• Journal of the Korean Wood Science and Technology
• /
• 제43권5호
• /
• pp.672-681
• /
• 2015

As a part of abating the formaldehyde emission of amino resin-bonded wood-based composite panels, this study was conducted to investigate hydrolytic stability of urea-melamine-formaldehyde (UMF) resin depending on various hydrolysis conditions and hardener types. Commercial UMF resin was cured and ground into a powdered form, and then hydrolyzed with hydrochloric acid. After the acid hydrolysis, the concentration of liberated formaldehyde in the hydrolyzed solution and mass loss of the cured UMF resins were determined to compare their hydrolytic stability. The hydrolysis of cured UMF resin increased with an increase in the acid concentration, time, and temperature and with a decrease in the smaller particle size. An optimum hydrolysis condition for the cured UMF resins was determined as $50^{\circ}C$, 90 minutes, 1.0 M hydrochloric acid and $250{\mu}m$ particle size. Hydrolysis of the UMF resin cured with different hardener types showed different degrees of the hydrolytic stability of cured UMF resins with a descending order of aluminum sulfate, ammonium chloride, and ammonium sulfate. The hydrolytic stability also decreased as the addition level of ammonium chloride increased. These results indicated that hardener types and level also had an impact on the hydrolytic stability of cured UMF resins.

• Macromolecular Research
• /
• 제12권6호
• /
• pp.545-552
• /
• 2004

The long-term stability of sulfonic acid-containing polyimides has been investigated. The hydrolytic degradation of homopolyimide and the block copolyimide comprising $27\;mol\%$ of 2,2'-bis(trifluoromethyl)benzidine and $9\;mol\%$ of m-phenylenediamine (BTFMB27mPl0[7/(3+1)]), was quantified through viscosity measurements and FT-IR spectroscopic analyses. The viscosity decrease with respect to time and the degradation rate were similar. The degrees of degradation with respect to time under ambient conditions and at elevated temperature in water were monitored by FT-IR spectroscopy. A new absorption peak was observed at $1786\;cm^{-1},$ which we corresponds to the presence of anhydride end groups formed by hydrolytic scission of the imide rings.

• 한국전기화학회:학술대회논문집
• /
• 한국전기화학회 2004년도 수소연료전지공동심포지움 2004논문집
• /
• pp.205-210
• /
• 2004

• Fisheries and Aquatic Sciences
• /
• 제5권4호
• /
• pp.263-270
• /
• 2002

The Pacific oysters, Crassostrea gigas, were stressed with different concentrations of benzo(a) pyrene and depurated to determine the hemocyte lysosomal membrane stability and hydrolytic enzymatic activity as a biomarker candidate to the chemical, using NRR (neutral red retention) and API ZYM System, respectively. The membrane damage measured as NRR decrease was significant with the increase of chemical concentration and exposure time (P<0.05), providing a possible tool for biomarker. Interestingly, the control showed intrinsic stress probably due to captive life in the laboratory, and a recovering trend was also found during the depuration. The benzo(a)pyrene-exposed oysters showed increased enzyme activities in alkaline phosphatase, esterase (C4), acid phosphatase, naphthol-AS-BI-phospho­hydrolase, $\beta$-galactosidase, $\beta$-glucuronidase, and N-acetyl- $\beta$-glucosaminidase. Of them, only two enzymes, acid phosphatase and alkaline phosphatase, showed some potential available for the generation of enzymatic biomarker in the oyster. The results are suggestive of the potential availability of the cellular and enzymatic properties as a biomarker. However, considering that a robust biomarker should be insensitive to natural stress coming from normal physiological variation, but sensitive to pollutants, a concept of intrinsic stress the animal possesses should be taken into consideration. This reflects the necessity of further research on the intrinsic stress affecting the cellular and enzymatic properties of the chemical­stressed oysters prior to using the data as a biomarker.

• Asian-Australasian Journal of Animal Sciences
• /
• 제19권10호
• /
• pp.1429-1436
• /
• 2006

Fermentation characteristics, nutrient retention and aerobic stability of barley silages prepared using 6 commercial inoculants were evaluated using 126 mini-silos (3-L) in a completely randomized design. Whole barley forage was chopped, wilted to 39% DM and treated with water (control, S) or one of six inoculants: A (containing Lactobacillus plantarum); B (L. plantarum and Enterococcus faecium); C (L. plantarum and Pediococcus cerevisiae); D (L. plantarum, Pediococcus pentosaceus and Propionibacterium freudenreichii, plus hydrolytic enzymes); E (Lactobacillus buchneri plus hydrolytic enzymes); F (L. buchneri and P. pentosaceus plus hydrolytic enzymes). Samples of treated forage were collected for analysis at the time of ensiling, and then 18 silos of each treatment were filled, capped and weighed. Triplicate silos were weighed and opened after 1, 3, 5, 7, 33, and 61 d. On d 61, $400{\pm}5g$ of material from each silo was placed in 1-L styrofoam containers, covered with cheesecloth and held at room temperature. Silage temperature was recorded hourly for 14 d via implanted thermocouple probes. Chemical composition of the forage at ensiling was consistent with previously reported values. At d 61, pH was lowest (p<0.01) in silage S. Ammonia-N was lower (p<0.05) in silage A than in silages S, B, E, or F. Compared to pre-ensiling values, water soluble carbohydrate concentrations were elevated in silages S, A, B, C and D, and decreased in E and F. Lactic acid concentrations were similar (p>0.10) across treatments. Acetic acid levels were highest (p<0.01) in silage E and lowest (p<0.01) in silage D. Recovery of DM was lower (p<0.01) in silage F than in silages S, A, B, C, or D. On d 61, yeasts were most numerous (p<0.01) in silage D, which was the only silage in which temperature rose more than $2^{\circ}C$ above ambient during aerobic exposure. Silage D also had the highest (p<0.01) pH and ADIN content after aerobic exposure. Lactic acid and WSC content of silage D decreased dramatically during the 14-d aerobic exposure period. Yeast counts (at d 14 of exposure) were lowest (p<0.01) in silages E and F. In general, the commercial inoculants did not appear to enhance the fermentation of barley silage to any appreciable extent in laboratory silos.

