• Proceedings of the Korean Society For Composite Materials Conference
• /
• 1999.11a
• /
• pp.198-203
• /
• 1999

2D carbon/carbon composites have been prepared with and without addition of 1, 3 and 5wt% of oxidation inhibitor boron and then heat teated up to 1700, 2000, 2300, 2600 each. This paper presents the effects of boron on the mechanical properties of 2D C/C composites in terms of the acceleration of graphitization and also discussed about the retardation of air oxidation.

• Journal of the Korean Society for Heat Treatment
• /
• v.12 no.1
• /
• pp.9-20
• /
• 1999

The effect of post oxidation, water-quenched after holding in air for 5~420 seconds or cooling or furnace cooling, on corrosion resistance and phase formation characteristics of the surface layer of SM20C and SM45C carbon steels after gas nirtrocarbursing in the $NH_3-5%CO_2-N_2$ gas atmosphere at $580^{\circ}C$ for 3hours is studied. The compound layers of two steels consist of ${\varepsilon}-Fe_{2-3}N$, ${\gamma}^{\prime}-Fe_4N$ and $Fe_3O_4$, phases, however, the quantity of ${\gamma}^{\prime}-Fe_4N$ phase increases for the furnace cooled specimen compared to that of air cooling specimen. With increasing $NH_3$ content in the gas mixture and also increasing the keeping time in the air after gas nitrocarburising, the ${\varepsilon}-Fe_{2-3}N$ phase of compound layer increases, while the decreased current density recognizing the improvement of corrosion resistance are shown. the passive current density of SM45C steel is lower than that of SM20C steel at the same nitrocarburising conditions.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2011.02a
• /
• pp.325-325
• /
• 2011

Very initial stage of oxidation process of Si (001) surface at room temperature (300 K) and high temperature (1200 K) was investigated using large scale molecular dynamics simulation. Reactive force field potential [1] was used for the simulation owing to its ability to handle charge variation as well as breaking and forming of bonds associated with the oxidation reaction. The results show that oxygen molecules adsorb dissociatively or otherwise leave the silicon surface. Initial position and orientation of oxygen molecule above the surface play important role in determining final state and time needed to dissociate. At 300 K, continuous transformation of ion $Si^+$ (or suboxide Si2O) to $Si2^+$ (SiO), $Si3^+$ (Si2O3) and finally to $Si4^+$ (SiO2) clearly observed. High temperature silicon surface provide heat energy that enable oxygen atom to penetrate into deeper silicon surface. The heat energy also retards adsorption process. As a result, transformation of ion $Si^+$ is impeded at 1200 K.

• Journal of the Korean Society for Heat Treatment
• /
• v.8 no.2
• /
• pp.137-148
• /
• 1995

The nitridation kinetics of titanium powder were studied by isothermal and non-isothermal (dynamic) methods in high purity nitrogen under I atm pressure. For the comparison with nitridation, the oxidation kinetics of titanium powder were also studied in dry oxygen at I atm pressure. An automatic recording electrobalance was used to measure the weight gain as a function of time and temperature. For the reaction with nitrogen, the nitride was formed at over $700^{\circ}C$. The reaction with nitrogen followed the parabolic rate law, and the activation energy was calculated to be 31 kcal/mol in the isothermal method (above $900^{\circ}C$). The non-stoichiometric TiNx has been synthesized by the nitridation at a proper temperature and time, followed by the homogenizing treatment above $1100^{\circ}C$. In comparison with the stoichiometric $TiN_{1.0}$ and the non-stoichiometric TiNx ($TiN_{0.5}$ and $TiN_{0.65}$), the hot oxidation characteristics of the former is superior to that of the latter. However, both non-stoichiometric nitrides make little difference in the hot oxidation characteristics.

• Journal of Advanced Marine Engineering and Technology
• /
• v.13 no.3
• /
• pp.48-55
• /
• 1989

The purpose of present study is to evaluate both the radiative heat loss from a flame and the local formation and oxidation rate of soot. The present paper describes a comprehensive mathematical model to deal with combustion and radiative heat transfer simultaneously. The involved radiative heat transfer model was based on the "heat ray tracing method" originally proposed by Hayasaka et al.. Some predicted results were compared with the experiments.periments.

