• Korean Journal of Remote Sensing
• /
• v.40 no.4
• /
• pp.387-396
• /
• 2024

Most very high-resolution (VHR) satellite images provide rational polynomial coefficients (RPC) data to facilitate the transformation between ground coordinates and image coordinates. However, initial RPC often contains geometric errors, necessitating correction through matching with ground control points (GCPs). A GCP chip is a small image patch extracted from an orthorectified image together with height information of the center point, which can be directly used for geometric correction. Many studies have focused on area-based matching methods to accurately align GCP chips with VHR satellite images. In cases with seasonal differences or changed areas, edge-based algorithms are often used for matching due to the difficulty of relying solely on pixel values. However, traditional edge extraction algorithms,such as canny edge detectors, require appropriate threshold settings tailored to the spectral characteristics of satellite images. Therefore, this study utilizes deep learning-based edge information that is insensitive to the regional characteristics of satellite images for matching. Specifically,we use a pretrained pixel difference network (PiDiNet) to generate the edge maps for both satellite images and GCP chips. These edge maps are then used as input for normalized cross-correlation (NCC) and relative edge cross-correlation (RECC) to identify the peak points with the highest correlation between the two edge maps. To remove mismatched pairs and thus obtain the bias-compensated RPC, we iteratively apply the data snooping. Finally, we compare the results qualitatively and quantitatively with those obtained from traditional NCC and RECC methods. The PiDiNet network approach achieved high matching accuracy with root mean square error (RMSE) values ranging from 0.3 to 0.9 pixels. However, the PiDiNet-generated edges were thicker compared to those from the canny method, leading to slightly lower registration accuracy in some images. Nevertheless, PiDiNet consistently produced characteristic edge information, allowing for successful matching even in challenging regions. This study demonstrates that improving the robustness of edge-based registration methods can facilitate effective registration across diverse regions.

• Korean Journal of Remote Sensing
• /
• v.36 no.1
• /
• pp.29-39
• /
• 2020

Forest fire is a critical disaster that causes massive destruction of forest ecosystem and economic loss. Hence, accurate estimation of the burned area is important for evaluation of the degree of damage and for preparing baseline data for recovery. Since most of the area size damaged by wildfires in Korea is less than 1 ha, it is necessary to use satellite or drone images with a resolution of less than 10m for detecting the damage area. This paper aims to detect wildfire-damaged area from a Kompsat-3 image using the indices such as NDVI (normalized difference vegetation index) and FBI (fire burn index) and to examine the classification characteristics according to the methods such as Otsu thresholding and ISODATA(iterative self-organizing data analysis technique). To mitigate the salt-and-pepper phenomenon of the pixel-based classification, a gaussian filter was applied to the images of NDVI and FBI. Otsu thresholding and ISODATA could distinguish the burned forest from normal forest appropriately, and the salt-and-pepper phenomenon at the boundaries of burned forest was reduced by the gaussian filter. The result from ISODATA with gaussian filter using NDVI was closest to the official record of damage area (56.9 ha) published by the Korea Forest Service. Unlike Otsu thresholding for binary classification,since the ISODATA categorizes the images into multiple classes such as(1)severely burned area, (2) moderately burned area, (3) mixture of burned and unburned areas, and (4) unburned area, the characteristics of the boundaries consisting of burned and normal forests can be better expressed. It is expected that our approach can be utilized for the high-resolution images obtained from other satellites and drones.

• Journal of the Korean Society of Surveying, Geodesy, Photogrammetry and Cartography
• /
• v.37 no.6
• /
• pp.481-489
• /
• 2019

Change detection, one of the main applications of multi-temporal satellite images, is an indicator that directly reflects changes in human activity. Change detection can be divided into pixel-based change detection and object-based change detection. Although pixel-based change detection is traditional method which is mostly used because of its simple algorithms and relatively easy quantitative analysis, applying this method in VHR (Very High Resolution) images cause misdetection or noise. Because of this, pixel-based change detection is less utilized in VHR images. In addition, the sensor of acquisition or geographical characteristics bring registration noise even if co-registration is conducted. Registration noise is a barrier that reduces accuracy when extracting spatial information for utilizing VHR images. In this study object-based change detection of VHR images was performed considering registration noise. In this case, object-based change detection results were derived considering various pixel-based change detection methods, and the major voting technique was applied in the process with segmentation image. The final object-based change detection result applied by the proposed method was compared its performance with other results through reference data.

