• 한국응용과학기술학회지
• /
• 제22권1호
• /
• pp.56-61
• /
• 2005

Methanol was synthesized by homogeneous and catalytic reactions of partial oxidation of methane. The effect of pressure, temperature and oxygen concentration on methanol synthesis was investigated. The catalyst used was Bi-Cs-Mg-Cu-Mo mixed oxide. The partial oxidation reaction was carried out in a fixed bed reactor at 20${\sim}$46 bar and $450{\sim}480^{\circ}C$ and oxygen concentration of 5.3${\sim}$7.7mol%. The results were compared with results of homogeneous reaction performed at the same conditions. Methane conversions of the homogeneous and catalytic reactions increased with temperature. Methanol selectivity of the homogeneous reaction decreased with increasing temperature. However, the methanol selectivity of catalytic reaction increased with temperature. For both homogeneous and catalytic reactions, the methane conversions were around 5%. This may be due to the low oxygen concentration. Methanol selectivity of the catalytic reaction was higher than that of homogeneous one.

• 한국분말재료학회지
• /
• 제15권5호
• /
• pp.386-392
• /
• 2008

Silver particles were synthesized from silver nitrate by homogeneous precipitation and chemical reduction methods involving the intermediate silver cyanate. The obtained silver particles were characterized by XRD, SEM, TEM, and BET. Urea which could prevent the agglomeration of the reduced silver particles was used as a homogeneous precipitator. The spherical silver particles with average particle diameter of 100 nm were obtained under the optimum reaction conditions. The optimum synthetic conditions were found as follows: reaction temperature $100^{\circ}C$, reaction time 60 min, concentration of silver nitrate $1{\times}10^{-2}$ mol, urea $5{\times}10^{-3}$ mol, and sodium citrate $8.5{\times}10^{-4}$ mol. The phase of obtained silver particles was crystalline state and the silver particles were relatively dense, which had the surface area of $0.7571\;m^{2}/g$.

• 한국신재생에너지학회:학술대회논문집
• /
• 한국신재생에너지학회 2007년도 춘계학술대회
• /
• pp.41-44
• /
• 2007

Steam reforming reaction of natural gas is an important process for fuelcell commercialization. In this paper, steam reforming reaction is studied by numerical method. Pseudo-homogeneous model is incorporated for chemical reactions and one medium approach is used to take into account thermally equilibrium phenomena between catalyst and bulk gas. The model is validated with our experimental results under the same operating conditions. Because performance of reformer has relation to heat flux from wall, heat flux profiles was investigated by using Nusselt number. Value of Nusselt number in steam reformer is larger than one in channel, which does not have chemical reaction because steam reforming reaction is an endothermic reaction. When the difference of Nusselt number at the front and the rear is larger, performance is improved.

• 한국연소학회지
• /
• 제11권2호
• /
• pp.28-36
• /
• 2006

A constant volume combustion chamber was used to investigate the combustion characteristics. of homogeneous charge of methane-air mixture under various initial pressure, equivalence ratio and ignition times. The constant volume combustion chamber(CVCC) mostly has been studied by the experiments of visualization until now. So it is needed the numerical analysis of fluid and combustion characteristics in chamber by the more detail simulation. In this paper, the numerical analysis is tried to approach basically the homogeneous charge combustion phenomena under the various conditions, and the combustion phenomena in chamber is numerically analyzed by the commercial FIRE code. As a results, the combustion phenomena which were mean temperature, OH radical and reaction rate in chamber were investigated and it showed that the smallest flame growth occurs for the lean state and the increase of initial charged pressure condition due to the reduced OH radical.

• Fibers and Polymers
• /
• 제1권1호
• /
• pp.6-11
• /
• 2000

In the polycondensation reaction of polyethyleneterephthalate(PET), $Sb_2$$O_3$, can react effectively as a catalyst, if physically transformed. $Sb_2$$O_3$ powder is transformed into liquid solution by dissolving in ethylene glycol(EG). Homogeneous catalyst is made by mixing this liquid solution with glycols having different solubility. The efficient reaction of PET polymerization is expected by using homogeneous catalyst. PET was synthesized using homogeneous catalysts of 4 wt.% $Sb_2$$O_3$ solution dissolved in glycol[EG, 2,2-bis(4-(2-hydroxyethoxy)phenol)propane(BHPP), neopentyl glycol(NPO), and 1,3-propandiol(PD)]. PET using EG-BHPP($Sb_2$$O_3$) catalysts shows the highest I.V. within a reaction time of 120 min. In the p-d analysis, PET using EG-BHPP($Sb_2$$O_3$) catalysts has the fastest propagation rate and slowest degradation rate. EG-BHPP($Sb_2$$O_3$) catalysts are more efficient than EG($Sb_2$$O_3$) catalysts and $Sb_2$$O_3$ powder catalysts.

