• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.20 no.2
• /
• pp.245-252
• /
• 2016

In this paper, the design of a double-dipole quasi-Yagi antenna (DDQYA) with a gain over 7 dBi at 1.70-2.70 GHz band is studied. The proposed DDQYA consists of two strip dipoles with different lengths and a ground reflector, which are connected trough a coplanar stripline. The length of the second dipole is adjusted to increase the gain in the low frequency band, whereas a rectangular patch director is appended to the DDQYA to enhance the gain in the middle and high frequency band. The effects of the length of the second dipole, and the length and width of the director on the antenna performance are analyzed, and final design parameters to obtain a gain over 7 dBi are obtained. A prototype of the proposed DDQYA is fabricated on an FR4 substrate, and the experimental results show that the antenna has a frequency band of 1.60-2.86 GHz for a VSWR < 2, and measured gain ranges 7.2-7.6 dBi at 1.70-2.70 GHz band.

• The Journal of the Acoustical Society of Korea
• /
• v.33 no.2
• /
• pp.87-93
• /
• 2014

If one identifies the detailed distribution of pressure and axial velocity at a source plane, the position and strength of major noise sources can be known, and the propagation characteristics in axial direction can be well understood to be used for the low noise design. Conventional techniques are usually limited in considering the constant source characteristics specified on the whole source surface; then, the source activity cannot be known in detail. In this work, a method to estimate the pressure and velocity field distribution on the source surface with high spatial resolution is studied. The matrix formulation including the evanescent modes is given, and the nearfield measurement method is proposed. Validation experiment is conducted on a wide duct system, at which a part of the source plane is excited by an acoustic driver in the absence of airflow. Increasing the number of evanescent modes, the prediction of pressure spectrum becomes further precise, and it has less than -25 dB error with 26 converged evanescent modes within the Helmholtz number range of interest. By using the converged modal amplitudes, the source parameter distribution is restored, and the position of the driver is clearly identified at kR = 1. By applying the regularization technique to the restored result, the unphysical minor peaks at the source plane can be effectively suppressed with the filtering of the over-estimated pure radial modes.

• Asia-Pacific Journal of Business Venturing and Entrepreneurship
• /
• v.12 no.4
• /
• pp.175-189
• /
• 2017

Science and technologies develop rapidly and in conditions where it is difficult to predict both domestically and abroad, the rapidly changing business environment demands innovation. To strengthen the businesses' competitive edge, the key challenge is not to control but rather grant autonomy, allowing it to anticipate the future and actively deal with. This will allow to train and manage talented people with competence and abilities, which all links to the concept of the Super Leadership. Currently, our society is in the change due to the Fourth Industrial Revolution wave and paradigm related with high-tech industry, hence is in desperate need for creativeness and speed management. It is a time where risk and challenges coexist and is not a standardized environment. Businesses must make efforts in managing human resources and allow them to have leaderships compatible with the current era, giving them opportunities to face challenges. The necessity for Super Leadership is emphasized especially in the industry-orientated era, where new revolutionary technologies are emerging and existing technologies are being advanced and maximized, to cultivate the potentials of the members and secure competitive superiority for the best management and creation. Therefore, in this research, the empirical analysis of the relationship between Super Leadership of small and medium enterprises and the business outcome was conducted. Research outcome states that, in order to create a sustainable business outcome, enterprises need to invest more in developing leaderships and in accordance with it, promote talent. In order to survive and sustain growth in the period of endless competition like today, it is concluded that it is imperative to establish a powerful Super Leadership that will endeavor to engage and maximize the competence of members of the organization.

