• 조명전기설비학회논문지
• /
• 제14권5호
• /
• pp.27-35
• /
• 2000

본 논문에서는 공진형 Full Bridge DC-DC 컨버터의 고효율 및 고밀도의 적류 안정화 전원장치의 전력제어를 위해서 스위칭 소자 대한 스위칭 손실 스위칭 스트레스를 줄이고, 가변입력에 대한 정상상태의 오차를 없애기 위해서 개선된 소프트 스위칭 방법인 디지털 I-PD 워상천이 제어기를 설계하여 적용하고자 한다. 공진형 FB DC-DC 컨버터에 대한 회로분석을 통한 모드별 소프트 스위칭 동작 특성을 해석하고, 질렬공진 등가회로로부터 이산시간계 상태방정식을 도출하며 입력에 대한 급변하는 error를 막고, 정성상태 오차없이 추종하도록 하는 디지털 I-PD형 제어기를 구성한다. 또한 고속의 소프트 스위청 공진혐 FB DC-DC 컨버터 제어기에 위해서 디지털 I-PD제어기에 위상천이 제어기를 부가하므로서 컨버터의 중량을 줄이고 스위치 소자의 스트레스가 경감되는 컨버터를 실현하였다.

• 반도체디스플레이기술학회지
• /
• 제2권1호
• /
• pp.1-5
• /
• 2003

Plasma generator based on non-self-sustained low-pressure arc discharge has been examined as a tool for deposition of highly-adhesive hydrogenated amorphous diamond-like carbon(DLC) films. Since the discharge is stable in wide range of gas pressures and currents, this plasma source makes possible to realize both plasma-immersion ion implantation(PIII) and plasma-immersion ion deposition(PIID) in a unified vacuum cycle. The plasma parameters were measured as functions of discharge current. Discharge and substrate bias voltage parameters have been determined for the PIII and PIID modes. For PIID it has been demonstrated that hard and well-adherent DLC coating are produced at 200-500 eV energies per deposited carbon atom. The growth rates of DLC films in this case are about 200-300 nm/h. It was also shown that short(∼60$\mu\textrm{s}$) high-voltage(> 1kV) substrate bias pulses are the most favorable for achieving high hardness and good adhesion of DLC, as well as for reducing of residual intrinsic stress are.

• 한국가금학회지
• /
• 제26권1호
• /
• pp.1-25
• /
• 1999

Concerns about meat quality, including chicken meat, for the human diet has led to many attempts to manipulate the carcass fat and increase the eating quality. For actual eating quality, the birds must be grown and finished in a manner that results in meat that are tender, succulent and of good flavor, as well as being free from any foreign taint, flavor or safety hazard. Tenderization treatment with high voltage(820V) electrical stimulation and prechill muscle tensioning would improve the tenderness of chicken meat. Proper programs for the withdrawal of feed and water require a team approach for maximizing yield of meat and minimizing carcass contamination. Also effding of supplemental levels of-tocopherol to poultry with vegetable or fish oils increases of desirable polyunsaturated fatty acid(PUFA) content and stablizes the meat against rancidity and fish off-flavors. The nutritional effects of varying dietary ingredients on broiler carcass fat content are also important. Increasing the levels of energy in the ration increases the carcass fat content, while increasing the proteing levels decreases carcass fat content. Supplement-tation of poultry diets with amino acids such as methionine, lysine, glycine and tryptophan as well as amino acid such as well as amino acid mixtures can reduce body fat deposition. Normal stress leads to chicken muscular damage resulting in reduced meat quality, but this can be controlled by preslaughter management practices. Feed manufactures can utilize ntilize nutrient modulation to control pale soft exudative(PSE)syndrome. Finally, the success in poultry meat production depends on the consistent achievement of carefully selected levels of quality. Quality assurance should be the wider function of incorporating quality into the production system and the combination of motivating quality into actions and operations.

• 한국신뢰성학회지:신뢰성응용연구
• /
• 제12권2호
• /
• pp.67-78
• /
• 2012

An electric double-layer capacitor(EDLC) is an electrochemical capacitor with relatively high energy density, typically hundreds of times greater than conventional electrolytic capacitors. EDLCs are widely used for energy storage rather than as general-purpose circuit components. They have a variety of commercial applications, notably in energy smoothing and momentary-load devices, and energy-storage and kinetic energy recovery system devices used in vehicles, etc. This paper presents an accelerated degradation test of an EDLC with rated voltage 2.7V, capacitance 100F, and usage temperature $-40^{\circ}C{\sim}65^{\circ}C$. The EDLCs are tested at $50^{\circ}C$, $60^{\circ}C$, and $70^{\circ}C$, respectively for 1,750hours, and their capacitances are measured at predetermined times by constant current discharge method. The failure times are predicted from their capacitance deterioration patterns, where the failure is defined as 30% capacitance decrease from the initial one. It is assumed that the lifetime distribution of EDLC follows Weibull and Arrhenius life-stress relationship holds. The life-stress relationship, acceleration factor, and $B_{10}$ life at design condition are estimated by analyzing the accelerated life test data.

• Structural Engineering and Mechanics
• /
• 제17권3_4호
• /
• pp.291-302
• /
• 2004

In this paper, load monitoring technologies using U-shape Magnetoelastic (EM or ME) sensors have been exploited systemically for the first time. The steel rod to be tested is the Japan 7 mm piano steel rod. The load dependence of the magnetic properties of the piano steel rod was manifested. Two experimental designs of U-shape magnetoelastic sensors were introduced, one with double pick-up concentric coils wound on the rod to be tested, the other with pick-up coil on one yoke foot. The former design is used to derive the correlation of the relative permeability with elastic tension, while the latter is aimed to reflect the stress induced magnetic flux variation along the magnetic circuit. Magnetostatic simulations provide interpretations for the yoke foot sensing technology. Tests with double pick-up coils indicate that under proper working points (primary voltages), the relative permeability varies linearly with the axial load for the Japan 7 mm piano steel rod. Tests with pick-up coil on the yoke foot show that the integrated sensing voltage changes quadratically with the load, and error is more acceptable when the working point is high enough.

