conducted with changing drain boundary conditions and initial void ratios corresponding to four and five times of liquid limits. The RI meter was used to measure void ratio during consolidation of sample in column tests. Test results were analyzed by using the Terzaghi's infinitesimal strain theory and the finite strain theory.

• Proceedings of the Korean Operations and Management Science Society Conference
• /
• 2002.05a
• /
• pp.410-417
• /
• 2002

We consider the constraint based explicit routing problem in MPLS based IP Network. In this problem, we are given a set of traffic demands and a network with different link capacities. The problem is to assign the demand commodities to the paths in the network while minimizing the maximum link load ratio. We formulate this problem as an integer programming problem and propose an efficient column generation technique. To strengthen the formulation, we consider some valid inequalities. We also incorporate the column generation technique with variable fixing scheme Computational results show that the algorithm gives high quality solutions in a short execution time.

• Journal of Korean Institute of Industrial Engineers
• /
• v.19 no.4
• /
• pp.13-22
• /
• 1993

The aircraft scheduling, which is used to determine flight frequency, departure times and aircraft type assignments, is main problem of airline's planning. This paper proposes a new algorithm for aircraft scheduling that is to maximize airline profits. This paper proposes a column generation algorithm to get an optimal solution of the continous relaxation not using all the feasible variables, but using only a limited number of variables that is generated whenever it is necessary. Using this algorithm, proposes an optimal algorithm to get an optimal integer solution of aircraft scheduling problem efficiently. The effectiveness of the column generation algorithm and the optimal algorithm is illustrated by the computational results obtained from a series of real airline problems.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.13 no.8
• /
• pp.3774-3778
• /
• 2012

A dynamic simulation of a fully thermally coupled distillation is conducted for the design of a possible operation scheme, and its performance is examined with an example process of reformate fractionation process. The outcome of the dynamic simulation indicates that the column can be operated by using a $3{\times}3$ control structure. The structure consists of three controlled variables of the compositions of overhead, side products and bottom and three manipulated variables of the flow rate of reflux, liquid split ratio between a main column and a prefractionator and steam.

• Journal of Industrial and Engineering Chemistry
• /
• v.67
• /
• pp.255-265
• /
• 2018

The huge amount of solvents used in the semi-conductor and display industry typically result in waste of valuable solvents which often form complex azeotropic mixtures. This study explored a recovery process of a quaternary waste solvent, comprising methyl 2-hydroxybutyrate, propylene glycol monomethyl ether acetate, ethyl lactate, and ethyl-3-ethoxy propionate. In this study, a novel shortcut column method with a graphical approach was exploited for the distillation column design of complex quaternary azeotropic mixtures. As a result, the proposed shortcut method and design procedure solved the complex separation paths successfully with less computational efforts while achieving all requirements for component purity.

• Structural Engineering and Mechanics
• /
• v.36 no.2
• /
• pp.197-206
• /
• 2010

The purpose of this paper is to carry out both experimental and theoretical investigations of R.C. short column subjected to horizontal forces under constant compressive loading. Eight specimens with section of 40 cm ${\times}$ 40 cm, height 40 cm and 50 cm and different type hoop were used of the steel cage to detect the seismic behavior of reinforced concrete short columns. Hoop spacing of column, strength of concrete, and the axial load of experiments were the three main parameters in this test. A series of equations were derived to reveal the theory could be used on analysis short column, too. Through test failure model of R.C short column being established, the type of hoop affects the behavior R.C short column in ductility rather than in strength. And the effect of analysis by Truss Model is evident and reliable in shear failure model of short column.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.15 no.7
• /
• pp.4611-4617
• /
• 2014

This paper proposes an approximate method to estimate member forces of columns in a rigid frame. One of the conventional methods, Cantilever Method assumes the midpoint of a column as a hinge and linear distribution of axial stresses regarding the centroid of the column areas. As a result, it shows erroneous results compared to those of matrix analysis of two frames. In this study, a new method is proposed to estimate the member forces in columns and location of hinges in columns, which can be adopted easily by a practicing engineer, and numerical examples showed improved results compared to conventional methods.

• Journal of Korean Society of Occupational and Environmental Hygiene
• /
• v.6 no.1
• /
• pp.138-143
• /
• 1996

After oral administration of 14C-labelled $N^G$-mono[methyl-14C]-L-arginine into rats, 38.2 % and 14.7 % of the administered radioactivity bad been recovered in the urine and stool during 10 days. In the urine, 59.4 % of the radioactivity was recovered in the first 24-hours and used for the indentification of the formation of methylamine. The strong cation-exchange resin column chromatography showed 6.3 %, 7.4 %, 4.9 %, and 81.5 % of the distributions of radioactivity of the neutral, monomethylamine, basic, and uneluted portions, respectively. The radioactivity of monomethylamine portion reeluted into the column chromatography was 39.5 %. The radioactivities corresponding monomethylamine in the column chromatography, thin-layer chromatography, and thin-layer electrophoresis were 39.5 %, 37.3 %, and 28.8 % of the recovered radioactivity, respectively.

• Journal of the Korea Institute of Building Construction
• /
• v.13 no.3
• /
• pp.291-305
• /
• 2013

This paper presents the continuous hoop reinforcement method as a means to overcome the difficulty of rebar construction due to the seismic detail of lateral reinforcement. Because the continuous hoop has no seismic hook, and there is less interference during the rebar work, rebar quantities and construction time can be reduced. Since the details of column and beam continuous hoops are different from those of conventional lateral reinforcements, the construction method should be developed through mock-up tests. The length of the beam mock-up is 8m and the section size is $500mm{\times}700mm$, the height of the column mock-up is 2.8m and 4m, and the section size is $800{\times}800mm$. The length and the size are determined based on the elements that are generally used in reinforced concrete basement parking lots and office buildings. The results of the mock-up test showed that the quantities of rebar could be reduced by 20% and the time could be reduced by up to 40% compared with conventional lateral reinforcements.

• Journal of the Korean Chemical Society
• /
• v.7 no.2
• /
• pp.128-132
• /
• 1963

A study has been made on the applicability of gas-liquid partition chromatography to the qualitative and quantitative analysis of complex mixture of gaseous hydrocarbons. While phthalate columns are widely used for this $purpose^9$, they separates neither saturated hydrocarbons from the unsaturated nor n-butane from isobutene or butene-1, therefore combined columns such as phthalate and dimethylsulfolane have been used for the perfect separation of gaseous hydrocarbons. It is shown by this study, however, that hydrocarbons having $C_1$ through $C_4$ can be separated with a 2-meters tetraethyleneglycol dimethylether column except ethane from ethylene, and trans-from cis-2-butene especially operated at $15^{\circ}C$$ using helium as the carrier gas. The column effluents were in order of methane, (ethane, ethylene), propane, propylene, isobutane, n-butane, isobutylene, butene-1, (trans-& cis-2-butene, isopentane), (butadiene-1, 3, n-pentane). Two kinds of liquified petroleum gases in market are analysed qualitatively and quantitatively. The results indicate that use of this 2-meters TEGDE column permits the separation and identification of all the commonly encountered aliphatic gaseous hydrocarbons.