• The Transactions of the Korean Institute of Electrical Engineers B
• /
• v.51 no.4
• /
• pp.210-220
• /
• 2002

We analysised the effect of harmonics on electric machines of substation power system barred on quantitatively measured harmonics and proposed the methods for prevention of harmonics through checking on transformer, rectifier and cable's capacities against harmonics with reference to KEPCO's electricity service standard. In order to analysis harmoninics of silicon rectifier that is power source in DC substation, computer simulations for a substation with TR of high voltage distribution switchboard are performed. Simulation results show that the total harmonic distortion factor becomes smaller for TR primary and receiving points in order rather than silicon rectifier which is harmonic generation source so that the harmonics generated frets each rectifier are outflowed to power supply and high voltage distribution switchboard The result of higher distortion factors of voltage and current for rectifier with 100% load than those with 50 % and 30% indicates that the waveform of voltage and current for the real substation power system at the office-going and the closing hours with heavy loads might be more distorted. As proposed methods for harmonic reduction, the conventional 6 pulse-type for substation is required to be replaced by 12 pulse-type for reduction of 5th and 7th harmonics. The active filter rather than the passive filter is more effective due to severe variance of rectifier loads, but the high cost is price to be paid. In view of installation area and costs, the use of 12 pulse-type transformer is desirable and then the parallel transformer and the rectifier within the substation must be replaced at the same time. Other substations with parallel feeder can use 6 pulse-type transformer.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2010.06a
• /
• pp.92-92
• /
• 2010

In this paper, the test is performed on MgO, which is used as a filler in epoxy additives, respectively (0, 1.0, 3.0, 5.0, 7.0, 10 [wt%]) for HVDC(high voltage direct current) submarine cable insulating material to improve electrical properties of epoxy resin in high temperature. The breakdown strength due to increasing amount of filler increased to 5.0 [wt%] by the effects of the Coulomb blockade. However, it is confirmed that strength of dielectric breakdown decreased because the filler functioned as impurities and affected the breakdown when filler additive exceeded by 5.0 [wt%] or more. We have found that the highest dielectric breakdown strength of specimen added 5.0 wt% at $25^{\circ}C$, and is more increased approximately 13.7 [%] than virgin specimen.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.29 no.3B
• /
• pp.314-324
• /
• 2004

Recently, high-speed internet subscribers have grown continuously, and reached up to 10 millions. But existing network management that is responsible only for user access is confronted with many difficulties, since user access network(xDSL, Cable, B-WILL, and so on) has diversified and value added wired/wireless contents service has developed. In this paper propose the Agent based Inter Networking platform as object-oriented hierarchical system that can provide various service such as access QoS(Quality of Service), customized application service and security service according to user on demand. This system has divided into two parts(user agent and agent management system ＆ local and central management systems). Management system periodically receive status information such as bandwidth, download speed, delay, current service, and so on, and process them, then build a policy based on processed information. According to personal user profile that is generated by this policy, the customized service can be provided for users. And This system adopt the object-oriented modeling in case that system migration and integration, and implement a system that is robust and stable for security through hierarchical server system.

• Structural Engineering and Mechanics
• /
• v.88 no.1
• /
• pp.53-65
• /
• 2023

With the gradual implementation of long-span suspension bridges into high-speed railway operations, the main beam's bending stiffness contribution to the live load response permanently grows. Since another critical control parameter of railway suspension bridges is the beam-end rotation angle, it should not be ignored by treating the main beam deflection as the only deformation response. To this end, the current study refines the existing method of the main cable shape and simply supported beam bending moment analogy. The bending stiffness of the main beam is considered, and the main beam's analytical expressions of deflection and rotation angle in the whole span are obtained using the cable-beam deformation coordination relationship. Taking a railway suspension bridge as an example, the effectiveness and accuracy of the proposed analytical method are verified by the finite element method (FEM). Comparison of the results by FEM and the analytical method ignoring the main beam stiffness revealed that the bending stiffness of the main beam strongly contributed to the live load response. Under the same live load, as the main beam stiffness increases, the overall deformation of the structure decreases, and the reduction is particularly noticeable at locations with original larger deformations. When the main beam stiffness is increased to a certain extent, the stiffening effect is no longer pronounced.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.49 no.9
• /
• pp.801-811
• /
• 2021

Lightning can deliver large amounts of energy to the aircraft in a short period of time, resulting in catastrophic consequence. In particular, lightning strikes accompanied by high temperature heat and current can damage aircraft surface and internal electronic equipment, seriously affecting flight safety. Lightning experiments to analyze this effect use a Component A waveform with a maximum current of 200 kA as specified in SAE ARP 5412B. However, the actual lightning occurs mostly below 35kA and lightning indirect tests are conducted by reducing waveforms to prevent damage to internal electronic equipment. In this study, we examine previous methods to plot the Component A reduced waveform and identify their limitations. We then propose a new method to plot the reduced waveform based on adjusting the correction factor of the aircraft lightning Component A waveform. Finally, the electromagnetic analysis software EMA3D was used to compare the internal induced current size reduction ratio of the internal cable harness of the EC-155B helicopter.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.15 no.4
• /
• pp.199-203
• /
• 2015

