• Journal of Communications and Networks
• /
• 제5권1호
• /
• pp.25-32
• /
• 2003

4G mobile communication system requires the throughput of 10-100Mbps. Adaptive modulated OFDM system is promising technique for increasing the throughput. In the pilot symbol assisted high-speed packet transmission system, the data symbol duration is generally considered to be small compared to the coherence time. However, OFDM symbol duration is longer than the symbol duration of a single carrier system, so that the packet duration of the pilot symbol assisted high speed packet transmission system is long. In this case, the change of channel conditions is too fast to be accurately estimated by channel estimator at the receiver in high Doppler frequency, so that many errors occur during demodulation, especially with the data symbols at the end of each packet. In this paper, we consider the BER at various instantaneous $E_b/N_o$ that includes the demodulation errors in high Doppler frequency. When the coherence time is ten times longer than the duration of a single packet, the channel can be closely approximated as an AWGN channel. Otherwise, the approximation breaks down and the above-mentioned errors that occur during demodulation must be taken into consideration. In this paper, we propose the pilot symbol assisted high speed packet transmission system based on adaptive OFDM using a novel lookup table to consider the demodulated errors and evaluate the throughput performance.

• 한국초전도저온공학회:학술대회논문집
• /
• 한국초전도저온공학회 1999년도 제1회 학술대회논문집(KIASC 1st conference 99)
• /
• pp.129-133
• /
• 1999

In recent years, there is a growing needs for large capacity underground power transmission lines with the increasing demand of electric power in the urban area, where various environmental limitations are imposed on the overhead transmission lines. But it is difficult to get the space for the underground power transmission cables because of complicated distributions of underground public facilties such as subway, water pipes, gas etc. As the superconducting power cables have the large power transmission capacity, the high power transmission capacity, the high power transmission density, and low loss characteristics in comparison with a conventional cable, it would be a solution to meet the increased power demand. In this paper, the results of the conceptual design and analysis of power system of HTS power transmission cable is described.

• Journal of information and communication convergence engineering
• /
• 제6권2호
• /
• pp.192-197
• /
• 2008

High-speed harmonic optical modulation-demodulation schemes are presented and a possibility of the schemes for applying to high-speed light wave transmission system is tested at microwave frequency range. An example of this concept is as follows : Light wave is modulated succeedingly through cascaded optical modulators by a sub-carrier to produce a modulated light wave at harmonic frequency which is higher than the feasible frequency of the individual modulators. For demodulation of the base-band signal, the high frequency optical sub-carrier is down-converted by the same kind of optical modulator with the same concept of harmonic modulation.

• 한국산업융합학회 논문집
• /
• 제22권3호
• /
• pp.365-371
• /
• 2019

Recently, the demonstration and research on the power transmission using high voltage DC such as HVDC(High Voltage DC), Smart Grid, DC transmission and distribution have been actively conducted. In order to control the power converter in high-voltage DC power transmission system, SMPS(Switching Modulation Power Supply) for power converter control using high-voltage DC input is essential. However, the demand for high-pressure SMPS is still low, so the development is not enough. In the low-output SMPS using the high-voltage input, it is difficult to achieve high efficiency due to the switching transient loss especially at light load. In this paper, we propose a new switching scheme for high power SMPS control for low output power. The proposed method can provide better efficiency increase effect in the light load region compared to the existing PWM method. To verify the feasibility of the proposed method, a 40 W SMPS for HVDC MMC(Modulation Multi-level Converter) was designed and verified by simulation.

• 정보처리학회논문지:컴퓨터 및 통신 시스템
• /
• 제4권9호
• /
• pp.321-326
• /
• 2015

본 논문에서는 가청 주파수 영역 중 사람들에게 거의 들리지 않는 고주파와 순환 중복 검사 기법을 이용하여 스마트 기기 간의 신뢰성 있는 데이터를 무선으로 전송하는 알고리즘을 제안한다. 제안 알고리즘은 스마트 기기의 내장 스피커에서 출력할 수 있는 가청 주파수 영역(20 Hz~22 kHz) 중 고주파 영역인 18 kHz~22 kHz를 사용한다. 이때 데이터의 전송량을 높이기 위해 고주파 영역 1(18.0 kHz~21.2 kHz)에서 여러 개의 주파수를 혼합하여 전달하며, 이와 동시에 전송 데이터의 정확성을 높이기 위해 고주파 영역 2(21.2 kHz~22.0 kHz)에서 순환 중복 검사를 위한 체크섬을 전달한다. 제안 방법의 데이터 전송 속도와 정확성을 확인하기 위해 스마트 북과 스마트 기기 간에 데이터 전달 실험을 하였다. 그 결과 평균 235 ms에 32 bits 데이터를 전송할 수 있었으며, 전송 성공률은 99.47%, 그리고 순환 중복 검사에 의한 에러 검출률은 0.53%인 것을 확인하였다. 따라서 제안 방법은 스마트 기기 간에 무선으로 데이터를 전송할 수 있는 유용한 기술이 될 것이다.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1996년도 추계학술대회 논문집 학회본부
• /
• pp.434-436
• /
• 1996