• Korean Journal of Remote Sensing
• /
• v.24 no.4
• /
• pp.351-358
• /
• 2008

KOMPSAT-5 will be launched in 2010 carrying a SAR (Synthetic Aperture Radar) system to obtain high resolution images of the earth surface regardless of weather or solar condition. In this paper, the orbits of KOMPSAT-5 and the imaging modes of SAR were analyzed for radargrammetry, and the best image pairs were suggested. We set the pass number from the nearest orbit to a given ground point and selected image pairs for radargrarnmetry, with height sensitivity of parallax higher than 0.5 to achieve enough height resolution and with the value lower than 0.8 to avoid errors from geometric distortion. On the equator, for example, where the distance between two adjacent passes is fixed to 95 km, we solved the orbit geometry and found that the image pairs with the pass numbers of 3-2 and 5-3 are suitable for radargrarnmetry. As the examples with arbitrary latitude, we selected Daejeon and Sejong Antarctic stations and calculated the orbital elements by using STK software. Three image pairs (5-4, 7-5 and 8-5) were found suitable for radargrammetry at Daejeon while 10 pairs (8-6, 9-7, 10-7, 11-8, 12-8, 13-9, 14-9, 15-9, 15-10 and 15-11) at Sejong Antarctic station.

• Aerospace Engineering and Technology
• /
• v.4 no.2
• /
• pp.220-229
• /
• 2005

The Earth observation imagery from satellite provide valuable informations for the central government, local governments and diverse public organizations. The analysis of applications and data, which are sold by commercial distributors of Earth observation satellite data, shows this phenomenon clearly. The Government of Republic of Korea established and carried out a national space development plan to meet the national needs for remotely sensed imagery. After this national space development plan and on behalf of Korean government KARI has developed and launched successfully the KOMPSAT-1 and operates it up to now. KARI is now to launch by the end of year 2005 another optical remote sensing satellite with very high resolution and named as KOMPSAT-2. For the application of such very high resolution remotely sensed data the product validation should be done carefully and this product validation require lots of ancillary data such as in-situ measurements. For the purpose of diverse ancillary data acquisition joint work with other nations, related institutes and international bodies is essential. In this paper the status of Korean European Cooperations will be introduced, which are derived by KARI, ARCS and ESA for the wide use of KOMPSAT data in Europe.

• Journal of Astronomy and Space Sciences
• /
• v.21 no.4
• /
• pp.329-342
• /
• 2004

In this paper, we present preliminary feasibility studies on three types of solar observation payloads for future Korean Science and Technology Satellite (STSAT) programs. The three candidates are (1) an UV imaging telescope, (2) an UV spectrograph, and (3) an X-ray spectrometer. In the case of UV imaging telescope, the most important constraint seems to be the control stability of a satellite in order to obtain a reasonably good spatial resolution. Considering that the current pointing stability estimated from the data of the Far ultraviolet Imaging Spectrograph (FIMS) onboard the Korean STSAT-1, is around 1 arc minutes/sec, we think that it is hard to obtain a spatial resolution sufficient for scientific research by such an UV Imaging Telescope. For solar imaging missions, we realize that an image stabilization system, which is composed of a small guide telescope with limb sensor and a servo controller of secondary mirror, is quite essential for a very good pointing stability of about 0.1 arcsec. An UV spectrograph covering the solar full disk seems to be a good choice in that there is no risk due to poor pointing stability as well as that it can provide us with valuable UV spectral irradiance data valuable for studying their effects on the Earth's atmosphere and satellites. The heritage of the FIMS can be a great advantage of developing the UV spectrograph. Its main disadvantage is that two major missions are in operation or scheduled. Our preliminary investigations show that an X-ray spectrometer for the full disk Sun seems to be the best choice among the three candidates. The reasons are : (1) high temporal and spectral X-ray data are very essential for studying the acceleration process of energetic particles associated with solar flares, (2) we have a good heritage of X-ray detectors including a rocket-borne X-ray detector, (3) in the case of developing countries such as India and Czech, solar X-ray spectrometers were selected as their early stage satellite missions due to their poor pointing stabilities, and (4) there is no planned major mission after currently operating Reuven Ramaty High-Energy Solar Spectroscopic Imager (RHESSI) mission. Finally, we present a preliminary design of a solar X-ray spectrometer covering soft X-ray (2 keV) to gamma ray (10 MeV).

