• YAKHAK HOEJI
• /
• v.33 no.1
• /
• pp.46-53
• /
• 1989

The extractable organic matter was extraced from airborne particulates collected in Seoul during 1986. It was fractionated to several fracrtions and mutagenicities of them were tested in Salmonella thyphimurium TA98 by Ames method. The neutral fraction showed the highest indirect acting mutagenicity while the highest direct acting mutagenicity was observed in the acidic fraction. Indirect acting mutagenicity of airborne particulate was attributed to its neutral fraction about 88% in average, to acidic about 10% in average and to basic fraction about 2% in average. Direct acting mutagenicity of airborne particulate was attributed to its neutral fraction about 70%, to acidic fraction about 29% and to basic fraction about 1%. Among five subfractions of neutral fraction, the proportion of mutagenicity of polynuclear aromatic hydrocarbon subfraction was 13.2% in indirect acting mutagenicity and 5.0% in direct acting mutagenicity.

• The Transactions of the Korean Institute of Electrical Engineers B
• /
• v.54 no.1
• /
• pp.40-46
• /
• 2005

This paper has investigated the speed sensorless indirect vectorcontrol of a two-phase induction motor to implement adjustable-speed drive for low-power applications. The sliding mode observer estimates rotor speed. The convergence of the nonlinear time-varying observer along with the asymptotic stability of the controller has been analyzed. To define the control action which maintains the motion on the sliding manifold, an "equivalent control" concept is used. It has been simulated and implemented on a sensorless indirect vector drive for 150W two-phase induction motor. The simulation and experimental results demonstrate effectiveness of the estimation method.

• Proceedings of the KSR Conference
• /
• 2000.11a
• /
• pp.680-687
• /
• 2000

In this paper we present a new vector control scheme for induction motor. An exact knowledge of the rotor flux position is essential for a high-performance vector control. The position of the rotor flux is measured in the direct scheme or estimated in the indirect schemes. Since the estimation of the flux position requires a priori knowledge of the induction motor parameters, the indirect schemes are machine parameter dependent. The rotor resistance and stator resistance among the parameters change with temperature. Variations in the parameters of induction machine cause deterioration of both the steady state and dynamic operation of the induction motor drive. Several methods have been presented to minimize the consequences of parameter sensitivity in indirect scheme. In this paper new estimation scheme of rotor flux position is presented to eliminate sensitivity due to resistance change with temperature. Simulation results are used to verify the performance of the proposed vector control scheme.

• Tunnel and Underground Space
• /
• v.19 no.5
• /
• pp.450-462
• /
• 2009

To analyze the behavioral characteristics of rocks on indirect tests and uniaxial compressive strength, researchers have investigated 1417 pieces of rock block, which include igneous, metamorphic and sedimentary rocks in Korea. The same behavioral characteristics have been shown in every type of sedimentary rock and in the same species of rock in the case of Brazilian strength application. This suggests that correlations of rocks for geological considerations can lead to high reliability of the experimental results in case of an indirect method.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.8 no.1
• /
• pp.1-9
• /
• 2000

In the present study, the IDI-type constant volume chamber, which utilizes the indirect injection stratified charge method, is used to solve several problems including misfires and cycle-variations caused by unstable initial ignitions. A subchamber has been used to make an ignitable mixture under the low mean equivalence ratio. After burned in the subchamber, the flame jet getting through the passage hode enters the main chamber and burns the lean charge. There are many factors which affect the combustion characteristics of the indirect injection stratified engine. The passage hole angle is the most important since it determines the direction of flame flows into the main chamber. In the present study, we measured the combustion pressure, and the wall temperature, and computed the heat flux through the cylinder wall in order to understand the combustion characteristics depending on passage hole angle and the equivalence ratio.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.5 no.3
• /
• pp.66-75
• /
• 1997

Sound transmission from the luggage comparment into the car cabin is important in the viewpoint if exhaust and road noises of passenger cars. In this paper, acoustic modal coupling between passenger and luggage compartments through loudspeaker holes at parcel shelf is dealt with for a sedan type passenger car with rigid rear seat. For these purposes, a half-scaled model car is tested and computed by the indirect BEM. Predicted acoustic transfer functions are compared with experimental ones and they agree reasonably well. It is found that the fore-aft resonance frequencies of the passenger cavity in the absence of coupling holes are tend to shift to higher frequencies when the luggage compartment is coupled to the passenger cavity.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.2 no.5
• /
• pp.110-120
• /
• 1994

Due to the increasing demands in comfortable drivability, most motor companies are developing their own unique shift controller to suppress the shift shock induced by gear change. For a typical automatic transmission system, the dynamic constraints of friction clutch was clarified for efficient program development and major factors effecting the shift transient was confirmed by simulation study. The MIMO LQG/LTR controller was designed to control the turbine and corresponding gear speed. By establishing the control strategy recalling transient response during shift the speed controller mentioned above was used as an indirect torque controller. Consequently a new concept for a systematic design method of shift controller applicable to wide-varying systems was suggested which is time efficient and cost efficient saving a lot of experimental study.

• Structural Engineering and Mechanics
• /
• v.15 no.6
• /
• pp.653-668
• /
• 2003

Many papers which deal with the dynamic instability of shell-like structures under the STEP load have been published. But, there have been few papers related to the dynamic instability of hybrid cable domes. In this study, the dynamic instability of hybrid cable domes considering geometric nonlinearity is investigated by a numerical method. The characteristic structural behaviour of a cable dome shows a strong nonlinearity, so we determine the shape of a cable dome by applying initial stress and examine the indirect buckling mechanism under dynamic external forces. The dynamic critical loads are determined by the numerical integration of the nonlinear equation of motion, and the indirect buckling is examined by using the phase plane to investigate the occurrence of chaos.

• Proceedings of the KIEE Conference
• /
• 2000.07d
• /
• pp.2374-2376
• /
• 2000

In this paper, we propose an indirect vector control method using Adaptive Neuro-Fuzzy Inference System (ANFIS) parameter estimator. It estimates the rotor time constant when the indirect vector control of induction motor is applied. We use the stator current error that is difference between the current command and estimated current calculated from terminal voltage and current. And two induced current estimate equations are used in training ANFIS.The estimator is trained by the hybrid learning algorithm. Simulation results shows good performance under load disturbance and motor parameter variations.

• Proceedings of the KAIS Fall Conference
• /
• 2007.11a
• /
• pp.81-84
• /
• 2007

In this thesis, we have designed the indirect adaptive controller using Dynamic Neural Units(DNU) for unknown nonlinear systems. Proposed indirect adaptive controller using Dynamic Neural Unit based upon the topology of a reverberating circuit in a neuronal pool of the central nervous system. In this thesis, we present a genetic DNU-control scheme for unknown nonlinear systems. Our method is different from those using supervised learning algorithms, such as the backpropagation (BP) algorithm, that needs training information in each step. The contributions of this thesis are the new approach to constructing neural network architecture and its training.