• 한국연소학회지
• /
• 제5권1호
• /
• pp.1-6
• /
• 2000

Surface reaction occurs at a certain surface temperature when a catalyst is heated up in a reactive mixture. If homogeneous ignition does not occur, a steady state is observed because the heat produced by the surface reaction is balanced with the heat loss caused by convection, conduction and radiation. The present paper treats the effects of pressure on the surface temperature at the steady state. Hydrogen and oxygen are used as reactants and nitrogen as an inert gas. A spherical platinum catalyst of 1.5 mm in diameter is sustained in the chamber with two wires of 0.1 mm in diameter. As results, there exists a maximum steady temperature at a certain relative hydrogen concentration which increases with total pressure. At the steady state, it can be approximated that the heat release is estimated by the mass transfer considering the effect of natural convection. The experimental results are explained qualitatively by the approximation.

• 공업화학
• /
• 제31권5호
• /
• pp.475-480
• /
• 2020

Lactic acid와 키토산을 Cu(II) 이온과 반응시켜 합성한 착물을 사용하여 유기인 유사 독성물질인 DFP (Diisopropyl fluorophosphate) 분해반응에 적용하였다. Cu(II)-lactic acid 착물의 경우 homogeneous 상태에서 분해반응 반감기가 37. 1 min으로 분해성능이 우수하였다. 1 kDa 저분자량 수용성 키토산으로 합성한 Cu(II)-LMWS chitosan 착물은 결정화 후에는 용해도가 낮아 heterogeneous 한 상태에서 분해반응이 진행되었으며 그 반감기는 32.9 h이었다. 이 결과는 기존에 연구된 18 kDa 키토산 Cu(II)착물의 분해반응속도보다 약 16배 정도 증가된 것이다. Cu(II)-LMWS chitosan 착물을 결정화하지 않고 homogeneous한 상태로 진행한 분해반응에서는 반감기가 8.75 h로 용해도에 따라 약 4배의 차이를 확인할 수 있었다.

• 한국세라믹학회지
• /
• 제33권5호
• /
• pp.495-506
• /
• 1996

Monodispersed colloidaly yttria(Y2O3) can be used in a variety of applications such as phosphors. IR transparent materials and fine ceramics. For preparing monodispersed yttria homogeneous precipitation has been regarded as a fovorable method that is monodispersed yttria can be obtained through calcining monodispersed colloidal compound of yttrium (eg:Y(OH)CO3.nH2O)which can be prepared by homogeneous precipitation with urea. It is however still required to find out the quantitative effects of important variables of precipitation such as concentration of yttrium and urea reaction temperature and initial pH of reactant even though homogeneous precipitation of Y3+ with urea has been studied extensively. Among the effects of these variables we investiga-ted 1) the effect of yttrium concentration on the shape and size of precipitate and the reation rate 2) range of yttrium concentration required to make monodispersed colloidal particles 3) the reason for limited concentra-tion range of yttrium and 4) the effect of ultrasonic radiation on the limited concentration.

• 한국지반공학회논문집
• /
• 제16권4호
• /
• pp.5-16
• /
• 2000

본 연구에서는 지금까지 수행한 일련의 결과들에 근거한 지반력 계수와 극한 지반반력을 역해석적 방법으로 결정하고 이를 이용하여 비균질 지반에서의 비선형 수평거동을 예측할 수 있는 해석기법을 제안하고자 함이 목적이다. Chang이 제안한 해석기법은 비균질 지반의 비선형적인 거동을 예측하기에는 어려움이 있다. 이에 본 연구에서는 말뚝의 비선형 거동 예측을 위하여 Chang 모델에 p - y 곡선을 적용하는 복합적인 해석기법을 제안하고 해석 프로그램을 개발하였다. 그리고 본 해석기법의 적용성 검증을 위하여 모형실험 및 현장실험 결과와 상용 프로그램인 Pentagon2D을 이용한 해석 결과와 비교 검토하였다. 해석상에 이용한 지반반력 계수와 극한 지반반력은 균질지반에서 결정된 값을 비균질 지반에 적용하였으며, 본 해석기법에 의한 거동 예측결과는 모형실험 결과와 잘 일치하였다. 또한 현장실험과의 비교에서도 정도 높은 일치성을 보였다.

• 한국세라믹학회지
• /
• 제45권12호
• /
• pp.845-850
• /
• 2008

Hydrated sodium silicate was synthesized by hydrothermal reaction using anhydrous sodium silicate. The optimum additions of water was 25wt% to make hydrated sodium silicate with homogeneous and purposed water contents. Porous ceramics with homogeneous microstructure and spherical closed pore can be fabricated by elimination of the large pores(a few mm in size) which was formed during first heat treatment through the decomposition of water. Spherical closed pore was formed above $600^{\circ}C$ and the pore size was increased with increasing second heat treatment temperature due to growth of pores. The size of spherical closed pore was varied from 35 to $233\;{\mu}m$ and specific gravity was varied from 0.2 to 1.02 depending on the combinations of the first and second heat treatment temperature.