• Journal of Korean Society for Geospatial Information Science
• /
• v.17 no.1
• /
• pp.21-35
• /
• 2009

KOMPSAT-2 is the seventh high-resolution image satellite in the world that provides both 1m-grade panchromatic images of the GSD and 4m-grade multispectral images of the GSD. It's anticipated to be used across many different areas including mapping, territory monitoring and environmental watch. However, due to the complexity and security concern involved with the use of the MSC, the use of KOMPSAT-2 images are limited in terms of geometric images, such as satellite orbits and detailed mapping information. Therefore, this study aims to produce DEM and orthoimage by using the stereo images of KOMPSAT-2, and to explore the applicability of geo-spatial information with KOMPSAT -2. Orientation interpretations were essential for the production of DEM and orthoimage using KOMPSAT-2 images. In the study, they are performed by utilizing both RPC and GCP. In this study, the orientation interpretations are followed by the generation of DEM and orthoimage, and the analysis of their accuracy based on a 1:5,000 digital map. The accuracy analysis of DEM is performed and the results indicate that their altitudes are, in general, higher than those obtained from the digital map. The altitude discrepancies on plains, hills and mountains are calculated as 1.8m, 7.2m, and 11.9m, respectively. In this study, the mean differences between horizontal position between the orthoimage data and the digital map data are found to be ${\pm}3.081m$, which is in the range of ${\pm}3.5m$, within the permitted limit of a 1:5,000 digital map. KOMPSAT-2 images are used to produce DEM and orthoimage in this research. The results suggest that DEM can be adequately used to produce digital maps under 1:5,000 scale.

• Journal of the Korean Association of Geographic Information Studies
• /
• v.11 no.1
• /
• pp.80-89
• /
• 2008

Mapping applications using satellite imagery have been possible to quantitative analysis since SPOT satellite with stereo image was launched. Especially, high resolution satellite imagery was efficiently used in the field of digital mapping for the areas which are difficult to produce large-scale maps by aerial photogrammetry or carry out ground control point surveying due to unaccessibility. This study extracted the geospatial information out of consideration for topographic characteristic from ortho imagery of the National Geospatial-intelligence Agency(NGA) in the United States of America and analyzed the accuracy of plane coordinate for ortho imagery. For this purpose, the accuracy according to topographic character by comparison between both extraction data from ortho imagery and the digital topographic maps of 1:5000 scale which were produced by Korea National Geographic Information Institute(NGI) was evaluated. It is expected that the results of this study will be fully used as basic information for ground control point acquisition or digital mapping in unaccessible area.

• Aerospace Engineering and Technology
• /
• v.9 no.2
• /
• pp.161-167
• /
• 2010

CEU(Camera Electronic Unit) loaded in optical satellite for a high resolution image acquisition is composited with CC(Camera Controlloer), FPA(Focal Plane Assembly) and CEUP(CEU Power supply). EMC test and analysis results are explained in this paper. CE, CS, RE and RS test is performed in the 1st EMC test, RE, RS test which is not complied and influence considerably after shielding structure is performed in the 2nd EMC test. An effect due to the noise of CEU in the GPS/S-band receiving band is analyzed based on 2nd EMC test results. Margin more than 6dB is guaranteed when CEU is shielded.

• Proceedings of the KSRS Conference
• /
• v.2
• /
• pp.959-962
• /
• 2006

Public education is undoubtedly a very important aspect for a country to develop space program. People have the rights to understand how the tax they paid is being used. This paper addresses the effectiveness of FORMOSAT-2 on public education in Taiwan. As the first remote sensing satellite of the National Space Organization (NSPO) of Taiwan, FORMOSAT-2 is a small satellite of 746 kg mass for two remote sensing missions: Earth and upward lightning observations. The mission orbit is sun-synchronous of 888 km altitude for exactly 14 revolutions per day. For earth observation, the payload is an advanced high resolution remote sensing instrument (RSI) with ground sampling distance (GSD) 2 m in panchromatic (PAN) band and 8 m in four multi-spectral (MS) bands. For upward lightning observation, the payload is an imager of sprites and upper atmospheric lightning (ISUAL). After more than two years of Earth observation started in June 2004, the effectiveness of FORMOSAT-2 images on public education in Taiwan is very promised. Five domestic universities and one private company in Taiwan have signed contracts respectively with NSPO to take the roles of satellite image investigator and distributor. A private company has signed contract with NSPO to generate and provide URMAP (= your map) in its website for general public applications by using FORMOSAT-2 images. The Newtonkids Book Company used FORMOSAT-2 images to publish a kind of calendar for children education purpose. Besides, a science team in National Cheng Kung University (NCKU) is doing the research work on the 3820 (up to 30 June 2006) transient luminous events (TLEs) observed by FORMOSAT-2.