• Journal of Yeungnam Medical Science
• /
• v.8 no.1
• /
• pp.63-71
• /
• 1991

Noninvasive techniques for antenatal detection of the fetal development and well-being such as biophysical profile, non-stress and stress test remain major challenges in modem obstetric practice. To obtain and analyze umbilical artery velocity waveform by pulsed-wave doppler ultrasound, a total of 160 determinations were carried out on 157 normal pregnant women between 16th to 41st week gestation. The ratio of peak systolic to end-diastolic flow velocity(S/D ratio), pulsatility index and resistance index were measured as indices of the resistance in feto-placental circulation. The results were as follows : As gestation advances, the, mean values for peak systolic and end-diastolic velocities raised progressively. As gestation advances, the mean values for the S/D ratio declined progressively, exhibiting high diastolic flow velocity caused by low resistance. Pulsatility index, and resistance index were also declined progressively, as gestation advances. The analysis of umbilical artery blood flow velocity waveforms provides a new noninvasive technique to evaluate fetal development and well-being, and may be expected a reliable method for assessment of fetal life.

• Journal of the Korean Geophysical Society
• /
• v.8 no.1
• /
• pp.45-48
• /
• 2005

In order to investigate the velocity structure of the southern part of the Korean peninsula, exploded seismic signals were recorded for 120 s along a 294-km WNW-ESE line and 150 s along a 335-km NNW-SSE line in 2002 and 2004, respectively. Velocity tomograms were derived from inverting first arrival times. One-dimensional velocity models derived by joint analyses of teleseismic receiver functions and surface wave dispersion at several stations near the profiles were uesd to build initial models. The raypaths indicate several midcrust interfaces including ones at approximate depths of 2.0 and 14.9 km with refraction velocities of approximately 6.0 and 7.1 km/s, respectively. The deepest significant interface varies in depth from 30.8 km to 36.1 km. The critically refracting velocity varies from 7.8 to 8.1 km/s along this interface which may correspond to the Moho discontinuity. The velocity tomograms show (1) existence of a low-velocity zone centered at 6-7 km depth under the Okchon fold belt, (2) extension of the Yeongdon fault down to greater than 10 km, and (3) existence of high-velocity materials under the Gyeongsan basin whose thickness is less than 4.2 km.

• Geophysics and Geophysical Exploration
• /
• v.18 no.1
• /
• pp.1-8
• /
• 2015

To estimate the shear-wave velocity (${\nu}_s$ beneath the OTVZ seismic station on Ngauruhoe volcano in New Zealand, we calculated receiver functions (RFs) using 127 teleseismic data ($Mw{\geq}5.5$) with high signal-to-noise ratios recorded during November 11, 2011 to September 11, 2013. The genetic inversion algorithms was applied to 21 RFs calculated by the iterative time-domain deconvolution method. In the 1-D ${\nu}_s$ model derived by the inversion, the Moho is observed at a 14 km depth, marked by a ${\nu}_s$ transition from 3.7 km/s to 4.7 km/s. The average ${\nu}_s$ of the overlying crust is 3.4 km/s, and the average ${\nu}_s$ of a greater than 9-km thick low-velocity layer (LVL) in the lower crust is 3.1 km/s. The LVL becomes thinner with increasing distance from the station. Another LVL thicker than 10 km with ${\nu}_s$ less than 4.3 km/s is found in the upper mantle. Those LVLs in the lower crust and the upper mantle and the relatively thin crust might be related to the magma activity caused by the subducting Pacific plate.

• Geophysics and Geophysical Exploration
• /
• v.19 no.2
• /
• pp.67-75
• /
• 2016

To investigate spatial and temporal variations of low-frequency (${\leq}5Hz$) ambient seismic noise, we analyzed the noise data recorded for one whole year of 2014 at surface accelerometer stations in South Korea. After decomposed into low-frequency (LF; < 1 Hz) and high-frequency (HF; ${\geq}1Hz$) components, the root-mean-squared (RMS) amplitudes and power spectral densities (PSD) of the noise data were computed. The RMS amplitudes were larger on islands and near-shore stations, but also large RMS amplitudes were observed at inland stations in large cities only for HF components. The RMS amplitudes of HF components were larger in the daytime than at nighttime and during weekdays than on Sunday and holidays. This indicates the HF components are closely related to human activities. On the contrary, daily and weekly variations were not clear in the LF components while they showed seasonal variations with its maximum during the winter and a good correlation with significant wave height. Therefore, we interpret the mechanism of LF components is closely related to natural phenomena such as sea. The amplitude of LF components decreased as an exponential function of the distance to the center of typhoons. The exponential index of -0.76 suggested that ambient seismic noise included both surface and body waves. Peak frequencies of the PSD curves were near 0.34 Hz indicating the double frequency. No temporal variation in the peak frequency was clearly noticed.