This paper deals with the signal communication system for MAGLEV which is indispensible to train control with safety and high speed operation. Therefore it is necessary for signal system to ensure high speed transmission. massive transmission, low error rate, and reliability of information. And the ensured information should be transmitted between ground and on-board for safety and high speed operation. For these reasons, we have considered the guaranteed reliability by applying FSK method and HDLC protocol. Because HDLC has the advantages of high efficiency, high reliability, low bit rate, and bit transparency. HDLC is the appropriate method for data transmission in MAGLEV.

• 전기학회논문지
• /
• 제60권5호
• /
• pp.999-1004
• /
• 2011

Nowadays, it is becoming difficult to secure a transmission line route when a new transmission line is constructed due to social environment and resident complaints. As existing urban areas are expanded and new cities are constructed, the necessity of high-capacity underground power transmission has been increasing because of load concentration in downtown areas. In North America, Europe and Japan, the research has been carried out for 2nd generation gas insulated transmission lines(GIL) which is more environmentally friendly and economical compared to previous GILs. The new GILs have been applied to real power systems from early 2000s. In South Korea, GIL is being considered as a possible solution for replacing 345kV high-capacity overhead transmission lines with underground transmission ones, so KEPCO is planning to develop and apply a new 362kV rated GIL underground transmission lines instead of overhead transmission lines. In this paper, the overvoltage generated at the combined transmission line adapting GIL was reviewed using EMTP.

• 전기학회논문지
• /
• 제57권4호
• /
• pp.576-581
• /
• 2008

Electricity Market in Korea can't provide locational price signal through energy price because energy market is CBP(Cost Based Pool) using uniform price. Generators don't want to locate in a densely populated load area(like the metropolitan area). Because they are paid more fixed cost in metropolitan area. This situation has loss and congestion occurred in power system. However energy market without price signal can't lead generator to the metropolitan. So, market participants should be provided price signal through the transmission price instead of energy price. This paper proposes transmission pricing method considering reliability cost in order to offer price signal. Also, it proposes the method to allocate the transmission cost to each transmission line user through a fair and a reasonable manner. The transmission price is decided by the reliability value of each line. If a transmission line of high reliability value is broke, users using that line will get a loss and a discomfort. So, it is fair that users using a transmission line of high reliability value pay more than the other users. Also, it is reasonable that a transmission line owner get paid more form users using that line.

• 한국항행학회논문지
• /
• 제17권2호
• /
• pp.202-207
• /
• 2013

본 논문에서는 병렬 연결된 전송선로를 이용하여 고 비율 비대칭 전력 분배기를 설계하였다. 병렬 연결된 전송선로는 마이크로스트립 기술로 구현하기 어려운 낮은 임피던스의 전송선로를 높은 임피던스 전송선로로 구현하는 방법이다. 비율 비대칭 분배기 구현 시 사용되는 낮은 임피던스를 구현하기 위하여 병렬 연결된 전송선로를 이용함으로서 구현을 쉽게 할 수 있었다. 이러한 설계방법의 타당성을 보이기 위해서 중심 주파수 1 GHz에서 10:1 비율의 비대칭 전력 분배기를 제작하였고, 이것의 특성은 시뮬레이션과 거의 동일함을 확인하였다.

• 전기전자학회논문지
• /
• 제21권3호
• /
• pp.195-201
• /
• 2017

대용량 무선 전력 전송 시스템은 ESS, 배터리 장치 등의 발전을 위한 핵심 기술이다. 무선 전력 전송 장치는 현재 자기유도 및 자기공진 기술들이 주를 이루고 있으며 유선 전력 전송에 비해 전력 전송 용량이 낮고 효율이 낮은 단점이 있다. 이 논문에서는 자기 결합을 갖는 가변속 모터 시스템을 기반으로 하는 대용량 무선 전력 전송 시스템을 제안하고자 한다. 제안된 방식은 대용량 전력 전송이 가능하며, 고효율과 낮은 고장 가능성의 장점을 가지고 있으며 시뮬레이션과 실험을 통해 제안된 기법의 성능을 검증하였다.