• 한국염색가공학회:학술대회논문집
• /
• 한국염색가공학회 2008년도 제39차 학술발표회
• /
• pp.149-150
• /
• 2008

인체에 무해한 친환경 소재인 TPU수지를 인조합성피혁에 채용하여 기존에는 없던 통기성을 부여하였으며 PU 소재의 제품보다 내가수분해성이 뛰어나면서 기본물성이 우수한 고감성 인조합성 피혁 제품을 개발하였다.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1997년도 하계학술대회 논문집 C
• /
• pp.1216-1218
• /
• 1997

Hydrolysis of BTDA-ODA: MPDA, PMDA-ODA, PIQ polyimides were investigated by FT-IR. The results showed that hydrolysis depends on structure of polyimide and that polyimide obtains hydrolytic stability by curing. Polyimide-aluminum interfaces were characterized by RAIR. It was concluded that imidization of the polyamic acid to polyimde was inhibited by interaction of acid groups with substrate to form aluminum carboxylate.

• Journal of Microbiology and Biotechnology
• /
• 제26권1호
• /
• pp.20-27
• /
• 2016

Lactobacillus kefiranofaciens ZW3 was obtained from kefir grains, which have high lactose hydrolytic activity. In this study, a heterodimeric LacLM-type β-galactosidase gene (lacLM) from ZW3 was isolated, which was composed of two overlapping genes, lacL (1,884 bp) and lacM (960 bp) encoding large and small subunits with calculated molecular masses of 73,620 and 35,682 Da, respectively. LacLM, LacL, and LacM were expressed in Escherichia coli BL21(DE3) and these recombinant proteins were purified and characterized. The results showed that, compared with the recombinant holoenzyme, the recombinant large subunit exhibits obviously lower thermostability and hydrolytic activity. Moreover, the optimal temperature and pH of the holoenzyme and large subunit are 60℃ and 7.0, and 50℃ and 8.0, respectively. However, the recombinant small subunit alone has no activity. Interestingly, the activity and thermostability of the large subunit were greatly improved after mixing it with the recombinant small subunit. Therefore, the results suggest that the small subunit might play an important role in maintaining the stability of the structure of the catalytic center located in the large subunit.

• Environmental Engineering Research
• /
• 제11권6호
• /
• pp.325-332
• /
• 2006

A novel series of polystyrene (PS) beads containing various sulfonamide groups was prepared, and their chemical stabilities in an aqueous solution were tested in order to determine their ability to inactivate microbes. By reacting aminomethyl polystyrene (AM PS) beads or carboxy polystyrene beads with various benzenesulfonic acid derivatives, the sulfonamide groups were introduced on the PS beads. The characteristics of the product beads were analyzed by elementary analysis after the substitution of various sulfonamide groups. Energy Dispersive Spectroscopy (EDS), and FT-IR analysis were used to analyze the elemental functional group composition, respectively. The hydrolytic stabilities of the PS beads containing various sulfonamide groups along with the relationship between the swelling ratio and their hydrophilicity were investigated. The antibacterial activity of the beads was determined by their ability to inactivate E. coli. This study reports that PS beads containing sulfonamide groups had lasting antibacterial efficacy over a satisfactory period, whilst maintaining their chemical stabilities against hydrolysis. The 8 synthesized polymer beads exhibited antibacterial ability.

• 접착 및 계면
• /
• 제14권1호
• /
• pp.36-42
• /
• 2013

폴리우레탄 접착제의 내가수 분해성 향상을 위하여 실란 커플링제를 첨가하여 특성을 고찰 하였다. 실란 커플링제는 사슬 내에 2종 이상의 다른 기능성기를 가지고 있는 3-isocyanatopropyl triethoxy silane (ITS)을 사용하였는데 일반적으로 고분자와 무기, 유기 또는 금속소재와의 복합계에서 계면결합으로 접착성 개선을 가져올 수 있다. 본 연구에서는 폴리우레탄 접착제 제조에서 ITS의 양을 0, 0.3, 0.5, 0.7 및 1 wt%로 첨가하여 샘플을 제조하고 가사시간, modulus, 내열성 및 접착력을 평가하였다. ITS가 첨가된 샘플은 대부분의 물성에서 우수한 특성을 나타내었다.