• Journal of the Society of Cosmetic Scientists of Korea
• /
• v.30 no.2
• /
• pp.279-294
• /
• 2004

This study described about a liquid crystalline technology that is used in cosmetics industry. Various intermediate phases may exist between solid and liquid. At high surfactant concentration, several liquid crystalline phases can be made to have formed. Although molecular arrangement with crystallization is not regular, it is known that more relative regular state is liquid crystalline or meso-phase than liquid phase. Usually, it described in detail about manufacturing method that explained about a kind of liquid crystalline technology in cosmetics, a new liquid crystalline technology, and makes liquid crystalline. Specialty, it introduced about kind of special an emulsifier to form liquid crystalline. There were hydrogenated lecithin, ceramide, dipalmitoylhydroxyproline, DEA-cetyl phosphate, Gemini-surfactant in representative raw material to form liquid crystalline. Liquid crystalline extent that used polarization microscope to observe formation, and appears best from 400times, 600times, 1,000times well appeared. Also, droplet particle size that liquid crystal is made best 1.0-10.0$\mu\textrm{m}$ be. General emulsion more than superior result that measures the skin moisturizing effect to take advantage of liquid crystalline technology of vitamin was seen. As presence at a clinical result, wave and general emulsion more than superior result (more than 20%) that measures skin moisturizing effect about liquid crystalline of vitamin B$\_$5/ were seen (ANOMA t-test, p<0.05)

• Korean Journal of Optics and Photonics
• /
• v.16 no.4
• /
• pp.326-333
• /
• 2005

Phase-only encryption scheme using exclusive-OR rules in Fourier plane and a single path decryption system are presented. A zero-padded original image, multiplied by a random phase image, is Fourier transformed and its real-valued data is encrypted with key data by using XOR rules. A decryption is simply performed based on 2-1 setup with spatial filter by Fourier transform for multiplying phase-only encrypted data by phase-only key data, which are obtained by phase-encoding process, and spatial filtering for zero-order elimination in inverse-Fourier plane. Since the encryption process is peformed in Fourier plane, proposed encryption scheme is more tolerant to loss of key information by scratching or cutting than previous XOR encryption method in space domain. Compare with previous phase-visualization systems, due to the simple architecture without a reference wave, our system is basically robust to mechanical vibrations and fluctuations. Numerical simulations have confirmed the proposed technique as high-level encryption and simple decryption architecture.

• Food Science and Preservation
• /
• v.14 no.6
• /
• pp.722-726
• /
• 2007

Extracting and analytical conditions of curcumin, and removal of bitterness substance from Curcuma longa L. were investigated. Absorption maxima was shown to be 424 nm at methanol solvent. Optimal conditions for analysis of curcumin was Zorbax eclipse $C_{18}$ column ; mobile phase, 75% MeOH ; flow rate, 0.8 mL/min ; wave length, UV 424 nm. Curcumin component was analyzed to be the highest content in methanol extract. In all samples, extraction yield by heating was shown to be effective as compared to room temperature. Curcumin contents of methanol and ethanol extracts in extraction of room temperature were 14.4 and 14.2 times higher than that of water extract, respectively. Two hot solvent extracts has a high curcumin content being 150 mg% as compared to room temperature. Extracting time was an effective condition when it was extracted for 60 minutes for elevating the curcumin content of water and methanol extracts. Bitter substance (BS) was markedly decreased in water extract by heat treatment of above $80^{\circ}C$. BS was weak in $121^{\circ}C$ treatment than in room temperature and it was however strong in $100^{\circ}C$ treatment. RT and $70^{\circ}C$ heat treatment were not different in BS intensity.