• 한국전기전자재료학회논문지
• /
• 제32권1호
• /
• pp.64-69
• /
• 2019

Methylammonium lead triiodide ($MAPbI_3$)-based perovskite solar cells potentially have potential advantages such as high efficiency and low-cost manufacturing procedures. However, $MAPbI_3$ is structurally unstable and has low phase-change temperatures ($30^{\circ}C$ and $130^{\circ}C$); it is necessary to solve these problems. We investigated the crystal structure and phase separation using real-time temperature-change X-ray diffraction, transmission electron microscopy, and electron energy loss spectroscopy. $MAPbI_3$ has a tetragonal structure, and at about $35^{\circ}C$ the c-axis contracts, transforming $MAPbI_3$ into the related cubic crystal structure. In addition, at $130^{\circ}C$, phase separation occurs in which $CH_3NH_2$ and HI at the center of the unit cell of the perovskite structure are extracted by gas, leavingand only $PbI_2$ of the three-component structure, is produced as the final solid product.

• 한국전기전자재료학회논문지
• /
• 제13권3호
• /
• pp.254-258
• /
• 2000

Current leads of high $T_{c}$ superconductor were fabricated with Bi excess B $i_{2.2}$/S $r_{1.8}$/C $a_{1}$/C $u_{2}$/ $O_{x}$ composition by rapid cooling method. The dimensions of final samples were fixed 3 mm and 8 mm diameter with 50 mm length each To control uniform density the samples were preformed by CIP(Cold Isostatic Press) process and followed by partial or full melting process after raising up to 90$0^{\circ}C$ for 30min. Plate shaped microstructure was clearly observed adjacent to the Ag tube wall and the size of plate was about 100$\mu$m. However the severe destruction of growth orientation was shown in the inner growth part. critical temperature ( $T_{c}$) was about 53~71K after directional growth while Tc was decreased about 77~80 K before directional growth. After directional growth critical current( $I_{c}$) and critical current density( $J_{c}$) in the specimen of 8 mm diameter at 50 K were about 110 A and 280 A/c $m^2$ respectively.pectively.ely.

• 한국전기전자재료학회논문지
• /
• 제20권10호
• /
• pp.883-888
• /
• 2007

Investigation of improving the properties of UV detector which uses the wide bandgap of ZnO are under active progress. The present study focused on the design and fabrication of i-ZnO/p-inversion $layer/n^--Si$ Epi. which is characterized with very thin p-type inversion layer for UV detectors. The i-ZnO thin film for achieving p-inversion layer which was grown by RF sputtering at $450^{\circ}C$ and then annealed at $400^{\circ}C$ in $O_2$ gas for 20 min shows good intrinsic properties. High (0002) peak intensity of the i-ZnO film is shown on XRD spectrum and it is confirmed by XPS analysis that the ratio of Zn : O of the i-ZnO film is nearly 1 : 1. Measurement shows high transmission of 79.5 % in UV range (< 400 nm) for the i-ZnO film. Measurement of $V_r-I_{ph}$ shows high UV photo-current of 1.2 mA under the reverse bias of 30 V.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2008년도 추계학술대회 논문집 Vol.21
• /
• pp.275-275
• /
• 2008

This paper describe the fabrication of a Pd/polycrystalline 3C-SiC schottky diode and its characteristics, in which the polycrystalline 3C-SiC layer and Pd Schottky contact were deposited by using APCVD and sputter, respectively. Crystalline quality, uniformity, and preferred orientations of the Pd thin film were evaluated by SEM and XRD, respectively. Pd/poly 3C-SiC Schottky diodes were fabricated and characterized by I-V and C-V measurements. Its electric current density Js and barrier height voltage were measured as $2\times10^{-3}$ A/$cm^2$ and 0.58 eV, respectively. These devices were operated until about $400^{\circ}C$. Therefore, from these results, Pd/poly 3C-SiC Schottky devices have very high potential for high temperature chemical sensor applications.