• 한국전기전자재료학회논문지
• /
• 제19권12호
• /
• pp.1085-1091
• /
• 2006

The microstructure, electrical properties, and its stability of (Pr, Co, Cr, La)-doped ZnO varistors were investigated at different sintering temperatures in the range of $1230{\sim}1300^{\circ}C$. As the sintering temperature increased, the sintered density increased from 5.50 to $5.77g/cm^3$, the varistor voltage decreased from 777.9 to 108.0 V/mm, the nonlinear coefficient decreased from 77.0 to 7.1, and the leakage current increased from $0.4{\mu}A\;to\;50.6{\mu}A$. On the other hand, the donor concentration increased from $0.90{\times}10^{18}\;to\;2.59{\times}10^{18}/cm^3$ and the barrier height decreased from 1.89 to 0.69 eV with increasing temperature. The stability of nonlinear electrical properties was obtained from sintering temperature of $1260^{\circ}C$. The varistors sintered at $1260^{\circ}C$ marked the high electrical stability, with $%{\Delta}V_{1mA}=+1.9%,\;%{\Delta}a=10.6%,\;and\;%{\Delta}I_L=+20%$ for DC accelerated aging stress state of $0.95V_{1mA}/150^{\circ}C/24h$.

• 한국기계가공학회지
• /
• 제3권3호
• /
• pp.86-92
• /
• 2004

This paper describes the properties of temperature-viscosity characteristics of hydrous and anhydrous electro-rheological fluids containing starch and titanium particle in silicone oil ER effects arise from electrostatic forces between the starch particles and titanium particles dispersed to the electrically insulating silicone oil induced when electric field is applied ER fluids under electric field control have been found to provide resonable estimates of ER fluid viscosity variation characteristics. Yield shear stress of the ER fluids were measured the couette cell type rheometer as a function of electrlc fields. The outer cup is connected to positive electrode(+) and bob becomes ground(-). The electrie field is applied by high voltage DC power supply. In this experiment shear rates were increased from 0 to 200 $s^{-1}$ in 2 minutes. The ER fluid's viscosity change is very small and stable at the temperature range of $40^{\circ}C$ to $60^{\circ}C$. Therefore, applications of a new ER fluid to control systems application are suitable.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2001년도 추계학술대회 논문집 Vol.14 No.1
• /
• pp.467-471
• /
• 2001

DC accelerated aging characteristics of $Pr_{6}O_{11}$-based ZnO varistors, which are composed of $ZnO+Pr_{6}O_{11}+CoO+Cr_{2}O_{3}+Dy_{2}O_{3}$ ceramics were investigated with CoO content in the range of 0.5 - 5.0 mol%. The varistors doped with 1.0 mol% revealing maximum value(66.61) in the nonlinear exponent exhibited excellent stability, in which the variation rates of the varistor voltage, the nonlinear exponent and leakage current are -1.93%, -10.48%, and +288.79%, respectively, under DC accelerated aging stress, such as $(0.85V_{lmA}/115^{\circ}C/24h)+(0.90V_{lmA}120^{\circ}C/24h)+(0.95V_{lmA}/125^{\circ}C/24h)+(0.95V_{lmA}/150^{\circ}C/24h)$. Next the varistors doped with 2.0 mol% exhibiting the nonlinear exponent of 47.39 showed high stability.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1998년도 하계학술대회 논문집 E
• /
• pp.1614-1616
• /
• 1998

Insulation performance of major components of prefabricated joint such as epoxy insulation unit and premolded rubber cone are guaranteed by material selection design and proper manufacturing. On the other hand insulation performance of the interfaces between the premolded rubber cone and the epoxy insulation unit and the cable insulation is maintained by keeping the premolded rubber cone to close contact with such insulation by spring. Electric characteristics of a interface depend on the contact pressure, but the required characteristics are assured so far as a proper contact pressure is maintained. In this report, the interfacial pressure by pressure sensors both in the early stage and after heating cycle were measured and the simulation by FEM program were presented. The comparison of these two results show that interfacial pressure could be controlled optimally by changing the spring length and lubricant state of the interface.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2001년도 추계학술대회 논문집
• /
• pp.467-471
• /
• 2001

DC accelerated aging characteristics of Pr$_{6}$O$_{11}$-based ZnO varistors, which are composed of ZnO+Pr$_{6}$O$_{11}$+CoO+Cr$_2$O$_3$+Dy$_2$O$_3$ ceramics were investigated with CoO content in the range of 0.5~5.0 mol%. The varistors doped with 1.0 mol% revealing maximum value(66.61) in the nonlinear exponent exhibited excellent stability, in which the variation rates of the varistor voltage, the nonlinear exponent and leakage current are -1.93%, -10.48%, and 288.79%, respectively, under DC accelerated aging stress, such as (0.85 V$_{1mA}$/115$^{\circ}C$/24h)+(0.90 V$_{1mA}$/12$0^{\circ}C$/24h)+(0.95 V$_{1mA}$/1$25^{\circ}C$/24h)+(0.95 V$_{1mA}$/15$0^{\circ}C$/24h). Next the varistors doped with 2.0 mol% exhibiting the nonlinear exponent of 47.39 showed high stability,ity,ability,ity,