With the development of industry these days, the demand for electric power increases and the larger capacity for power transfer is required. The scales of facilities should become larger; and the relative systems are required to operate with a higher degree of reliability. Therefore, stabilization of electric power systems is an important issue. The high degree of reliability required in the process of production and supply of electric power is an essential part of industrial society. Accident such as blackouts causes a hugh amount of economic losses to the high-tech industrial society dependent upon electric power. This paper is about the basic study of the relations between the load current and lifetime of power cables in operation. In order to do the research, we installed a current transformer and an equipment for measuring temperature at the 6.6. kV cables in operation. The two equipments have been installed on the cable systems in operation for the last 20 years. Since the insulation resistance of most of the cables showed the value larger than the threshold, it was not easy to tell the remaining lifetime of cables. The load current of the cables was almost constant. The surrunding temperature was $15{\sim}25^{\circ}C$, little variation of temperature values.

• Journal of the Korean GEO-environmental Society
• /
• v.12 no.1
• /
• pp.13-26
• /
• 2011

Because the allowable current loading of buried electrical transmission cables is frequently limited by the maximum permissible temperature of the cable or of the surrounding ground, there is a need for cable backfill materials to be maintained at a low thermal resistivity during the service period. Temperatures greater than $50^{\circ}C$ to $60^{\circ}C$ may lead to breakdown of cable insulation and thermal runaway if the surrounding backfill material is unable to dissipate the heat as rapidly as it is generated. This paper describes the results of studies aimed at the development of backfill material to reduce the thermal resistivity. A large number of different additive materials were tested to determine their applicability as a substitute material. The results of Dong-rim river sand (relatively uniform) show that as water content level increases, thermal resistivity tends to decrease, whereas the thermal resistivity on dry condition is very high value($260^{\circ}C-cm/watt$). In addition, other materials(such as Jinsan granite screenings, A-2(sand and gravel mixture), E-1(rubble and granite screenings mixture) and SGFC(sand, gravel, fly-ash and cement mixture)) are well-graded materials with low thermal resistivity($100^{\circ}C-cm/watt$ when dry). Based on this research, 4 types of improved materials were suggested as the environmentally friendly backfill materials with low thermal resistivity.

• Journal of the Korea institute for structural maintenance and inspection
• /
• v.15 no.6
• /
• pp.92-99
• /
• 2011

Ultra High Performance Concrete(UHPC) is a superior structural material with high strength and durability. Construction of light and slim structures is realized to apply this expectable new materials in practice. This research is a part of the project to develop UHPC precast deck system for hybrid cable stayed bridge. The main object of this study is to investigate behavior of the lap-spliced reinforced connection in UHPC. The major parameter considered in experimental plan was lap-spliced length. The 4-points bending test for 12 specimens were conducted to verify the effect of considered parameters. Test results show that the minimum value of lap spliced length of 300mm which specified in current korea high bridge design code was very conservative for UHPC precast deck system.

• Journal of Internet Computing and Services
• /
• v.21 no.4
• /
• pp.51-57
• /
• 2020

Currently, High-efficient video coding (HEVC) has become the most promising video coding technology. However, the implementation of HEVC in video streaming systems is restricted by factors such as cost, design complexity, and compatibility with existing systems. While HEVC is considering deploying to various systems with different reached methods, H264/AVC can be one of the best choices for current video streaming systems. This paper presents an adaptive method for manipulating video streams using video coding on an integrated circuit (IC) designed with a private network processor. The proposed system allows to transfer multimedia data from cameras or other video sources to client. For this work, a series of video or audio packages from the video source are forwarded to the designed IC via HDMI cable, called Tx transmitter. The Tx processes input data into a real-time stream using its own protocol according to the Real-Time Transmission Protocol for both video and audio, then Tx transmits output packages to the video client though internet. The client includes hardware or software video/audio decoders to decode the received packages. Tx uses H264/AVC or HEVC video coding to encode video data, and its audio coding is PCM format. By handling the message exchanges between Tx and the client, the transmitted session can be set up quickly. Output results show that transmission's throughput can be achieved about 50 Mbps with approximately 80 msec latency.

• Proceedings of the Korea Technology Innovation Society Conference
• /
• 2001.11a
• /
• pp.37-57
• /
• 2001

Digital technology enhanced the improvement of technological aspects in the both broadcasting and telecommunications industries. The infrastructures of each industry converged to one, which impacts not only on technology but also on the broadcasting service. The current broadcasting service is characterized by one-way service, but it'll changed to be customized, or two-way service that reflects the interest of customers. This change requires a new standard to categorize and analyze the future broadcasting service converged and market structure, differing from the present standard based on the transmission channels. This study aims at forecasting the demand of interactive TV service as a representative broadcasting service in the near future, and analyzing the market structure of the broadcasting services. We assume that the present broadcasting and information and telecommunications services such as terrestrial, cable TV, satellite, digital TV services and high-speed broadband service have strong relationship with interactive TV service. First we use Bass diffusion method to predict the diffusion curve of the present five services. Then we analyze the relationship between the present services and interactive TV service by Delphi method. Finally we estimate the potential subscription number of interactive TV service based on the relationship among the services and diffusion parameters.