• 한국진공학회:학술대회논문집
• /
• 한국진공학회 2008년도 제34회 동계학술대회 초록집
• /
• pp.106-106
• /
• 2008

• Journal of Nutrition and Health
• /
• 제38권10호
• /
• pp.817-826
• /
• 2005

Recently it has been reported that vitamin A and retinol binding proteins (RBPs) in blood and urine were changed in the condition of diabetes mellitus or hyperlipidemia. Fruits and vegetables are recommended to consume for the people suffered from these chronic degenerative diseases. The main components of fruits and vegetables are dietary fibers, for example cellulose and pectin, of which function to affect the absorption and excretion of dietary fat and fat-soluble substances. This study was conducted to investigate the effect of dietary fibers on RBPs mRNA expression in liver, small intestine and serum of rat fed high fat diet during 4 weeks. Sprague-Dawley rats, weighing 121g on average, were divided into four groups; (Control; $17\%$ fat & cellulose supplement diet, HF0: $25\%$ fat & fiber free diet, B:.Uc: $25\%$ fat & cellulose supplement diet and HF0: $25\%$ fat & pectin supplement diet) . The rats fed high fat diet groups (HF0, HFC, HFP) tended to consume the food less than the control group, but FER of HF0 groups was significantly higher than the control (p < 0.05) . The weight of adrenal gland in high fat diet groups (HF0, HFC, HFP) was significantly less than the control. Total lipid in feces daily excreted and in liver did not show any significant differences among the groups. Total cholesterol in HFP group was significantly different from that of HFC group. Serum total cholesterol and triglyceride in other group tended to lower than other groups and HDL cholesterol higher. Consequently, AI (atherogenic index) was the lowest in HFP group. Vit A contents in feces daily excreted tended to lower in high fat diet groups (HF0, HFP) compared to the control group. That content in adrenal gland was the lowest in HF0 group, but not in liver. In HFP group were down-regulated cRBPI mRNA in liver and cRBPII mRNA in small intestine and up-regulated RBP and transthyretin expression in serum compared to the other groups. In conclusion, dietary fibers, especially pectin, in high fat diet might down-regulate the expression of CRBP I, CRBP II mRNA in liver and small intestine, but increase the secretion of RBP into serum and therefore inhance the bioavailability of Vit A through the body. (Korean J Nutrition 38(10): 817$\sim$826,2005)

• 센서학회지
• /
• 제17권6호
• /
• pp.414-417
• /
• 2008

This paper describes the fabrication of a Pd/poly 3C-SiC Schottky diode and its characteristics, in which the poly 3C-SiC layer and Pd Schottky contact were deposited by using APCVD and sputter, respectively. Crystalline quality, uniformity, and preferred orientations of the Pd thin film were evaluated by SEM and XRD, respectively. Pd/poly 3C-SiC schottky diodes were fabricated and characterized by I-V and C-V measurements. Its electric current density Js and barrier height voltage were measured as $2{\times}10^{-3}A/cm^2$ and 0.58 eV, respectively. These devices were operated until about $400^{\circ}C$. Therefore, from these results, Pd/poly 3C-SiC Schottky devices have very high potential for high temperature chemical sensor applications.

• 한국분말야금학회:학술대회논문집
• /
• 한국분말야금학회 2006년도 Extended Abstracts of 2006 POWDER METALLURGY World Congress Part 1
• /
• pp.217-218
• /
• 2006

More and more applications or demands for machine parts etc are expected for AISI 440C (hereinafter referred to as "440C") Stainless Steel because of its characteristic features, i.e. high-strength as well as high-corrosion resistance. This research has enabled us to obtain sintered products with good quality even under a wide range of temperature by utilizing the pinning effect of NbC, improving the relevant sintering feature of 440C Stainless Steel in the MIM method.

• 한국초전도저온공학회:학술대회논문집
• /
• 한국초전도저온공학회 2002년도 학술대회 논문집
• /
• pp.315-317
• /
• 2002

The value of I$_{c}$(critical current) in HTS (High Temperature Superconducting) tape has a great influence on B(equation omitted) (magnetic field amplitude applied perpendicular to the tape surface). Therefore, I$_{c}$ of HTS magnet is determined by not only operating temperature but also the B(equation omitted). In shape design of field coil for the HTS motor, a method to reduce the B(equation omitted) and to determine operating current should be considered in order to optimal design. On the basis of the magnetic field analysis, this paper deals with various field coil shape to obtain operating current of HTS motor by using analytical method. And also this paper discusses the operating current of 100hp class HTS motor by using I$_{c}$-B(equation omitted) curve.curve.

• 대한안전경영과학회지
• /
• 제24권1호
• /
• pp.73-80
• /
• 2022

The purpose of this study is to present the direction of the plan to transform the residential complex into a space that can provide an open residential environment that can lead to social communication and exchange without being closed to the urban residential environment, especially in the apartment complex environment, which is becoming more dense. As a result of the Openness analysis of the 'Codan Shinonome Canal Court', the overall accessibility was good in terms of space utilization, and the openness was low in terms of the spatial composition, which is a physical environment due to the dense block type. When looking at the overall openness of the Codan Sinonome complex in terms of analysis by block, the corrected openness index (C.O.I) for all six blocks was 0.245, the corrected accessibility index (C.A.I) was 1.447 and the openness composite index (O.C.I) was assessed at 1.692. This was due to the formation of high-density block-type urban dwellings and the introduction of S-shaped streets and the layout of low-rise urban support facilities and commercial facilities. The Codan Sinonome Canal Court, which is considered an "open city residence," quantitatively confirmed that it embodies macro-space structure and human-scale space environment even in high-precision environments.