• Journal of the Korean Society for Heat Treatment
• /
• v.16 no.6
• /
• pp.335-340
• /
• 2003

To improve properties of wear resistance and anti-corrosion of the trivalent chromium platings, oxinitrocarbunsing and steam oxidation were conducted. Armophous trivalent Cr platings could be transformed to chromium carbides of high hardness, that showed low friction and wear rate. Even though micro-cracks were within as platings, superior anti-corrosion property was obtained by these treatments due to healing of cracks at the interface between the trivalent chromium platings and substrate.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 1997.11a
• /
• pp.279-282
• /
• 1997

The propose of this study is research and improvement of LiNiO$_2$as cathode material for Lithium secondary batteries. LiNiO$_2$is prepared by heating LiOH . $H_2O$ and Ni(OH)$_2$(mole ratio 1 : 1) on various heat condition. In the result of XRD mesurement, all LiNiO$_2$prepared at this study showed hexagonal structure. In Cyclic Voltammetry, LiNiO$_2$is not conspicous about oxidation peak but oxidation curve change steeply over 3.8V and reduction peak discover at 3.6V. In discharge capacities, specific capacity is higher $O_2$than air when preliminary heated and 75$0^{\circ}C$ than $700^{\circ}C$, 80$0^{\circ}C$ when heated. Therefore, when preliminary heat at $650^{\circ}C$ $O_2$and heat at 75$0^{\circ}C$ carried out, discharge property is the best.

• Asian-Australasian Journal of Animal Sciences
• /
• v.30 no.8
• /
• pp.1135-1142
• /
• 2017

Objective: The objective of this study was to evaluate effects of heat treatment and soybean oil inclusion on protein oxidation of soy protein isolate (SPI) and of oxidized protein on redox status of broilers at an early age. Methods: SPI mixed with soybean oil (SPIO) heated at $100^{\circ}C$ for 8 h was used to evaluate protein oxidation of SPI. A total of two hundred and sixteen 1-day-old Arbor Acres chicks were divided into 3 groups with 6 replicates of 12 birds, receiving basal diet (CON), heat-oxidized SPI diet (HSPI) or mixture of SPI and 2% soybean oil diet (HSPIO) for 21 d, respectively. Results: Increased protein carbonyl, decreased protein sulfhydryl of SPI were observed as heating time increased in all treatments (p<0.05). Addition of 2% soybean oil increased protein carbonyl of SPI at 8 h heating (p<0.05). Dietary HSPI and HSPIO decreased the average daily gain of broilers as compared with the CON (p<0.05). Broilers fed HSPI and HSPIO exhibited decreased glutathione (GSH) in serum, catalase activity and total sulfhydryl in liver and increased malondialdehyde (MDA) and protein carbonyl in serum, advanced oxidation protein products (AOPPs) in liver and protein carbonyl in jejunal mucosa as compared with that of the CON (p<0.05). Additionally, broilers receiving HSPIO showed decreased glutathione peroxidase activity (GSH-Px) in serum, GSH and hydroxyl radical scavenging capacity in liver, GSH-Px activity in duodenal mucosa, GSH-Px activity and superoxide anion radical scavenging capacity in jejunal mucosa and increased AOPPs in serum, MDA and protein carbonyl in liver, MDA and AOPPs in jejunal mucosa (p<0.05). Conclusion: Protein oxidation of SPI can be induced by heat and soybean oil and oxidized protein resulted in redox imbalance in broilers at an early age.

• Journal of the Korean institute of surface engineering
• /
• v.29 no.6
• /
• pp.607-614
• /
• 1996

Yttrium(Y) coating was incorporated by ion-plating method either directly on the TiAl substrate or after pack aluminizing on TiAl to improve the oxidation resistance of TiAl alloy. After Y-coating, heat treatment at low oxygen partial pressure was carried out. Performance of various coating was evaluated by isothermal and cyclic oxidation tests. A simple Y-coating without pack aluminizing can give a detrimental effect on the. oxidation resistance of TiAl alloy, because it enhances formation of $TiO_2$. On the other hand, a composite coating of aluminide-yttrium has shown excellent oxidation resistance. A continuous protective $Al_2O_3$ scale is formed on the aluminized TiAl, and Y-coating improves $Al_2O_3$ scale adherence and substantially prevents depletion of Al in the aluminide-coating layer.

• Journal of Hydrogen and New Energy
• /
• v.28 no.4
• /
• pp.392-400
• /
• 2017

An experimental study was conducted to investigate behavior of steel surface oxidation with characteristics of the combustion. The excess entalphy combustion in porous media system was applied to implement the direct radiation heating system. The surface oxidation thickness (SOT) of fuel-lean was thicker than the SOT of fuel-rich. Also, the SOT was increased by increasing residence time. Detailed explanations were given by SEM and EDS analysis.